| 1. |
|
|
| 2. |
- Berggren, Karl, 1989-
(författare)
-
Spectral image quality and applications in breast tomosynthesis
- 2018
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- In the 1970s, it was determined that screening mammography is an efficient tool in fighting the increasing number of women dying from breast cancer, and many countries have established screening programs since then. Mammography systems have improved substantially over the years with one of the major advances being the transition from x-ray film to digital x-ray detectors. Following this development, the number of women dying from breast cancer has decreased, but there is still much room for improvement. One technology that is changing the breast imaging landscape is breast tomosynthesis; tomographic imaging with in-plane resolution similar to that of mammography, albeit limited height resolution. Breast tomosynthesis is commonly implemented with flat-panel detectors, but line detectors in a slit-scanning geometry can also be used. The latter configuration allows for more complex detector technologies, such as spectral photon-counting detectors that enable single-shot spectral imaging. The combination of spectral imaging and tomosynthesis opens up for a range of new applications, but the slit scanning geometry, which differs substantially from that of flat-panel tomosynthesis systems, and the factors affecting image quality have not been well understood. This thesis aims at filling this gap. Image quality and the parameters that influence image quality in spectral photon-counting slit-scanning breast tomosynthesis are characterized and analyzed using cascaded-systems modelling and linear image quality metrics. In addition, the thesis goes into characterizing the x-ray properties of breast tissue, an important input parameter for accurate material decomposition of in-vivo tissue. Material decomposition with spectral imaging opens up a range of applications, such as accurate measurement of volumetric breast density and spectral lesion characterization for decision support as part of mammography screening, and contrast-enhanced K-edge imaging for diagnostics. Tomosynthesis combined with material decomposition has the potential to improve these methods further by, for instance, separating lesions or regions of interest from surrounding fibro-glandular tissue in quantitative 3D maps of breast tissue.
|
|
| 3. |
- Cederström, B., et al.
(författare)
-
Lesion characterization in spectral photon-counting tomosynthesis
- 2017
-
Ingår i: Medical Imaging 2017. - : SPIE - International Society for Optical Engineering. - 9781510607095
-
Konferensbidrag (refereegranskat)abstract
- It has previously been shown that 2D spectral mammography can be used to discriminate between (likely benign) cystic and (potentially malignant) solid lesions in order to reduce unnecessary recalls in mammography. One limitation of the technique is, however, that the composition of overlapping tissue needs to be interpolated from a region surrounding the lesion. The purpose of this investigation was to demonstrate that lesion characterization can be done with spectral tomosynthesis, and to investigate whether the 3D information available in tomosynthesis can reduce the uncertainty from the interpolation of surrounding tissue. A phantom experiment was designed to simulate a cyst and a tumor, where the tumor was overlaid with a structure that made it mimic a cyst. In 2D, the two targets appeared similar in composition, whereas spectral tomosynthesis revealed the exact compositional difference. However, the loss of discrimination signal due to spread from the plane of interest was of the same strength as the reduction of anatomical noise. Results from a preliminary investigation on clinical tomosynthesis images of solid lesions yielded results that were consistent with the phantom experiments, but were still to some extent inconclusive. We conclude that lesion characterization is feasible in spectral tomosynthesis, but more data, as well as refinement of the calibration and discrimination algorithms, are needed to draw final conclusions about the benefit compared to 2D.
|
|
| 4. |
- Fredenberg, Erik, PhD, 1979-, et al.
(författare)
-
Photon-Counting Spectral Phase-Contrast Mammography
- 2012
-
Ingår i: Medical Imaging 2012. - : SPIE - International Society for Optical Engineering. - 9780819489623
-
Konferensbidrag (refereegranskat)abstract
- Phase-contrast imaging is an emerging technology that may increase the signal-difference-to-noise ratio in medical imaging. One of the most promising phase-contrast techniques is Talbot interferometry, which, combined with energy-sensitive photon-counting detectors, enables spectral differential phase-contrast mammography. We have evaluated a realistic system based on this technique by cascaded-systems analysis and with a task-dependent ideal-observer detectability index as a figure-of-merit. Beam-propagation simulations were used for validation and illustration of the analytical framework. Differential phase contrast improved detectability compared to absorption contrast, in particular for fine tumor structures. This result was supported by images of human mastectomy samples that were acquired with a conventional detector. The optimal incident energy was higher in differential phase contrast than in absorption contrast when disregarding the setup design energy. Further, optimal weighting of the transmitted spectrum was found to have a weaker energy dependence than for absorption contrast. Taking the design energy into account yielded a superimposed maximum on both detectability as a function of incident energy, and on optimal weighting. Spectral material decomposition was not facilitated by phase contrast, but phase information may be used instead of spectral information.
|
|
| 5. |
|
|
