| 1. |
- Svane, Bjarke, et al.
(författare)
-
Multipole electron densities and atomic displacement parameters in urea from accurate powder X-ray diffraction
- 2019
-
Ingår i: Acta Crystallographica Section A: Foundations and Advances. - 2053-2733. ; 75, s. 600-609
-
Tidskriftsartikel (refereegranskat)abstract
- Electron density determination based on structure factors obtained through powder X-ray diffraction has so far been limited to high-symmetry inorganic solids. This limit is challenged by determining high-quality structure factors for crystalline urea using a bespoke vacuum diffractometer with imaging plates. This allows the collection of data of sufficient quality to model the electron density of a molecular system using the multipole method. The structure factors, refined parameters as well as chemical bonding features are compared with results from the high-quality synchrotron single-crystal study by Birkedal et al. [Acta Cryst. (2004), A60, 371-381] demonstrating that powder X-ray diffraction potentially provides a viable alternative for electron density determination in simple molecular crystals where high-quality single crystals are not available.
|
|
| 2. |
- Andersen, Casper Welzel, et al.
(författare)
-
Redox-Driven Migration of Copper Ions in the Cu-CHA Zeolite as Shown by the InSitu PXRD/XANES Technique
- 2017
-
Ingår i: Angewandte Chemie - International Edition. - : Wiley. - 1433-7851. ; 56:35, s. 10367-10372
-
Tidskriftsartikel (refereegranskat)abstract
- Using quasi-simultaneous insitu PXRD and XANES, the direct correlation between the oxidation state of Cu ions in the commercially relevant deNOx NH3-SCR zeolite catalyst Cu-CHA and the Cu ion migration in the zeolitic pores was revealed during catalytic activation experiments. A comparison with recent reports further reveals the high sensitivity of the redox-active centers concerning heating rates, temperature, and gas environment during catalytic activation. Previously, Cu+ was confirmed present only in the 6R. Results verify a novel 8R monovalent Cu site, an eventually large Cu+ presence upon heating to high temperatures in oxidative conditions, and demonstrate the unique potential in combining insitu PXRD and XANES techniques, with which both oxidation state and structural location of the redox-active centers in the zeolite framework could be tracked.
|
|
| 3. |
- Anker, Andy S., et al.
(författare)
-
Extracting structural motifs from pair distribution function data of nanostructures using explainable machine learning
- 2022
-
Ingår i: npj Computational Materials. - : Springer Science and Business Media LLC. - 2057-3960. ; 8:1
-
Tidskriftsartikel (refereegranskat)abstract
- Characterization of material structure with X-ray or neutron scattering using e.g. Pair Distribution Function (PDF) analysis most often rely on refining a structure model against an experimental dataset. However, identifying a suitable model is often a bottleneck. Recently, automated approaches have made it possible to test thousands of models for each dataset, but these methods are computationally expensive and analysing the output, i.e. extracting structural information from the resulting fits in a meaningful way, is challenging. Our Machine Learning based Motif Extractor (ML-MotEx) trains an ML algorithm on thousands of fits, and uses SHAP (SHapley Additive exPlanation) values to identify which model features are important for the fit quality. We use the method for 4 different chemical systems, including disordered nanomaterials and clusters. ML-MotEx opens for a type of modelling where each feature in a model is assigned an importance value for the fit quality based on explainable ML.
|
|
| 4. |
- Borup, Anders Bæk, et al.
(författare)
-
Unveiling the formation mechanism of PbxPdy intermetallic phases in solvothermal synthesis using in situ X-ray total scattering
- 2023
-
Ingår i: Nanoscale. - 2040-3364. ; 15:45, s. 18481-18488
-
Tidskriftsartikel (refereegranskat)abstract
- Pd possesses attractive catalytic properties and nano-structuring is an obvious way to enhance catalytic activity. Alloying Pd with Pb has been shown to enhance the catalytic effect of alcohol oxidation. Further optimization of the catalytic effect can be accomplished by controlling the particle size and key to this is understanding the formation mechanism. By monitoring solvothermal syntheses using in situ X-ray total scattering, this study unveils the formation mechanism of PbxPdy intermetallic nanoparticles. The formation occurs through a multi-step mechanism. Initially, Pd nanoparticles are formed, followed by incorporation of Pb into the Pd-structure, thus forming PbxPdy intermetallic nanoparticles. By varying the reaction time and temperature, the incorporation of Pb can be controlled, thereby tailoring the phase outcome. Based on the in situ solvothermal syntheses, ex situ autoclave syntheses were performed, resulting in the synthesis of Pb3Pd5 and Pb9Pd13 with a purity above 93%. The catalytic effect of these intermetallic phases towards the hydrogen evolution reaction (HER) is assessed. It is found that Pd, Pb3Pd5, and Pb9Pd13 have comparable stabilities, however, the overpotential increases with increasing amounts of Pb.
|
|
| 5. |
- Broge, Nils Lau Nyborg, et al.
