| 1. |
- Aamodt, K., et al.
(author)
-
Charged-Particle Multiplicity Density at Midrapidity in Central Pb-Pb Collisions at root s(NN)=2.76 TeV
- 2010
-
In: Physical Review Letters. - 1079-7114. ; 105:25
-
Journal article (peer-reviewed)abstract
- The first measurement of the charged-particle multiplicity density at midrapidity in Pb-Pb collisions at a center-of-mass energy per nucleon pair root s(NN) = 2.76 TeV is presented. For an event sample corresponding to the most central 5% of the hadronic cross section, the pseudorapidity density of primary charged particles at midrapidity is 1584 +/- 4(stat) +/- 76(syst), which corresponds to 8.3 +/- 0.4(syst) per participating nucleon pair. This represents an increase of about a factor 1.9 relative to pp collisions at similar collision energies, and about a factor 2.2 to central Au-Au collisions at root s(NN) = 0.2 TeV. This measurement provides the first experimental constraint for models of nucleus-nucleus collisions at LHC energies.
|
|
| 2. |
- Aamodt, K., et al.
(author)
-
Elliptic Flow of Charged Particles in Pb-Pb Collisions at root s(NN)=2.76 TeV
- 2010
-
In: Physical Review Letters. - 1079-7114. ; 105:25
-
Journal article (peer-reviewed)abstract
- We report the first measurement of charged particle elliptic flow in Pb-Pb collisions at root s(NN) p = 2.76 TeV with the ALICE detector at the CERN Large Hadron Collider. The measurement is performed in the central pseudorapidity region (vertical bar eta vertical bar < 0.8) and transverse momentum range 0.2 < p(t) < 5.0 GeV/c. The elliptic flow signal v(2), measured using the 4-particle correlation method, averaged over transverse momentum and pseudorapidity is 0.087 +/- 0.002(stat) +/- 0.003(syst) in the 40%-50% centrality class. The differential elliptic flow v(2)(p(t)) reaches a maximum of 0.2 near p(t) = 3 GeV/c. Compared to RHIC Au-Au collisions at root s(NN) = 200 GeV, the elliptic flow increases by about 30%. Some hydrodynamic model predictions which include viscous corrections are in agreement with the observed increase.
|
|
| 3. |
- Dey, Lankeswar, et al.
(author)
-
Authenticating the Presence of a Relativistic Massive Black Hole Binary in OJ 287 Using Its General Relativity Centenary Flare : Improved Orbital Parameters
- 2018
-
In: Astrophysical Journal. - : American Astronomical Society. - 0004-637X .- 1538-4357. ; 866:1
-
Journal article (peer-reviewed)abstract
- Results from regular monitoring of relativistic compact binaries like PSR 1913+16 are consistent with the dominant (quadrupole) order emission of gravitational waves (GWs). We show that observations associated with the binary black hole (BBH) central engine of blazar OJ 287 demand the inclusion of gravitational radiation reaction effects beyond the quadrupolar order. It turns out that even the effects of certain hereditary contributions to GW emission are required to predict impact flare timings of OJ 287. We develop an approach that incorporates this effect into the BBH model for OJ 287. This allows us to demonstrate an excellent agreement between the observed impact flare timings and those predicted from ten orbital cycles of the BBH central engine model. The deduced rate of orbital period decay is nine orders of magnitude higher than the observed rate in PSR 1913+16, demonstrating again the relativistic nature of OJ 287's central engine. Finally, we argue that precise timing of the predicted 2019 impact flare should allow a test of the celebrated black hole no-hair theorem at the 10% level.
|
|
| 4. |
- Winkler, P. W., et al.
(author)
-
Increasing the posterior tibial slope lowers in situ forces in the native ACL primarily at deep flexion angles
- 2023
-
In: Journal of Orthopaedic Research. - : Wiley. - 0736-0266 .- 1554-527X. ; 41:7, s. 1430-1438
-
Journal article (peer-reviewed)abstract
- High tibial osteotomy is becoming increasingly popular but can be associated with unintentional posterior tibial slope (PTS) increase and subsequent anterior cruciate ligament (ACL) degeneration. This study quantified the effect of increasing PTS on knee kinematics and in situ forces in the native ACL. A robotic testing system was used to apply external loads from full extension to 90 degrees flexion to seven human cadaveric knees: (1) 200 N axial compressive load, (2) 5 Nm internal tibial + 10 Nm valgus torque, and (3) 5 Nm external tibial + 10 Nm varus torque. Kinematics and in situ forces in the ACL were acquired for the native and increased PTS state. Increasing PTS resulted in increased anterior tibial translation at 30 degrees (1.8 mm), 60 degrees (1.7 mm), and 90 degrees (0.9 mm) flexion and reduced in situ force in the ACL at 30 degrees (57.6%), 60 degrees (69.8%), and 90 degrees (75.0%) flexion in response to 200 N axial compressive load. In response to 5 Nm internal tibial + 10 Nm valgus torque, there was significantly less (39.0%) in situ force in the ACL at 90 degrees flexion in the increased compared with the native PTS state. Significantly less in situ force in the ACL at 60 degrees (62.8%) and 90 degrees (67.0%) flexion was observed in the increased compared with the native PTS state in response to 5 Nm external tibial + 10 Nm varus torque. Increasing PTS affects knee kinematics and results in a reduction of in situ forces in the native ACL during compressive and rotatory loads at flexion angles exceeding 30 degrees. In a controlled laboratory setting PTS increase unloads the ACL, affecting its natural function.
|
|
