1. |
- Abazov, V. M., et al.
(författare)
-
Determination of the strong coupling constant from the inclusive jet cross section in pp collisions at s=1.96 TeV
- 2009
-
Ingår i: PHYS REV D. - 1550-7998 .- 1550-2368. ; 80, s. 111107-
-
Tidskriftsartikel (refereegranskat)abstract
- We determine the strong coupling constant alpha(s) and its energy dependence from the p(T) dependence of the inclusive jet cross section in pp collisions at s=1.96 TeV. The strong coupling constant is determined over the transverse momentum range 50 < p(T)< 145 GeV. Using perturbative QCD calculations to order O(alpha(3)(s)) combined with O(alpha(4)(s)) contributions from threshold corrections, we obtain alpha(s)(M-Z)=0.1161(-0.0048)(+0.0041). This is the most precise result obtained at a hadron-hadron collider.
|
|
2. |
- Giannazzo, F., et al.
(författare)
-
Graphene integration with nitride semiconductors for high power and high frequency electronics
- 2017
-
Ingår i: Physica Status Solidi (a) applications and materials science. - : WILEY-V C H VERLAG GMBH. - 1862-6300 .- 1862-6319. ; 214:4
-
Tidskriftsartikel (refereegranskat)abstract
- Group III nitride semiconductors (III-N), including GaN, AlN, InN, and their alloys, are currently the materials of choice for many applications in optoelectronics (light-emitting diodes, laser diodes), and high-power and high-frequency transistors. Due to its attractive electrical, optical, mechanical, and thermal properties, graphene (Gr) integration with III-N technology has been considered in the last few years, in order to address some of the major issues which still limit the performances of GaN-based devices. To date, most of the studies have been focused on the use of Gr as transparent conductive electrode (TCE) to improve current spreading from top electrodes and light extraction in GaN-LEDs. This paper will review recent works evaluating the benefits of Gr integration with III-N for high power and high frequency electronics. From the materials side, recent progresses in the growth of high quality GaN layers on Gr templates and in the deposition of Gr on III-N substrates and templates will be presented. From the applications side, strategies to use Gr for thermal management in high-power AlGaN/GaN transistors will be discussed. Finally, recent proposals of implementing new ultra-high-frequency (THz) transistors, such as the Gr base hot electron transistor (GBHET), by Gr integration with III-N will be highlighted. (C) 2016 WILEY-VCH Verlag GmbH amp; Co. KGaA, Weinheim
|
|
3. |
- Giannazzo, F, et al.
(författare)
-
Electronic transport at monolayer-bilayer junctions in epitaxial graphene on SiC
- 2012
-
Ingår i: Physical Review B. Condensed Matter and Materials Physics. - : American Physical Society. - 1098-0121 .- 1550-235X. ; 86:23
-
Tidskriftsartikel (refereegranskat)abstract
- Two-dimensional maps of the electronic conductance in epitaxial graphene grown on SiC were obtained by calibrated conductive atomic force microscopy. The correlation between morphological and electrical maps revealed the local conductance degradation in epitaxial graphene over the SiC substrate steps or at the junction between monolayer (1L) and bilayer (2L) graphene regions. The effect of steps strongly depends on the charge transfer phenomena between the step sidewall and graphene, whereas the resistance increase at the 1L/2L junction is a purely quantum-mechanical effect independent on the interaction with the substrate. First-principles transport calculations indicate that the weak wave-function coupling between the 1L pi/pi* bands with the respective first bands of the 2L region gives rise to a strong suppression of the conductance for energies within +/- 0.48 eV from the Dirac point. Conductance degradation at 1L/2L junctions is therefore a general issue for large area graphene with a certain fraction of inhomogeneities in the layer number, including graphene grown by chemical vapor deposition on metals. DOI: 10.1103/PhysRevB.86.235422
|
|
4. |
- Giannazzo, F., et al.
