| 1. |
- Mattera, Andrea, 1985-, et al.
(författare)
-
A neutron source for IGISOL-JYFLTRAP : Design and characterisation
- 2017
-
Ingår i: European Physical Journal A. - : Springer Science and Business Media LLC. - 1434-6001 .- 1434-601X. ; 53:173
-
Tidskriftsartikel (refereegranskat)abstract
- A white neutron source based on the Be(p,nx) reaction for fission studies at the IGISOLJYFLTRAP facility has been designed and tested. 30 MeV protons impinge on a 5mm thick water-cooled beryllium disc. The source was designed to produce at least 1012 fast neutrons/s on a secondary fission target, in order to reach competitive production rates of fission products far from the valley of stability.The Monte Carlo codes MCNPX and FLUKA were used in the design phase to simulate the neutron energy spectra. Two experiments to characterise the neutron field were performed: the first was carried out at The Svedberg Laboratory in Uppsala (SE), using an Extended-Range Bonner Sphere Spectrometer and a liquid scintillator which used the time-of-flight (TOF) method to determine the energy of the neutrons; the second employed Thin-Film Breakdown Counters for the measurement of the TOF, and activation foils, at the IGISOL facility in Jyväskylä (FI). Design considerations and the results of the two characterisation measurements are presented, providing benchmarks for the simulations.
|
|
| 2. |
- Mattera, Andrea, 1985-, et al.
(författare)
-
Characterization of a Be(p,xn) neutron source for fission yields measurements
- 2014
-
Ingår i: Nuclear Data Sheets. - : Elsevier BV. - 0090-3752 .- 1095-9904. ; 119, s. 416-418
-
Tidskriftsartikel (refereegranskat)abstract
- We report on measurements performed at The Svedberg Laboratory (TSL) to characterize a proton-neutron converter for independent fission yield studies at the IGISOL-JYFLTRAP facility (Jyväskylä, Finland). A 30-MeV proton beam impinged on a 5 mm water-cooled Beryllium target. Two independent experimental techniques have been used to measure the neutron spectrum: a Time-of-Flight (TOF) system to estimate the high-energy contribution, and a Bonner Sphere Spectrometer to provide precise results from thermal energies up to 20 MeV. An overlap between the energy regions covered by the two systems will permit a cross-check of the results from the different techniques. In this paper, the measurement and the analysis technique will be presented together with some preliminary results.
|
|
| 3. |
|
|
| 4. |
- Al-Adili, Ali, et al.
(författare)
-
Neutron-multiplicity experiments for enhanced fission modelling
- 2017
-
Ingår i: EPJ Web of Conferences. - : EDP Sciences. - 9782759890200
-
Konferensbidrag (refereegranskat)abstract
- The nuclear de-excitation process of fission fragments (FF) provides fundamental information for the understanding of nuclear fission and nuclear structure in neutron-rich isotopes. The variation of the prompt-neutron multiplicity, ν(A), as a function of the incident neutron energy (En) is one of many open questions. It leads to significantly different treatments in various fission models and implies that experimental data are analyzed based on contradicting assumptions. One critical question is whether the additional excitation energy (Eexc) is manifested through an increase of ν(A) for all fragments or for the heavy ones only. A systematic investigation of ν(A) as a function of En has been initiated. Correlations between prompt-fission neutrons and fission fragments are obtained by using liquid scintillators in conjunction with a Frisch-grid ionization chamber. The proof-of-principle has been achieved on the reaction 235U(nth,f) at the Van De Graff (VdG) accelerator of the JRC-Geel using a fully digital data acquisition system. Neutrons from 252Cf(sf) were measured separately to quantify the neutron-scattering component due to surrounding shielding material and to determine the intrinsic detector efficiency. Prelimenary results on ν(A) and spectrum in correlation with FF properties are presented.
|
|
| 5. |
- Al-Adili, Ali, et al.
(författare)
-
Studying fission neutrons with 2E-2v and 2E
- 2018
-
Ingår i: SCIENTIFIC WORKSHOP ON NUCLEAR FISSION DYNAMICS AND THE EMISSION OF PROMPT NEUTRONS AND GAMMA RAYS (THEORY-4). - : EDP Sciences. - 9782759890316
-
Konferensbidrag (refereegranskat)abstract
- This work aims at measuring prompt-fission neutrons at different excitation energies of the nucleus. Two independent techniques, the 2E-2v and the 2E techniques, are used to map the characteristics of the mass-dependent prompt fission neutron multiplicity, 7(A), when the excitation energy is increased. The VERDI 2E-2v spectrometer is being developed at JRC-GEEL. The Fission Fragment (FF) energies are measured using two arrays of 16 silicon (Si) detectors each. The FFs velocities are obtained by time-of-flight, measured between micro-channel plates (MCP) and Si detectors. With MCPs placed on both sides of the fission source, VERDI allows for independent timing measurements for both fragments. Cf-252(sf) was measured and the present results revealed particular features of the 2E-2v technique. Dedicated simulations were also performed using the GEF code to study important aspects of the 2E-2v technique. Our simulations show that prompt neutron emission has a non-negligible impact on the deduced fragment data and affects also the shape of 17(A). Geometrical constraints lead to a total-kinetic energy-dependent detection efficiency. The 2E technique utilizes an ionization chamber together with two liquid scintillator detectors. Two measurements have been performed, one of Cf-252(sf) and another one of thermal-neutron induced fission in U-235(n,f). Results from Cf-252(sf) are reported here.
|
|
| 6. |
- Gao, Zhihao, et al.