(författare)
-
Exploration of anion effects in solvothermal synthesis using in situ X-ray diffraction
- 2024
-
Ingår i: Physical Chemistry Chemical Physics. - 1463-9076. ; 26:15, s. 12121-12132
-
Tidskriftsartikel (refereegranskat)abstract
- Solvothermal synthesis presents a facile and highly flexible approach to chemical processing and it is widely used for preparation of micro- and nanosized inorganic materials. The large number of synthesis parameters in combination with the richness of inorganic chemistry means that it is difficult to predict or design synthesis outcomes, and it is demanding to uncover the effect of different parameters due to the sealed and complex nature of solvothermal reactors along with the time demands related to reactor cleaning, sample purification, and characterization. This study explores the effect on formation of crystalline products of six common anions in solvothermal treatment of aqueous and ethanolic precursors. Three different cations are included in the study (Mn2+, Co2+, Cu2+) representing chemical affinities towards different regions of the periodic table with respect to the hard soft acid base (HSAB) classification and the Goldschmidt classification. They additionally belong to the commonly used 3d transition metals and display a suitable variety in solvothermal chemistry to highlight anion effects. The results of the solvothermal in situ experiments demonstrate a clear effect of the precursor anions, with respect to whether crystallization occurs or not and the characteristics of the formed phases. Additionally, some of the anions are shown to be redox active and to influence the formation temperature of certain phases which in turn relates to the observed average crystallite sizes.
|
|
| 6. |
- Christensen, Christian Kolle, et al.
(författare)
-
Beam damage in operando X-ray diffraction studies of Li-ion batteries
- 2023
-
Ingår i: Journal of Synchrotron Radiation. - 0909-0495. ; 30:Pt 3, s. 561-570
-
Tidskriftsartikel (refereegranskat)abstract
- Operando powder X-ray diffraction (PXRD) is a widely employed method for the investigation of structural evolution and phase transitions in electrodes for rechargeable batteries. Due to the advantages of high brilliance and high X-ray energies, the experiments are often carried out at synchrotron facilities. It is known that the X-ray exposure can cause beam damage in the battery cell, resulting in hindrance of the electrochemical reaction. This study investigates the extent of X-ray beam damage during operando PXRD synchrotron experiments on battery materials with varying X-ray energies, amount of X-ray exposure and battery cell chemistries. Battery cells were exposed to 15, 25 or 35 keV X-rays (with varying dose) during charge or discharge in a battery test cell specially designed for operando experiments. The observed beam damage was probed by μPXRD mapping of the electrodes recovered from the operando battery cell after charge/discharge. The investigation reveals that the beam damage depends strongly on both the X-ray energy and the amount of exposure, and that it also depends strongly on the cell chemistry, i.e. the chemical composition of the electrode.
|
|
| 7. |
- Christensen, Thorbjørn Erik Køppen, et al.
(författare)
-
Flexible design in the stomatopod dactyl club
- 2023
-
Ingår i: IUCrJ. - 2052-2525. ; 10:Pt 3, s. 288-296
-
Tidskriftsartikel (refereegranskat)abstract
- The stomatopod is a fascinating animal that uses its weaponized appendage dactyl clubs for breaking mollusc shells. Dactyl clubs are a well studied example of biomineralized hierarchical structures. Most research has focused on the regions close to the action, namely the impact region and surface composed of chitin and apatite crystallites. Further away from the site of impact, the club has lower mineralization and more amorphous phases; these areas have not been as actively studied as their highly mineralized counterparts. This work focuses on the side of the club, in what is known as the periodic and striated regions. A combination of laboratory micro-computed tomography, synchrotron X-ray diffraction mapping and synchrotron X-ray fluorescence mapping has shown that the mineral in this region undergoes the transition from an amorphous to a crystalline phase in some, but not all, clubs. This means that this side region can be mineralized by either an amorphous phase, calcite crystallites or a mixture of both. It was found that when larger calcite crystallites form, they are organized (textured) with respect to the chitin present in this biocomposite. This suggests that chitin may serve as a template for crystallization when the side of the club is fully mineralized. Further, calcite crystallites were found to form as early as 1 week after moulting of the club. This suggests that the side of the club is designed with a significant safety margin that allows for a variety of phases, i.e. the club can function independently of whether the side region has a crystalline or amorphous mineral phase.
|
|
| 8. |
- Graae, Kristoffer Visti, et al.
