| 1. |
- Jain, Vishal, 1989-, et al.
(författare)
-
A comparative study of nanowire based infrared p+-i-n+ photodetectors
- 2012
-
Konferensbidrag (refereegranskat)abstract
- We present a comparative study of electrical and optical properties of two types of p+-i-n+ photodetectors based on self-assembled ensembles of vertical InP nanowires (NWs) monolithically grown on InP. The detectors differ in the type of p+ contact, one detector geometry has p+-i-n+ segments integrated into the NWs (type A) while the other detector has i-n+ NW segments grown directly on a p+ substrate(type B). The samples were prepared by first depositing 80 nm Au nanoparticles on a p+ InP substrate using an aerosol technique and subsequently growing NWs using MOVPE. The NWs have a polytypecrystal structure of alternating wurtzite and zincblende segments. The processing of the detectors include deposition of SiO2, followed by an etching step to remove the oxide from the tip of the NWs, and finally sputtering of ITO on 1x1 mm2 device areas. The two most prominent differences between the detectors concern the current-voltage (I-V) characteristics and the spatial location of generated photocurrent. From spectrally resolved photocurrent measurements, we conclude that the photocurrent in detector type A is primarily generated in the NWs, whereas the photocurrent in type B detectors mainly stems from the substrate. Photogenerated carriers in the substrate diffuse to the NWs where they are effectively funnelled into the NWs. The I-V characteristics of the type A detector displays a non-trivial transport behaviour for forward biases, whereas type B shows excellent rectifying behavior with an ideality factor of about 2.5. We will discuss detailed analysis of the spectral fingerprints of the two detector types revealing the mixed crystal phase of the polytype NWs and bandstructure effects, temperature dependence of the I-V characteristics and typical photodetector parameters.
|
|
| 2. |
- Pettersson, Håkan, 1962-, et al.
(författare)
-
Electrical and optical properties of InP nanowire ensemble p(+)-i-n(+) photodetectors
- 2012
-
Ingår i: Nanotechnology. - Bristol, UK : Institute of Physics Publishing (IOPP). - 0957-4484 .- 1361-6528. ; 23:13
-
Tidskriftsartikel (refereegranskat)abstract
- We report on a comprehensive study of electrical and optical properties of efficient near-infrared p(+)-i-n(+) photodetectors based on large ensembles of self-assembled, vertically aligned i-n(+) InP nanowires monolithically grown on a common p(+) InP substrate without any buffer layer. The nanowires have a polytype modulated crystal structure of wurtzite and zinc blende. The electrical data display excellent rectifying behavior with an ideality factor of about 2.5 at 300 K. The ideality factor scales with 1/T, which possibly reflects deviations from classical transport models due to the mixed crystal phase of the nanowires. The observed dark leakage current is of the order of merely similar to 100 fA/nanowire at 1 V reverse bias. The detectors display a linear increase of the photocurrent with reverse bias up to about 10 pA/nanowire at 5 V. From spectrally resolved measurements, we conclude that the photocurrent is primarily generated by funneling photogenerated carriers from the substrate into the NWs. Contributions from direct excitation of the NWs become increasingly important at low temperatures. The photocurrent decreases with temperature with an activation energy of about 50 meV, which we discuss in terms of a temperature-dependent diffusion length in the substrate and perturbed transport through the mixed-phase nanowires. © 2012 IOP Publishing Ltd.
|
|
| 3. |
- Pettersson, Håkan, et al.
(författare)
-
Intersubband photoconductivity of self-assembled InAs quantum dots embedded in InP
- 2004
-
Ingår i: Journal of Applied Physics. - : American Institute of Physics (AIP). - 0021-8979 .- 1089-7550. ; 95:4, s. 1829-1831
-
Tidskriftsartikel (refereegranskat)abstract
- The results from photoconductivity (PC) measurements on InAs dots embedded in InP are presented. The PC technique is recently applied to the study of InAs dots embedded in matrices of GaAs and Al0.3Ga0.7As matrix, respectively. It is demonstrated that this technique reveals important new physical insight into the electronic structure of the InAs/InP dots, information that cannot easily be obtained by other techniques.
|
|
| 4. |
|
|
| 5. |
- Amin, Mohammed Nurul, et al.
(författare)
-
Electrical and optical characteristics of Infrared Photodetectors based on InP nanowire
- 2011
-
Ingår i: 14th International Conference on Computer and Information Technology, ICCIT 2011. - Piscataway, NJ : IEEE. ; , s. 629-634
-
Tidskriftsartikel (refereegranskat)abstract
- High speed photodetectors are most sophisticated optoelectronic devices, because it has high photo sensitivity, and allow a large wavelength range of detection as a receiver from 750 nm to 1.3-1.55 μm in the optical communication system. Since the last decade, the electrical and optical characteristics of photodetectors have been investigated to improve their performance and price. We have worked on two different type of infrared photodetectors based on nanowire. One photodetector was p-n photodiode, and the other one was p-i-n structure. We investigated the detector performance at 77K-300K temperature corresponding with wavelength in darkness and under illumination as regarding breakdown voltage, sensitivity, and quantum efficiency. We have also compared the differences between the two photodetectors performance characteristics. © 2011 IEEE.
|
|
