1. |
- Matthews, G. F., et al.
(författare)
-
Overview of the ITER-like wall project
- 2007
-
Ingår i: Physica Scripta. - 0031-8949 .- 1402-4896. ; T128, s. 137-143
-
Tidskriftsartikel (refereegranskat)abstract
- Work is in progress to completely replace, in 2008/9, the existing JET CFC tiles with a configuration of plasma facing materials consistent with the ITER design. The ITER-like wall (ILW) will be created with a combination of beryllium ( Be), tungsten ( W), W-coated CFC and Be-coated inconel tiles, with the material depending on the local anticipated heat flux and geometry. It is part of an integrated package of JET enhancements whose aim is to develop an understanding of the ITER materials issues and develop the techniques required to operate with inductive and advanced scenarios as close as possible to ITER parameters. Over 4000 tiles will be replaced and the ILW will accommodate additional heating up to at least 50 MW for 10 s. This paper describes the scientific background to the project, the technical objectives, the material configuration selected, the R&D behind the practical realization of the objectives and the generic problems associated with the Be tiles ( power handling capacity and disruption induced eddy currents). One of the objectives is to maintain or improve the existing CFC tile power handling performance which has been achieved in most cases by hiding bolt holes, optimizing tile size and profile and introducing castellations on plasma facing surfaces.
|
|
2. |
|
|
3. |
|
|
4. |
|
|
5. |
- Piazza, G., et al.
(författare)
-
R&D on tungsten plasma facing components for the JET ITER-like wall project
- 2007
-
Ingår i: Journal of Nuclear Materials. - : Elsevier BV. - 0022-3115 .- 1873-4820. ; 367, s. 1438-1443
-
Tidskriftsartikel (refereegranskat)abstract
- Currently, the primary ITER materials choice is a full beryllium main wall with carbon fibre composite at the divertor strike points and tungsten on the upper vertical targets and dome. The full tungsten divertor option is a possibility for the subsequent D-T phase. Neither of the ITER material combinations of first wall and divertor materials has ever been tested in a tokamak. To collect operational experience at JET with ITER relevant material combination (Be, C and W) would reduce uncertainties and focus the preparation for ITER operations. Therefore, the ITER-like wall project has been launched to install in JET a tungsten divertor and a beryllium main wall. This paper describes the R&D activities carried out for the project to develop an inertially cooled bulk tungsten divertor tile, to fully characterise tungsten coating technologies for CFC divertor tiles and to develop erosion markers for use as diagnostics on beryllium tiles.
|
|
6. |
|
|
7. |
|
|