(författare)
-
Fission studies at IGISOL/JYFLTRAP : Simulations of the ion guide for neutron-induced fission and comparison with experimental data
- 2020
-
Ingår i: ND 2019. - : EDP Sciences. - 9782759891061
-
Konferensbidrag (refereegranskat)abstract
- For the production of exotic nuclei at the IGISOL facility, an ion guide for neutron-induced fission has been developed and tested in experiments. Fission fragments are produced inside the ion guide and collected using a helium buffer gas. Meanwhile, a GEANT4 model has been developed to simulate the transportation and stopping of the charged fission products. In a recent measurement of neutron-induced fission yields, implantation foils were located at different positions in the ion guide. The gamma spectra from these foils and the fission targets are compared to the results from the GEANT4 simulation.In order to allow fission yield measurements in the low yield regions, towards the tails and in the symmetric part of the mass distribution, the stopping and extraction efficiency of the ion guide has to be significantly improved. This objective can be achieved by increasing the size while introducing electric field guidance using a combination of static electrodes and an RF-carpet. To this end, the GEANT4 model is used to optimise the design of such an ion guide.
|
|
| 7. |
- Gorelov, D., et al.
(författare)
-
Measuring independent yields of fission products using a penning trap
- 2015
-
Ingår i: Bulletin of the Russian Academy of Sciences: Physics. - 1062-8738. ; 79:7, s. 869-871
-
Tidskriftsartikel (refereegranskat)abstract
- A new method for determining independent fission products is used in an experiment at the Accelerator Laboratory of the University of Jyväskylä. The method combines the chemical universality of the ion guide technique and the unique properties of the Penning trap. A beam of charged particles is formed by stopping fission products in gaseous helium. The Penning trap is employed as a highly accurate filter to identify particles by their mass. The yields of fission products are determined by the ion count downstream of the trap. The setup’s mass resolving power is on the order of 105 with a radio frequency excitation time of 400 ms. Such high mass resolution occasionally allows us not only to separate nuclides but to separate the isomeric and ground states of nuclei as well. Independent yields of fission products are measured in the fission reaction of the 232Th isotope by protons with an energy of 25 MeV. A short description of the method ae nd soexperimental data are supplememnted by the results fro theoretical calculations.
|
|
| 8. |
- Lantz, Mattias, 1971-, et al.
(författare)
-
Design of a neutron converter for fission studies at the IGISOL facility
- 2012
-
Ingår i: Physica Scripta. - he Royal Swedish Academy of Sciences. - 0031-8949 .- 1402-4896. ; T150, s. 014020-
-
Konferensbidrag (refereegranskat)abstract
- The upgraded IGISOL facility with JYFLTRAP, at the accelerator laboratory of the University of Jyväskylä, has been supplied with a new cyclotron which will provide proton or deuteron beams of the order of 100 μA with up to 30 MeV energy. This makes it an ideal place for measurements of neutron-induced fission fragments from various actinides, in view of proposed future nuclear fuel cycles. In the present paper, some considerations for the design ofa neutron converter, based on simulations with the Monte Carlo codes MCNPX and FLUKA,are described.
|
|
| 9. |
|
|
| 10. |
- Mattera, Andrea, 1985-, et al.
(författare)
-
A methodology for the intercomparison of nuclear fission codes using TALYS
- 2017
-
Ingår i: ND 2016. - Les Ulis : EDP Sciences. - 9782759890200
-
Konferensbidrag (refereegranskat)abstract
- Codes for the calculation of fission observables are frequently used to describe experimentally observed phenomena as well as provide predictions in cases where measurements are missing. Assumptions in the models, and tuning of parameters within the codes, often result in a good reproduction of experimental data. In this work we propose a methodology, coded in the newly developed program DELFIN (De-Excitation of FIssion fragmeNts), that can be used to compare some of the assumptions of the various models. Our code makes use of the fission fragments information after scission and processes them in an independent and consistent fashion to obtain measurable fission observables (such as ν(A) distributions and Isomeric Fission Yield ratios). All the available information from the models, such as fragments' excitation energies, spin distributions and yields are provided as input to DELFIN that uses the nuclear reaction code TALYS to handle the de-excitation of the fission fragments. In this way we decouple the fragments relaxation from the actual fission models. We report here the first results of a comparison carried out on the GEF, Point-by-Point and FREYA models for thermal fission of 235U and 239Pu and spontaneous fission of 252Cf.
|
|
