| 1. |
- Biznárová, Janka, 1995, et al.
(författare)
-
Mitigation of interfacial dielectric loss in aluminum-on-silicon superconducting qubits
- 2024
-
Ingår i: npj Quantum Information. - 2056-6387. ; 10:1
-
Tidskriftsartikel (refereegranskat)abstract
- We demonstrate aluminum-on-silicon planar transmon qubits with time-averaged T1 energy relaxation times of up to 270 μs, corresponding to Q = 5 million, and a highest observed value of 501 μs. Through materials analysis techniques and numerical simulations we investigate the dominant source of energy loss, and devise and demonstrate a strategy toward its mitigation. Growing aluminum films thicker than 300 nm reduces the presence of oxide, a known host of defects, near the substrate-metal interface, as confirmed by time-of-flight secondary ion mass spectrometry. A loss analysis of coplanar waveguide resonators shows that this results in a reduction of dielectric loss due to two-level system defects. The correlation between the enhanced performance of our devices and the film thickness is due to the aluminum growth in columnar structures of parallel grain boundaries: transmission electron microscopy shows larger grains in the thicker film, and consequently fewer grain boundaries containing oxide near the substrate-metal interface.
|
|
| 2. |
- Chen, Liangyu, 1994, et al.
(författare)
-
Transmon qubit readout fidelity at the threshold for quantum error correction without a quantum-limited amplifier
- 2023
-
Ingår i: npj Quantum Information. - : Springer Science and Business Media LLC. - 2056-6387. ; 9:1
-
Tidskriftsartikel (refereegranskat)abstract
- High-fidelity and rapid readout of a qubit state is key to quantum computing and communication, and it is a prerequisite for quantum error correction. We present a readout scheme for superconducting qubits that combines two microwave techniques: applying a shelving technique to the qubit that reduces the contribution of decay error during readout, and a two-tone excitation of the readout resonator to distinguish among qubit populations in higher energy levels. Using a machine-learning algorithm to post-process the two-tone measurement results further improves the qubit-state assignment fidelity. We perform single-shot frequency-multiplexed qubit readout, with a 140 ns readout time, and demonstrate 99.5% assignment fidelity for two-state readout and 96.9% for three-state readout–without using a quantum-limited amplifier.
|
|
| 3. |
- Fadavi Roudsari, Anita, 1978, et al.
(författare)
-
Three-wave mixing traveling-wave parametric amplifier with periodic variation of the circuit parameters
- 2023
-
Ingår i: Applied Physics Letters. - : AIP Publishing. - 0003-6951 .- 1077-3118. ; 122:5
-
Tidskriftsartikel (refereegranskat)abstract
- We report on the implementation of a near-quantum-limited, traveling-wave parametric amplifier that uses three-wave mixing (3WM). To favor amplification by 3WM, we use superconducting nonlinear asymmetric inductive element (SNAIL) loops, biased with a dc magnetic flux. In addition, we equip the device with dispersion engineering features to create a stopband at the second harmonic of the pump and suppress the propagation of the higher harmonics that otherwise degrade the amplification. With a chain of 440 SNAILs, the amplifier provides up to 20 dB gain and a 3-dB bandwidth of 1 GHz. The added noise by the amplifier is found to be less than one photon.
|
|
| 4. |
- Grigoras, K., et al.
(författare)
-
Qubit-Compatible Substrates With Superconducting Through-Silicon Vias
- 2022
-
Ingår i: IEEE Transactions on Quantum Engineering. - 2689-1808. ; 3
-
Tidskriftsartikel (refereegranskat)abstract
- We fabricate and characterize superconducting through-silicon vias and electrodes suitable for superconducting quantum processors. We measure internal quality factors of a million for test resonators excited at single-photon levels, on chips with superconducting vias used to stitch ground planes on the front and back sides of the chips. This resonator performance is on par with the state of the art for silicon-based planar solutions, despite the presence of vias. Via stitching of ground planes is an important enabling technology for increasing the physical size of quantum processor chips, and is a first step toward more complex quantum devices with three-dimensional integration.
|
|
| 5. |
- Kosen, Sandoko, 1991, et al.
(författare)
-
Building blocks of a flip-chip integrated superconducting quantum processor
- 2022
-
Ingår i: Quantum Science and Technology. - : IOP Publishing. - 2058-9565. ; 7:3
-
Tidskriftsartikel (refereegranskat)abstract
- We have integrated single and coupled superconducting transmon qubits into flip-chip modules. Each module consists of two chips-one quantum chip and one control chip-that are bump-bonded together. We demonstrate time-averaged coherence times exceeding 90 mu s, single-qubit gate fidelities exceeding 99.9%, and two-qubit gate fidelities above 98.6%. We also present device design methods and discuss the sensitivity of device parameters to variation in interchip spacing. Notably, the additional flip-chip fabrication steps do not degrade the qubit performance compared to our baseline state-of-the-art in single-chip, planar circuits. This integration technique can be extended to the realisation of quantum processors accommodating hundreds of qubits in one module as it offers adequate input/output wiring access to all qubits and couplers.
|
|
| 6. |
- Osman, Amr, 1993, et al.