(författare)
-
Impact of substrate steps and of monolayer-bilayer junctions on the electronic transport in epitaxial graphene on 4H-SiC (0001)
- 2013
-
Ingår i: Silicon Carbide and Related Materials 2012. - : Trans Tech Publications Inc.. ; , s. 113-116
-
Konferensbidrag (refereegranskat)abstract
- Two dimensional maps of the electronic conductance in epitaxial graphene (EG) grown on SiC were obtained by conductive atomic force microscopy (CAFM). The correlation between morphological and electrical maps revealed the local conductance degradation in EG over the SiC substrate steps or at the junction between monolayer (1L) and bilayer (2L) graphene regions. The effect of steps strongly depends on the charge transfer phenomena between the step sidewall and graphene, whereas the resistance increase at 1L/2L junction is a purely quantum mechanical effect, due to the weak coupling between 1L and 2L electron wavefunctions.
|
|
5. |
- Monakhov, E., et al.
(författare)
-
Boron-enhanced diffusion in excimer laser annealed Si
- 2004
-
Ingår i: Materials Science & Engineering. - : Elsevier BV. - 0921-5107 .- 1873-4944. ; 114-15, s. 114-117
-
Tidskriftsartikel (refereegranskat)abstract
- The effect of excimer laser annealing (ELA) and rapid thermal annealing (RTA) on B redistribution in B-implanted Si has been studied by secondary ion mass spectrometry (SIMS) and spreading resistance probe (SRP). B has been implanted with an energy of 1 keV and a dose of 10(16) cm(-2) forming a distribution with a width of 20-30nm and a peak concentration of similar to5 x 10(21) cm(-3). It has been found that ELA with 10 pulses of the energy density of 850 mJ/cm(2) results in a uniform B distribution over the ELA-molten region with an abrupt profile edge. SRP measurements demonstrate good activation of the implanted B after ELA, with the concentration of the activated fraction (similar to10(21) cm(-3)) exceeding the solid solubility level. RTA (30 s at 1100degreesC) of the as-implanted and ELA-treated samples leads to a diffusion of B with diffusivities exceeding the equilibrium one and the enhancement is similar for both of the samples. It is also found that RTA decreases the activated B in the ELA-treated sample to the solid solubility limit (2 x 10(20) cm(-3)). The similarity of the B diffusivity for the as-implanted and ELA-treated samples suggests that the enhancement of the B diffusivity is due to the so-called boron-enhanced diffusion (BED). Possible mechanisms of BED are discussed.
|
|
6. |
- Monakhov, E. V., et al.
(författare)
-
Boron distribution in silicon after excimer laser annealing with multiple pulses
- 2005
-
Ingår i: Materials Science & Engineering. - : Elsevier BV. - 0921-5107 .- 1873-4944. ; 124, s. 228-231
-
Tidskriftsartikel (refereegranskat)abstract
- We have studied B re-distribution in Si after excimer laser annealing (ELA) with multiple laser pulses. B was implanted using both B and BF2 ions with energies from 1 to 20 keV and doses of 1 x 10(14) and 1 x 10(15) cm(-2). ELA with the number of pulses from 1 to 100 was performed in vacuum with the sample kept at room temperature and 450 degrees C. Independently of the implantation parameters and the ELA conditions used, a peak in the B concentration is observed near the maximum melting depth after 10 pulses of ELA. A detailed study has revealed that B accumulates at the maximum melt depth gradually with the number of ELA pulses. An increase in the carrier concentration at the maximum melt depth is observed after ELA with 100 pulses. No structural defects have been detected by transmission electron microscopy in the region of the B accumulation.
|
|
7. |
- Monakhov, E. V., et al.
