| 1. |
|
|
| 2. |
- Ahmed, Bilal, et al.
(författare)
-
Electrochemical activation of commercial graphite sheets for supercapacitive applications
- 2022
-
Ingår i: Electrochimica Acta. - : PERGAMON-ELSEVIER SCIENCE LTD. - 0013-4686 .- 1873-3859. ; 431
-
Tidskriftsartikel (refereegranskat)abstract
- Carbon-based substrates are widely used as current collectors for high-performance energy storage materials in supercapacitors. However, these substrates exhibit negligible charge storage due to inferior electrochemical activity and small surface area. Herein, electrochemical activation is utilized to enhance the electrochemical activity of - inherently inactive - commercial graphite sheets for supercapacitive applications. The results reveal that the electrochemically activated graphite sheets render a 30-fold increase in areal capacitance, i.e., from 22 to 447 mF cm(-2), which can be ascribed to the activation of graphite oxide functional groups on the surface. Also, the influence of electrochemical activation time on electrochemical performance is explored in detail, followed by the fabrication and characterization of symmetric supercapacitors based on the optimum process parameters in single-cell and tandem configurations, demonstrating the potential of electrochemically activated graphite sheets in practical applications.
|
|
| 3. |
- Ahmed, Heba, et al.
(författare)
-
Recovery of oxidized two-dimensional MXenes through high frequency nanoscale electromechanical vibration
- 2023
-
Ingår i: Nature Communications. - : NATURE PORTFOLIO. - 2041-1723. ; 14:1
-
Tidskriftsartikel (refereegranskat)abstract
- MXenes hold immense potential given their superior electrical properties. The practical adoption of these promising materials is, however, severely constrained by their oxidative susceptibility, leading to significant performance deterioration and lifespan limitations. Attempts to preserve MXenes have been limited, and it has not been possible thus far to reverse the materials performance. In this work, we show that subjecting oxidized micron or nanometer thickness dry MXene films-even those constructed from nanometer-order solution-dispersed oxidized flakes-to just one minute of 10 MHz nanoscale electromechanical vibration leads to considerable removal of its surface oxide layer, whilst preserving its structure and characteristics. Importantly, electrochemical performance is recovered close to that of their original state: the pseudocapacitance, which decreased by almost 50% due to its oxidation, reverses to approximately 98% of its original value, with good capacitance retention ( approximate to 93%) following 10,000 charge-discharge cycles at 10 A g(-1). These promising results allude to the exciting possibility for rejuvenating the material for reuse, therefore offering a more economical and sustainable route that improves its potential for practical translation. Despite their vast potential, the practical deployment of MXenes has been hampered by their tendency to be oxidized. Here, the authors show that simply vibrating MXene films in just a minute can remove the oxide layer formed and restore their electrochemical performance close to its original state.
|
|
| 4. |
- Alijani, Hossein, et al.
(författare)
-
Acoustomicrofluidic Synthesis of Pristine Ultrathin Ti3C2Tz MXene Nanosheets and Quantum Dots
- 2021
-
Ingår i: ACS Nano. - : AMER CHEMICAL SOC. - 1936-0851 .- 1936-086X. ; 15:7, s. 12099-12108
-
Tidskriftsartikel (refereegranskat)abstract
- The conversion of layered transition metal carbides and/or nitrides (MXenes) into zero-dimensional structures with thicknesses and lateral dimensions of a few nanometers allows these recently discovered materials with exceptional electronic properties to exploit the additional benefits of quantum confinement, edge effects, and large surface area. Conventional methods for the conversion of MXene nanosheets and quantum dots, however, involve extreme conditions such as high temperatures and/or harsh chemicals that, among other disadvantages, lead to significant degradation of the material as a consequence of their oxidation. Herein, we show that the large surface acceleration.on the order of 10 million gs.produced by high-frequency (10 MHz) nanometer-order electromechanical vibrations on a chipscale piezoelectric substrate is capable of efficiently nebulizing, and consequently dimensionally reducing, a suspension of multilayer Ti3C2Tz (MXene) into predominantly monolayer nanosheets and quantum dots while, importantly, preserving the material from any appreciable oxidation. As an example application, we show that the high-purity MXene quantum dots produced using this room-temperature chemical-free synthesis method exhibit superior performance as electrode materials for electrochemical sensing of hydrogen peroxide compared to the highly oxidized samples obtained through conventional hydrothermal synthesis. The ability to detect concentrations as low as 5 nM is a 10-fold improvement to the best reported performance of Ti3C2Tz MXene electrochemical sensors to date.
|
|
| 5. |
- Anasori, Babak, et al.
