| 1. |
- Zhu, Youjian, et al.
(författare)
-
Effect of sodium carboxymethyl cellulose addition on particulate matter emissions during biomass pellet combustion
- 2018
-
Ingår i: Applied Energy. - : Elsevier BV. - 0306-2619 .- 1872-9118. ; 230, s. 925-934
-
Tidskriftsartikel (refereegranskat)abstract
- Sodium carboxymethyl cellulose (CMC) can be used as a cost-effective and environmentally friendly binder in the pelletizing process for production of biomass pellets with good quality. However, the effect of its addition on the emission of particulate matters (PM) during the combustion process, are still not clear. In this study, four typical biomass fuels, cotton stalk, cornstalk, camphorwood and rice husk, were used to investigate the effect of the addition of 5 wt% CMC in the biomass pellets on PM emissions during the combustion process. In the case of pure CMC combustion, a large amount of PM mainly with PM2.5 were generated, which was associated to the evaporation and condensation of NaOH and Na2CO3. The PM10 emission from the combustion of the four biomass fuels varied from 9.72 mg/Nm3 to 23.12 mg/Nm3 with mainly PM1. The addition of 5 wt% CMC in cotton stalk, corn stalk and camphorwood significantly increased the PM emissions due to the evaporation and subsequent condensation of Na-containing species, e.g. NaCl, Na2SO4, NaOH and Na2CO3. For rice husk, the addition of CMC hardly affected PM1 emission due to the dominated SiO2 component in rice husk ash, which reacted with the Na-containing species from the combustion of CMC and facilitated the formation of coarse ash particles and the reduction of PM1 emission. Although the addition of CMC in biomass fuels can greatly enhance the pellets qualities, its addition increases the PM emissions to varying degree. Therefore, in the industrial application of CMC to biomass densification, countermeasures such as mixing of high Si-containing rice husk or SiO2-rich minerals with biomass fuels should be taken to alleviate the PM issues resulting from the introduction of CMC.
|
|
| 2. |
- Zhu, Youjian, et al.
(författare)
-
P-Based Additive for Reducing Fine Particulate Matter Emissions during Agricultural Biomass Combustion
- 2019
-
Ingår i: Energy & Fuels. - : American Chemical Society (ACS). - 0887-0624 .- 1520-5029. ; 33:11, s. 11274-11284
-
Tidskriftsartikel (refereegranskat)abstract
- To understand the influence of P-containing compounds on particulate matter (PM) emissions from the combustion of agricultural residues, the combustion of cornstalk was performed with the addition of a phosphorus-based additive, namely, ammonium dihydrogen phosphate (NH4H2PO4), in a fixed-bed combustion system. Simultaneously the ash samples, including PM collected by a Dekati low-pressure impactor (DLPI) and residual ash, were analyzed with variant analytical techniques. It was found that NH4H2PO4 addition significantly reduced PM0.1 and PM0.1-1 yields but increased PM1-10 yields. The maximum PM0.1 and PM1 reduction efficiency can reach up to 50% at an optimal P/K molar ratio equal to 1. Meanwhile, the addition of NH4H2PO4 to cornstalk changed the chemical composition of PM1 from being dominated by KCl and KOH/K2CO3 with a small amount of K2SO4 to a system dominated by KPO3 and KCl with a small amount of K2SO4. Simultaneously, the possible PM1 reduction mechanism was proposed. In addition, the residual ash after combustion was rich in K- and P-containing species, indicating a potential utilization as a fertilizer. It showed that the addition of NH4H2PO4 is a promising approach to reduce PM1 emissions during the combustion of agricultural biomass.
|
|
