| 1. |
- Ding, Haoming, et al.
(författare)
-
Synthesis of MAX phases Nb2CuC and Ti2(Al0.1Cu0.9)N by A-site replacement reaction in molten salts
- 2019
-
Ingår i: Materials Research Letters. - : Taylor & Francis. - 2166-3831. ; 7:12, s. 510-516
-
Tidskriftsartikel (refereegranskat)abstract
- New MAX phases Ti2(AlxCu1−x)N and Nb2CuC were synthesized by A-site replacement by reacting Ti2AlN and Nb2AlC, respectively, with CuCl2 or CuI molten salt. X-ray diffraction, scanning electron microscopy, and atomically resolved scanning transmission electron microscopy showed complete A-site replacement in Nb2AlC, which lead to the formation of Nb2CuC. However, the replacement of Al in Ti2AlN phase was only close to complete at Ti2(Al0.1Cu0.9)N. Density-functional theory calculations corroborated the structural stability of Nb2CuC and Ti2CuN phases. Moreover, the calculated cleavage energy in these Cu-containing MAX phases are weaker than in their Al-containing counterparts.The preparation of MAX phases Nb2CuC and Ti2(Al0.1Cu0.9)N were realized by A-site replacement in Ti2AlN and Nb2AlN, respectively.
|
|
| 2. |
- Ekström, Erik, 1989-, et al.
(författare)
-
Epitaxial Growth of CaMnO3-y Films on LaAlO3 (112 over bar 0) by Pulsed Direct Current Reactive Magnetron Sputtering
- 2022
-
Ingår i: Physica Status Solidi. Rapid Research Letters. - : Wiley-V C H Verlag GMBH. - 1862-6254 .- 1862-6270. ; 16:4
-
Tidskriftsartikel (refereegranskat)abstract
- CaMnO3 is a perovskite with attractive magnetic and thermoelectric properties. CaMnO3 films are usually grown by pulsed laser deposition or radio frequency magnetron sputtering from ceramic targets. Herein, epitaxial growth of CaMnO3-y (002) films on a (112 over bar 0)-oriented LaAlO3 substrate using pulsed direct current reactive magnetron sputtering is demonstrated, which is more suitable for industrial scale depositions. The CaMnO3-y shows growth with a small in-plane tilt of <approximate to 0.2 degrees toward the (200) plane of CaMnO3-y and the (1 over bar 104) with respect to the LaAlO3 (112 over bar 0) substrate. X-ray photoelectron spectroscopy of the electronic core levels shows an oxygen deficiency described by CaMnO2.58 that yields a lower Seebeck coefficient and a higher electrical resistivity when compared to stoichiometric CaMnO3. The LaAlO3 (112 over bar 0) substrate promotes tensile-strained growth of single crystals. Scanning transmission electron microscopy and electron energy loss spectroscopy reveal antiphase boundaries composed of Ca on Mn sites along and , forming stacking faults.
|
|
| 3. |
- Halim, Joseph, 1985-, et al.
(författare)
-
Synthesis of Two-Dimensional Nb1.33C (MXene) with Randomly Distributed Vacancies by Etching of the Quaternary Solid Solution (Nb2/3Sc1/3)2AlC MAX Phase
- 2018
-
Ingår i: ACS Applied Nano Materials. - : American Chemical Society (ACS). - 2574-0970. ; 1:6, s. 2455-2460
-
Tidskriftsartikel (refereegranskat)abstract
- Introducing point defects in two-dimensional (2D) materials can alter or enhance their properties. Here, we demonstrate how etching a laminated (Nb2/3Sc1/3)2AlC MAX phase (solid solution) of both the Sc and Al atoms results in a 2D Nb1.33C material (MXene) with a large number of vacancies and vacancy clusters. This method is applicable to any quaternary, or higher, MAX phase, wherein one of the transition metals is more reactive than the other and could be of vital importance in applications such as catalysis and energy storage. We also report, for the first time, on the existence of solid solution (Nb2/3Sc1/3)3AlC2 and (Nb2/3Sc1/3)4AlC3 phases.
|
|
| 4. |
- Lu, Jun, 1962-, et al.
