1. |
- Andaji-Garmaroudi, Z., et al.
(författare)
-
Elucidating and Mitigating Degradation Processes in Perovskite Light-Emitting Diodes
- 2020
-
Ingår i: Advanced Energy Materials. - : Wiley-VCH Verlag. - 1614-6832 .- 1614-6840. ; 10:48
-
Tidskriftsartikel (refereegranskat)abstract
- Halide perovskites have attracted substantial interest for their potential as disruptive display and lighting technologies. However, perovskite light-emitting diodes (PeLEDs) are still hindered by poor operational stability. A fundamental understanding of the degradation processes is lacking but will be key to mitigating these pathways. Here, a combination of in operando and ex situ measurements to monitor the performance degradation of (Cs0.06FA0.79MA0.15)Pb(I0.85Br0.15)3 PeLEDs over time is used. Through device, nanoscale cross-sectional chemical mapping, and optical spectroscopy measurements, it is revealed that the degraded performance arises from an irreversible accumulation of bromide content at one interface, which leads to barriers to injection of charge carriers and thus increased nonradiative recombination. This ionic segregation is impeded by passivating the perovskite films with potassium halides, which immobilizes the excess halide species. The passivated PeLEDs show enhanced external quantum efficiency (EQE) from 0.5% to 4.5% and, importantly, show significantly enhanced stability, with minimal performance roll-off even at high current densities (>200 mA cm−2). The decay half-life for the devices under continuous operation at peak EQE increases from <1 to ≈15 h through passivation, and ≈200 h under pulsed operation. The results provide generalized insight into degradation pathways in PeLEDs and highlight routes to overcome these challenges.
|
|
2. |
- Babst, F., et al.
(författare)
-
When tree rings go global: Challenges and opportunities for retro- and prospective insight
- 2018
-
Ingår i: Quaternary Science Reviews. - : Elsevier BV. - 0277-3791. ; 197, s. 1-20
-
Tidskriftsartikel (refereegranskat)abstract
- The demand for large-scale and long-term information on tree growth is increasing rapidly as environmental change research strives to quantify and forecast the impacts of continued warming on forest ecosystems. This demand, combined with the now quasi-global availability of tree-ring observations, has inspired researchers to compile large tree-ring networks to address continental or even global-scale research questions. However, these emergent spatial objectives contrast with paleo-oriented research ideas that have guided the development of many existing records. A series of challenges related to how, where, and when samples have been collected is complicating the transition of tree rings from a local to a global resource on the question of tree growth. Herein, we review possibilities to scale tree-ring data (A) from the sample to the whole tree, (B) from the tree to the site, and (C) from the site to larger spatial domains. Representative tree-ring sampling supported by creative statistical approaches is thereby key to robustly capture the heterogeneity of climate-growth responses across forested landscapes. We highlight the benefits of combining the temporal information embedded in tree rings with the spatial information offered by forest inventories and earth observations to quantify tree growth and its drivers. In addition, we show how the continued development of mechanistic tree-ring models can help address some of the non-linearities and feedbacks that complicate making inference from tree-ring data. By embracing scaling issues, the discipline of dendrochronology will greatly increase its contributions to assessing climate impacts on forests and support the development of adaptation strategies. © 2018 Elsevier Ltd
|
|
3. |
- Bröms, P., et al.
(författare)
-
Optical absorption studies of sodium doped poly(cyanoterephthalylidene)
- 1994
-
Ingår i: Synthetic metals. - : Elsevier. - 0379-6779 .- 1879-3290. ; 67:1-3, s. 93-96
-
Tidskriftsartikel (refereegranskat)abstract
- The effects of doping poly(cyanoterephthalylidene) with sodium in ultrahighvacuum been studied by optical absorption spectroscopy. Upon doping, new optical transitions are observed within the bandgap; the characteristics of these transitions are consistent with the formation of bipolarons. The optical absorption results are confirmed by direct measurements of the doping-induced gap states using ultraviolet photoelectron spectroscopy.
|
|
4. |
- Cacialli, F., et al.
