| 1. |
|
|
| 2. |
|
|
| 3. |
- Abdesselam, A., et al.
(författare)
-
The ATLAS semiconductor tracker end-cap module
- 2007
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 575:3, s. 353-389
-
Tidskriftsartikel (refereegranskat)abstract
- The challenges for the tracking detector systems at the LHC are unprecedented in terms of the number of channels, the required read-out speed and the expected radiation levels. The ATLAS Semiconductor Tracker. (SCT) end-caps have a total of about 3 million electronics channels each reading out every 25 ns into its own on-chip 3.3 mu s buffer. The highest anticipated dose after 10 years operation is 1.4x10(14) cm(-2) in units of 1 MeV neutron equivalent (assuming the damage factors scale with the non-ionising energy loss). The forward tracker has 1976 double-sided modules, mostly of area similar to 70 cm(2), each having 2 x 768 strips read out by six ASICs per side. The requirement to achieve an average perpendicular radiation length of 1.5% X-0, while coping with up to 7 W dissipation per module (after irradiation), leads to stringent constraints on the thermal design. The additional requirement of 1500e(-) equivalent noise charge (ENC) rising to only 1800e(-) ENC after irradiation, provides stringent design constraints on both the high-density Cu/Polyimide flex read-out circuit and the ABCD3TA read-out ASICs. Finally, the accuracy of module assembly must not compromise the 16 mu m (r phi) resolution perpendicular to the strip directions or 580 mu m radial resolution coming from the 40 mrad front-back stereo angle. A total of 2210 modules were built to the tight tolerances and specifications required for the SCT. This was 234 more than the 1976 required and represents a yield of 93%. The component flow was at times tight, but the module production rate of 40-50 per week was maintained despite this. The distributed production was not found to be a major logistical problem and it allowed additional flexibility to take advantage of where the effort was available, including any spare capacity, for building the end-cap modules. The collaboration that produced the ATLAS SCT end-cap modules kept in close contact at all times so that the effects of shortages or stoppages at different sites could be rapidly resolved.
|
|
| 4. |
- Gultepe, Ismail, et al.
(författare)
-
A review on ice fog measurements and modeling
- 2015
-
Ingår i: Atmospheric research. - : Elsevier BV. - 0169-8095 .- 1873-2895. ; 151, s. 2-19
-
Tidskriftsartikel (refereegranskat)abstract
- The rate of weather-related aviation accident occurrence in the northern latitudes is likely 25 times higher than the national rate of Canada. If only cases where reduced visibility was a factor are considered, the average rate of occurrence in the north is about 31 times higher than the Canadian national rate. Ice fog occurs about 25% of the time in the northern latitudes and is an important contributor to low visibility. This suggests that a better understanding of ice fog prediction and detection is required over the northern latitudes. The objectives of this review are the following: 1) to summarize the current knowledge of ice fog microphysics, as inferred from observations and numerical weather prediction (NWP) models, and 2) to describe the remaining challenges associated with measuring ice fog properties, remote sensing microphysical retrievals, and simulating/predicting ice fog within numerical models. Overall, future challenges related to ice fog microphysics and visibility are summarized and current knowledge is emphasized.
|
|
| 5. |
|
|
| 6. |
|
|
| 7. |
- Stojkov, K, et al.
(författare)
-
Guideline-based indicators for adult patients with myelodysplastic syndromes
- 2020
-
Ingår i: Blood advances. - : American Society of Hematology. - 2473-9537 .- 2473-9529. ; 4:16, s. 4029-4044
-
Tidskriftsartikel (refereegranskat)abstract
- Myelodysplastic syndromes (MDSs) represent a heterogeneous group of hematological stem cell disorders with an increasing burden on health care systems. Evidence-based MDS guidelines and recommendations (G/Rs) are published but do not necessarily translate into better quality of care if adherence is not maintained in daily clinical practice. Guideline-based indicators (GBIs) are measurable elements for the standardized assessment of quality of care and, thus far, have not been developed for adult MDS patients. To this end, we screened relevant G/Rs published between 1999 and 2018 and aggregated all available information as candidate GBIs into a formalized handbook as the basis for the subsequent consensus rating procedure. An international multidisciplinary expert panel group (EPG) of acknowledged MDS experts (n = 17), health professionals (n = 7), and patient advocates (n = 5) was appointed. The EPG feedback rates for the first and second round were 82% (23 of 28) and 96% (26 of 27), respectively. A final set of 29 GBIs for the 3 domains of diagnosis (n = 14), therapy (n = 8), and provider/infrastructural characteristics (n = 7) achieved the predefined agreement score for selection (>70%). We identified shortcomings in standardization of patient-reported outcomes, toxicity, and geriatric assessments that need to be optimized in the future. Our GBIs represent the first comprehensive consensus on measurable elements addressing best practice performance, outcomes, and structural resources. They can be used as a standardized instrument with the goal of assessing, comparing, and fostering good quality of care within clinical development cycles in the daily care of adult MDS patients.
|
|
| 8. |
|
|
| 9. |
|
|
| 10. |
- Poyatos, R., et al.
(författare)
-
Plasticity in hydraulic architecture of Scots pine across Eurasia
- 2007
-
Ingår i: Oecologia. - : Springer Science and Business Media LLC. - 1432-1939 .- 0029-8549. ; 153:2, s. 245-259
-
Tidskriftsartikel (refereegranskat)abstract
- Widespread tree species must show physiological and structural plasticity to deal with contrasting water balance conditions. To investigate these plasticity mechanisms, a meta-analysis of Pinus sylvestris L. sap flow and its response to environmental variables was conducted using datasets from across its whole geographical range. For each site, a Jarvis-type, multiplicative model was used to fit the relationship between sap flow and photosynthetically active radiation, vapour pressure deficit (D) and soil moisture deficit (SMD); and a logarithmic function was used to characterize the response of stomatal conductance (G(s)) to D. The fitted parameters of those models were regressed against climatic variables to study the acclimation of Scots pine to dry/warm conditions. The absolute value of sap flow and its sensitivity to D and SMD increased with the average summer evaporative demand. However, relative sensitivity of G(s) to D (m/G(s,ref) where m is the slope and G(s,ref) is reference G(s) at D = 1 kPa) did not increase with evaporative demand across populations, and transpiration per unit leaf area at a given D increased accordingly in drier/warmer climates. This physiological plasticity was linked to the previously reported climate- and size-related structural acclimation of leaf to sapwood area ratios. G(s,ref), and its absolute sensitivity to D (m), tended to decrease with age/height of the trees as previously reported for other pine species. It is unclear why Scots pines have higher transpiration rates at drier/warmer sites, at the expense of lower water-use efficiency. In any case, our results suggest that these structural adjustments may not be enough to prevent lower xylem tensions at the driest sites.
|
|
