| 1. |
- Abel, I, et al.
(författare)
-
Overview of the JET results with the ITER-like wall
- 2013
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
-
Tidskriftsartikel (refereegranskat)abstract
- Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
|
|
| 2. |
- Romanelli, F, et al.
(författare)
-
Overview of the JET results
- 2011
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
-
Tidskriftsartikel (refereegranskat)abstract
- Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
|
|
| 3. |
- Van Oost, G., et al.
(författare)
-
Turbulent transport reduction by E x B velocity shear during edge plasma biasing : recent experimental results
- 2003
-
Ingår i: Plasma Physics and Controlled Fusion. - 0741-3335 .- 1361-6587. ; 45:5, s. 621-643
-
Tidskriftsartikel (refereegranskat)abstract
- Experiments in the tokamaks TEXTOR, CASTOR, T-10 and ISTTOK, as well as in the reversed field pinch RFX have provided new and complementary evidence on the physics of the universal mechanism of E x B velocity shear stabilization of turbulence, concomitant transport barrier formation and radial conductivity by using various edge biasing techniques. In TEXTOR the causality between transport reduction and induced electric fields in the edge has been for the first time clearly demonstrated. The high electric field gradients have been identified as the cause for the quenching of turbulent cells. A quantitative analysis of the measured transport reduction is in good agreement with theoretical predictions. The scaling of plasma turbulence suppression with velocity shear has been established, revealing the density-potential cross-phase as a key element. Reduction in poloidal electric field, temperature, and density fluctuations across the shear layer lead to a reduction of the anomalous conducted and convected heat fluxes resulting in an energy transport barrier that is measured directly. In CASTOR the biasing electrode is placed at the separatrix in a non-intrusive configuration which has demonstrated strongly sheared electric fields and consequent improvement of the global particle confinement, as predicted by theory. The impact of sheared E x B flow on edge turbulent structures has been measured directly using a comprehensive set of electrostatic probe arrays as well as emissive probes. Measurements with a full poloidal Langmuir probe array have revealed quasi-coherent electrostatic waves in the SOL with a dominant mode number equal to the edge safety factor. In T-10 edge biasing is clearly improving the global performance of ECR heated discharges. Reflectometry and heavy ion beam probe measurements show the existence of a narrow plasma layer with strong suppression of turbulence. On ISTTOK, the influence of alternating positive and negative electrode and (non-intrusive) limiter biasing has been compared. Electrode biasing is found to be more efficient in modifying the radial electric field E, and confinement, limiter biasing acting mainly on the SOL. In the RFX reversed field pinch it has been demonstrated that also in RFPs biasing can increase the local E x B velocity shear in the edge region, and hence substantially reduce the local turbulence driven particle flux mainly due to a change in the relative phase between potential and density fluctuations.
|
|
