| 1. |
|
|
| 2. |
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
|
|
| 6. |
- van Hullebusch, E. D., et al.
(författare)
-
Nature-based units as building blocks for resource recovery systems in cities
- 2021
-
Ingår i: Water. - : MDPI AG. - 2073-4441. ; 13:22
-
Tidskriftsartikel (refereegranskat)abstract
- Cities are producers of high quantities of secondary liquid and solid streams that are still poorly utilized within urban systems. In order to tackle this issue, there has been an ever-growing push for more efficient resource management and waste prevention in urban areas, following the concept of a circular economy. This review paper provides a characterization of urban solid and liquid resource flows (including water, nutrients, metals, potential energy, and organics), which pass through selected nature-based solutions (NBS) and supporting units (SU), expanding on that characterization through the study of existing cases. In particular, this paper presents the currently implemented NBS units for resource recovery, the applicable solid and liquid urban waste streams and the SU dedicated to increasing the quality and minimizing hazards of specific streams at the source level (e.g., concentrated fertilizers, disinfected recovered products). The recovery efficiency of systems, where NBS and SU are combined, operated at a micro-or meso-scale and applied at technology readiness levels higher than 5, is reviewed. The importance of collection and transport infrastructure, treatment and recovery technology, and (urban) agricultural or urban green reuse on the quantity and quality of input and output materials are discussed, also regarding the current main circularity and application challenges.
|
|
| 7. |
|
|
| 8. |
- Lonardo, F., et al.
(författare)
-
Influence of the Heat Treatment on the Layer JC of Internal-Sn Nb3Sn Wires With Internally Oxidized Nanoparticles
- 2024
-
Ingår i: IEEE transactions on applied superconductivity (Print). - : Institute of Electrical and Electronics Engineers (IEEE). - 1051-8223 .- 1558-2515. ; 34:5
-
Tidskriftsartikel (refereegranskat)abstract
- We evaluated various heat treatments (HT) for maximizing the Nb 3 Sn layer thickness while retaining a refined grain microstructure in low filament count internal-Sn Nb 3 Sn Rod-In-Tube wires with internally oxidized nanoparticles. These wires were manufactured in our laboratory using SnO 2 as oxygen source and Nb alloys containing Ta and Zr or Hf. By reacting the wires at 650 °C for 200 hours we obtained relatively thin reaction layers but high layer critical current densities (layer J C ) of ∼3000 A/mm 2 for Hf-containing wires and ∼2700 A/mm 2 for Zr-containing wires, both at 4.2 K and 16 T. Notably, both of these values are over the layer J C threshold of 2500 A/mm 2 , which is estimated to be necessary for attaining the corresponding Future Circular Collider (FCC) target non-Cu J C of 1500 A/mm 2 . Following this heat treatment, the fine-grained Nb 3 Sn area occupies only ∼35% of the filament area for Hf-containing wires and ∼20% for Zr-containing wires. After heat treatments with a reaction step at 700 °C these values increase to 70–80% and ∼60%, respectively, with only a minor increase of the grain size. However, we observed a noticeable decrease in the layer J C for these HT. Magnetic measurements show that the high J C wires exhibit a point defect contribution from precipitates to the pinning force, which is missing in wires with depressed J C values. The higher heat treatment temperatures may have caused excessive coarsening of the oxide precipitates, to sizes unsuitable for flux pinning. Reaction heat treatment temperatures in the range of 650 °C to 700 °C and durations between 50 and 200 hours may provide a better compromise between the Nb 3 Sn layer thickness, its grain size and nanoparticle size.
|
|
| 9. |
- Zhang, Huai, et al.
(författare)
-
A global survey on the use of the international classification of diseases codes for metabolic dysfunction-associated fatty liver disease.
- 2024
-
Ingår i: Hepatology international. - 1936-0541.
-
Tidskriftsartikel (refereegranskat)abstract
- With the implementation of the 11th edition of the International Classification of Diseases (ICD-11) and the publication of the metabolic dysfunction-associated fatty liver disease (MAFLD) nomenclature in 2020, it is important to establish consensus for the coding of MAFLD in ICD-11. This will inform subsequent revisions of ICD-11.Using the Qualtrics XM and WJX platforms, questionnaires were sent online to MAFLD-ICD-11 coding collaborators, authors of papers, and relevant association members.A total of 890 international experts in various fields from 61 countries responded to the survey. We also achieved full coverage of provincial-level administrative regions in China. 77.1% of respondents agreed that MAFLD should be represented in ICD-11 by updating NAFLD, with no significant regional differences (77.3% in Asia and 76.6% in non-Asia, p=0.819). Over 80% of respondents agreed or somewhat agreed with the need to assign specific codes for progressive stages of MAFLD (i.e. steatohepatitis) (92.2%), MAFLD combined with comorbidities (84.1%), or MAFLD subtypes (i.e., lean, overweight/obese, and diabetic) (86.1%).This global survey by a collaborative panel of clinical, coding, health management and policy experts, indicates agreement that MAFLD should be coded in ICD-11. The data serves as a foundation for corresponding adjustments in the ICD-11 revision.
|
|
