| 1. |
|
|
| 2. |
- Beal, Jacob, et al.
(författare)
-
Robust estimation of bacterial cell count from optical density
- 2020
-
Ingår i: Communications Biology. - : Springer Science and Business Media LLC. - 2399-3642. ; 3:1
-
Tidskriftsartikel (refereegranskat)abstract
- Optical density (OD) is widely used to estimate the density of cells in liquid culture, but cannot be compared between instruments without a standardized calibration protocol and is challenging to relate to actual cell count. We address this with an interlaboratory study comparing three simple, low-cost, and highly accessible OD calibration protocols across 244 laboratories, applied to eight strains of constitutive GFP-expressing E. coli. Based on our results, we recommend calibrating OD to estimated cell count using serial dilution of silica microspheres, which produces highly precise calibration (95.5% of residuals <1.2-fold), is easily assessed for quality control, also assesses instrument effective linear range, and can be combined with fluorescence calibration to obtain units of Molecules of Equivalent Fluorescein (MEFL) per cell, allowing direct comparison and data fusion with flow cytometry measurements: in our study, fluorescence per cell measurements showed only a 1.07-fold mean difference between plate reader and flow cytometry data.
|
|
| 3. |
- Klionsky, Daniel J., et al.
(författare)
-
Guidelines for the use and interpretation of assays for monitoring autophagy
- 2012
-
Ingår i: Autophagy. - : Informa UK Limited. - 1554-8635 .- 1554-8627. ; 8:4, s. 445-544
-
Forskningsöversikt (refereegranskat)abstract
- In 2008 we published the first set of guidelines for standardizing research in autophagy. Since then, research on this topic has continued to accelerate, and many new scientists have entered the field. Our knowledge base and relevant new technologies have also been expanding. Accordingly, it is important to update these guidelines for monitoring autophagy in different organisms. Various reviews have described the range of assays that have been used for this purpose. Nevertheless, there continues to be confusion regarding acceptable methods to measure autophagy, especially in multicellular eukaryotes. A key point that needs to be emphasized is that there is a difference between measurements that monitor the numbers or volume of autophagic elements (e.g., autophagosomes or autolysosomes) at any stage of the autophagic process vs. those that measure flux through the autophagy pathway (i.e., the complete process); thus, a block in macroautophagy that results in autophagosome accumulation needs to be differentiated from stimuli that result in increased autophagic activity, defined as increased autophagy induction coupled with increased delivery to, and degradation within, lysosomes (in most higher eukaryotes and some protists such as Dictyostelium) or the vacuole (in plants and fungi). In other words, it is especially important that investigators new to the field understand that the appearance of more autophagosomes does not necessarily equate with more autophagy. In fact, in many cases, autophagosomes accumulate because of a block in trafficking to lysosomes without a concomitant change in autophagosome biogenesis, whereas an increase in autolysosomes may reflect a reduction in degradative activity. Here, we present a set of guidelines for the selection and interpretation of methods for use by investigators who aim to examine macroautophagy and related processes, as well as for reviewers who need to provide realistic and reasonable critiques of papers that are focused on these processes. These guidelines are not meant to be a formulaic set of rules, because the appropriate assays depend in part on the question being asked and the system being used. In addition, we emphasize that no individual assay is guaranteed to be the most appropriate one in every situation, and we strongly recommend the use of multiple assays to monitor autophagy. In these guidelines, we consider these various methods of assessing autophagy and what information can, or cannot, be obtained from them. Finally, by discussing the merits and limits of particular autophagy assays, we hope to encourage technical innovation in the field.
|
|
| 4. |
-
- 2019
-
Tidskriftsartikel (refereegranskat)
|
|
| 5. |
- Abbafati, Cristiana, et al.
(författare)
-
- 2020
-
Tidskriftsartikel (refereegranskat)
|
|
| 6. |
- Feng, Bo, et al.
(författare)
-
Mechanisms of N2O Formation from Char Combustion
- 1996
-
Ingår i: Energy & Fuels. - 1520-5029 .- 0887-0624. ; 10:1, s. 203-208
-
Tidskriftsartikel (refereegranskat)abstract
- This paper describes an experimental study on N2O and NOx emission from char combustion. Experiments have been carried out in a fixed bed reactor in the temperature range of 973−1323 K. Oxygen concentrations for combustion, temperature, and char type have been found to have strong effects on both N2O and NOx emissions. With an increasing temperature, N2O reaches a peak at 1073 K and then decreases with temperature. At the same time NOx remains nearly the same. When oxygen concentration increases, the concentration of N2O increases and NOx first increases and then decreases. The char with higher nitrogen content emits more N2O, indicating that nitrogen oxides come from char-N. When NO is included in the inlet gases, much more N2O is produced from char combustion. This suggests that the reaction of NO + O2 + char is the main pathway for N2O formation. Another pathway, i.e., the homogeneous oxidation of HCN from the gasfication of char, seems to be important as well.
|
|
| 7. |
- Feng, Bo, et al.