(författare)
-
Mitigation of frequency collisions in superconducting quantum processors
- 2023
-
Ingår i: Physical Review Research. - 2643-1564. ; 5:4
-
Tidskriftsartikel (refereegranskat)abstract
- The reproducibility of qubit parameters is a challenge for scaling up superconducting quantum processors. Signal cross talk imposes constraints on the frequency separation between neighboring qubits. The frequency uncertainty of transmon qubits arising from the fabrication process is attributed to deviations in the Josephson junction area, tunnel barrier thickness, and the qubit shunt capacitor. We decrease the sensitivity to these variations by fabricating larger Josephson junctions and reduce the wafer-level standard deviation in resistance down to 2%. We characterize 32 identical transmon qubits and demonstrate the reproducibility of the qubit frequencies with a 40 MHz standard deviation (i.e., 1%) with qubit quality factors exceeding 2 million. We perform two-level-system (TLS) spectroscopy and observe no significant increase in the number of TLSs causing qubit relaxation. We further show by simulation that for our parametric-gate architecture, and accounting only for errors caused by the uncertainty of the qubit frequency, we can scale up to 100 qubits with an average of only three collisions between quantum-gate transition frequencies, assuming 2% cross talk and 99.9% target gate fidelity.
|
|
| 7. |
- Osman, Amr, 1993, et al.
(författare)
-
Simplified Josephson-junction fabrication process for reproducibly high-performance superconducting qubits
- 2021
-
Ingår i: Applied Physics Letters. - : AIP Publishing. - 0003-6951 .- 1077-3118. ; 118:6
-
Tidskriftsartikel (refereegranskat)abstract
- We introduce a simplified fabrication technique for Josephson junctions and demonstrate superconducting Xmon qubits with T1 relaxation times averaging above 50 μs (Q > 1.5 × 1 0 6). Current shadow-evaporation techniques for aluminum-based Josephson junctions require a separate lithography step to deposit a patch that makes a galvanic, superconducting connection between the junction electrodes and the circuit wiring layer. The patch connection eliminates parasitic junctions, which otherwise contribute significantly to dielectric loss. In our patch-integrated cross-type junction technique, we use one lithography step and one vacuum cycle to evaporate both the junction electrodes and the patch. This eliminates a key bottleneck in manufacturing superconducting qubits by reducing the fabrication time and cost. In a study of more than 3600 junctions, we show an average resistance variation of 3.7% on a wafer that contains forty 0.5 × 0.5-cm2 chips, with junction areas ranging between 0.01 and 0.16 μm2. The average on-chip spread in resistance is 2.7%, with 20 chips varying between 1.4% and 2%. For the junction sizes used for transmon qubits, we deduce a wafer-level transition-frequency variation of 1.7%-2.5%. We show that 60%-70% of this variation is attributed to junction-area fluctuations, while the rest is caused by tunnel-junction inhomogeneity. Such high frequency predictability is a requirement for scaling-up the number of qubits in a quantum computer.
|
|
| 8. |
- Warren, Christopher, 1992, et al.
(författare)
-
Extensive characterization and implementation of a family of three-qubit gates at the coherence limit
- 2023
-
Ingår i: npj Quantum Information. - 2056-6387. ; 9:1
-
Tidskriftsartikel (refereegranskat)abstract
- While all quantum algorithms can be expressed in terms of single-qubit and two-qubit gates, more expressive gate sets can help reduce the algorithmic depth. This is important in the presence of gate errors, especially those due to decoherence. Using superconducting qubits, we have implemented a three-qubit gate by simultaneously applying two-qubit operations, thereby realizing a three-body interaction. This method straightforwardly extends to other quantum hardware architectures, requires only a firmware upgrade to implement, and is faster than its constituent two-qubit gates. The three-qubit gate represents an entire family of operations, creating flexibility in the quantum-circuit compilation. We demonstrate a process fidelity of 97.90%, which is near the coherence limit of our device. We then generate two classes of entangled states, the Greenberger–Horne–Zeilinger and Dicke states, by applying the new gate only once; in comparison, decompositions into the standard gate set would have a two-qubit gate depth of two and three, respectively. Finally, we combine characterization methods and analyze the experimental and statistical errors in the fidelity of the gates and of the target states.
|
|
| 9. |
- He, X. L., et al.
(författare)
-
Fast generation of Schrödinger cat states using a Kerr-tunable superconducting resonator
- 2023
-
Ingår i: Nature Communications. - 2041-1723 .- 2041-1723. ; 14:1
-
Tidskriftsartikel (refereegranskat)abstract
- Schrödinger cat states, quantum superpositions of macroscopically distinct classical states, are an important resource for quantum communication, quantum metrology and quantum computation. Especially, cat states in a phase space protected against phase-flip errors can be used as a logical qubit. However, cat states, normally generated in three-dimensional cavities and/or strong multi-photon drives, are facing the challenges of scalability and controllability. Here, we present a strategy to generate and preserve cat states in a coplanar superconducting circuit by the fast modulation of Kerr nonlinearity. At the Kerr-free work point, our cat states are passively preserved due to the vanishing Kerr effect. We are able to prepare a 2-component cat state in our chip-based device with a fidelity reaching 89.1% under a 96 ns gate time. Our scheme shows an excellent route to constructing a chip-based bosonic quantum processor.
|
|
| 10. |
- Kudra, Marina, 1992, et al.
(författare)
-
High quality three-dimensional aluminum microwave cavities
- 2020
-
Ingår i: Applied Physics Letters. - : AIP Publishing. - 0003-6951 .- 1077-3118. ; 117:7
-
Tidskriftsartikel (refereegranskat)abstract
- We present a comprehensive study of internal quality factors in superconducting stub-geometry three-dimensional cavities made of aluminum. We use wet etching, annealing, and electrochemical polishing to improve the as machined quality factor. We find that the dominant loss channel is split between the two-level system loss and an unknown source with a 40:60 proportion. A total of 17 cavities of different purity, resonance frequency, and size were studied. Our treatment results in reproducible cavities, with 10 of them showing internal quality factors above 80 x 10(6) at a power corresponding to an average of a single photon in the cavity. The best cavity has an internal quality factor of 115 x 10(6) at a single photon level. (C) 2020 Author(s). All article content, except where otherwise noted, is licensed under a Creative Commons Attribution (CC BY) license (http:// creativecommons.org/licenses/by/4.0/).
|
|
