| 1. |
- Baud, Patrick, et al.
(författare)
-
The Brittle-Ductile Transition in Porous Limestone : Failure Mode, Constitutive Modeling of Inelastic Deformation and Strain Localization
- 2021
-
Ingår i: Journal of Geophysical Research: Solid Earth. - 2169-9313. ; 126:5
-
Tidskriftsartikel (refereegranskat)abstract
- Understanding of the mechanics of the brittle-ductile transition (BDT) in porous limestone is significantly more challenging than for sandstone because of the lack of consistent acoustic emission activity in limestone, meaning that one must rely on alternative techniques. In this paper, we investigate systematically the failure modes in Indiana limestone using X-ray microComputed Tomography imaging (μCT) and Digital Volume Correlation (DVC). Our new mechanical data show that the envelope for the onset of shear-enhanced compaction can be well approximated by an elliptical cap. The DVC analysis revealed the development of shear bands through the BDT, but no evidence of compaction bands. The shear band angles were between 29° and 46° with respect to the maximum principal stress. Compiling these new results with published data on Purbeck and Leitha limestones, we showed that inelastic compaction in each of these dual porosity allochemical limestones was in a good agreement with the normality condition, as defined in plasticity theory. Comparison of the observed failure modes with predictions based on bifurcation analysis showed that the shear band angles are consistently smaller than the theoretical predictions.
|
|
| 2. |
- Baud, Patrick, et al.
(författare)
-
The Brittle-Ductile Transition in Porous Limestone Imaged by X-Ray Computed Tomography and Digital Image Correlation
- 2017
-
Ingår i: Poromechanics 2017 - Proceedings of the 6th Biot Conference on Poromechanics. - Reston, VA : American Society of Civil Engineers. - 9780784480779 ; , s. 1782-1788
-
Konferensbidrag (refereegranskat)abstract
- We studied the brittle-ductile transition in three porous carbonates, Indiana, USA, Majella, Italy, and Leitha, Austria, with porosity ranging between 16 and 31%. A series of triaxial experiments were performed at room temperature, constant strain rate, and at effective pressures ranging from 5 to 150 MPa. Several sets of X-ray Tomography images were acquired before and after deformation. 3D digital image correlation (DIC) was performed on the images of the intact and deformed samples. The use of 3D-volumetric DIC allowed us to map out the subtle development of strain localization associated with the transition from brittle faulting to cataclastic flow in the three limestones. Our observations showed that strain localization may develop at relatively small axial strains of ~1%, in both the brittle faulting and transitional regimes. In Majella limestone (porosity = 31%), the localized deformation involved both shear and compaction. Compaction bands were only observed in less cemented samples of Leitha limestone.
|
|
| 3. |
- Darmawan, Herlan, et al.
(författare)
-
Hidden mechanical weaknesses within lava domes provided by buried high-porosity hydrothermal alteration zones
- 2022
-
Ingår i: Scientific Reports. - : Springer Nature. - 2045-2322. ; 12
-
Tidskriftsartikel (refereegranskat)abstract
- Catastrophic lava dome collapse is considered an unpredictable volcanic hazard because the physical properties, stress conditions, and internal structure of lava domes are not well understood and can change rapidly through time. To explain the locations of dome instabilities at Merapi volcano, Indonesia, we combined geochemical and mineralogical analyses, rock physical property measurements, drone-based photogrammetry, and geoinformatics. We show that a horseshoe-shaped alteration zone that formed in 2014 was subsequently buried by renewed lava extrusion in 2018. Drone data, as well as geomechanical, mineralogical, and oxygen isotope data suggest that this zone is characterized by high-porosity hydrothermally altered materials that are mechanically weak. We additionally show that the new lava dome is currently collapsing along this now-hidden weak alteration zone, highlighting that a detailed understanding of dome architecture, made possible using the monitoring techniques employed here, is essential for assessing hazards associated with dome and edifice failure at volcanoes worldwide.
|
|
| 4. |
|
|
| 5. |
- Harnett, Claire E., et al.
