| 1. |
|
|
| 2. |
|
|
| 3. |
- Berts, Ida, 1984-, et al.
(författare)
-
Controlling adsorption of albumin with hyaluronan on silica surfaces and sulfonated latex particles
- 2017
-
Ingår i: Journal of Colloid and Interface Science. - : Elsevier BV. - 0021-9797 .- 1095-7103. ; 504, s. 315-324
-
Tidskriftsartikel (refereegranskat)abstract
- Polysaccharides are known to modify binding of proteins at interfaces and this paper describes studies of these interactions and how they are modified by pH. Specifically, the adsorption of human serum albumin on to polystyrene latex and to silica is described, focusing on how this is affected by hyaluronan. Experiments were designed to test how such binding might be modified under relevant physiological conditions. Changes in adsorption of albumin alone and the co-adsorption of albumin and hyaluronan are driven by electrostatic interactions. Multilayer binding is found to be regulated by the pH of the solution and the molecular mass and concentration of hyaluronan. Highest adsorption was observed at pH below 4.8 and for low molecular mass hyaluronan (<= 150 kDa) at concentrations above 2 mg ml(-1). On silica with grafted hyaluronan, albumin absorption is reversed by changes in solvent pH due to their strong electrostatic attraction. Albumin physisorbed on silica surfaces is also rinsed away with dilute hyaluronan solution at pH 4.8. The results demonstrate that the protein adsorption can be controlled both by changes of pH and by interaction with other biological macromolecules.
|
|
| 4. |
- Boge, Lukas, et al.
(författare)
-
Peptide-Loaded Cubosomes Functioning as an Antimicrobial Unit against Escherichia coli
- 2019
-
Ingår i: ACS Applied Materials and Interfaces. - : American Chemical Society. - 1944-8244 .- 1944-8252. ; 11:24, s. 21314-21322
-
Tidskriftsartikel (refereegranskat)abstract
- Dispersions of cubic liquid crystalline phases, also known as cubosomes, have shown great promise as delivery vehicles for a wide range of medicines. Due to their ordered structure, comprising alternating hydrophilic and hydrophobic domains, cubosomes possess unique delivery properties and compatibility with both water-soluble and -insoluble drugs. However, the drug delivery mechanism and cubosome interaction with human cells and bacteria are still poorly understood. Herein, we reveal how cubosomes loaded with the human cathelicidin antimicrobial peptide LL-37, a system with high bacteria-killing effect, interact with the bacterial membrane and provide new insights into the eradication mechanism. Combining the advanced experimental techniques neutron reflectivity and quartz crystal microbalance with dissipation monitoring, a mechanistic drug delivery model for LL-37-loaded cubosomes on bacterial mimicking bilayers was constructed. Moreover, the cubosome interaction with Escherichia coli was directly visualized using super-resolution laser scanning microscopy and cryogenic electron tomography. We could conclude that cubosomes loaded with LL-37 adsorbed and distorted bacterial membranes, providing evidence that the peptide-loaded cubosomes function as an antimicrobial unit.
|
|
| 5. |
- Gustafsson, Emil, et al.
(författare)
-
Understanding interactions of plasticisers with a phospholipid monolayer
- 2024
-
Ingår i: Soft Matter. - : Royal Society of Chemistry. - 1744-683X .- 1744-6848. ; 20:13, s. 2892-2899
-
Tidskriftsartikel (refereegranskat)abstract
- The use of DEHP (diethylhexyl phthalate) is now banned for most applications in Europe; the exception is for blood bags, where its toxicity is overshadowed by its ability to extend the storage life of red blood cells. Another plasticiser, BTHC (butanoyl trihexyl citrate), is used in paediatric blood bags but does not stabilise blood cells as effectively. Interactions between plasticisers and lipids are investigated with a phospholipid, DMPC, to understand the increased stability of blood cells in the presence of DEHP as well as bioaccumulation and identify differences with BTHC. Mixed monolayers of DMPC and DEHP or BTHC were studied on Langmuir troughs where surface pressure/area isotherms can be measured. Neutron reflection measurements were made to determine the composition and structure of these mixed layers. A large amount of plasticiser can be incorporated into a DMPC monolayer but once an upper limit is reached, plasticiser is selectively removed from the interface at high surface pressures. The upper limit is found to occur between 40–60 mol% for DEHP and 20–40 mol% for BTHC. The areas per molecule are also different with DEHP being in the range of 50–100 Å2 and BTHC being 65–120 Å2. Results indicate that BTHC does not fit as well as DEHP in DMPC monolayers which could help explain the differences observed with regards to the stability of blood cells.
|
|
| 6. |
- Gustafsson, Emil, et al.