(författare)
-
Synthesis and characterisation of poly(distyrylbenzene-block-hexa(ethylene oxide)) and its fluorinated analogue - Two new block copolymers and their application in electroluminescent devices
- 2002
-
Ingår i: Polymer. - 0032-3861 .- 1873-2291. ; 43:12, s. 3555-3561
-
Tidskriftsartikel (refereegranskat)abstract
- Two new soluble block copolymers are reported in which chromophores and hexa(ethylene oxide) units alternate along the polymer backbone. In polymer 1 the chromophore was the distyrylbenzene unit. The polymer was synthesised via the Wittig reaction and the ionization potential of 5.4 ± 0.2 eV was measured by cyclic voltammetry and photoelectron spectroscopy. Polymer 1 showed a high solid-state photoluminescence efficiency (34%) and was used to make efficient (0.5 cd/A) light emitting diodes (LEDs). Polymer 1 was also used in light emitting cells, these showed luminescence in reverse bias and a reduced turn-on voltage compared to the LEDs. Polymer 2, in which the chromophore was dodecafluoro-distryrylbenzene, was prepared via the Horner-Wittig reaction and showed an ionization potential of 6.25 ± 0.15 eV and a solid-state photoluminescence efficiency of 17%. It was used as electron-conducting layer in a LED but failed to give significant electroluminescence. The optical energy gap for both polymers was 3.0 eV. © 2002 Published by Elsevier Science Ltd.
|
|
5. |
|
|
6. |
- Dannetun, Per, et al.
(författare)
-
New Results on Metal-Polymer Interfaces
- 1993
-
Ingår i: Molecular Crystals and Liquid Crystals. - : Taylor & Francis. - 1542-1406 .- 1563-5287. ; 228:1, s. 43-48
-
Tidskriftsartikel (refereegranskat)abstract
- New results on studies of the early stages of formation of the aluminum-poly(p-phenylenevinylene) interface are presented.
|
|
7. |
- Dannetun, Per, et al.
(författare)
-
Proceedings of the International Conference on Science and Technology of Synthetic Metals The chemical and electronic structure of the interface between aluminum and conjugated polymers or molecules
- 1993
-
Ingår i: Synthetic metals. - : Elsevier. - 0379-6779 .- 1879-3290. ; 55:1, s. 212-217
-
Tidskriftsartikel (refereegranskat)abstract
- The interaction between aluminum and α-Ï-diphenyltetradecaheptaenee (DP7), α-sexithienyl (6T), and poly(p-phenylenevinylene) (PPV), respectively have been studied using both X-ray Photoelectron Spectroscopy (XPS) and Ultraviolet Photoelectron Spectroscopy (UPS). The UPS valence band spectra, are interpreted with the help of quantum chemical calculations based upon Modified Neglect of Diatomic Overlap (MNDO), Valence Effective Hamitonian (VEH) and ab initio Hartree-Fock methods. DP7 is a model molecule for polyacetylene, while 6T is a model molecule (an oligomer) of polythiophene. The results indicate that aluminum reacts strongly with the surfaces of all of the materials studied. The Ï-electronic structure of each material was strongly modified. Furthermore, aluminum reacts preferentially with the polyene partof DP7, with the vinylene part of PPV, and with the α-carbons of the thiophene nits of 6T.
|
|
8. |
- Kim, J.S., et al.
(författare)
-
Kelvin probe and ultraviolet photoemission measurements of indium tin oxide work function: : a comparison
- 2000
-
Ingår i: Synthetic metals. - 0379-6779 .- 1879-3290. ; 111-112, s. 311-314
-
Tidskriftsartikel (refereegranskat)abstract
- We report a comparison of the work functions of thin films of indium tin oxide (ITO), carried out by means of ultraviolet photoelectron spectroscopy (UPS) and by measurements of the contact potential difference with respect to a gold reference electrode (Kelvin probe (KP) method). We investigated commercially available ITOs both "as-received", and after certain surface treatments, such as oxygen plasma. First, we find measurable discrepancies between KP values measured with three different instruments, and between the KP and the UPS values. Secondly, and unexpectedly, we find that the KP, although more sensitive than UPS, does not detect certain differences between ITOs with different surface treatments. We discuss the results in view of the different environments in which the measurements are carried out (UHV for the UPS and air/Ar for the Kelvin method), of the effects which may be induced by the high-energy photon irradiation in the UPS measurement, and of the stability of the gold probe work function in gas ambient. We conclude that UPS is better-suited for absolute work function determination, although KP remains a convenient and inexpensive tool for fast screening of contact potential differences. (C) 2000 Elsevier Science S.A. All rights reserved.
|
|
9. |
|
|
10. |
|
|