| 1. |
|
|
| 2. |
- Klionsky, Daniel J., et al.
(författare)
-
Guidelines for the use and interpretation of assays for monitoring autophagy
- 2012
-
Ingår i: Autophagy. - : Informa UK Limited. - 1554-8635 .- 1554-8627. ; 8:4, s. 445-544
-
Forskningsöversikt (refereegranskat)abstract
- In 2008 we published the first set of guidelines for standardizing research in autophagy. Since then, research on this topic has continued to accelerate, and many new scientists have entered the field. Our knowledge base and relevant new technologies have also been expanding. Accordingly, it is important to update these guidelines for monitoring autophagy in different organisms. Various reviews have described the range of assays that have been used for this purpose. Nevertheless, there continues to be confusion regarding acceptable methods to measure autophagy, especially in multicellular eukaryotes. A key point that needs to be emphasized is that there is a difference between measurements that monitor the numbers or volume of autophagic elements (e.g., autophagosomes or autolysosomes) at any stage of the autophagic process vs. those that measure flux through the autophagy pathway (i.e., the complete process); thus, a block in macroautophagy that results in autophagosome accumulation needs to be differentiated from stimuli that result in increased autophagic activity, defined as increased autophagy induction coupled with increased delivery to, and degradation within, lysosomes (in most higher eukaryotes and some protists such as Dictyostelium) or the vacuole (in plants and fungi). In other words, it is especially important that investigators new to the field understand that the appearance of more autophagosomes does not necessarily equate with more autophagy. In fact, in many cases, autophagosomes accumulate because of a block in trafficking to lysosomes without a concomitant change in autophagosome biogenesis, whereas an increase in autolysosomes may reflect a reduction in degradative activity. Here, we present a set of guidelines for the selection and interpretation of methods for use by investigators who aim to examine macroautophagy and related processes, as well as for reviewers who need to provide realistic and reasonable critiques of papers that are focused on these processes. These guidelines are not meant to be a formulaic set of rules, because the appropriate assays depend in part on the question being asked and the system being used. In addition, we emphasize that no individual assay is guaranteed to be the most appropriate one in every situation, and we strongly recommend the use of multiple assays to monitor autophagy. In these guidelines, we consider these various methods of assessing autophagy and what information can, or cannot, be obtained from them. Finally, by discussing the merits and limits of particular autophagy assays, we hope to encourage technical innovation in the field.
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
-
- 2019
-
Tidskriftsartikel (refereegranskat)
|
|
| 6. |
- Ablikim, M., et al.
(författare)
-
Measurement of the branching fraction for psi(3686) -> omega K+K-
- 2014
-
Ingår i: Physical Review D. - 1550-7998 .- 1550-2368. ; 89:11, s. 112006-
-
Tidskriftsartikel (refereegranskat)abstract
- With 1.06 x 10(8) psi(3686) events collected with the BESIII detector, the branching fraction of psi(3686) -> omega K+K- is measured to be (1.54 +/- 0.04 +/- 0.11) x 10(-4). This is the most precise result to date, due to the largest psi(3686) sample, improved signal reconstruction efficiency, good simulation of the detector performance, and a more accurate knowledge of the continuum contribution. Using the branching fraction of J/psi -> omega K+K-, the ratio B(psi(3868) -> K+K-)/B(J/psi -> K+K-) is determined to be (18.4 +/- 3.7)%. This constitutes a significantly improved test of the 12% rule, with the uncertainty now dominated by the J/psi branching fraction.
|
|
| 7. |
- Ablikim, M., et al.