(författare)
-
Tin+1Cn MXenes with fully saturated and thermally stable Cl terminations
- 2019
-
Ingår i: Nanoscale Advances. - : Royal Society of Chemistry. - 2516-0230. ; 1:9, s. 3680-3685
-
Tidskriftsartikel (refereegranskat)abstract
- MXenes are a rapidly growing family of 2D materials that exhibit a highly versatile structure and composition, allowing for significant tuning of the materials properties. These properties are, however, ultimately limited by the surface terminations, which are typically a mixture of species, including F and O that are inherent to the MXene processing. Other and robust terminations are lacking. Here, we apply high-resolution scanning transmission electron microscopy (STEM), corresponding image simulations and first-principles calculations to investigate the surface terminations on MXenes synthesized from MAX phases through Lewis acidic melts. The results show that atomic Cl terminates the synthesized MXenes, with mere residual presence of other termination species. Furthermore, in situ STEM-electron energy loss spectroscopy (EELS) heating experiments show that the Cl terminations are stable up to 750 degrees C. Thus, we present an attractive new termination that widely expands the MXenes functionalization space and enables new applications.
|
|
| 5. |
- Magnusson, Roger, 1977-, et al.
(författare)
-
Preparation and tunable optical properties of amorphous AlSiO thin films
- 2021
-
Ingår i: Vacuum. - : Elsevier. - 0042-207X .- 1879-2715. ; 187
-
Tidskriftsartikel (refereegranskat)abstract
- Thin films in the aluminosilicate (AlSiO) system containing up to 31 at. % Al and 23 at. % Si were prepared by reactive RF magnetron co-sputtering in order to investigate the dependence of film formation and optical properties on substrate temperature and Si and Al contents. The obtained films were amorphous with smooth microstructure. The growth rate at different substrate temperatures ranged from 1.2 to 3.3 nm/min and increase with increasing the Si target power. The roughness decreases and thickness increases with increasing Si content. The thickness of the films grown at a deposition temperature of 100 °C is found to be higher than the films deposited at 300 and 500 °C. The AlSiO-coated glasses have a higher transmission in the visible region than the uncoated glass. The spectroscopic ellipsometry analysis reveals that the refractive index value decreased with decreasing the Al content, having extinction coefficient values of zero in the measured spectral region and band gap values ≥ 3.4 eV. The obtained thin films have over 90% transmittance in the visible range and no systematic variation of transmittance was observed with substrate temperature. The results suggest that glass substrate coated with AlSiO thin films have improved optical properties.
|
|
| 6. |
- Shu, Rui, et al.
(författare)
-
Solid-State Janus Nanoprecipitation Enables Amorphous-Like Heat Conduction in Crystalline Mg3Sb2-Based Thermoelectric Materials
- 2022
-
Ingår i: Advanced Science. - : Wiley. - 2198-3844. ; 9:25
-
Tidskriftsartikel (refereegranskat)abstract
- Solid-state precipitation can be used to tailor material properties, ranging from ferromagnets and catalysts to mechanical strengthening and energy storage. Thermoelectric properties can be modified by precipitation to enhance phonon scattering while retaining charge-carrier transmission. Here, unconventional Janus-type nanoprecipitates are uncovered in Mg3Sb1.5Bi0.5 formed by side-by-side Bi- and Ge-rich appendages, in contrast to separate nanoprecipitate formation. These Janus nanoprecipitates result from local comelting of Bi and Ge during sintering, enabling an amorphous-like lattice thermal conductivity. A precipitate size effect on phonon scattering is observed due to the balance between alloy-disorder and nanoprecipitate scattering. The thermoelectric figure-of-merit ZT reaches 0.6 near room temperature and 1.6 at 773 K. The Janus nanoprecipitation can be introduced into other materials and may act as a general property-tailoring mechanism.
|
|
| 7. |
- Alijan Farzad Lahiji, Faezeh
(författare)
-
Epitaxy of oxide and nitride thin films grown by magnetron sputtering
- 2023
-
Licentiatavhandling (övrigt vetenskapligt/konstnärligt)abstract
- The need for electronic devices with new functionalities has caused research to move in a way to design and utilize materials with high-performance thermoelectricity, widely used in batteries, sensors, and electronic devices. Two-dimensional materials (2D) with unique structures and remarkable properties have been identified to fabricate oxide heteroepitaxy. The growth of heteroepitaxy has been focused on the growth of high-quality films on single crystalline substrates. The preferred orientation and the crystallization of the materials with thin or two-dimensional structures require an understanding of epitaxy. In epitaxial growth, using a specific, well- defined substrate with lattice constants close to that film is decisive in controlling the film orientation with high epitaxial quality. The electrical, optical, magnetic, and structural properties of the film are strongly determined by the texture and its epitaxial alignment. The majority of studies report epitaxial growth on Si and sapphire with different crystallographic orientations. The family of NaCl-structured materials covers a variety of nitrides and oxides broadly used in science and technology that have been epitaxially grown on monocrystalline Si and sapphire (Al2O3). In this thesis, the structure and optical properties of NiO are investigated as functions of oxygen content on Si(100) and c-Al2O3 using pulsed dc reactive magnetron sputtering. It is found that NiO with cubic structure is a single phase with predominant orientation along (111) on both substrates. It is fiber textured on Si(100), while twin domain epitaxy is achieved on c-Al2O3. The growth of two cases of metal oxide and nitride films (NiO and CrN) with rock-salt (NaCl) structure is also demonstrated on r-plane sapphire. It is revealed that the NaCl-structured materials NiO and CrN grow with a tilted orientation relative to the substrate. This characterization and analysis of the epitaxy, crystallography, and growth modes yield a single and identical epitaxial relationship of these two cubic materials on r-plane sapphire, in contrast to earlier studies on NaCl-structured materials on r-plane sapphire, indicating several different orientation relationships. The results advance the understanding of growth modes and unusual epitaxial relationships of two cases of metal oxide and nitride films with rock-salt (NaCl) structure broadly used in science and technology on r-plane sapphire.