(författare)
-
Understanding interactions of plasticisers with a phospholipid monolayer
- 2024
-
Ingår i: Soft Matter. - : Royal Society of Chemistry. - 1744-683X .- 1744-6848. ; 20:13, s. 2892-2899
-
Tidskriftsartikel (refereegranskat)abstract
- The use of DEHP (diethylhexyl phthalate) is now banned for most applications in Europe; the exception is for blood bags, where its toxicity is overshadowed by its ability to extend the storage life of red blood cells. Another plasticiser, BTHC (butanoyl trihexyl citrate), is used in paediatric blood bags but does not stabilise blood cells as effectively. Interactions between plasticisers and lipids are investigated with a phospholipid, DMPC, to understand the increased stability of blood cells in the presence of DEHP as well as bioaccumulation and identify differences with BTHC. Mixed monolayers of DMPC and DEHP or BTHC were studied on Langmuir troughs where surface pressure/area isotherms can be measured. Neutron reflection measurements were made to determine the composition and structure of these mixed layers. A large amount of plasticiser can be incorporated into a DMPC monolayer but once an upper limit is reached, plasticiser is selectively removed from the interface at high surface pressures. The upper limit is found to occur between 40-60 mol% for DEHP and 20-40 mol% for BTHC. The areas per molecule are also different with DEHP being in the range of 50-100 Å2 and BTHC being 65-120 Å2. Results indicate that BTHC does not fit as well as DEHP in DMPC monolayers which could help explain the differences observed with regards to the stability of blood cells.
|
|
| 7. |
- Hellsing, Maja, et al.
(författare)
-
Adsorption of Aerosol-OT to Sapphire : Lamellar Structures Studied with Neutrons
- 2011
-
Ingår i: Langmuir. - : American Chemical Society (ACS). - 0743-7463 .- 1520-5827. ; 27:8, s. 4669-4678
-
Tidskriftsartikel (refereegranskat)abstract
- The adsorption of sodium bis 2-ethylhexyl sulfosuccinate, NaAOT, to a sapphire surface from aqueous solution has been studied by neutron reflection at concentrations above the critical micelle concentration (cmc). Complementary measurements of the bulk structure were made with small-angle neutron scattering and grazing incidence small-angle neutron scattering. At a concentration of about 1% wt (10 X cmc), lamellar phase NaAOT was observed both at the surface and in the bulk. The structure seen at the interface for a solution of 2% wt NaAOT is a 35 +/- 2 angstrom thick bilayer adsorbed to the sapphire surface at maximum packing density, followed by an aligned stack of fluctuating bilayers of thickness 51 +/- 2 angstrom and with an area per molecule of 40 +/- 2 angstrom(2). Each bilayer is separated by a water: at 25 degrees C, this layer is 148 +/- 2 angstrom. A simple model for the reflectivity from fluctuating layers is presented, and for 2.0% wt NaAOT the fluctuations were found to have an amplitude of 25 +/- 5 angstrom. The temperature sensitivity of the structure at the surface was investigated in the range 15-30 degrees C. The effect of temperature was pronounced, with the solvent layer becoming thinner and the volume occupied by the NaAOT molecules in a bilayer increasing with temperature. The amplitude of the fluctuations, however, is approximately temperature independent in this range. The adsorption of NaAOT at the sapphire surface resembles that previously found at hydrophilic and hydrophobic silica surfaces. The coexisting bulk lamellar phase has a spacing of layers similar to that observed at the surface. These observations are an indication that the major driving force for adsorption is self-assembly, independent of the chemical nature of the interface.
|
|
| 8. |
- Hellsing, Maja, et al.
