1. |
|
|
2. |
- Abate, E., et al.
(författare)
-
Combined performance tests before installation of the ATLAS Semiconductor and Transition Radiation Tracking Detectors
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 3
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS (A Toroidal LHC ApparatuS) Inner Detector provides charged particle tracking in the centre of the ATLAS experiment at the Large Hadron Collider (LHC). The Inner Detector consists of three subdetectors: the Pixel Detector, the Semiconductor Tracker (SCT), and the Transition Radiation Tracker (TRT). This paper summarizes the tests that were carried out at the final stage of SCT+TRT integration prior to their installation in ATLAS. The combined operation and performance of the SCT and TRT barrel and endcap detectors was investigated through a series of noise tests, and by recording the tracks of cosmic rays. This was a crucial test of hardware and software of the combined tracker detector systems. The results of noise and cross-talk tests on the SCT and TRT in their final assembled configuration, using final readout and supply hardware and software, are reported. The reconstruction and analysis of the recorded cosmic tracks allowed testing of the offline analysis chain and verification of basic tracker performance parameters, such as efficiency and spatial resolution, in combined operation before installation.
|
|
3. |
- Abdesselam, A., et al.
(författare)
-
The ATLAS semiconductor tracker end-cap module
- 2007
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 575:3, s. 353-389
-
Tidskriftsartikel (refereegranskat)abstract
- The challenges for the tracking detector systems at the LHC are unprecedented in terms of the number of channels, the required read-out speed and the expected radiation levels. The ATLAS Semiconductor Tracker. (SCT) end-caps have a total of about 3 million electronics channels each reading out every 25 ns into its own on-chip 3.3 mu s buffer. The highest anticipated dose after 10 years operation is 1.4x10(14) cm(-2) in units of 1 MeV neutron equivalent (assuming the damage factors scale with the non-ionising energy loss). The forward tracker has 1976 double-sided modules, mostly of area similar to 70 cm(2), each having 2 x 768 strips read out by six ASICs per side. The requirement to achieve an average perpendicular radiation length of 1.5% X-0, while coping with up to 7 W dissipation per module (after irradiation), leads to stringent constraints on the thermal design. The additional requirement of 1500e(-) equivalent noise charge (ENC) rising to only 1800e(-) ENC after irradiation, provides stringent design constraints on both the high-density Cu/Polyimide flex read-out circuit and the ABCD3TA read-out ASICs. Finally, the accuracy of module assembly must not compromise the 16 mu m (r phi) resolution perpendicular to the strip directions or 580 mu m radial resolution coming from the 40 mrad front-back stereo angle. A total of 2210 modules were built to the tight tolerances and specifications required for the SCT. This was 234 more than the 1976 required and represents a yield of 93%. The component flow was at times tight, but the module production rate of 40-50 per week was maintained despite this. The distributed production was not found to be a major logistical problem and it allowed additional flexibility to take advantage of where the effort was available, including any spare capacity, for building the end-cap modules. The collaboration that produced the ATLAS SCT end-cap modules kept in close contact at all times so that the effects of shortages or stoppages at different sites could be rapidly resolved.
|
|
4. |
-
- 2019
-
Tidskriftsartikel (refereegranskat)
|
|
5. |
- Abdesselam, A., et al.
(författare)
-
Engineering for the ATLAS SemiConductor Tracker (SCT) end-cap
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 3
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS SemiConductor Tracker (SCT) is a silicon-strip tracking detector which forms part of the ATLAS inner detector. The SCT is designed to track charged particles produced in proton-proton collisions at the Large Hadron Collider (LHC) at CERN at an energy of 14 TeV. The tracker is made up of a central barrel and two identical end-caps. The barrel contains 2112 silicon modules, while each end-cap contains 988 modules. The overall tracking performance depends not only on the intrinsic measurement precision of the modules but also on the characteristics of the whole assembly, in particular, the stability and the total material budget. This paper describes the engineering design and construction of the SCT end-caps, which are required to support mechanically the silicon modules, supply services to them and provide a suitable environment within the inner detector. Critical engineering choices are highlighted and innovative solutions are presented - these will be of interest to other builders of large-scale tracking detectors. The SCT end-caps will be fully connected at the start of 2008. Further commissioning will continue, to be ready for proton-proton collision data in 2008.
|
|
6. |
- Abt, I, et al.
(författare)
-
Inclusive V-0 production cross sections from 920 GeV fixed target proton-nucleus collisions
- 2003
-
Ingår i: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044. ; 29:2, s. 181-190
-
Tidskriftsartikel (refereegranskat)abstract
- Inclusive differential cross sections dsigma(pA)/dx(F) and dsigma(pA)/dp(t)(2) for the production of K-S(0), Lambda, and (&ULambda;) over bar particles are measured at HERA in proton-induced reactions on C, Al, Ti, and W targets. The incident beam energy is 920 GeV, corresponding to roots = 41.6 GeV in the proton-nucleon system. The ratios of differential cross sections dsigma(pA)(K-S(0))/dsigma(pA)(Lambda) and dsigma(pA)((&ULambda;) over bar)/dsigma(pA) (Lambda) are measured to be 6.2 +/- 0.5 and 0.66 +/- 0.07, respectively, for x(F) approximate to -0.06. No significant dependence upon the target material is observed. Within errors, the slopes of the transverse momentum distributions da,Ald t also show no significant dependence upon the target material. The dependence of the extrapolated total cross sections sigma(pA) on the atomic mass A of the target material is discussed, and the deduced cross sections per nucleon sigma(pN) are compared with results obtained at other energies.
|
|
7. |
- Abt, I, et al.
