| 1. |
- Bao, Chunxiong, et al.
(författare)
-
High Performance and Stable All-Inorganic Metal Halide Perovskite-Based Photodetectors for Optical Communication Applications
- 2018
-
Ingår i: Advanced Materials. - : WILEY-V C H VERLAG GMBH. - 0935-9648 .- 1521-4095. ; 30:38
-
Tidskriftsartikel (refereegranskat)abstract
- Photodetectors are critical parts of an optical communication system for achieving efficient photoelectronic conversion of signals, and the response speed directly determines the bandwidth of the whole system. Metal halide perovskites, an emerging class of low-cost solution-processed semiconductors, exhibiting strong optical absorption, low trap states, and high carrier mobility, are widely investigated in photodetection applications. Herein, through optimizing the device engineering and film quality, high-performance photodetectors based on all-inorganic cesium lead halide perovskite (CsPbIxBr3-x), which simultaneously possess high sensitivity and fast response, are demonstrated. The optimized devices processed from CsPbIBr2 perovskite show a practically measured detectable limit of about 21.5 pW cm(-2) and a fast response time of 20 ns, which are both among the highest reported device performance of perovskite-based photodetectors. Moreover, the photodetectors exhibit outstanding long-term environmental stability, with negligible degradation of the photoresponse property after 2000 h under ambient conditions. In addition, the resulting perovskite photodetector is successfully integrated into an optical communication system and its applications as an optical signal receiver on transmitting text and audio signals is demonstrated. The results suggest that all-inorganic metal halide perovskite-based photodetectors have great application potential for optical communication.
|
|
| 2. |
- de Miranda, Noel F. C. C., et al.
(författare)
-
DNA repair genes are selectively mutated in diffuse large B cell lymphomas
- 2013
-
Ingår i: Journal of Experimental Medicine. - : Rockefeller University Press. - 0022-1007 .- 1540-9538. ; 210:9, s. 1729-1742
-
Tidskriftsartikel (refereegranskat)abstract
- DNA repair mechanisms are fundamental for B cell development, which relies on the somatic diversification of the immunoglobulin genes by V(D)J recombination, somatic hypermutation, and class switch recombination. Their failure is postulated to promote genomic instability and malignant transformation in B cells. By performing targeted sequencing of 73 key DNA repair genes in 29 B cell lymphoma samples, somatic and germline mutations were identified in various DNA repair pathways, mainly in diffuse large B cell lymphomas (DLBCLs). Mutations in mismatch repair genes (EXO1, MSH2, and MSH6) were associated with microsatellite instability, increased number of somatic insertions/deletions, and altered mutation signatures in tumors. Somatic mutations in nonhomologous end-joining (NHEJ) genes (DCLRE1C/ARTEMIS, PRKDC/DNA-PKcs, XRCC5/KU80, and XRCC6/KU70) were identified in four DLBCL tumors and cytogenetic analyses revealed that translocations involving the immunoglobulin-heavy chain locus occurred exclusively in NHEJ-mutated samples. The novel mutation targets, CHEK2 and PARP1, were further screened in expanded DLBCL cohorts, and somatic as well as novel and rare germline mutations were identified in 8 and 5% of analyzed tumors, respectively. By correlating defects in a subset of DNA damage response and repair genes with genomic instability events in tumors, we propose that these genes play a role in DLBCL lymphomagenesis.
|
|
| 3. |
- de Miranda, Noel F. C. C., et al.
(författare)
-
Exome sequencing reveals novel mutation targets in diffuse large B-cell lymphomas derived from Chinese patients
- 2014
-
Ingår i: Blood. - : American Society of Hematology. - 0006-4971 .- 1528-0020. ; 124:16, s. 2544-2553
-
Tidskriftsartikel (refereegranskat)abstract
- Next-generation sequencing studies on diffuse large B-cell lymphomas (DLBCLs) have revealed novel targets of genetic aberrations but also high intercohort heterogeneity. Previous studies have suggested that the prevalence of disease subgroups and cytogenetic profiles differ between Western and Asian patients. To characterize the coding genome of Chinese DLBCL, we performed whole-exome sequencing of DNA derived from 31 tumors and respective peripheral blood samples. The mutation prevalence of B2M, CD70, DTX1, LYN, TMSB4X, and UBE2A was investigated in an additional 105 tumor samples. We discovered 11 novel targets of recurrent mutations in DLBCL that included functionally relevant genes such as LYN and TMSB4X. Additional genes were found mutated at high frequency (>= 10%) in the Chinese cohort including DTX1, which was the most prevalent mutation target in the Notch pathway. We furthermore demonstrated that mutations in DTX1 impair its function as a negative regulator of Notch. Novel and previous unappreciated targets of somatic mutations in DLBCL identified in this study support the existence of additional/alternative tumorigenic pathways in these tumors. The observed differences with previous reports might be explained by the genetic heterogeneity of DLBCL, the germline genetic makeup of Chinese individuals, and/or exposure to distinct etiological agents.