(författare)
-
Large-scale lava dome fracturing as a result of concealed weakened zones
- 2022
-
Ingår i: Geology. - : Geological Society of America. - 0091-7613 .- 1943-2682. ; 50:12, s. 1346-1350
-
Tidskriftsartikel (refereegranskat)abstract
- Mechanically weakened alteration zones in lava domes are thought to jeopardize their stability. Such zones can be hazardous when concealed within the dome, either because they formed by subsurface hydrothermal circulation or because they formed on the surface but were subsequently buried by renewed lava extrusion. We present a new suite of computa-tional models showing how the size and position of a weakened brittle zone within a dome can affect large-scale fracture formation, displacement, and the collapse mechanism. By combining recent laboratory data for the mechanical behavior of dome rocks with discrete element method models, we show (1) the presence of a weak zone increases instability, which is exacerbated when the size of the zone increases or the zone is positioned off-center; (2) the position of the weak zone changes the deformation mechanism from slumping-type slope de-formation when the zone is positioned centrally, compared with deep-seated rotational slope failure when the zone is positioned toward the dome flank; and finally, (3) dome-cutting tensile fractures form in the presence of a small weak zone (60 m diameter, -14% of dome width), whereas large weak zones (120 m diameter, -27% of dome width) promote the formation of longer and deeper fractures that jeopardize larger dome volumes. Our results corroborate previous field observations at lava domes and indicate that large fracture formation, which greatly influences dome stability and outgassing, can be explained by the presence of con-cealed alteration zones. This improved understanding of the mechanisms responsible for dome instability enables better hazard assessment at volcanoes worldwide.
|
|
| 6. |
- Heap, Graham A., et al.
(författare)
-
HLA-DQA1-HLA-DRB1 variants confer susceptibility to pancreatitis induced by thiopurine immunosuppressants
- 2014
-
Ingår i: Nature Genetics. - : Nature Publishing Group. - 1061-4036 .- 1546-1718. ; 46:10, s. 1131-1134
-
Tidskriftsartikel (refereegranskat)abstract
- Pancreatitis occurs in approximately 4% of patients treated with the thiopurines azathioprine or mercaptopurine. Its development is unpredictable and almost always leads to drug withdrawal. We identified patients with inflammatory bowel disease (IBD) who had developed pancreatitis within 3 months of starting these drugs from 168 sites around the world. After detailed case adjudication, we performed a genome-wide association study on 172 cases and 2,035 controls with IBD. We identified strong evidence of association within the class II HLA region, with the most significant association identified at rs2647087 (odds ratio 2.59, 95% confidence interval 2.07-3.26, P = 2 x 10(-16)). We replicated these findings in an independent set of 78 cases and 472 controls with IBD matched for drug exposure. Fine mapping of the H LA region identified association with the HLA-DQA1*02:01-HLA-DRB1*07:01 haplotype. Patients heterozygous at rs2647087 have a 9% risk of developing pancreatitis after administration of a thiopurine, whereas homozygotes have a 17% risk.
|
|
| 7. |
|
|
| 8. |
- Heap, Michael J., et al.
(författare)
-
Hydrothermal alteration of andesitic lava domes can lead to explosive volcanic behaviour
- 2019
-
Ingår i: Nature Communications. - : Springer Science and Business Media LLC. - 2041-1723. ; 10
-
Tidskriftsartikel (refereegranskat)abstract
- Dome-forming volcanoes are among the most hazardous volcanoes on Earth. Magmatic outgassing can be hindered if the permeability of a lava dome is reduced, promoting pore pressure augmentation and explosive behaviour. Laboratory data show that acid-sulphate alteration, common to volcanoes worldwide, can reduce the permeability on the sample lengthscale by up to four orders of magnitude and is the result of pore- and microfracture-filling mineral precipitation. Calculations using these data demonstrate that intense alteration can reduce the equivalent permeability of a dome by two orders of magnitude, which we show using numerical modelling to be sufficient to increase pore pressure. The fragmentation criterion shows that the predicted pore pressure increase is capable of fragmenting the majority of dome-forming materials, thus promoting explosive volcanism. It is crucial that hydrothermal alteration, which develops over months to years, is monitored at dome-forming volcanoes and is incorporated into real-time hazard assessments.
|
|
| 9. |
- Heap, Michael J., et al.