(författare)
-
Time and space resolved operando synchrotron X-ray and Neutron diffraction study of NMC811/Si–Gr 5 Ah pouch cells
- 2023
-
Ingår i: Journal of Power Sources. - 0378-7753. ; 570
-
Tidskriftsartikel (refereegranskat)abstract
- Silicon–Graphite blended electrodes in Li-ion batteries have been proposed as a way to harness the high capacity of Si as an anode material, while minimising the negative effects of their large volume expansion. NMC 811 is the current state-of-the-art layered oxide cathode material, where the cobalt content of the cathode has been minimised. These are the two of the most promising materials for achieving electric vehicle targets in terms of performance, cyclability and price, however their degradation mechanism is not fully understood. Here these two materials have been used to manufacture 5 Ah prototype multi-layer pouch cells, which are aged and then studied using two complimentary diffraction techniques. Neutron diffraction has enabled a quantitative analysis of phase transitions in Si–Gr anodes in a pristine and degraded cell, and the alloying behaviour of Si and Li has been inferred by comparison of identical cells with either graphite or Si–Gr anodes. Synchrotron X-ray Diffraction has been used to make an operando 2D map of the cathode and anode lithiation in the pouch cell, as well as to map the volume expansion across the cell. This approach has revealed that degradation entails significant inhomogeneities across both electrodes, linked to the inhomogeneous volume expansion of the Si–Gr anodes.
|
|
| 9. |
- Htet, Cho Sandar, et al.
(författare)
-
Effect of Local Structural Distortions on Antiferroelectric-Ferroelectric Phase Transition in Dilute Solid Solutions of K xNa1- xNbO3
- 2022
-
Ingår i: Inorganic Chemistry. - : American Chemical Society (ACS). - 0020-1669 .- 1520-510X. ; 61:50, s. 20277-20287
-
Tidskriftsartikel (refereegranskat)abstract
- The fundamental principles that govern antiferroelectric (AFE)-ferroelectric (FE) transitions are not well understood for many solid solutions of perovskite compounds. For example, crystal chemical considerations based on the average Goldschmidt tolerance factor or ionic polarizability do not precisely predict the boundary between the AFE and FE phases in dilute solid solutions of alkali niobates, such as KxNa1-xNbO3(x ≤ 0.02). Here, based on detailed structural analysis from neutron total scattering experiments, we provide insights about how the relative local distortions around the A- and B-sites of the ABO3perovskite structure affect the AFE/FE order of the average crystallographic phases in KxNa1-xNbO3. We show that a higher (lower) ratio of B-site-centered distortions over A-site-centered distortions drives transition toward a long-range FE (AFE) phase, which is based on a competition between the long-range polarizing field of the Nb-O dipoles and the disordering effect of local distortions around the A-site. Our study provides a predictive tool for designing complex solid-solution perovskites with tunable (anti)ferroelectric polarization properties, which can be of interest for various energy-related applications such as high-density energy storage and solid-state cooling.
|
|
| 10. |
- Htet, Cho Sandar, et al.
(författare)
-
Local structural mechanism for enhanced energy storage properties in heterovalent doped NaNbO3 ceramics
- 2024
-
Ingår i: Journal of the European Ceramic Society. - 0955-2219. ; 44:3, s. 1597-1609
-
Tidskriftsartikel (refereegranskat)abstract
- In recent years, there is a growing interest for new lead-free oxides with reversible antiferroelectric (AFE)-ferroelectric (FE) phase transition for high-power energy-storage applications. NaNbO3-based ceramics are particularly attractive due to their easy synthesis and cost-effectiveness. In order to stabilize reversible AFE-FE phase transition, NaNbO3 is doped with a combination of heterovalent substitutions, although the underlying structural mechanism for the same is poorly understood. Here, we investigated local and average structures of Ca/Zr doped NaNbO3 using neutron total scattering. We show that Ca/Zr doping increases the average AFE phase (Pbma) fraction, however, the material remains as a composite of both FE (P21ma) and AFE regions. Analysis of local structure suggests that increase in the long-range AFE phase results from more extensive twinning of local FE regions, due to introduced charge disorder. We propose that enhanced energy-storage properties of Ca/Zr-doped NaNbO3 arises from localized twin boundary motion between the defect-induced pinning centers.
|
|