(författare)
-
Boron distribution in silicon after multiple pulse excimer laser annealing
- 2005
-
Ingår i: Applied Physics Letters. - : AIP Publishing. - 0003-6951 .- 1077-3118. ; 87:8
-
Tidskriftsartikel (refereegranskat)abstract
- We have studied B redistribution in Si after excimer laser annealing (ELA) with multiple laser pulses. B was implanted with energies of 1 and 10 keV and doses of 1x10(14) and 1x10(15) cm(-2). ELA with the number of pulses from 1 to 100 was performed at room temperature and 450 degrees C in vacuum. Irrespective of the implantation parameters and the ELA conditions used, a pile-up in the B concentration is observed near the maximum melting depth after ten pulses of ELA. Moreover, a detailed study has revealed that B accumulates at the maximum melt depth gradually with the number of ELA pulses. Besides, an increase in the carrier concentration is observed at the maximum melt depth, suggesting electrical activity of the accumulated B. Formation of Si-B complexes and vacancy accumulation during multiple ELA are discussed as possible mechanisms for the B build-up.
|
|
8. |
- Monakhov, E. V., et al.
(författare)
-
Enhanced boron diffusion in excimer laser preannealed Si
- 2005
-
Ingår i: Applied Physics Letters. - : AIP Publishing. - 0003-6951 .- 1077-3118. ; 86:15
-
Tidskriftsartikel (refereegranskat)abstract
- We have investigated boron diffusion during rapid thermal annealing in Si implanted with boron using an energy of 1 keV and a dose of 1 x 10(16) cm(-2). Two types of samples have been studied: As-implanted and pretreated with excimer laser annealing. For both types an enhanced diffusion of boron has been observed with an enhancement by a factor of 3-5 over the standard diffusion. It is suggested that the high concentration of implanted boron is a dominant factor for the diffusion enhancement as compared to the effect of implantation-induced damage. The data indicate that the proximity of the surface can also affect the boron diffusion enhancement.
|
|
9. |
- Monakhov, E. V., et al.
(författare)
-
Excimer laser annealing of B and BF2 implanted Si
- 2005
-
Ingår i: Materials Science & Engineering. - : Elsevier BV. - 0921-5107 .- 1873-4944. ; 124, s. 232-234
-
Tidskriftsartikel (refereegranskat)abstract
- We have performed a comparative study of B re-distribution and electrical activation after excimer laser annealing (ELA) of B and BF2 implanted Si. Chemical B concentration and electrical activation profiles were measured by secondary ion mass spectrometry (SIMS) and spreading resistance profiling (SRP), respectively. SIMS data demonstrate that the presence of F does not influence significantly the re-distribution of B during ELA. A dramatic contrast, however, can be observed in the electrical activation of the dopant in the B and BF2 implanted samples. While almost 100% electrical activation of B occurs in the B implanted samples, only 20-50% of the dopant can be activated by ELA in the BF2 implanted sample. Possible mechanisms causing the deactivation of B in the BF2 implanted samples after ELA are discussed.
|
|
10. |
- Monakhov, E. V., et al.
(författare)
-
Excimer laser annealing of shallow As and B doped layers
- 2004
-
Ingår i: Materials Science & Engineering. - : Elsevier BV. - 0921-5107 .- 1873-4944. ; 114-15, s. 352-357
-
Tidskriftsartikel (refereegranskat)abstract
- Excimer laser annealing (ELA) of As-, B- and BF2-implanted Si has been studied by secondary ion mass spectrometry (SIMS), spreading resistance probe (SRP) and transmission electron microscopy (TEM). The implantations have been performed in the energy range from I to 30 keV with doses of 10(15)-10(16) cm(-2). ELA has been carried out with the energy densities in the range of 600-1200 mJ/cm(2) and the number of laser pulses from 1 to 10. It is shown that ELA results in a more uniform dopant distribution over the doped region with a more abrupt profile edge as compared to those after rapid thermal annealing (RTA). Besides, in contrast to RTA, ELA demonstrates a highly confined annealing effect, where the distribution of dopants below the melting region is not affected. SRP measurements demonstrate almost complete activation of the implanted dopants after ELA, and TEM does not reveal extended defects in the ELA-treated samples. The depth of the doped layers, abruptness of the profiles and the total doping dose as a function of ELA energy density and number of laser pulses are investigated. Computer simulations of ELA show a good agreement with the experimental data.
|
|