| 1. |
- Baier, Robert, et al.
(författare)
-
Electronic properties of grain boundaries in Cu(In,Ga)Se-2 thin films with various Ga-contents
- 2012
-
Ingår i: Solar Energy Materials and Solar Cells. - : Elsevier BV. - 0927-0248. ; 103, s. 86-92
-
Tidskriftsartikel (refereegranskat)abstract
- We present a study on the electronic properties of grain boundaries (GBs) in polycrystalline Cu(In,Ga)Se-2 (CIGSe) thin films by means of Kelvin probe force microscopy. As grown as well as KCN-treated films were investigated comparatively. No influence of the chemical treatment on the electronic properties of GBs was found. GBs generally exhibited large variations in their electronic properties. By means of a novel method of data analysis both potential barriers for holes and electrons were found at GBs, in a range from -118 mV to +114 mV, as well as GBs without potential barrier. No dependence of the electronic GB-properties on the Ga-content was detected. Consequently, we conclude that there is no correlation between the electronic properties of GBs and the obtained maximum efficiencies of CIGSe thin film solar cells as a function of the Ga-content. (C) 2012 Elsevier B.V. All rights reserved.
|
|
| 2. |
- Hertzberg, Joachim, et al.
(författare)
-
The RACE Project : Robustness by Autonomous Competence Enhancement
- 2014
-
Ingår i: Künstliche Intelligenz. - : Springer Berlin/Heidelberg. - 0933-1875 .- 1610-1987. ; 28:4, s. 297-304
-
Tidskriftsartikel (refereegranskat)abstract
- This paper reports on the aims, the approach, and the results of the European project RACE. The project aim was to enhance the behavior of an autonomous robot by having the robot learn from conceptualized experiences of previous performance, based on initial models of the domain and its own actions in it. This paper introduces the general system architecture; it then sketches some results in detail regarding hybrid reasoning and planning used in RACE, and instances of learning from the experiences of real robot task execution. Enhancement of robot competence is operationalized in terms of performance quality and description length of the robot instructions, and such enhancement is shown to result from the RACE system.
|
|
| 3. |
- Lehmann, Jascha, et al.
(författare)
-
Reliable wet-chemical cleaning of natively oxidized high-efficiency Cu(In,Ga)Se-2 thin-film solar cell absorbers
- 2014
-
Ingår i: Applied Physics Reviews. - : AIP Publishing. - 1931-9401. ; 116:23
-
Tidskriftsartikel (refereegranskat)abstract
- Currently, Cu-containing chalcopyrite-based solar cells provide the highest conversion efficiencies among all thin-film photovoltaic (PV) technologies. They have reached efficiency values above 20%, the same performance level as multi-crystalline silicon-wafer technology that dominates the commercial PV market. Chalcopyrite thin-film heterostructures consist of a layer stack with a variety of interfaces between different materials. It is the chalcopyrite/buffer region (forming the p-n junction), which is of crucial importance and therefore frequently investigated using surface and interface science tools, such as photoelectron spectroscopy and scanning probe microscopy. To ensure comparability and validity of the results, a general preparation guide for "realistic" surfaces of polycrystalline chalcopyrite thin films is highly desirable. We present results on wet-chemical cleaning procedures of polycrystalline Cu(In1-xGax)Se-2 thin films with an average x = [Ga]/([In] + [Ga]) = 0.29, which were exposed to ambient conditions for different times. The hence natively oxidized sample surfaces were etched in KCN- or NH3-based aqueous solutions. By x-ray photoelectron spectroscopy, we find that the KCN treatment results in a chemical surface structure which is - apart from a slight change in surface composition - identical to a pristine as-received sample surface. Additionally, we discover a different oxidation behavior of In and Ga, in agreement with thermodynamic reference data, and we find indications for the segregation and removal of copper selenide surface phases from the polycrystalline material. (C) 2014 AIP Publishing LLC.
|
|
| 4. |
- Aghaeipour, Mahtab, et al.
(författare)
-
Optical response of wurtzite and zinc blende GaP nanowire arrays
- 2015
-
Ingår i: Optics Express. - 1094-4087. ; 23:23, s. 30177-30187
-
Tidskriftsartikel (refereegranskat)abstract
- We compare the optical response of wurtzite and zinc blende GaP nanowire arrays for varying geometry of the nanowires. We measure reflectance spectra of the arrays and extract from these measurements the absorption in the nanowires. To support our experimental findings and to allow for more detailed investigations of the optical response of the nanowire arrays than possible in experiments, we perform electromagnetic modeling. This modeling highlights the validity of the extraction of the absorptance from reflectance spectra, as well as limitations of the extraction due to anti-reflection properties of the nanowires. In our combined experimental and theoretical study, we find for both zinc blende and wurtzite nanowires an absorption resonance that can be tuned into the ultraviolet by decreasing the diameter of the nanowires. This peak stops blue-shifting with decreasing nanowire diameter at a wavelength of approximately 330 nm for zinc blende GaP. In contrast, for the wurtzite GaP nanowires, the resonance continues blue-shifting at 310 nm for the smallest diameters we succeeded in fabricating. We interpret this as a difference in refractive index between wurtzite and zinc blende GaP in this wavelength region. These results open up for optical applications through resonant absorption in the visible and ultraviolet wavelength regions with both zinc blende and wurtzite GaP nanowire arrays. Notably, zinc blende and wurtzite GaP support resonant absorption deeper into the ultraviolet region than previously found for zinc blende and wurtzite InP and InAs. (C) 2015 Optical Society of America
|
|
| 5. |
- Aghaeipour, Mahtab, et al.