(författare)
-
Observation of e(+)e(-) -> pi(0)pi(0)h(c) and a Neutral Charmoniumlike Structure Z(c)(4020)(0)
- 2014
-
Ingår i: Physical Review Letters. - 0031-9007 .- 1079-7114. ; 113:21, s. 212002-
-
Tidskriftsartikel (refereegranskat)abstract
- Using data collected with the BESIII detector operating at the Beijing Electron Positron Collider at center-of-mass energies of root s = 4.23, 4.26, and 4.36 GeV, we observe e(+)e(-) -> pi(0)pi(0)h(c) for the first time. The Born cross sections are measured and found to be about half of those of e(+)e(-) -> pi(+)pi(-)h(c) within less than 2 sigma. In the pi(0)h(c) mass spectrum, a structure at 4.02 GeV/c(2) is found. It is most likely to be the neutral isospin partner of the Z(c)(4020)(+/-) observed in the process of e(+)e(-) -> pi(+)pi(-)h(c) being found. A fit to the pi(0)h(c) invariant mass spectrum, with the width of the Z(c)(4020)(0) fixed to that of its charged isospin partner and possible interferences with non-Z(c)(4020)(0) amplitudes neglected, gives a mass of (4023.9 +/- 2.2 +/- 3.8) MeV/c(2) for the Z(c)(4020)(0), where the first error is statistical and the second systematic.
|
|
| 8. |
- Ablikim, M., et al.
(författare)
-
Observation of J/psi -> p(p)over-bara(0)(980) at BESIII
- 2014
-
Ingår i: Physical Review D. - 1550-7998 .- 1550-2368. ; 90:5, s. 052009-
-
Tidskriftsartikel (refereegranskat)abstract
- Using 2.25 x 10(8) J/psi events collected with the BESIII detector at the BEPCII storage rings, we observe for the first time the process J/psi -> p (p) over bara(0)(980) -> pi(0)eta with a significance of 6.5 sigma (3.2 sigma including systematic uncertainties). The product branching fraction of J/psi -> p (p) over bara(0)(980) -> p (p) over bara(0)pi(0)eta is measured to be (6.8 +/- 1.2 +/- 1.3) x 10(-5), where the first error is statistical and the second is systematic. This measurement provides information on the a(0) production near threshold coupling to p (p) over bar and improves the understanding of the dynamics of J/psi decays to four-body processes.
|
|
| 9. |
- Ablikim, M., et al.
(författare)
-
Search for C-parity violation in J/psi -> gamma gamma and gamma phi
- 2014
-
Ingår i: Physical Review D. - 1550-7998 .- 1550-2368. ; 90:9, s. 092002-
-
Tidskriftsartikel (refereegranskat)abstract
- Using 1.06 x 10(8) psi(3686) events recorded in e(+)e(-) collisions at root s = 3.686 GeV with the BESIII at the BEPCII collider, we present searches for C-parity violation in J/psi -> gamma gamma and gamma phi decays via psi(3686) -> J/psi pi(+)pi(-). No significant signals are observed in either channel. Upper limits on the branching fractions are set to be B(J/psi -> gamma gamma) < 2.7 x 10(-7) and B(J/psi -> gamma phi) < 1.4 x 10(-6) at the 90% confidence level. The former is one order of magnitude more stringent than the previous upper limit, and the latter represents the first limit on this decay channel.
|
|
| 10. |
- Beal, Jacob, et al.
(författare)
-
Robust estimation of bacterial cell count from optical density
- 2020
-
Ingår i: Communications Biology. - : Springer Science and Business Media LLC. - 2399-3642. ; 3:1
-
Tidskriftsartikel (refereegranskat)abstract
- Optical density (OD) is widely used to estimate the density of cells in liquid culture, but cannot be compared between instruments without a standardized calibration protocol and is challenging to relate to actual cell count. We address this with an interlaboratory study comparing three simple, low-cost, and highly accessible OD calibration protocols across 244 laboratories, applied to eight strains of constitutive GFP-expressing E. coli. Based on our results, we recommend calibrating OD to estimated cell count using serial dilution of silica microspheres, which produces highly precise calibration (95.5% of residuals <1.2-fold), is easily assessed for quality control, also assesses instrument effective linear range, and can be combined with fluorescence calibration to obtain units of Molecules of Equivalent Fluorescein (MEFL) per cell, allowing direct comparison and data fusion with flow cytometry measurements: in our study, fluorescence per cell measurements showed only a 1.07-fold mean difference between plate reader and flow cytometry data.
|
|
