| 1. |
- Ahlström, Johan, et al.
(författare)
-
Sustainable aviation fuels – Options for negative emissions and high carbon efficiency
- 2023
-
Ingår i: International Journal of Greenhouse Gas Control. - : Elsevier Ltd. - 1750-5836 .- 1878-0148. ; 125
-
Tidskriftsartikel (refereegranskat)abstract
- Mitigating the climate impact from aviation remains one of the tougher challenges in adapting society to fulfill stated climate targets. Long-range aviation cannot be electrified for the foreseeable future and the effects of combusting fuel at high altitude increase the climate impact compared to emissions of green-house gasses only, which further limits the range of sustainable fuel alternatives. We investigate seven different pathways for producing aviation biofuels coupled with either bio-energy carbon capture and storage (BECCS), or bio-energy carbon capture and utilization (BECCU). Both options allow for increased efficiency regarding utilization of feedstock carbon. Our analysis uses process-level carbon- and energy balances, with carbon efficiency, climate impact and levelized cost of production (LCOP) as primary performance indicators. The results show that CCS can achieve a negative carbon footprint for four out of the seven pathways, at a lower cost of GHG reduction than the base process option. Conversely, as a consequence of the electricity-intensive CO2 upgrading process, the CCU option shows less encouraging results with higher production costs, carbon footprints and costs of GHG reduction. Overall, pathways with large amounts of vented CO2, e.g., gasification of black liquor or bark, as well as fermentation of forest residues, reach a low GHG reduction cost for the CCS option. These are also pathways with a larger feedstock and corresponding production potential. Our results enable a differentiated comparison of the suitability of various alternatives for BECCS or BECCU in combination with aviation biofuel production. By quantifying the relative strengths and weaknesses of BECCS and BECCU and by highlighting cost, climate and carbon-efficient pathways, these results can be a source of support for both policymakers and the industry. © 2023 The Author(s)
|
|
| 2. |
- Andersson, Jim, et al.
(författare)
-
Multiscale Reactor Network Simulation of an Entrained Flow Biomass Gasifier : Model Description and Validation
- 2017
-
Ingår i: Energy Technology. - : Wiley. - 2194-4288. ; 5, s. 1-12
-
Tidskriftsartikel (refereegranskat)abstract
- This paper describes the development of a multiscale equivalent reactor network model for pressurized entrained flow biomass gasification to quantify the effect of operational parameters on the gasification process, including carbon conversion, cold gas efficiency, and syngas methane content. The model, implemented in the commercial software Aspen Plus, includes chemical kinetics as well as heat and mass transfer. Characteristic aspects of the model are the multiscale effect caused by the combination of transport phenomena at particle scale during heating, pyrolysis, and char burnout, as well as the effect of macroscopic gas flow, including gas recirculation. A validation using experimental data from a pilot-scale process shows that the model can provide accurate estimations of carbon conversion, concentrations of main syngas components, and cold gas efficiency over a wide range of oxygen-to-biomass ratios and reactor loads. The syngas methane content was most difficult to estimate accurately owing to the unavailability of accurate kinetic parameters for steam methane reforming.
|
|
| 3. |
- Argyropoulos, Dimitris D. S., et al.
(författare)
-
Kraft Lignin: A Valuable, Sustainable Resource, Opportunities and Challenges
- 2023
-
Ingår i: ChemSusChem. - : John Wiley and Sons Inc. - 1864-5631 .- 1864-564X. ; 16:23
-
Forskningsöversikt (refereegranskat)abstract
- Kraft lignin, a by-product from the production of pulp, is currently incinerated in the recovery boiler during the chemical recovery cycle, generating valuable bioenergy and recycling inorganic chemicals to the pulping process operation. Removing lignin from the black liquor or its gasification lowers the recovery boiler load enabling increased pulp production. During the past ten years, lignin separation technologies have emerged and the interest of the research community to valorize this underutilized resource has been invigorated. The aim of this Review is to give (1) a dedicated overview of the kraft process with a focus on the lignin, (2) an overview of applications that are being developed, and (3) a techno-economic and life cycle asseeements of value chains from black liquor to different products. Overall, it is anticipated that this effort will inspire further work for developing and using kraft lignin as a commodity raw material for new applications undeniably promoting pivotal global sustainability concerns.
|
|
| 4. |
- Bach Oller, Albert, et al.
