| 1. |
|
|
| 2. |
- Kjellsson, Henrik, et al.
(författare)
-
High Temperature Fatigue Performance of Electron Beam Powder Bed Fusion Manufactured Alloy 718
- 2022
-
Ingår i: Metallurgical and Materials Transactions. A. - : Springer Nature. - 1073-5623 .- 1543-1940. ; 53, s. 2496-2514
-
Tidskriftsartikel (refereegranskat)abstract
- The microstructure and mechanical properties of additively manufactured (AM) parts have been shown to be different from that of cast and wrought counterparts. In this study, electron beam powder bed fusion (EB-PBF) fabricated Alloy 718 was exposed to three different heat treatment routes followed by strain-controlled fatigue testing at 550 degrees C. The fatigue tests were performed with specimens built with their center axis parallel and transverse relative to the build direction. The microstructure showed saturated precipitation of delta-Ni3Nb after repeated solution treatment at 954 degrees C. In contrast, no delta-Ni3Nb precipitates could be observed after a single-step solution treatment at 1025 degrees C. However, the disparity of secondary phases showed no noticeable influence on the fatigue life. A significant difference in fatigue behavior was noted between the parallel and transverse directions. The specimens loaded parallel to the elongated grains showed on average similar to 5x greater life in comparison to the perpendicularly loaded specimens. Compared to corresponding heat-treated material conditions tested at ambient temperature, the specimens showed lower life at high strain amplitude and superior life at low strain amplitude. Moreover, competitive internal and surface failure modes were observed at the lower strain amplitudes while for the higher strain ranges, surface failure modes dominated. (C) The Author(s) 2022
|
|
| 3. |
- Kjellsson, Maria C., et al.
(författare)
-
Comparison of proportional odds and differential odds models for mixed-effects analysis of categorical data
- 2008
-
Ingår i: Journal of Pharmacokinetics and Pharmacodynamics. - : Springer Science and Business Media LLC. - 1567-567X .- 1573-8744. ; 35:5, s. 483-501
-
Tidskriftsartikel (refereegranskat)abstract
- In this work a model for analyzing categorical data is presented; the differential odds model. Unlike the commonly used proportional odds model, this model does not assume that a covariate affects all categories equally on the log odds scale. The differential odds model was compared to the proportional odds model, by assessing statistical significance and improvement of predictive performance when applying the differential odds model to data previously analyzed using the proportional odds model. Three clinical studies; 3-category T-cell receptor density data, 5-category diarrhea data and 6-category sedation data, were re-analyzed with the differential odds model. As expected, no improvements were seen with T-cell receptor density and diarrhea data. However, for the more complex measurement sedation, the differential odds model provided both statistical improvements and improvements in simulation properties. The estimated actual critical value was for all data lower than the nominal value, using the number of added parameters as the degree of freedom, i.e. the differential odds model is statistically indicated to a less extent than expected. The differential odds model had the desired property of not being indicated when not necessary, but it may provide improvements when the data does not represent a categorization of continuous data.
|
|
| 4. |
|
|
