| 1. |
- Abazov, V. M., et al.
(författare)
-
The upgraded DO detector
- 2006
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 565:2, s. 463-537
-
Tidskriftsartikel (refereegranskat)abstract
- The DO experiment enjoyed a very successful data-collection run at the Fermilab Tevatron collider between 1992 and 1996. Since then, the detector has been upgraded to take advantage of improvements to the Tevatron and to enhance its physics capabilities. We describe the new elements of the detector, including the silicon microstrip tracker, central fiber tracker, solenoidal magnet, preshower detectors, forward muon detector, and forward proton detector. The uranium/liquid -argon calorimeters and central muon detector, remaining from Run 1, are discussed briefly. We also present the associated electronics, triggering, and data acquisition systems, along with the design and implementation of software specific to DO.
|
|
| 2. |
- Abel, I, et al.
(författare)
-
Overview of the JET results with the ITER-like wall
- 2013
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
-
Tidskriftsartikel (refereegranskat)abstract
- Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
|
|
| 3. |
- Romanelli, F, et al.
(författare)
-
Overview of the JET results
- 2011
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
-
Tidskriftsartikel (refereegranskat)abstract
- Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
|
|
| 4. |
|
|
| 5. |
- Abazov, V. M., et al.
(författare)
-
Measurement of beta (t -> Wb)/beta(t -> Wq) at root s=1.96 TeV
- 2006
-
Ingår i: Physics Letters B. - : Elsevier BV. - 0370-2693 .- 1873-2445. ; 639:6, s. 616-622
-
Tidskriftsartikel (refereegranskat)abstract
- We present the measurement of R = B(t -> Wb)/B(t -> Wq) in pp collisions at root s = 1.96 TeV, using 230 pb(-1) of data collected by the DO experiment at the Fermilab Tevatron Collider. We fit simultaneously R and the number (N-tt) of selected top quark pairs (tt), to the number of identified b-quark jets in events with one electron or one muon, three or more jets, and high transverse energy imbalance. To improve sensitivity, kinematical properties of events with no identified b-quark jets are included in the fit. We measure R = 1.03(-0.17)(0.19) (stat + syst), in good agreement with the standard model. We set lower limits of R > 0.61 and vertical bar V-tb vertical bar > 0.78 at 95% confidence level.
|
|
| 6. |
- Abazov, V. M., et al.
(författare)
-
Search for W ' boson production in the W ' -> t(b)over-bar decay channel
- 2006
-
Ingår i: Physics Letters B. - : Elsevier BV. - 0370-2693 .- 1873-2445. ; 641:6, s. 423-431
-
Tidskriftsartikel (refereegranskat)abstract
- We present a search for the production of a new heavy gauge boson W' that decays to a top quark and a bottom quark. We have analyzed 230 pb(-1) of data collected with the DO detector at the Fermilab Tevatron collider at a center-of-mass energy of 1.96 TeV. No significant excess of events above the standard model expectation is found in any region of the final state invariant mass distribution. We set upper limits on the production cross section of W' bosons times branching ratio to top quarks at the 95% confidence level for several different W, boson masses. We exclude masses between 200 and 610 GeV for a W' boson with standard-model-like couplings, between 200 and 630 GeV for a W, boson with right-handed couplings that is allowed to decay to both leptons and quarks, and between 200 and 670 GeV for a W' boson with right-handed couplings that is only allowed to decay to quarks.
|
|
| 7. |
|
|
| 8. |
- Abazov, V. M., et al.
(författare)
-
Measurement of the B-s(0) lifetime using semileptonic decays
- 2006
-
Ingår i: Physical Review Letters. - 0031-9007 .- 1079-7114. ; 97:24, s. 241801-
-
Tidskriftsartikel (refereegranskat)abstract
- We report a measurement of the B-s(0) lifetime in the semileptonic decay channel B-s(0)-> D-s(-)mu(+)nu X (and its charge conjugate), using approximately 0.4 fb(-1) of data collected with the D0 detector during 2002-2004. Using 5176 reconstructed D-s(-)mu(+) signal events, we have measured the B-s(0) lifetime to be tau(B-s(0))=1.398 +/- 0.044(stat)(-0.025)(+0.028)(syst) ps. This is the most precise measurement of the B-s(0) lifetime to date.
|
|
| 9. |
- Abazov, V. M., et al.
(författare)
-
Search for a heavy resonance decaying into a Z plus jet final state in p(p)over-bar collisions at root s=1.96 TeV using the D0 detector
- 2006
-
Ingår i: Physical Review D - Particles, Fields, Gravitation and Cosmology. - 1550-7998 .- 1550-2368. ; 74:1, s. 011104-
-
Tidskriftsartikel (refereegranskat)abstract
- We have searched for a heavy resonance decaying into a Z+jet final state in p (p) over bar collisions at a center of mass energy of 1.96 TeV at the Fermilab Tevatron collider using the D0 detector. No indication for such a resonance was found in a data sample corresponding to an integrated luminosity of 370 pb(-1). We set upper limits on the cross section times branching fraction for heavy resonance production at the 95% C.L. as a function of the resonance mass and width. The limits are interpreted within the framework of a specific model of excited quark production.
|
|
| 10. |
- Abazov, V. M., et al.
(författare)
-
Search for associated Higgs boson production WH -> WWW*-> l(+/-)nu l('+/-)nu(')+X in p(p)over-bar collisions at root S=1.96 TeV
- 2006
-
Ingår i: Physical Review Letters. - 0031-9007 .- 1079-7114. ; 97:15, s. 151804-
-
Tidskriftsartikel (refereegranskat)abstract
- We present a search for associated Higgs boson production in the process p (p) over bar -> WH -> WWW*-> l(+/-)nu l('+/-)nu(')+X in final states containing two like-sign isolated electrons or muons (e(+/-)e(+/-), e(+/-)mu(+/-), or mu(+/-)mu(+/-)). The search is based on D0 run II data samples corresponding to integrated luminosities of 360-380 pb(-1). No excess is observed over the predicted standard model background. We set 95% C.L. upper limits on sigma ->(p (p) over bar WH) x Br(H -> WW*) between 3.2 and 2.8 pb for Higgs boson masses from 115 to 175 GeV.
|
|
