| 1. |
- Andersson, S., et al.
(författare)
-
Sulfur recirculation for increased electricity production in Waste-to-Energy plants
- 2014
-
Ingår i: Waste Management. - : Elsevier BV. - 0956-053X .- 1879-2456. ; 34:1, s. 67-78
-
Tidskriftsartikel (refereegranskat)abstract
- Sulfur recirculation is a new technology for reducing boiler corrosion and dioxin formation. It was demonstrated in full-scale tests at a Waste to Energy plant in Goteborg (Sweden) during nearly two months of operation. Sulfur was recirculated as sulfuric acid from the flue gas cleaning back to the boiler, thus creating a sulfur loop. The new technology was evaluated by extensive measurement campaigns during operation under normal conditions (reference case) and operation with sulfur recirculation. The chlorine content of both fly ash and boiler ash decreased and the sulfur content increased during the sulfur recirculation tests. The deposit growth and the particle concentration decreased with sulfur recirculation and the dioxin concentration (I-TEQ) of the flue gas was reduced by approximately 25%. Sulfuric acid dew point measurements showed that the sulfuric acid dosage did not lead to elevated SO3 concentrations, which may otherwise induce low temperature corrosion. In the sulfur recirculation corrosion probe exposures, the corrosion rate decreased for all tested materials (16Mo3, Sanicro 28 and Inconel 625) and material temperatures (450 degrees C and 525 degrees C) compared to the reference exposure. The corrosion rates were reduced by 60-90%. Sulfur recirculation prevented the formation of transition metal chlorides at the metal/oxide interface, formation of chromate and reduced the presence of zinc in the corrosion products. Furthermore, measured corrosion rates at 525 degrees C with sulfur recirculation in operation were similar or lower compared to those measured at 450 degrees C material temperature in reference conditions, which corresponds to normal operation at normal steam temperatures. This implies that sulfur recirculation allows for higher steam data and electricity production without increasing corrosion.
|
|
| 2. |
- Davidsson, Kent, 1967, et al.
(författare)
-
Countermeasures against alkali-related problems during combustion of biomass in a circulating fluidized bed boiler
- 2008
-
Ingår i: Chemical Engineering Science. ; 63, s. 5314-5329
-
Tidskriftsartikel (refereegranskat)abstract
- The purpose of this work was to study different ways to mitigate alkali-related problems during combustionof biomass in circulating fluidized beds. Wood chips and wood pellets were fired together withstraw pellets, while the tendency to agglomerate and form deposits was monitored. In addition to areference case, a number of countermeasures were applied in related tests. Those were addition of elementalsulphur, ammonium sulphate and kaolin to a bed of silica sand, as well as use of olivine sand andblast-furnace slag as alternative bed materials. The agglomeration temperature, composition and structureof bed-ash samples were examined. The flue-gas composition, including gaseous alkali chlorides, wasmeasured in the hot flue gases and in the stack. Particles in the flue gas were collected and analysed forsize distribution and composition. Deposits were collected on a probe in hot flue gases and their amountand composition were analysed. Addition of kaolin was found to be the best method to counteract theagglomeration problem. The deposition problem is effectively counteracted with addition of ammoniumsulphate, while kaolin is too expensive to be used commercially against deposits, and sulphur is lesseffective than ammonium sulphate.
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
- Davidsson, Kent, 1967, et al.
(författare)
-
Potassium, chlorine, and sulfur in ash, particles, deposits, and corrosion during wood combustion in a circulating fluidized-bed boiler
- 2007
-
Ingår i: Energy & Fuels. - : American Chemical Society (ACS). - 1520-5029 .- 0887-0624. ; 21:1, s. 71-81
-
Tidskriftsartikel (refereegranskat)abstract
- The effect of the addition of chlorine and/or sulfur to the fuel on fly ash composition, deposit formation, and superheater corrosion has been studied during biomass combustion in a circulating fluidized-bed boiler. The chlorine (HCl (aq)) and sulfur (SO2 (g)) were added in proportions of relevance for the potassium chemistry. The composition of the bottom and the fly ashes was analyzed. Gas and particle measurements were performed downstream of the cyclone before the convection pass and the flue gas composition was recorded in the stack with a series of standard instruments and an FTIR analyzer. At the position downstream of the cyclone, a deposit probe was situated, simulating a superheater tube. Deposits on the probe and initial corrosion were examined. It is concluded that addition of sulfur and chlorine increases the formation of submicron particles leading to deposition of potassium sulfate and chloride. The results compare well with earlier work based on laboratory-scale experiments concerning effects of chlorine and sulfur on potassium chemistry.
|
|
| 6. |
- Derda, Patrycja, et al.