(författare)
-
Co-gasification of black liquor and pyrolysis oil at high temperature : Part 2. Fuel conversion
- 2017
-
Ingår i: Fuel. - : Elsevier. - 0016-2361 .- 1873-7153. ; 197, s. 240-247
-
Tidskriftsartikel (refereegranskat)abstract
- The efficiency and flexibility of the BL gasification process may improve by mixing BL with more energy-rich fuels such as pyrolysis oil (PO). To improve understanding of the fuel conversion process, blends of BL and PO were studied in an atmospheric drop tube furnace. Experiments were performed in varying atmosphere (5% and 0% CO2, balanced by N2), temperature (800–1400 °C), particle size (90–200 μm and 500–630 μm) and blending ratio (0%, 20% and 40% of PO in BL on weight basis). Additionally, pine wood was used as a reference fuel containing little alkali. The addition of PO to BL significantly increased the combined yield of CO and H2 and that of CH4. BL/based fuels showed much lower concentration of tar in syngas than pine wood. Remarkably, the addition of PO in BL further promoted tar reforming in presence of CO2. Unconverted carbon in the gasification residue decreased with increasing fractions of PO. Small fuel particles showed complete conversion at 1000 °C but larger particles did not reach complete conversion even at T = 1400 °C.
|
|
| 5. |
- Bach Oller, Albert, et al.
(författare)
-
Co-gasification of black liquor and pyrolysis oil at high temperature : Part 1. Fate of alkali elements
- 2017
-
Ingår i: Fuel. - : Elsevier. - 0016-2361 .- 1873-7153. ; 202, s. 46-55
-
Tidskriftsartikel (refereegranskat)abstract
- The catalytic activity of alkali compounds in black liquor (BL) enables gasification at low temperatures with high carbon conversion and low tar and soot formation. The efficiency and flexibility of the BL gasification process may be improved by mixing BL with fuels with higher energy content such as pyrolysis oil (PO). The fate of alkali elements in blends of BL and PO was investigated, paying special attention to the amount of alkali remaining in the particles after experiments at high temperatures. Experiments were conducted in a drop tube furnace under different environments (5% and 0% vol. CO2 balanced with N2), varying temperature (800–1400 °C), particle size (90–200 µm, 500–630 µm) and blending ratio (0%, 20% and 40% of pyrolysis oil in black liquor). Thermodynamic analysis of the experimental cases was also performed.The thermodynamic results qualitatively agreed with experimental measurements but in absolute values equilibrium under predicted alkali release. Alkali release to the gas phase was more severe under inert conditions than in the presence of CO2, but also in 5% CO2 most of the alkali was found in the gas phase at T = 1200 °C and above. However, the concentration of alkali in the gasification residue remained above 30% wt. and was insensitive to temperature variations and the amount of PO in the blend. Thermodynamic analysis and experimental mass balances indicated that elemental alkali strongly interacted with the reactor’s walls (Al2O3) by forming alkali aluminates. The experience indicated that adding PO into BL does not lead to alkali depletion during high temperature gasification.
|
|
| 6. |
- Bach-Oller, Albert, 1989-, et al.
(författare)
-
Effect of potassium impregnation on the emission of tar and soot from biomass gasification
- 2019
-
Ingår i: Energy Procedia. - : Elsevier. - 1876-6102. ; 158, s. 619-624
-
Tidskriftsartikel (refereegranskat)abstract
- Entrained flow gasification of biomass has the potential to generate synthesis gas as a source of renewable chemicals, electricity, and heat. Nonetheless, formation of tar and soot is a major challenge for continuous operation due to the problems they cause at downstream of the gasifier. Our previous studies showed the addition of alkali in the fuel can bring significant suppression of such undesirable products.The present work investigated, in a drop tube furnace, the effect of potassium on tar and soot formation (as well as on its intermediates) for three different types of fuels: an ash lean stemwood, a calcium rich bark and a silicon rich straw. The study focused on an optimal method for impregnating the biomass with potassium. Experiments were conducted for different impregnation methods; wet impregnation, spray impregnation, and solid mixing to investigate different levels of contact between the fuel and the potassium.Potassium was shown to catalyze both homogenous and heterogeneous reactions. Wet and spray impregnation had similar effects on heterogeneous reactions (in char conversion) indicating that there was an efficient molecular contact between the potassium and the organic matrix even if potassium was in the form of precipitated salts at a micrometer scale. On the other hand, potassium in the gas phase led to much lower yields of C2 hydrocarbons, heavy tars and soot. These results revealed that potassium shifted the pathways related to tar and soot formation, reducing the likelihood of carbon to end up as soot and heavy tars by favouring the formation of lighter compounds such as benzene. A moderate interaction between the added potassium and the inherent ash forming elements were also observed: Potassium had a smaller effect when the fuel was naturally rich in silicon.The combined results open the door to a gasification process that incorporates recirculation of naturally occurring potassium to improve entrained flow gasification of biomass.
|
|
| 7. |
- Bach-Oller, Albert, 1989-, et al.