|
|
| 4. |
- Gao, Jie, et al.
(författare)
-
A Study on Electrical Properties of Controlled Delamination Material
-
Annan publikation (övrigt vetenskapligt/konstnärligt)abstract
- Primarily used in aerospace applications, Controlled Delamination Material (CDM) has recently drawn attention to the traditional packaging industry due to its low-cost and electrical easy-open. Sinuate®, a CDM product, consists of two aluminum foils bonded together with a conductive epoxy adhesive. When applying a little electricity on its surface, the material can open easily without violence and release without residue. In this paper, a brief introduction on Sinuate® will be presented at first. And some test results on the electrical properties of the joint opening/detaching process will be shown and analyzed.
|
|
| 5. |
- Gao, Jie, et al.
(författare)
-
Interactive Packaging Solutions Based on RFIDTechnology and Controlled Delamination Material
- 2010
-
Konferensbidrag (refereegranskat)abstract
- Interactive packaging is an emerging research area in recent years. It brings people convenient and smart lives, reduces consumption of traditional packaging materials and direct or indirect labor costs as well. Being integrated in interactive packaging, Radio Frequency Identification (RFID) technology becomes one of the most proactive development enablers. In this paper, an interactive and intelligent packaging solution integrating passive RFID system and Controlled Delamination Material (CDM) is given at first. Package opening action is electrically controlled by the RFID system. CDM is primarily used in aerospace applications in the past and the conductor/adhesive joint can be easily opened by applying a little electric power on to the material. Some related works will be shown about the electrochemical characteristics of CDM in order to facilitate the system design. A demonstration system was developed and the test results have proved feasibility of the solution and shown the potential of low cost for mass production. Based on this solution, an interactive medication package for pervasive healthcare is further developed, using EPCglobal Gen2 RFID technology. It will make the medication being accessible for patient only at the prescribed dose and time, and medication taking information will be delivered as well. Such medication package will not only give unprecedented high patient compliance, but also improve the communication between patients and healthcare staffs.
|
|
| 6. |
- Jia, Ping, et al.
(författare)
-
Electronic phase engineering induced thermoelectric enhancement in manganites
- 2018
-
Ingår i: Journal of Applied Physics. - : AMER INST PHYSICS. - 0021-8979 .- 1089-7550. ; 124:3
-
Tidskriftsartikel (refereegranskat)abstract
- The nano-structuring engineering and the introduction of magnetic scattering are effective ways to enhance the thermoelectric performance. In this work, we use the magnetic treatments on La0.4Pr0.225Ca0.375MnO3 to demonstrate that the electronic phase engineering can enhance the thermoelectric performance by simultaneously reducing the thermal conductivity and raising the power factor in a strongly correlated electron system. This study indicates that the magnetic treatment changes the phase separation state and impedes the growth of ferromagnetic metal (FMM) phase. The reduction of FMM phase suppresses the bipolar effect, which raises the Seebeck coefficient and the power factor, reduces the thermal conductivity, and therefore enhances the thermoelectric performance.
|
|
| 7. |
- Jun, Chen, et al.