(författare)
-
Charged Polystyrene Nanoparticles Near a SiO2/Water Interface
- 2019
-
Ingår i: Langmuir. - : American Chemical Society (ACS). - 1520-5827 .- 0743-7463. ; 35:1, s. 222-228
-
Tidskriftsartikel (refereegranskat)abstract
- Quartz crystal microbalance with dissipation (QCM-D) monitoring is used to investigate the adsorption processes at liquid-solid interfaces and applied increasingly to characterize viscoelastic properties of complex liquids. Here, we contribute new insights into the latter field by using QCM-D to investigate the structure near the interface and the high-frequency viscoelastic properties of charge-stabilized polystyrene particles (radius 37 nm) dispersed in water. The study reveals changes with increasing ionic strength and particle concentration. Replacing water with a dispersion is usually expected to give rise to a decrease in frequency, f. Increases in both f and dissipation, D, were observed on exchanging pure water for particle dispersions at a low ionic strength. The QCM-D data are well-represented by a viscoelastic model, with viscosity increasing from 1.0 to 1.3 mPa s as the particle volume fraction changes from 0.005 to 0.07. This increase, higher than that predicted for noninteracting dispersions, can be explained by the charge repulsion between the particles giving rise to a higher effective volume fraction. It is concluded that the polystyrene particles did not adhere to the solid surface but rather were separated by a layer of pure dispersion medium. The QCM-D response was successfully represented using a viscoelastic Kelvin-Voigt model, from which it was concluded that the thickness of the dispersion medium layer was of the order of the particle-particle bulk separation, in the range of 50-250 nm, and observed to decrease with both particle concentration and addition of salt. Similar anomalous frequency and dissipation responses have been seen previously for systems containing weakly adherent colloidal particles and bacteria and understood in terms of coupled resonators. We demonstrate that surface attachment is not required for such phenomena to occur, but that a viscoelastic liquid separated from the oscillating surface by a thin Newtonian layer gives rise to similar responses.
|
|
| 9. |
- Hellsing, Maja S., 1975-
(författare)
-
Adsorption and Ordering of Surface Active Molecules and Particles at Solid Interfaces and in the Bulk
- 2012
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- Factors that influence the process of adsorption and order of dilute and concentrated systems of molecules and particles are explored in this thesis. The results are based largely on neutron scattering techniques. Study of the adsorption from dilute solutions of a common surfactant, AOT (sodium bis (2-ethylhexyl) sulfosuccinate), at a solid/liquid interface showed that AOT molecules adsorbed to the interface in a bilayer structure, with the hydrocarbon tails at maximum packing density even at very low concentrations. At higher AOT concentrations, a stack of fluctuating layers each separated by large amounts of water next to the dense bilayer was seen. The driving force for adsorption is dominated by self-assembly of AOT. It was found that an oriented lamellar phase wets the interface below the bulk concentration for formation of this phase.Proteins can be viewed as polymeric surfactants. The adsorption of proteins from seeds of the Moringa oleifera tree to a silicon oxide surface was studied to elucidate the mechanism of the protein as a flocculent in water treatment processes. The protein was found to adsorb at the interface as dense layers with a thickness suggestive of co-adsorption rather than single isolated molecules. The strong adsorption and tendency to associate in solution suggest mechanisms for flocculating particulate impurities in water.As with surfactants, dispersions of colloidal particles can assemble in regular structures by self-assembly. Polystyrene latex particles were studied and could form large three-dimensional crystals of about 1×1 cm2 in a 2 mm path cell. The diffraction pattern indicated a close packed structure with the 110 axis perpendicular to the container wall. The crystal was well-aligned and oriented by the direction of flow. At the solid interface large two-dimensional domains of about 20 cm2 of highly oriented particles were formed. The particle-particle separation at the surface and in the bulk was determined by the charge repulsion of the particles.
|
|
| 10. |
- Hellsing, Maja S., et al.
(författare)
-
Crystalline order of polymer nanoparticles over large areas at solid/liquid interfaces
- 2012
-
Ingår i: Applied Physics Letters. - : AIP Publishing. - 0003-6951 .- 1077-3118. ; 100:22, s. 221601-
-
Tidskriftsartikel (refereegranskat)abstract
- We report on the formation of large two-dimensional domains (about 20 cm2) of oriented and ordered structures of polystyrene particles dispersed in water at a solid/liquid interface. Gentle flow of the dispersed sample into the holder at a shear strain rate of about 0.1 s−1 caused particles at the air/latex meniscus to self-assemble in a regular structure on both solid silica or alumina surfaces. Scattering experiments show that the particle separation at the surface was the same as in the bulk and determined by repulsion arising from the charges on the particles. Close-packed planes formed parallel to the interface.
|
|
