| 1. |
- Agnarsson, Björn, 1977, et al.
(författare)
-
Rutile TiO 2 thin films grown by reactive high power impulse magnetron sputtering
- 2013
-
Ingår i: Thin Solid Films. - : Elsevier BV. - 0040-6090 .- 1879-2731. ; 545, s. 445-450
-
Tidskriftsartikel (refereegranskat)abstract
- Thin TiO 2 films were grown on Si(001) substrates by reactive dc magnetron sputtering (dcMS) and high power impulse magnetron sputtering (HiPIMS) at temperatures ranging from 300 to 700 C.Optical and structural properties of films were compared both before and after post-annealing using scanning electron microscopy, low angle X-ray reflection (XRR), grazing inc idence X-ray diffractometry and spectroscopic ellipsometry.Both dcMS- and HiPIMS-grown films reveal polycrystalline rutile TiO 2 , even prior to post-annealing.The HiPIMS-grown films exhibit significantly larger grains compared to that of dcMC-grown films, approaching 100% of the film thickness for films grown at 700 C.In addition, the XRR surface roughness of HiPIMS-grown films was significantly lower than that of dcMS-grown films over the whole temperature range 300-700 C.Dispersion curves could only be obtained for the HiPIMS-grown films, which were shown to have a refractive index in the range of 2.7-2.85 at 500 nm.The results show that thin, rutile TiO 2 films, with high refractive index, can be obtained by HiPIMS at relatively low growth temperatures, without post-annealing.Furthermore, these films are smoother and show better optical characteristics than their dcMS-grown counterparts.© 2013 Elsevier B.V.All rights reserved.
|
|
| 2. |
- Leosson, K., et al.
(författare)
-
Comparing resonant photon tunneling via cavity modes and Tamm plasmon polariton modes in metal-coated Bragg mirrors
- 2012
-
Ingår i: Optics Letters. - 0146-9592 .- 1539-4794. ; 37:19, s. 4026-4028
-
Tidskriftsartikel (refereegranskat)abstract
- Resonant photon tunneling was investigated experimentally in multilayer structures containing a high-contrast (TiO2/SiO2) Bragg mirror capped with a semitransparent gold film. Transmission via a fundamental cavity resonance was compared with transmission via the Tamm plasmon polariton resonance that appears at the interface between a metal film and a one-dimensional photonic bandgap structure. The Tamm-plasmon-mediated transmission exhibits a smaller dependence on the angle and polarization of the incident light for similar values of peak transmission, resonance wavelength, and finesse. Implications for transparent electrical contacts based on resonant tunneling structures are discussed.
|
|
| 3. |
- Hanifpour, Fatemeh, et al.
(författare)
-
Operando quantification of ammonia produced from computationally-derived transition metal nitride electro-catalysts
- 2022
-
Ingår i: Journal of Catalysis. - : Elsevier. - 0021-9517 .- 1090-2694. ; 413, s. 956-967
-
Tidskriftsartikel (refereegranskat)abstract
- Electrochemical reduction of dinitrogen to ammonia is investigated in a micro-reactor flow-cell using thin films of VN, CrN, NbN and ZrN. Chronoamperometry loops are used for ammonia production analysis. Operando ammonia quantification is accomplished in a flow injection analyzer. Results show the effect of presence/absence of N-2(g) within both the electrochemical characterization and ammonia production for ZrN. However, no ammonia is detected from studies on CrN. VN and NbN are inactivated upon reacting their N atoms of the surface top layer(s). Results obtained from ammonia measurements, electrochemical impedance spectroscopy analysis, surface stability checks, and surface characterization using X-ray reflectivity, reveal certain trends indicating catalytic behavior for ZrN. However, the concentration of produced ammonia is below the detection limit of the methods devised to analyze the samples from isotope labeling experiments. The onset of ammonia production on ZrN appears to be in close agreement with that predicted previously by computational studies.
|
|
| 4. |
- Leosson, K., et al.
(författare)
-
Integrated Biophotonics with CYTOP
- 2012
-
Ingår i: Micromachines. - : MDPI AG. - 2072-666X. ; 3:1, s. 114-125
-
Tidskriftsartikel (refereegranskat)abstract
- We describe how the amorphous fluoropolymer CYTOP can be advantageously used as a waveguide cladding material in integrated optical circuits suitable for applications in integrated biophotonics. The unique refractive index of CYTOP (n = 1.34) enables the cladding material to be well index-matched to an optically probed sample solution. Furthermore, ultra-high index contrast waveguides can be fabricated, using conventional optical polymers as waveguide core materials, offering a route to large-scale integration of optical functions on a single chip. We discuss applications of this platform to evanescent-wave excitation fluorescence microscopy, passive and/or thermo-electrically-controlled on-chip light manipulation, on-chip light generation, and direct integration with microfluidic circuits through low-temperature bonding.
|
|
| 5. |
- Leosson, K., et al.
(författare)
-
Ultra-thin gold films on transparent polymers
- 2013
-
Ingår i: Nanophotonics. - : Walter de Gruyter GmbH. - 2192-8614 .- 2192-8606. ; 2:1, s. 3-11
-
Tidskriftsartikel (refereegranskat)abstract
- Fabrication of continuous ultra-thin gold films (
|
|
