| 1. |
|
|
| 2. |
- Boknäs, Niklas, et al.
(författare)
-
Contact activation : important to consider when measuring the contribution of tissue factor-bearing microparticles to thrombin generation using phospholipid-containing reagents
- 2014
-
Ingår i: Journal of Thrombosis and Haemostasis. - : John Wiley & Sons. - 1538-7933 .- 1538-7836. ; 12:4, s. 515-518
-
Tidskriftsartikel (refereegranskat)abstract
- Background: A commercial MP reagent containing phospholipids is used for thrombin generation (TG) measurements to estimate the procoagulant activity of microparticles (MPs). Previous reports have shown that contact activation affects TG when TF levels are low, and that addition of phospholipids might augment this effect.Objectives: To quantify the impact of contact activation on TG in the presence of phospholipids and low/no TF, as is the case using a commercially available MP-reagent. Methods Thrombin generation was analyzed using MP- or platelet-rich plasma (PRP)-reagent in the presence and absence of corn trypsin inhibitor and anti-TF antibodies, respectively. To quantify the impact of different experimental parameters on contact activation, microparticle-depleted plasma was analyzed in the presence of different concentrations of phospholipids, TF and/or contact activating agents (kaolin).Results: Even with low contact activating blood collection tubes, substantial thrombin generation was observed with the MP-reagent, but this was completely inhibited by addition of corn trypsin inhibitor. Control experiments illustrate that the phospholipids in the reagent play a major role in enhancing TG initiated by FXIIa. Even with the PRP-reagent, which is recommended for determining the content of phospholipids from MPs, TG was partly dependent on contact activation.Conclusions: Contact activation plays a major role in TG when using reagents/samples containing phospholipids but little or no tissue factor. This needs to be considered and accounted for in future clinical studies using TG to assess the procoagulant activity of MPs.
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
|
|
| 6. |
- Ekblad, Tobias, 1979-, et al.
(författare)
-
Patterned Hydrogels for Controlled Platelet Adhesion from Whole Blood and Plasma
- 2010
-
Ingår i: Advanced Functional Materials. - : John Wiley & Sons. - 1616-301X .- 1616-3028. ; 20:15, s. 2396-2403
-
Tidskriftsartikel (refereegranskat)abstract
- This work describes the preparation and properties of hydrogel surface chemistries enabling controlled and well-defined cell adhesion. The hydrogels may be prepared directly on plastic substrates, such as polystyrene slides or dishes, using a quick and experimentally simple photopolymerization process, compatible with photolithographic and microfluidic patterning methods. The intended application for these materials is as substrates for diagnostic cell adhesion assays, particularly for the analysis of human platelet function. The adsorption of fibrinogen and other platelet promoting molecules is shown to be completely inhibited by the hydrogel, provided that the film thickness is sufficient (>5 nm). This allows the hydrogel to be used as a matrix for presenting selected bioactive ligands without risking interference from nonspecifically adsorbed platelet adhesion factors, even in undiluted whole blood and blood plasma. This concept is demonstrated by preparing patterns of proteins on hydrogel surfaces, resulting in highly controlled platelet adhesion. Further insights into the protein immobilization and platelet adhesion processes are provided by studies using imaging surface plasmon resonance. The hydrogel surfaces used in this work appear to provide an ideal platform for cell adhesion studies of platelets, and potentially also for other cell types.
|
|
| 7. |
|
|
| 8. |
- Faxälv, Lars, et al.