(författare)
-
A Novel Acceleration Data Compression Scheme for Wireless Sensor Network Application in Fresh Food Tracking System
- 2009
-
Ingår i: The Ninth International Conference on Electronic Measurement & Instruments ICEMI’2009. - : IEEE Press. - 9781424438631 ; , s. 3-1-3-5
-
Konferensbidrag (refereegranskat)abstract
- An enhanced dual-layer wide area wireless sensor network (WSN) system was developed and applied in fresh food tracking application. The sensor nodes of WSN provide a set of useful measurements about the environmental conditions during the fresh food transportation. Since the 3-axis acceleration data in such application account for more than 99% out of all collected source data, we propose a novel acceleration data compression scheme for this specific application, to overcome the resource and cost limitation imposed on embedded sensing nodes and wireless communication links in WSN. According to general fresh food transport behavior pattern, the acceleration data can be extracted into three components (D waveform, A waveform and P waveform). Each component could be compressed separately according to its distinct characteristic and then packetized as an encoded frame. In this paper we examine the experimental acceleration dataset from a field test (fresh melon fruit transport from Brazil to Sweden in 20 days) as a test case. Experimental results show that a high compression ratio (around 10:1) with the acceptable distortion could be achieved, confirming the effectiveness of the compression scheme proposed in this work.
|
|
| 8. |
- Ning, Weihua, et al.
(författare)
-
Long Electron-Hole Diffusion Length in High-Quality Lead-Free Double Perovskite Films
- 2018
-
Ingår i: Advanced Materials. - : WILEY-V C H VERLAG GMBH. - 0935-9648 .- 1521-4095. ; 30:20
-
Tidskriftsartikel (refereegranskat)abstract
- Developing environmentally friendly perovskites has become important in solving the toxicity issue of lead-based perovskite solar cells. Here, the first double perovskite (Cs2AgBiBr6) solar cells using the planar structure are demonstrated. The prepared Cs2AgBiBr6 films are composed of high-crystal-quality grains with diameters equal to the film thickness, thus minimizing the grain boundary length and the carrier recombination. These high-quality double perovskite films show long electron-hole diffusion lengths greater than 100 nm, enabling the fabrication of planar structure double perovskite solar cells. The resulting solar cells based on planar TiO2 exhibit an average power conversion efficiency over 1%. This work represents an important step forward toward the realization of environmentally friendly solar cells and also has important implications for the applications of double perovskites in other optoelectronic devices.
|
|
| 9. |
- Pang, Zhibo, et al.
(författare)
-
Mobile and Wide Area Deployable Sensor System for Networked Services
- 2009
-
Ingår i: 2009 IEEE SENSORS. - NEW YORK : IEEE. - 9781424445486 ; , s. 1329-1332
-
Konferensbidrag (refereegranskat)abstract
- A mobile and wide area deployable wireless sensor system, including hardware and software, is developed to enhance the mobility, deployment and capability of wireless sensors for networked services. Due to the dual-layer dual-directional wireless communication capability of a novel WAN-SAN coherent architecture and the removal of fix-installed gateway, all sensor nodes are remotely controllable and seamlessly integrated to internet services. Hardware modules are optimized for ultra low power and compact size. Abstract and extendable application interface is developed, based on SMS and TCP/UDP protocol, to be integrated easily into existing service systems. Hierarchical CPS-LPS Adaptive Localization, is supported based on CPS, wireless cellular ID, RFID, IR-UWB and inertial prediction. Specific data compression technique is adopted for high density data source. Finally, Fresh Food Tracking service is presented as an application example, including some field test data.
|
|
| 10. |
- Qing, Jian, et al.
(författare)
-
Aligned and Graded Type-II Ruddlesden-Popper Perovskite Films for Efficient Solar Cells
- 2018
-
Ingår i: Advanced Energy Materials. - : WILEY-V C H VERLAG GMBH. - 1614-6832 .- 1614-6840. ; 8:21
-
Tidskriftsartikel (refereegranskat)abstract
- Recently, Ruddlesden-Popper perovskites (RPPs) have attracted increasing interests due to their promising stability. However, the efficiency of solar cells based on RPPs is much lower than that based on 3D perovskites, mainly attributed to their poor charge transport. Herein, a simple yet universal method for controlling the quality of RPP films by a synergistic effect of two additives in the precursor solution is presented. RPP films achieved by this method show (a) high quality with uniform morphology, enhanced crystallinity, and reduced density of sub-bandgap states, (b) vertically oriented perovskite frameworks that facilitate efficient charge transport, and (c) type-II band alignment that favors self-driven charge separation. Consequently, a hysteresis-free RPP solar cell with a power conversion efficiency exceeding 12%, which is much higher than that of the control device (1.5%), is achieved. The findings will spur new developments in the fabrication of high-quality, aligned, and graded RPP films essential for realizing efficient and stable perovskite solar cells.
|
|