(författare)
-
A Tungsten-Based Nanolaminated Ternary Carbide: (W,Ti)(4)C4-x
- 2019
-
Ingår i: Inorganic Chemistry. - : AMER CHEMICAL SOC. - 0020-1669 .- 1520-510X. ; 58:2, s. 1100-1106
-
Tidskriftsartikel (refereegranskat)abstract
- Nanolamellar transition metal carbides are gaining increasing interests because of the recent developments of their twodimensional (2D) derivatives and promising performance for a variety of applications from energy storage, catalysis to transparent conductive coatings, and medicine. To develop more novel 2D materials, new nanolaminated structures are needed. Here we report on a tungsten based nanolaminated ternary phase, (W,Ti)(4)C4-x, synthesized by an Al catalyzed reaction of W, Ti, and C powders at 1600 degrees C for 4 h, under flowing argon. X-ray and neutron diffraction, along with Z-contrast scanning transmission electron microscopy, were used to determine the atomic structure, ordering, and occupancies. This phase has a layered hexagonal structure (P6(3)/mmc) with lattice parameters, a = 3.00880(7) angstrom, and c = 19.5633(6) angstrom and a nominal chemistry of (W,Ti)(4)C4-x (actual chemistry, W2.1(1)Ti1.6(1)C2.6(1)). The structure is comprised of layers of pure W that are also twin planes with two adjacent atomic layers of mixed W and Ti, on either side. The use of Al as a catalyst for synthesizing otherwise difficult to make phases, could in turn lead to the discovery of a large family of nonstoichiometric ternary transition metal carbides, synthesized at relatively low temperatures and shorter times.
|
|
| 6. |
- Anasori, Babak, et al.
(författare)
-
Experimental and theoretical characterization of ordered MAX phases Mo2TiAlC2 and Mo2Ti2AlC3
- 2015
-
Ingår i: Journal of Applied Physics. - : AMER INST PHYSICS. - 0021-8979 .- 1089-7550. ; 118:9, s. 094304-
-
Tidskriftsartikel (refereegranskat)abstract
- Herein, we report on the phase stabilities and crystal structures of two newly discovered ordered, quaternary MAX phases-Mo2TiAlC2 and Mo2Ti2AlC3-synthesized by mixing and heating different elemental powder mixtures of mMo:(3-m) Ti:1.1Al:2C with 1.5 less than= m less than= 2.2 and 2Mo: 2Ti:1.1Al:2.7C to 1600 degrees C for 4 h under Ar flow. In general, for m greater than= 2 an ordered 312 phase, (Mo2Ti) AlC2, was the majority phase; for mless than 2, an ordered 413 phase (Mo2Ti2)AlC3, was the major product. The actual chemistries determined from X-ray photoelectron spectroscopy (XPS) are Mo2TiAlC1.7 and Mo2Ti1.9Al0.9C2.5, respectively. High resolution scanning transmission microscopy, XPS and Rietveld analysis of powder X-ray diffraction confirmed the general ordered stacking sequence to be Mo-Ti-Mo-Al-Mo-Ti-Mo for Mo2TiAlC2 and Mo-Ti-Ti-Mo-Al-Mo-Ti-Ti-Mo for Mo2Ti2AlC3, with the carbon atoms occupying the octahedral sites between the transition metal layers. Consistent with the experimental results, the theoretical calculations clearly show that M layer ordering is mostly driven by the high penalty paid in energy by having the Mo atoms surrounded by C in a face-centered configuration, i.e., in the center of the Mn+1Xn blocks. At 331 GPa and 367 GPa, respectively, the Youngs moduli of the ordered Mo2TiAlC2 and Mo2Ti2AlC3 are predicted to be higher than those calculated for their ternary end members. Like most other MAX phases, because of the high density of states at the Fermi level, the resistivity measurement over 300 to 10K for both phases showed metallic behavior. (C) 2015 AIP Publishing LLC.
|
|
| 7. |
- Anasori, Babak, et al.