(författare)
-
Nitrogen oxides emission from a circulating fluidized bed combustor
- 1998
-
Ingår i: International Journal of Energy Research. - 1099-114X .- 0363-907X. ; 20:11, s. 1015-1025
-
Tidskriftsartikel (refereegranskat)abstract
- Experiments were carried out in a pilot-scale circulating fluidized bed (CFB) coal combustor to investigate the mechanism of N,O formation, nitrogen oxides (including NO, and N,O) emission and the effect of temperature, excess air ratio, recirculation ratio, etc. The concentrations of nitrous oxide and nitric oxide were measured along the height of the CFB furnace. N,O concentration increased with height, and in the exit of the combustor N,O reached the highest level. NO,, however, decreased with height, showing the inverse trend compared with N,O. The N,O emission decreased sharply with the rise of temperature at the bottom of the combustor; at the same time, the NO, concentration increased.
|
|
| 8. |
- Shi, Zhi Sheng, et al.
(författare)
-
Enrichment of Ni–Mo–V via pyrometallurgical reduction from spent hydrogenation catalysts and the multi-reaction mechanism
- 2023
-
Ingår i: Rare Metals. - 1001-0521 .- 1867-7185. ; 42:8, s. 2700-2712
-
Tidskriftsartikel (refereegranskat)abstract
- Spent hydrogenation catalysts are important secondary resources due to richness in the valuable metals of Ni, Mo and V. Recovery of valuable metals from spent catalysts has high economic value and environmental benefits since they are hazardous wastes as well. Traditional recycling processes including hydrometallurgical leaching and soda roasting-leaching have disadvantages such as generating large amounts of wastewater, long process, and low recovery efficiency of valuable metals. Thus, this paper proposed synergistic enrichment of Ni, Mo and V via pyrometallurgical reduction at 1400–1500 °C. The melting temperature and viscosity of slag were reduced through slag designing by software FactSage 7.1. The phase diagram of Al2O3-CaO-SiO2-Na2O-B2O3 was drawn, and low-temperature region (≤ 1300 °C) was selected as target slag composition. Ni, Mo, and V can be collaborative captured and recovered through the mutual solubility at molten state. Increasing the melting temperature and the amount of CaO, Na2O and C were conducive to improving the metals recovery rates. The kilogram-scale experiments were carried out, and the recovery efficiencies of Ni, Mo and V were 98.3%, 95.3% and 97.9% under optimized conditions: at 1500 °C, with the basicity of 1.0, 13.1 wt% SiO2, 7.0 wt% B2O3, 7.7 wt% Na2O and 20.0 wt% C. The distribution behavior of valuable metals was clarified by investigating the melting process of slag and the reduction in valuable metals. Ni was preferentially reduced and acted as a capturing agent, which captured other metals to form NiMoV alloys. Graphical abstract: [Figure not available: see fulltext.]
|
|
| 9. |
- Yu, Ling-Zhu, et al.
(författare)
-
MEK1/2 regulates microtubule organization, spindle pole tethering and asymmetric division during mouse oocyte meiotic maturation.
- 2007
-
Ingår i: Cell cycle (Georgetown, Tex.). - 1551-4005. ; 6:3, s. 330-8
-
Tidskriftsartikel (refereegranskat)abstract
- It is well known that MAPK plays pivotal roles in oocyte maturation, but the function of MEK (MAPK kinase) remains unknown. We have studied the expression, subcellular localization and functional roles of MEK during meiotic maturation of mouse oocytes. Firstly, we found that MEK1/2 phoshorylation (p-MEK1/2, indicative of MEK activation) was low in GV (germinal vesicle) stage, increased 2h after GVBD (germinal vesicle breakdown), and reached the maximum at metaphase II. Secondly, we found that P-MEK1/2 was restricted in the GV prior to GVBD. In prometaphase I and metaphase I, P-MEK1/2 was mainly associated with the spindle, especially with the spindle poles. At anaphase I and telophase I, p-MEK1/2 became diffusely distributed in the region between the separating chromosomes, and then became associated with the midbody. The association of p-MEK1/2 with spindle poles was further confirmed by its colocalization with the centrosomal proteins, gamma-tubulin and NuMA. Thirdly, we have investigated the possible functional role of MEK1/2 activation by intravenous administration and intrabursal injection of a specific MEK inhibitor, U0126, and by microinjection of MEK siRNA into oocytes. All these manipulations cause disorganized spindle poles and spindle structure, misaligned chromosomes and larger than normal polar bodies. Our results suggest that MEK1/2 may function as a centrosomal protein and may have roles in microtubule organization, spindle pole tethering and asymmetric division during mouse oocyte maturation.
|
|
| 10. |
- Yuan, Bo, et al.
(författare)
-
Preparation and properties of porous silicon carbide based ceramic filter
- 2016
-
Ingår i: Journal of Alloys and Compounds. - : Elsevier BV. - 0925-8388 .- 1873-4669. ; 684, s. 613-615
-
Tidskriftsartikel (refereegranskat)abstract
- Porous silicon carbide ceramics with high open porosity and large pore size are usually applied as filters for the cleaning of hot dust gases. However, the large porosity and large pore size will decrease the mechanical properties. In the present study, porous SiC ceramics were prepared using bentonite as bonding phase. The effects of sintering temperature on the microstructure and the compressive strength were studied. Bentonite could melt and spread on the surface of silicon carbide particles at all the sintering temperatures. However, the bonding effects were very different at different temperatures.
|
|
