| 1. |
- Beal, Jacob, et al.
(författare)
-
Robust estimation of bacterial cell count from optical density
- 2020
-
Ingår i: Communications Biology. - : Springer Science and Business Media LLC. - 2399-3642. ; 3:1
-
Tidskriftsartikel (refereegranskat)abstract
- Optical density (OD) is widely used to estimate the density of cells in liquid culture, but cannot be compared between instruments without a standardized calibration protocol and is challenging to relate to actual cell count. We address this with an interlaboratory study comparing three simple, low-cost, and highly accessible OD calibration protocols across 244 laboratories, applied to eight strains of constitutive GFP-expressing E. coli. Based on our results, we recommend calibrating OD to estimated cell count using serial dilution of silica microspheres, which produces highly precise calibration (95.5% of residuals <1.2-fold), is easily assessed for quality control, also assesses instrument effective linear range, and can be combined with fluorescence calibration to obtain units of Molecules of Equivalent Fluorescein (MEFL) per cell, allowing direct comparison and data fusion with flow cytometry measurements: in our study, fluorescence per cell measurements showed only a 1.07-fold mean difference between plate reader and flow cytometry data.
|
|
| 2. |
- Yao, Lei, et al.
(författare)
-
Atmospheric new particle formation from sulfuric acid and amines in a Chinese megacity
- 2018
-
Ingår i: Science. - : American Association for the Advancement of Science (AAAS). - 0036-8075 .- 1095-9203. ; 361:6399, s. 278-281
-
Tidskriftsartikel (refereegranskat)abstract
- Atmospheric new particle formation (NPF) is an important global phenomenon that is nevertheless sensitive to ambient conditions. According to both observation and theoretical arguments, NPF usually requires a relatively high sulfuric acid (H2SO4) concentration to promote the formation of new particles and a low preexisting aerosol loading to minimize the sink of new particles. We investigated NPF in Shanghai and were able to observe both precursor vapors (H2SO4) and initial clusters at a molecular level in a megacity. High NPF rates were observed to coincide with several familiar markers suggestive of H2SO4-dimethylamine (DMA)water (H2O) nucleation, including sulfuric acid dimers and H2SO4-DMA clusters. In a cluster kinetics simulation, the observed concentration of sulfuric acid was high enough to explain the particle growth to similar to 3 nanometers under the very high condensation sink, whereas the subsequent higher growth rate beyond this size is believed to result fromthe added contribution of condensing organic species. These findings will help in understanding urban NPF and its air quality and climate effects, as well as in formulating policies to mitigate secondary particle formation in China.
|
|
| 3. |
- Chang, Qingyan, et al.
(författare)
-
Precursor engineering enables high-performance all-inorganic CsPbIBr2 perovskite solar cells with a record efficiency approaching 13%
- 2024
-
Ingår i: Journal of Energy Chemistry. - : Elsevier BV. - 2095-4956 .- 2096-885X. ; 90, s. 16-22
-
Tidskriftsartikel (refereegranskat)abstract
- All-inorganic CsPbIBr2 perovskite has attracted widespread attention in photovoltaic and other optoelectronic devices because of its superior thermal stability. However, the deposition of high-quality solution-processed CsPbIBr2 perovskite films with large thicknesses remains challenging. Here, we develop a triple-component precursor (TCP) by employing lead bromide, lead iodide, and cesium bromide, to replace the most commonly used double-component precursor (DCP) consisting of lead bromide and cesium iodide. Remarkably, the TCP system significantly increases the solution concentration to 1.3 M, leading to a larger film thickness (∼390 nm) and enhanced light absorption. The resultant CsPbIBr2 films were evaluated in planar n-i-p structured solar cells, which exhibit a considerably higher optimal photocurrent density of 11.50 mA cm−2 in comparison to that of DCP-based devices (10.69 mA cm−2). By adopting an organic surface passivator, the maximum device efficiency using TCP is further boosted to a record efficiency of 12.8% for CsPbIBr2 perovskite solar cells.
|
|
| 4. |
- Dai, Ting, et al.