(författare)
-
Mo2TiAlC2: A new ordered layered ternary carbide
- 2015
-
Ingår i: Scripta Materialia. - : Elsevier. - 1359-6462 .- 1872-8456. ; 101, s. 5-7
-
Tidskriftsartikel (refereegranskat)abstract
- Herein we report on the synthesis of a new layered ternary carbide, Mo2TiAlC2, that was synthesized by heating an elemental mixture at 1600 degrees C for 4 h under an Ar flow. Its hexagonal, a and c lattice parameters were calculated via Rietveld analysis of powder X-ray diffraction patterns to be, respectively, 2.997 angstrom and 18.661 angstrom. High-resolution scanning transmission electron microscopy showed that this phase is ordered, with Ti layers sandwiched between two Mo layers in a M(3)AX(2) type ternary carbide structure. (C) 2015 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
|
|
| 8. |
- Björk, Jonas, et al.
(författare)
-
Predicting chemical exfoliation: fundamental insights into the synthesis of MXenes
- 2023
-
Ingår i: NPJ 2D MATERIALS AND APPLICATIONS. - : NATURE PORTFOLIO. - 2397-7132. ; 7:1
-
Tidskriftsartikel (refereegranskat)abstract
- The factors controlling the top-down synthesis of MXenes, by selectively removing the A elements from parent MAX phases, is still under debate. In particular, understanding why some MAX phases can be used for creating MXenes, while others cannot, is of immense interest and would greatly support computational screening and identification of new two-dimensional materials that could also be created by chemical exfoliation. Here we computationally study the etching of MAX phases in hydrofluoric acid, considering the complete exfoliation process and competing processes during the initial steps of the synthesis. The results are compared to experiments and MAX phases successfully converted to MXenes, as well as so far unsuccessful attempts, including previously unpublished experimental data, rationalizing why some MAX phases are exfoliable while others are not. Our results provide an improved understanding of the synthesis of MXenes under acid conditions, anticipated to be vital for our ability to discover novel two-dimensional materials.
|
|
| 9. |
- Byeon, Ayeong, et al.
(författare)
-
Two-Dimensional Titanium Carbide MXene As a Cathode Material for Hybrid Magnesium/Lithium-Ion Batteries
- 2017
-
Ingår i: ACS Applied Materials and Interfaces. - : AMER CHEMICAL SOC. - 1944-8244 .- 1944-8252. ; 9:5, s. 4296-4300
-
Tidskriftsartikel (refereegranskat)abstract
- As an alternative to pure lithium-ion, Lit, systems, a hybrid magnesium, Mg2+, and Li+ battery can potentially combine the high capacity, high voltage, and fast Li+ intercalation of Li-ion battery cathodes and the high capacity, low cost, and dendrite-free Mg metal anodes. Herein, we report on the use of two-dimensional titanium carbide, Ti3C2Tx (MXene), as a cathode in hybrid Mg2+/Li+ batteries, coupled with a Mg metal anode. Free-standing and flexible Ti3C2Tx/carbon nanotube composite "paper" delivered-,100 mAh at 0.1 C and similar to 50 mAh g(-1) at 10 C. At 1 C the capacity was maintained for amp;gt;500 cycles at 80 mAh g(-1). The Mo2CTx MXene also demonstrated good performance as a cathode material in this hybrid battery. Considering the variety of available MXenes, this work opens the door for exploring a new large family of 2D materials with high electrical conductivity and large intercalation capacity as cathodes for hybrid Mg2+/Li+ batteries.
|
|
| 10. |
- Chaix-Pluchery, O., et al.
(författare)
-
First-order Raman scattering in three-layered Mo-based ternaries: MoAlB, Mo2Ga2C and Mo2GaC
- 2017
-
Ingår i: Journal of Raman Spectroscopy. - : WILEY. - 0377-0486 .- 1097-4555. ; 48:5, s. 631-638
-
Tidskriftsartikel (refereegranskat)abstract
- Here, we report, for the first time, on the first-order Raman spectra of the layered Mo-based ternaries: MoAlB, Mo2Ga2C and Mo2GaC. Polycrystalline samples were fabricated, and well-defined Raman spectra were recorded. When the experimental peak positions were compared with those predicted from density functional theory, good agreement was obtained, indirectly validating both. Furthermore, all modes in the three compounds were symmetry assigned. Copyright (c) 2017 John Wiley amp; Sons, Ltd.
|
|