(författare)
-
Activation of blood coagulation at charged supported lipid membranes
-
Annan publikation (övrigt vetenskapligt/konstnärligt)abstract
- The purpose of this work was to investigate the relationship between surface charge of phospholipid membranes and coagulation. Also, we wanted to demonstrate that coagulation at phospholipid membranes could successfully be studied in the method for imaging of coagulation.Analytical procedure: Supported phospholipid membranes were formed from palmitoyl-oleoyl-glycero-3-ethylphosphocholine (POEPC), 1-palmitoyl-2-oleoyl-sn-glycero-3-phosphocholine (POPC), and 1- palmitoyl-2-oleoyl-sn-glycero-3-[phospho-L-serine] (POPS) on silicon substrates. The surface charge of the phospholipid membranes was controlled by using different compositions of POPS (negative net charge), POPC (weak negative net charge) and POEPC (positive net charge). Imaging of coagulation experiments were performed on all phospholipid membrane coated surfaces as well as the clean silicon substrate. The experiments were performed in platelet-free plasma (PFP) diluted 50:50 with phosphate-buffered saline (PBS).Results: Comparing the negatively charged SiO2 surface with the negatively charged POPS (30%)/POPC(70%) we found an interesting difference. Although both surfaces activated coagulation rapidly, the POPS surface facilitated a faster propagation of coagulation from the surface than the SiO2 surface. It was also found that in order for the phospholipid membranes to exert procoagulant properties, the POPS content in the membrane had to exceed ~6 %. It was also found that positively charged phospholipid membranes did not induce activation of coagulation.Conclusions: The work in this paper demonstrated that the coagulation process at phospholipid membranes can be studied in a straightforward manner using the imaging of coagulation setup. Furthermore, we speculate that the negatively charged phospholipid membranes but not the SiO2 surface can support the binding of coagulation factor complexes, thus facilitating a faster propagation of coagulation. The fact that the POPS content must exceed ~ 6% to fully exert procoagulant properties was also a very interesting result, especially since platelets, when activated, become procoagulant by increasing their negatively charged phosphatidylserine exposure from ~0 % to maximally ~10 %.
|
|
| 9. |
- Faxälv, Lars, et al.
(författare)
-
Blood compatibility of photografted hydrogel coatings
- 2010
-
Ingår i: ACTA BIOMATERIALIA. - : Elsevier Science B.V. Amsterdam. - 1742-7061. ; 6:7, s. 2599-2608
-
Tidskriftsartikel (övrigt vetenskapligt/konstnärligt)abstract
- In this work we have evaluated the haemocompatibility of different surface modifications, intended for biomaterials and biosensor applications. Polystyrene slides were coated with thin hydrogel films by self-initiated photografting of four different monomers. The hydrogel surface modifications were thoroughly characterized and tested for their protein resistance and ability to facilitate platelet adhesion and activation of the coagulation system. There was very little protein adsorption from human plasma on the hydrogels formed from poly(ethylene glycol) methacrylate (PEGMA) and 2-hydroxyethyl methacrylate (HEMA). Platelet adhesion tests performed under both static and flow conditions showed that these coatings also demonstrated very high resistance towards platelet adhesion. A small amount of platelets were found to adhere to hydrogels formed from ethylene glycol methyl ether methacrylate (EGMEMA) and 2-carboxyethyl methacrylate (CEA). The polystyrene substrates themselves facilitated large amounts of platelet adhesion under both static and flow conditions. Utilizing a novel setup for imaging of coagulation, it was shown that none of the hydrogel surfaces activated the coagulation system to any great extent. We suggest that this simple fabrication method can be used to produce hydrogel coatings with unusually high blood compatibility, suitable for demanding biomaterials applications.
|
|
| 10. |
- Faxälv, Lars, et al.
(författare)
-
Imaging of blood plasma coagulation and its propagation at surfaces.
- 2008
-
Ingår i: Journal of biomedical materials research. Part A. - : Wiley. - 1552-4965 .- 1549-3296. ; 85:4, s. 1129-34
-
Tidskriftsartikel (refereegranskat)abstract
- A new method utilizing image capture and processing was developed for the analysis of blood plasma coagulation at surfaces. The coagulation was detected in a cuvette by time-lapse image capture of light scattering from the developing fibrin network. By image processing and computer analysis of the captured image data, both early detection of coagulation at the surface and the propagation phase of coagulation could be measured in the same experiment. It is possible to use both platelet-rich plasma (PRP) and platelet-free plasma (PFP) with the method, and thereby study the platelet contribution to both surface coagulation and propagation of coagulation. Two well-known model surfaces, hydrophilic and hydrophobic glass, were used in combination with PRP and PFP to illustrate the method. Hydrophilic glass activated coagulation significantly faster (PRP: 7.0 +/- 1.7 min, PFP: 5.9 +/- 1.2 min, n= 16) than hydrophobic glass (PRP: 50 +/- 14 min, PFP: 65 +/- 32 min, n = 16) in both PRP and PFP. Hydrophilic surfaces showed a faster initial propagation of coagulation adjacent to the surface (mean velocity: 0.14 +/- 0.05 mm/ minute) compared with the propagation observed further out from the surface (mean velocity: 0.05 +/- 0.01 mm/min). The method is very flexible and can be suitable for screening hemocompatibility of biomaterials.
|
|