(författare)
-
Assessment of Fast Fluid Dynamics with Different Turbulence Models for Simulating Airflow and Pollutant Dispersion Around Buildings
- 2023
-
Ingår i: Proceedings of the 5th International Conference on Building Energy and Environment. - : Springer Nature. ; , s. 51-59
-
Konferensbidrag (refereegranskat)abstract
- Fast fluid dynamics (FFD) could provide efficient airflow and concentration simulation. The commonly used turbulence model in FFD was RNG k- ε turbulence model which solved two transport equations to obtain eddy viscosity. To improve computing speed, this investigation implemented no turbulence model, Smagorinsky model and dynamic Smagorinsky model which calculated eddy viscosity without solving equation in FFD in an open-source program, OpenFOAM. By simulating single-building case and comparing with experiment and CFD, this study assessed accuracy and efficiency of FFD with those turbulence models. Compared with CFD, FFD improved computing speed without reducing accuracy. The simulation of FFD without turbulence model was fast but inaccurate. FFD with Smagorinsky model increased computing speed while ensuring the same accuracy as RNG k- ε turbulence model. FFD with dynamic Smagorinsky model provided accurate results with high efficiency. This investigation suggested FFD with dynamic Smagorinsky model for outdoor airflow and pollutant dispersion studies.
|
|
| 5. |
- Dai, Ting, et al.
(författare)
-
Evaluation of fast fluid dynamics with different turbulence models for predicting outdoor airflow and pollutant dispersion
- 2022
-
Ingår i: Sustainable cities and society. - : Elsevier BV. - 2210-6707. ; 77, s. 103583-
-
Tidskriftsartikel (refereegranskat)abstract
- Fast fluid dynamics (FFD) could provide informative and efficient airflow and concentration simulation. The commonly used turbulence model in FFD was Re-Normalization Group (RNG) k-epsilon turbulence model which solved two transport equations to obtain eddy viscosity. To reduce this part of time and further improve computing speed, this investigation implemented no turbulence model, Smagorinsky model and dynamic Smagorinsky model which calculated eddy viscosity without solving equation in FFD in an open-source program, OpenFOAM. By simulating several outdoor cases of varying complexity and comparing with experiment and CFD, this study assessed the accuracy and computing efficiency of FFD with four turbulence models. Compared with CFD, FFD greatly improved the computing speed without reducing accuracy. The simulation of FFD without turbulence model was fast but inaccurate. FFD with Smagorinsky model increased the computing speed while ensuring the same accuracy as RNG k-epsilon turbulence model. FFD with dynamic Smagorinsky model provided accurate results with high efficiency. Computation errors arose mainly from inaccurate prediction of turbulence dispersion. The computing cost was associated with the number of transport equations and calculation method of model coefficient. This investigation recommended the use of FFD with dynamic Smagorinsky model for outdoor airflow and pollutant dispersion studies.
|
|
| 6. |
- Hou, Jing, et al.
(författare)
-
Associations of indoor carbon dioxide concentrations, air temperature, and humidity with perceived air quality and sick building syndrome symptoms in Chinese homes
- 2021
-
Ingår i: Indoor Air. - : John Wiley & Sons. - 0905-6947 .- 1600-0668. ; 31:4, s. 1018-1028
-
Tidskriftsartikel (refereegranskat)abstract
- The indoor environment influences occupants' health. From March 1, 2018, to February 28, 2019, we continuously monitored indoor temperature (T), relative humidity (RH), and CO2 concentration in bedrooms via an online system in 165 residences that covered all five climate zones of China. Meanwhile, we asked one specific occupant in each home to complete questionnaires about perceived air quality and sick building syndrome (SBS) symptoms at the end of each month. Higher CO2 concentration was significantly associated with a higher percentage of perceived stuffy odor and skin SBS symptoms. Higher relative humidity was associated with higher percentage of perceived moldy odor and humid air, while lower RH was associated with a higher percentage of perceived dry air. Occupants who lived in residences with high RH were less likely to have mucosal and skin SBS symptoms (adjusted odds ratio (AOR): 0.73-0.78). However, the benefit of high humidity for perceived dry air and skin dryness symptoms is weaker if there is a high CO2 concentration level.
|
|
| 7. |
- Lai, Dayi, et al.