(författare)
-
Imaging strain localisation in porous andesite using digital volume correlation
- 2020
-
Ingår i: Journal of Volcanology and Geothermal Research. - : Elsevier BV. - 0377-0273. ; 404
-
Tidskriftsartikel (refereegranskat)abstract
- Strain localisation structures, such as shear fractures and compaction bands, are of importance due to their influence on permeability and therefore outgassing, a factor thought to influence eruptive style. In this study, we aim to develop a better understanding of strain localisation in porous volcanic rocks using X-ray tomographic images of samples of porous andesite (porosity = 0.26) acquired before and after deformation in the brittle and ductile regimes. These 3D images have been first analysed to provide 3D images of the porosity structure within the undeformed andesite, which consists of a large, well-connected porosity backbone alongside many smaller pores that are either isolated or connected to the porosity backbone by thin microstructural elements (e.g., microcracks). Following deformation, porosity profiles of the samples show localised dilation (porosity increase) and compaction (porosity reduction) within the samples deformed in the brittle and ductile regimes, respectively. Digital volume correlation (DVC) of the images before and after triaxial deformation was used to quantify the tensor strain fields, and the incremental divergence (volumetric strain) and curl (used as an indicator of shear strain) of the displacement fields were calculated from the DVC. These fields show that strain localisation in the sample deformed in the brittle regime manifested as a ~ 1 mm-wide, dilatational shear fracture oriented at an angle of 40–45° to the maximum principal stress. Pre- and post-deformation permeability measurements show that permeability of the sample deformed in the brittle regime increased from 3.9 × 10−12 to 4.9 × 10−12 m2, which is presumed to be related to the shear fracture. For the sample deformed in the ductile regime, strain localised into ~1 mm-thick, undulating compaction bands orientated sub-perpendicular to the maximum principal stress with little evidence of shear. Taken together, our data suggest that these bands formed during large stress drops seen in the mechanical data, within high-porosity zones within the sample, and within the large, well-connected porosity backbone. Pre- and post-deformation permeability measurements indicate that inelastic compaction decreased the permeability of the sample by a factor of ~3. The data of this study assist in the understanding of strain localisation in porous volcanic rocks, its influence on permeability (and therefore volcanic outgassing), and highlight an important role for DVC in studying strain localisation in volcanic materials.
|
|
| 10. |
- Heap, Michael J., et al.
(författare)
-
The tensile strength of hydrothermally altered volcanic rocks
- 2022
-
Ingår i: Journal of Volcanology and Geothermal Research. - : Elsevier. - 0377-0273 .- 1872-6097. ; 428
-
Tidskriftsartikel (refereegranskat)abstract
- The tensile strength of volcanic rocks is an important parameter for understanding and modelling a wide range of volcanic processes, and in the development of strategies designed to optimise energy production in volcanic geothermal reservoirs. However, despite the near-ubiquity of hydrothermal alteration at volcanic and geothermal systems, values of tensile strength for hydrothermally altered volcanic rocks are sparse. Here, we present an experimental study in which we measured the tensile strength of variably altered volcanic rocks. The alteration of these rocks, quantified as the weight percentage of secondary (alteration) minerals, varied from 6 to 62.8 wt%. Our data show that tensile strength decreases as a function of porosity, in agreement with previous studies, and as a function of alteration. We fit existing theoretical constitutive models to our data so that tensile strength can be estimated for a given porosity, and we provide a transformation of these models such that they are a function of alteration. However, because porosity and alteration influence each other, it is challenging to untangle their individual contributions to the measured reduction in tensile strength. Our new data and previously published data suggest that porosity exerts a first-order role on the tensile strength of volcanic rocks. Based on our data and observations, we also suggest that (1) alteration likely decreases tensile strength if associated with mineral dissolution, weak secondary minerals (such as clays), and an increase in microstructural heterogeneity and (2) alteration likely increases tensile strength if associated with pore- and crack-filling mineral precipitation. Therefore, we conclude that both alteration intensity and alteration type likely influence tensile strength. To highlight the implications of our findings, we provide discrete element method modelling which shows that, following the pressurisation of a dyke, the damage within weak hydrothermally altered host-rock is greater and more widespread than for strong hydrothermally altered host-rock. Because the rocks in volcanic and geothermal settings are likely to be altered, our results suggest that future modelling should consider the tensile strength of hydrothermally altered volcanic rocks.
|
|
