| 1. |
|
|
| 2. |
|
|
| 3. |
- Khuyagbaatar, J., et al.
(författare)
-
Fission in the landscape of heaviest elements: Some recent examples
- 2016
-
Ingår i: Nobel Symposium NS 160 – Chemistry and Physics of Heavy and Superheavy Elements. - : EDP Sciences. - 9782759890118 ; 131
-
Konferensbidrag (refereegranskat)abstract
- The fission process still remains a main factor that determines the stability of the atomic nucleus of heaviest elements. Fission half-lives vary over a wide range, 10^−19 to 10^24 s. Present experimental techniques for the synthesis of the superheavy elements that usually measure α-decay chains are sensitive only in a limited range of half-lives, often 10^5 to 10^3 s. In the past years, measurement techniques for very short-lived and very long-lived nuclei were significantly improved at the gas-filled recoil separator TASCA at GSI Darmstadt. Recently, several experimental studies of fission-related phenomena have successfully been performed. In this paper, results on 254−256Rf and 266Lr are presented and corresponding factors for retarding the fission process are discussed.
|
|
| 4. |
- Forsberg, Ulrika, et al.
(författare)
-
First Experiment at TASCA Towards X-Ray Fingerprinting of Element 115 Decay Chains
- 2012
-
Ingår i: Acta Physica Polonica. Series B: Elementary Particle Physics, Nuclear Physics, Statistical Physics, Theory of Relativity, Field Theory. - 0587-4254. ; 43:2, s. 305-311
-
Tidskriftsartikel (refereegranskat)abstract
- To identify the atomic number of superheavy nuclei produced in Ca-48-induced fusion-evaporation reactions, an experiment aiming at measuring characteristic X-rays is being prepared at GSI, Darmstadt, Germany. The gas-filled separator TASCA will be employed, sending the residues towards the multi-coincidence detector setup TASISpec. Two ion-optical modes relying on differing magnetic polarities of the quadrupole magnets can be used at TASCA. New simulations and experimental tests of transmission and background suppression for these two focusing modes into TASISpec are presented.
|
|
| 5. |
- Khuyagbaatar, J., et al.
(författare)
-
New Short-Lived Isotope 221U and the Mass Surface Near N=126
- 2015
-
Ingår i: Physical Review Letters. - 1079-7114. ; 115:24
-
Tidskriftsartikel (refereegranskat)abstract
- Two short-lived isotopes 221U and 222U were produced as evaporation residues in the fusion reaction 50Ti+176Yb at the gas-filled recoil separator TASCA. An α decay with an energy of Eα=9.31(5) MeV and half-life T1/2=4.7(7) μs was attributed to 222U. The new isotope 221U was identified in α-decay chains starting with Eα=9.71(5) MeV and T1/2=0.66(14) μs leading to known daughters. Synthesis and detection of these unstable heavy nuclei and their descendants were achieved thanks to a fast data readout system. The evolution of the N=126 shell closure and its influence on the stability of uranium isotopes are discussed within the framework of α-decay reduced width.
|
|
| 6. |
|
|
| 7. |
- Jeppsson, Lennart, et al.
(författare)
-
High-resolution Late Silurian correlations between Gotland, Sweden and the Broken River region, NE Australia: Lithologies, conodonts and isotopes
- 2007
-
Ingår i: Palaeogeography, Palaeoclimatology, Palaeoecology. - : Elsevier BV. - 0031-0182 .- 1872-616X. ; 245:1-2, s. 115-137
-
Konferensbidrag (refereegranskat)abstract
- High-resolution correlations, partly with a precision better than 10 ka, are achieved between late Ludfordian sequences on Gotland, Sweden (on Baltica), and a section (COG) through the Coral Gardens Formation along the Broken River, northeastern Australia (on Gondwana), despite these sections having been on different palaeocontinents facing different oceans. The interval is characterised by rapid, very large faunal, isotopic, and lithologic changes. Lithologies are remarkably similar in the two areas, consisting of, in order from below: marls with thin limestone beds, flaggy limestones, oncoidal crinoidal limestone, oncoidal marls, terrigenous clastics (silty clay, mudstone, sandstone), oolite, and cliff-/gorge-forming limestones. Further, independent correlation dates several of the lithological changes as coeval. The 813 C excursion in whole rock carbonates is one of the three largest ones known during the Phanerozoic. The increase in delta C-13 is very similar in the two areas, from below + 1 parts per thousand to c. + 9 parts per thousand VPDB though two Gotland samples yielded + 9.71 parts per thousand and + 10.54 parts per thousand (the corresponding COG interval included fewer carbonate layers than needed to definitely exclude that this difference is due to a lack of suitable rocks for sampling). Compared with the lithologies and the delta C-13 curves, the conodont faunas display some divergence, but key taxa permit precise correlations for much of the studied interval. The conodont assemblages change stepwise from very diverse in the Polygnathoides siluricus Zone to a low diversity fauna dominated markedly by a single taxon (Upper Icriodontid Subzone), returning abruptly to a comparatively diverse Ozarkodina snajdri Zone fauna. A method resembling graphic correlation in some respects is used to propose a similarly high-resolution correlation through a longer interval for future testing. (c) 2006 Elsevier B.V. All rights reserved.
|
|
| 8. |
- Jeppsson, Ulf, et al.
(författare)
-
Benchmark simulation models, quo vadis?
- 2013
-
Ingår i: Water Science and Technology. - : IWA Publishing. - 0273-1223 .- 1996-9732. ; 68:1, s. 1-15
-
Tidskriftsartikel (refereegranskat)abstract
- As the work of the IWA Task Group on Benchmarking of Control Strategies for wastewater treatment plants (WWTPs) is coming to an end, it is essential to disseminate the knowledge gained. For this reason, all authors of the IWA Scientific and Technical Report on benchmarking have come together to provide their insights, highlighting areas where knowledge may still be deficient and where new opportunities are emerging, and to propose potential avenues for future development and application of the general benchmarking framework and its associated tools. The paper focuses on the topics of temporal and spatial extension, process modifications within the WWTP, the realism of models, control strategy extensions and the potential for new evaluation tools within the existing benchmark system. We find that there are major opportunities for application within all of these areas, either from existing work already being done within the context of the benchmarking simulation models (BSMs) or applicable work in the wider literature. Of key importance is increasing capability, usability and transparency of the BSM package while avoiding unnecessary complexity.
|
|
| 9. |
|
|
| 10. |
|
|