(författare)
-
A comprehensive review of thermal comfort studies in urban open spaces
- 2020
-
Ingår i: Science of the Total Environment. - : Elsevier BV. - 0048-9697 .- 1879-1026. ; 742
-
Forskningsöversikt (refereegranskat)abstract
- Urban open spaces provide various benefits to large populations in cities. Since thermally comfortable urban open spaces improve the quality of urban living, an increasing number of studies have been conducted to extend the existing knowledge of outdoor thermal comfort. This paper comprehensively reviews current outdoor thermal comfort studies, including benchmarks, data collection methods, and models of outdoor thermal comfort. Because outdoor thermal comfort is a complex issue influenced by various factors, a conceptual framework is proposed which includes physical, physiological and psychological factors as direct influences: and behavioral, personal, social, cultural factors, as well as thermal history, site, and alliesthesia, as indirect influences. These direct and indirect factors are further decomposed and reviewed, and the interactions among various factors are discussed. This review provides researchers with a systematic and comprehensive understanding of outdoor thermal comfort, and can also guide designers and planners in creating thermally comfortable urban open spaces.
|
|
| 8. |
- Liu, Wei, 1987-, et al.
(författare)
-
A novel method for measuring air infiltration rate in buildings
- 2018
-
Ingår i: Energy and Buildings. - : Elsevier. - 0378-7788 .- 1872-6178. ; 168, s. 309-318
-
Tidskriftsartikel (refereegranskat)abstract
- Measuring the air infiltration rate in buildings is essential for reducing energy use and improving indoor air quality. This rate has traditionally been determined by means of the blower door method, which is disruptive to building occupants, cannot identify the location of infiltration, cannot provide the infiltration rate for a section of the envelope, and requires considerable effort for setup and tear-down. Therefore, this study has developed a novel technique to measure air infiltration in buildings using an infrared camera. A thermographic image of a building envelope produced by an infrared camera and the measured indoor/outdoor air parameters (velocity, temperature, and pressure) were used to identify the effective crack size and air infiltration rate by means of theoretical heat transfer and fluid mechanics analyses. The proposed method was validated by experimental measurements in an environmental chamber and an office. The experiment in the environmental chamber constructed a small-scale room with known crack size. The experimental setup was comparable to actual conditions. The proposed method was able to predict the crack size within a relative error of 20%. For the experiment in the office, this study used the tracer-gas decay method to measure the air infiltration rate, and the relative error of the calculated air infiltration rate was only 3%.
|
|
| 9. |
|
|
| 10. |
- Lou, Xinyuan, et al.
(författare)
-
A study on human perception in aircraft cabins and its association with volatile organic compounds
- 2022
-
Ingår i: Building and Environment. - : Elsevier. - 0360-1323 .- 1873-684X. ; 219
-
Tidskriftsartikel (refereegranskat)abstract
- More than 8 million people fly on commercial aircraft each day with approximately 5% having a pre-existing respiratory disease. Thus it is necessary to provide high air quality in aircraft to protect public health. Volatile organic compounds (VOCs) present in aircraft cabins are suspected to contribute to the reported complaints. We investigated concentrations of VOCs, air temperature, relative humidity, and CO2 concentrations in a total of 46 flights, including 26 Chinese domestic flights and 20 international flights. We focused on the data from the cruising phase without meal serving in which the air supply and air recirculation were steady. A total of 284 passengers (i.e., 101 on international flights and 183 on Chinese domestic flights) were invited to participate in questionnaire surveys in this phase. We performed a linear mixed model analysis by controlling for potential confounders (age, gender, smoke habits, and history of allergy) to study associations between VOCs exposures and passengers' complaints. Xylene was significantly associated with irritations of the eyes, nose, and throat on both international and domestic flights, with antilog beta values from 1.12 to 1.28 (p < 0.05). The association of some aldehydes (i.e., nonanal, decanal, and heptanal), which are potential oxidation products with ozone, with passengers' sensory irritations was also significant, especially during international flights (antilog beta values: 1.19-1.22). It indicates that VOCs, especially xylene and aldehydes, in aircraft cabins may influence the perceived indoor air quality and complaints among passengers.
|
|