(författare)
-
Tunable absorption resonances in the ultraviolet for InP nanowire arrays
- 2014
-
Ingår i: Optics Express. - 1094-4087. ; 22:23, s. 29204-29212
-
Tidskriftsartikel (refereegranskat)abstract
- The ability to tune the photon absorptance spectrum is an attracting way of tailoring the response of devices like photodetectors and solar cells. Here, we measure the reflectance spectra of InP substrates patterned with arrays of vertically standing InP nanowires. Using the reflectance spectra, we calculate and analyze the corresponding absorptance spectra of the nanowires. We show that we can tune absorption resonances for the nanowire arrays into the ultraviolet by decreasing the diameter of the nanowires. When we compare our measurements with electromagnetic modeling, we generally find good agreement. Interestingly, the remaining differences between modeled and measured spectra are attributed to a crystal-phase dependence in the refractive index of InP. Specifically, we find indication of significant differences in the refractive index between the modeled zinc-blende InP nanowires and the measured wurtzite InP nanowires in the ultraviolet. We believe that such crystal-phase dependent differences in the refractive index affect the possibility to excite optical resonances in the large wavelength range of 345 < lambda < 390 nm. To support this claim, we investigated how resonances in nanostructures can be shifted in wavelength by geometrical tuning. We find that dispersion in the refractive index can dominate over geometrical tuning and stop the possibility for such shifting. Our results open the door for using crystal-phase engineering to optimize the absorption in InP nanowire-based solar cells and photodetectors. (C) 2014 Optical Society of America
|
|
| 6. |
- Anttu, Nicklas, et al.
(författare)
-
Crystal Phase-Dependent Nanophotonic Resonances in InAs Nanowire Arrays
- 2014
-
Ingår i: Nano Letters. - : American Chemical Society (ACS). - 1530-6992 .- 1530-6984. ; 14:10, s. 5650-5655
-
Tidskriftsartikel (refereegranskat)abstract
- Nanostructures have many material, electronic, and optical properties that are not found in bulk systems and that are relevant for technological applications. For example, nanowires realized from III-V semiconductors can be grown into wurtzite crystal structure. This crystal structure does not naturally exist in bulk where these materials form the zinc-blende counterpart. Being able to concomitantly grow these nanowires in the zinc-blende and/or wurtzite crystal structure prlovides an important degree of control for the design and optimization of optoelectronic applications based on these semiconductor nanostructures. However, the refractive indices of this new crystallographic phase have so far not been elucidated. This shortcoming makes it impossible to predict and utilize he full potential of these new nanostructured materials for optoelectronics applications a careful design and optimization of optical resonances by tuning the nanostrucuted geometry is needed to achieve optimal performance. Here, we report and analyze striking differeences in the optical response of nanophotonic resonances in wurtzite and zinc-blend InAs nanowire arrays. Specifically, through reflectance measurements we find that the resonance can be tuned down to lambda approximate to 380 nm in wurtzite nanowires by decreasing the nanowire diameter. In stark contrast, a similar tuning to below approximate to 500 nm is not possible in the zinc-blende nanowires. Furthermore, we find that the wurtzite nanowires can absorb twice as strongly as the zinc-blende nanowires. We attribute these strikingly large differences in resonant behavior to large differences between the refractive indices of the two crystallographic phases realized in these nanostructures. We anticipate our finding to be relevant for other III-B materials as well as for all material systems that manifest polytypism. Taken together, our results demonstrate crystal phase engineering as a potentially new design dimension for optoelectronics applications.
|
|
| 7. |
|
|
| 8. |
- Bacic, Luka, et al.
(författare)
-
Structure and dynamics of the chromatin remodeler ALC1 bound to a PARylated nucleosome
- 2021
-
Ingår i: eLIFE. - : eLife Sciences Publications Ltd. - 2050-084X. ; 10
-
Tidskriftsartikel (refereegranskat)abstract
- The chromatin remodeler ALC1 is recruited to and activated by DNA damage-induced poly(ADP-ribose) (PAR) chains deposited by PARP1/PARP2/HPF1 upon detection of DNA lesions. ALC1 has emerged as a candidate drug target for cancer therapy as its loss confers synthetic lethality in homologous recombination-deficient cells. However, structure-based drug design and molecular analysis of ALC1 have been hindered by the requirement for PARylation and the highly heterogeneous nature of this post-translational modification. Here, we reconstituted an ALC1 and PARylated nucleosome complex modified in vitro using PARP2 and HPF1. This complex was amenable to cryo-EM structure determination without cross-linking, which enabled visualization of several intermediate states of ALC1 from the recognition of the PARylated nucleosome to the tight binding and activation of the remodeler. Functional biochemical assays with PARylated nucleosomes highlight the importance of nucleosomal epitopes for productive remodeling and suggest that ALC1 preferentially slides nucleosomes away from DNA breaks.
|
|
| 9. |
|
|
| 10. |
- Barker, David, et al.
(författare)
-
Experimental Verification of the Work Fluctuation-Dissipation Relation for Information-to-Work Conversion
- 2022
-
Ingår i: Physical Review Letters. - 0031-9007. ; 128:4
-
Tidskriftsartikel (refereegranskat)abstract
- We study experimentally work fluctuations in a Szilard engine that extracts work from information encoded as the occupancy of an electron level in a semiconductor quantum dot. We show that as the average work extracted per bit of information increases toward the Landauer limit Formula Presented, the work fluctuations decrease in accordance with the work fluctuation-dissipation relation. We compare the results to a protocol without measurement and feedback and show that when no information is used, the work output and fluctuations vanish simultaneously, contrasting the information-to-energy conversion case where increasing amount of work is produced with decreasing fluctuations. Our study highlights the importance of fluctuations in the design of information-to-work conversion processes.
|
|