(författare)
-
Fate of Alkali Metals during Co-Combustion of Biodiesel Residues with Coal in a Semi-Industrial CFB Boiler
- 2008
-
Ingår i: 9th International Conference on Circulating Fluidized Beds, CFB 2008, in Conjunction with the 4th International VGB Workshop on Operating Experience with Fluidized Bed Firing Systems; Hamburg; Germany; 13 May 2008 through 16 May 2008. - 9783930400577
-
Konferensbidrag (refereegranskat)abstract
- The use of biodiesel, especially of Rapeseed Methyl Ester (RME), has recently increased inthe European countries. This gives rise to an increasing amount of after production residues. Rapeseedcake is the main residue of the RME production process, and may become available in large amounts forenergy recovery. Since rapeseed cake contains high levels of alkali metals, it may cause bedagglomeration, deposit formation and corrosion upon combustion in fluidized beds.This paper presents the fate of alkali metals formed during co-combustion of coal and up to 25% ofrapeseed cake pellets in a 12 MW Circulating Fluidized Bed Boiler at Chalmers University ofTechnology (Sweden). Standard fuel analyses combined with sequential leaching and SEM/EDX, showedthe alkali entering the boiler. Gaseous emissions, bed samples, fly ash and deposits were analyzed inorder to monitor the alkali metals distribution. Gaseous alkali chlorides were measured upstream from theconvective pass at a flue gas temperature of 800 oC using an In-situ Alkali Chloride Monitor (IACM). Inthe same location, deposits were collected on a deposit probe fitted with rings for SEM/EDX analysis.Re-circulated bed material was analyzed as well.Two-day tests showed successful co-firing of up to 25% rapeseed cake on energy basis in the semiindustrialfluidized-bed boiler. Alkali metals were enriched in fly ash. No significant difference could benoticed in the distribution of alkali metals when increasing the share of rapeseed cake from 15% to 25%on energy basis. In the near future, further studies will be carried out to determine the influence oflimestone on the performed tests.
|
|
| 7. |
- Elled, Anna-Lena, 1975, et al.
(författare)
-
Sewage sludge as a deposit inhibitor when co-fired with high potassium fuels
- 2010
-
Ingår i: Biomass and Bioenergy. - : Elsevier BV. - 1873-2909 .- 0961-9534. ; 34:11, s. 1546-1554
-
Tidskriftsartikel (refereegranskat)abstract
- The objective of this work is to survey the fate of potassium in the gas phase of a fluidised bed boiler and gain deeper understanding of the involved mechanisms during co-firing of municipal sewage sludge with biomass containing high amounts of potassium and chlorine. The results show that formation of alkali chlorides in the flue gas and corrosive deposits on heat transfer surfaces can be controlled by addition of municipal sewage sludge even though the fuel is highly contaminated with chlorine. The beneficial effects are partly due to the content of sulphur in the sludge, partly to the properties of the sludge ash. The sludge ash consists of both crystalline and amorphous phases. It contains silica, aluminium, calcium, iron and phosphorus which all are involved in the capture of potassium. (c) 2010 Elsevier Ltd. All rights reserved.
|
|
| 8. |
- Gulyurtlu, Ibrahim, et al.
(författare)
-
Co-firing of biomass and other wastes in fluidized bed systems
- 2006
-
Ingår i: 19th International Conference on Fluidized Bed Combustion.
-
Konferensbidrag (refereegranskat)abstract
- A project on co-firing in large-scale power plants burning coal is currently funded by the European Commission. It is called COPOWER. The project involves 10 organisations from 6 countries. The project involves combustion studies over the full spectrum of equipment size, ranging from small laboratory-scale reactors and pilot plants, to investigate fundamentals and operating parameters, to proving trials on a commercial power plant in Duisburg. The power plant uses a circulating fluidized bed boiler. The results to be obtained are to be compared as function of scale-up. There are two different coals, 3 types of biomass and 2 kinds of waste materials are to be used for blending with coal for co-firing tests. The baseline values are obtained during a campaign of one month at the power station and the results are used for comparison with those to be obtained in other units of various sizes. Future tests will be implemented with the objective to achieve improvement on baseline values. The fuels to be used are already characterized. There are ongoing studies to determine reactivities of fuels and chars produced from the fuels. Reactivities are determined not only for individual fuels but also for blends to be used. Presently pilot-scale combustion tests are also undertaken to study the effect of blending coal with different types of biomass and waste materials. The potential for synergy to improve combustion is investigated. Simultaneously, studies to verify the availability of biomass and waste materials in Portugal, Turkey and Italy have been undertaken. Techno-economic barriers for the future use of biomass and other waste materials are identified. The potential of using these materials in coal fired power stations has been assessed. The conclusions will also be reported.
|
|
| 9. |
|
|
| 10. |
|
|