(författare)
-
On the role of potassium as a tar and soot inhibitor in biomass gasification
- 2019
-
Ingår i: Applied Energy. - : Elsevier Ltd. - 0306-2619 .- 1872-9118. ; 254
-
Tidskriftsartikel (refereegranskat)abstract
- The work investigates in a drop tube furnace the effect of potassium on carbon conversion for three different types of fuels: an ash lean stemwood, a calcium-rich bark and a silicon-rich straw. The study focuses on an optimal method for impregnating the biomass with potassium. The experiments are conducted for 3 different impregnation methods; wet impregnation, spray impregnation, and dry mixing to investigate different levels of contact between the fuel and the potassium. Potassium is found to catalyse both homogenous and heterogeneous reactions. All the impregnation methods showed a significant effect of potassium on heterogeneous reactions (char conversion). The fact that dry mixing of potassium in the biomass shows an effect reveals the existence of a gas-induced mechanism that supply and distributes potassium on the char particles. Concerning the effect of potassium on homogenous reactions, it is found that potassium in the gas phase leads to much lower yields of C2 hydrocarbons, heavy tars and soot. The results indicate that potassium reduces the likelihood of light aromatic to progress toward heavier polyaromatic hydrocarbons clusters, thereby inhibiting the formation of soot-like material. A moderate interaction between the added potassium and the inherent ash forming elements is also observed: Potassium has a smaller effect when the fuel is naturally rich in silicon. The combined results are of interest for the design of a gasification process that incorporates recirculation of naturally occurring potassium to improve entrained flow gasification of biomass.
|
|
| 8. |
|
|
| 9. |
- Carlsson, Per, et al.
(författare)
-
Experiments and mathematical models of black liquor gasification – influence of minor gas components on temperature, gas composition, and fixed carbon conversion
- 2010
-
Ingår i: TAPPI Journal. - 0734-1415. ; 9:9, s. 15-24
-
Forskningsöversikt (refereegranskat)abstract
- In this work, predictions from a reacting Computational Fluid Dynamics (CFD) model of a gasification reactor are compared to experimentally obtained data from an industrial pressurized black liquor gasification plant. The data consists of gas samples taken from the hot part of the gasification reactor using a water cooled sampling probe. During the considered experimental campaign, the oxygen-to-black liquor equivalence ratio (λ) was varied in three increments, which resulted in a change in reactor temperature and gas composition. The presented numerical study consists of CFD and thermodynamic equilibrium calculations in the considered λ-range using boundary conditions obtained from the experimental campaign. Specifically, the influence of methane concentration on the gas composition is evaluated using both CFD and thermodynamic equilibrium. The results show that the main gas components (H2, CO, CO2) can be predicted within a relative error of 5% using CFD if the modeled release of H2S and CH4 are specified a priori. In addition, the calculations also show that the methane concentration has large influence on the reactor outlet temperature and final carbon conversion.
|
|
| 10. |
- Carvalho, Lara, et al.
(författare)
-
Alkali enhanced biomass gasification with in situ S capture and a novel syngas cleaning : Part 2: Techno-economic analysis
- 2018
-
Ingår i: Energy. - : Elsevier. - 0360-5442 .- 1873-6785. ; 165:Part B, s. 471-482
-
Tidskriftsartikel (refereegranskat)abstract
- Previous research has shown that alkali addition has operational advantages in entrained flow biomass gasification and allows for capture of up to 90% of the biomass sulfur in the slag phase. The resultant low-sulfur content syngas can create new possibilities for syngas cleaning processes. The aim was to assess the techno-economic performance of biofuel production via gasification of alkali impregnated biomass using a novel gas cleaning systemcomprised of (i) entrained flow catalytic gasification with in situ sulfur removal, (ii) further sulfur removal using a zinc bed, (iii) tar removal using a carbon filter, and (iv) CO2 reductionwith zeolite membranes, in comparison to the expensive acid gas removal system (Rectisol technology). The results show that alkali impregnation increases methanol productionallowing for selling prices similar to biofuel production from non-impregnated biomass. It was concluded that the methanol production using the novel cleaning system is comparable to the Rectisol technology in terms of energy efficiency, while showing an economic advantagederived from a methanol selling price reduction of 2–6 €/MWh. The results showed a high level of robustness to changes related to prices and operation. Methanol selling prices could be further reduced by choosing low sulfur content feedstocks.
|
|