(författare)
-
Measurement of the b(b)over-bar production cross section in 920 GeV fixed-target proton-nucleus collisions
- 2003
-
Ingår i: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044. ; 26:3, s. 345-355
-
Tidskriftsartikel (refereegranskat)abstract
- Using the HERA-B detector, the b (b) over bar production cross section has been measured in 920 GeV proton collisions on carbon and titanium targets. The b (b) over bar production was tagged via inclusive bottom quark decays into J/psi by exploiting the longitudinal separation of J/psi --> l(+)l(-) decay vertices from the primary proton-nucleus interaction. Both e(+)e(-) and mu(+)mu(-) channels have been reconstructed and the combined analysis yields the cross section sigma(b (b) over bar) = 32(-12)(+14)(stat) (+6)(-7)(sys) nb/nucleon.
|
|
8. |
- Abdesselam, A., et al.
(författare)
-
The barrel modules of the ATLAS semiconductor tracker
- 2006
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 568:2, s. 642-671
-
Tidskriftsartikel (refereegranskat)abstract
- This paper describes the silicon microstrip modules in the barrel section of the SemiConductor Tracker (SCT) of the ATLAS experiment at the CERN Large Hadron Collider (LHC). The module requirements, components and assembly techniques are given, as well as first results of the module performance on the fully assembled barrels that make up the detector being installed in the ATLAS experiment.
|
|
9. |
- Backer, V., et al.
(författare)
-
Multidisciplinary approaches to identifying and managing global airways disease: Expert recommendations based on qualitative discussions
- 2023
-
Ingår i: Frontiers in Allergy. - : Frontiers Media SA. - 2673-6101. ; 4
-
Tidskriftsartikel (refereegranskat)abstract
- BackgroundChronic rhinosinusitis with nasal polyps (CRSwNP) and asthma frequently co-exist and share pathologic features. Taking a "global" treatment approach benefits diagnosis and treatment of both, but care is often siloed by specialty: joined-up clinics are uncommon. Our objectives were to explore expert opinion to give practical suggestions to identify adults needing global airways care; enhance cross-specialty working; and widen knowledge to support diagnosis and management, integrate with existing care pathways, and supplement existing guidelines.MethodsSixteen practicing physicians from northern Europe were invited for their national and/or international standing in treating asthma and/or chronic rhinosinusitis. Appreciative Inquiry techniques were used to guide their discussions.ResultsKey themes arising were screening and referral, collaboration on management, awareness and education, and research. Provided are screening criteria and suggestions for specialist referrals, and pointers for physicians to optimize their knowledge of global airways disease. Collaborative working is underscored, and practical suggestions are given for multidisciplinary teamworking within global airways clinics. Research gaps are identified.ConclusionThis initiative provides practical suggestions for optimizing the care of adults with CRSwNP and asthma. Discussion of the role of allergy and drug exacerbations on these conditions, and care for patients with other global airways diseases were beyond scope; however, we expect some principles of our discussion will likely benefit patients with related conditions. The suggestions bridge asthma and CRSwNP management guidelines, envisioning interdisciplinary, global airway clinics relevant to various clinical settings. They highlight the value of joint screening for early recognition and referral of patients.
|
|
10. |
- Hveem, T. S., et al.
(författare)
-
Changes in Chromatin Structure in Curettage Specimens Identifies High-Risk Patients in Endometrial Cancer
- 2017
-
Ingår i: Cancer Epidemiology Biomarkers & Prevention. - : American Association for Cancer Research (AACR). - 1055-9965 .- 1538-7755. ; 26:1, s. 61-67
-
Tidskriftsartikel (refereegranskat)abstract
- Background: Most endometrial carcinoma patients are diagnosed at an early stage with a good prognosis. However, a relatively low fraction with lethal disease constitutes a substantial number of patients due to the high incidence rate. Preoperative identification of patients with high risk and low risk for poor outcome is necessary to tailor treatment. Nucleotyping refers to characterization of cell nuclei by image cytometry, including the assessment of chromatin structure by nuclear texture analysis. This method is a strong prognostic marker in many cancers but has not been evaluated in preoperative curettage specimens from endometrial carcinoma. Methods: The prognostic impact of changes in chromatin structure quantified with Nucleotyping was evaluated in preoperative curettage specimens from 791 endometrial carcinoma patients prospectively included in the MoMaTEC multicenter trial. Results: Nucleotyping was an independent prognostic marker of disease-specific survival in preoperative curettage specimens among patients with Federation Internationale des Gynaecologistes et Obstetristes (FIGO) stage I-II disease (HR = 2.9; 95% CI, 1.2-6.5; P - 0.013) and significantly associated with age, FIGO stage, histologic type, histologic grade, myometrial infiltration, lymph node status, curettage histology type, and DNA ploidy. Conclusions: Nucleotyping in preoperative curettage specimens is an independent prognostic marker for disease-specific survival, with potential to supplement existing parameters for risk stratification to tailor treatment. Impact: This is the first study to evaluate the prognostic impact of Nucleotyping in curettage specimens from endometrial carcinoma and shows that this may be a clinically useful prognostic marker in endometrial cancer. External validation is warranted. (C) 2016 AACR.
|
|