|
|
| 8. |
- Bejerot, Susanne, 1955-, et al.
(författare)
-
Study protocol for a randomized controlled trial with rituximab for psychotic disorder in adults (RCT-Rits)
- 2023
-
Ingår i: BMC Psychiatry. - : BioMed Central (BMC). - 1471-244X. ; 23:1
-
Tidskriftsartikel (refereegranskat)abstract
- BACKGROUND: The role of inflammation in the aetiology of schizophrenia has gained wide attention and research on the association shows an exponential growth in the last 15 years. Autoimmune diseases and severe infections are risk factors for the later development of schizophrenia, elevated inflammatory markers in childhood or adolescence are associated with a greater risk of schizophrenia in adulthood, individuals with schizophrenia have increased levels of pro-inflammatory cytokines compared to healthy controls, and autoimmune diseases are overrepresented in schizophrenia. However, treatments with anti-inflammatory agents are so far of doubtful clinical relevance. The primary objective of this study is to test whether the monoclonal antibody rituximab, directed against the B-cell antigen CD20 ameliorates psychotic symptoms in adults with schizophrenia or schizoaffective disorder and to examine potential mechanisms. A secondary objective is to examine characteristics of inflammation-associated psychosis and to identify pre-treatment biochemical characteristics of rituximab responders. A third objective is to interview a subset of patients and informants on their experiences of the trial to obtain insights that rating scales may not capture.METHODS: A proof-of-concept study employing a randomised, parallel-group, double-blind, placebo-controlled design testing the effect of B-cell depletion in patients with psychosis. 120 participants with a diagnosis of schizophrenia spectrum disorders (SSD) (ICD-10 codes F20, F25) will receive either one intravenous infusion of rituximab (1000 mg) or saline. Psychiatric measures and blood samples will be collected at baseline, week 12, and week 24 post-infusion. Brief assessments will also be made in weeks 2 and 7. Neuroimaging and lumbar puncture, both optional, will be performed at baseline and endpoints. Approximately 40 of the patients and their informants will be interviewed for qualitative analyses on the perceived changes in well-being and emotional qualities, in addition to their views on the research.DISCUSSION: This is the first RCT investigating add-on treatment with rituximab in unselected SSD patients. If the treatment is helpful, it may transform the treatment of patients with psychotic disorders. It may also heighten the awareness of immune-psychiatric disorders and reduce stigma.TRIAL REGISTRATION: NCT05622201, EudraCT-nr 2022-000220-37 version 2.1. registered 14th of October 2022.
|
|
| 9. |
|
|
| 10. |
- Braunerhjelm, Pontus, et al.
(författare)
-
Taxes, the tax administrative burden and the entrepreneurial life cycle
- 2021
-
Ingår i: Small Business Economics. - : Springer New York LLC. - 0921-898X .- 1573-0913. ; 56:2, s. 681-694
-
Tidskriftsartikel (refereegranskat)abstract
- We present a modified version of the entrepreneurial choice model, where it is shown that the expected utility of becoming an entrepreneur is decreasing in both the levels of taxes and the tax administrative burden. We extend previous empirical findings by examining how these variables influence entrepreneurs at different stages in the entrepreneurial life cycle. Our findings imply that the effect of the tax administrative burden varies over the entrepreneurial life cycle from strongly negative to insignificant. The most pronounced negative effects appear in the early stages of entrepreneurship. We conclude that a 10% reduction in the tax administrative burden increases the propensity for new business establishments by 4%. Our findings support the idea that tax simplification is one way to encourage entrepreneurship, without any reduction in tax revenues. © 2019, The Author(s).
|
|
