| 1. |
- Kehoe, Laura, et al.
(author)
-
Make EU trade with Brazil sustainable
- 2019
-
In: Science. - : American Association for the Advancement of Science (AAAS). - 0036-8075 .- 1095-9203. ; 364:6438, s. 341-
-
Journal article (other academic/artistic)
|
|
| 2. |
- Abelev, Betty, et al.
(author)
-
Long-range angular correlations on the near and away side in p-Pb collisions at root S-NN=5.02 TeV
- 2013
-
In: Physics Letters. Section B: Nuclear, Elementary Particle and High-Energy Physics. - : Elsevier BV. - 0370-2693. ; 719:1-3, s. 29-41
-
Journal article (peer-reviewed)abstract
- Angular correlations between charged trigger and associated particles are measured by the ALICE detector in p-Pb collisions at a nucleon-nucleon centre-of-mass energy of 5.02 TeV for transverse momentum ranges within 0.5 < P-T,P-assoc < P-T,P-trig < 4 GeV/c. The correlations are measured over two units of pseudorapidity and full azimuthal angle in different intervals of event multiplicity, and expressed as associated yield per trigger particle. Two long-range ridge-like structures, one on the near side and one on the away side, are observed when the per-trigger yield obtained in low-multiplicity events is subtracted from the one in high-multiplicity events. The excess on the near-side is qualitatively similar to that recently reported by the CMS Collaboration, while the excess on the away-side is reported for the first time. The two-ridge structure projected onto azimuthal angle is quantified with the second and third Fourier coefficients as well as by near-side and away-side yields and widths. The yields on the near side and on the away side are equal within the uncertainties for all studied event multiplicity and p(T) bins, and the widths show no significant evolution with event multiplicity or p(T). These findings suggest that the near-side ridge is accompanied by an essentially identical away-side ridge. (c) 2013 CERN. Published by Elsevier B.V. All rights reserved.
|
|
| 3. |
- Abelev, Betty, et al.
(author)
-
Measurement of prompt J/psi and beauty hadron production cross sections at mid-rapidity in pp collisions at root s=7 TeV
- 2012
-
In: Journal of High Energy Physics. - 1029-8479. ; :11
-
Journal article (peer-reviewed)abstract
- The ALICE experiment at the LHC has studied J/psi production at mid-rapidity in pp collisions at root s = 7 TeV through its electron pair decay on a data sample corresponding to an integrated luminosity L-int = 5.6 nb(-1). The fraction of J/psi from the decay of long-lived beauty hadrons was determined for J/psi candidates with transverse momentum p(t) > 1,3 GeV/c and rapidity vertical bar y vertical bar < 0.9. The cross section for prompt J/psi mesons, i.e. directly produced J/psi and prompt decays of heavier charmonium states such as the psi(2S) and chi(c) resonances, is sigma(prompt J/psi) (p(t) > 1.3 GeV/c, vertical bar y vertical bar < 0.9) = 8.3 +/- 0.8(stat.) +/- 1.1 (syst.)(-1.4)(+1.5) (syst. pol.) mu b. The cross section for the production of b-hadrons decaying to J/psi with p(t) > 1.3 GeV/c and vertical bar y vertical bar < 0.9 is a sigma(J/psi <- hB) (p(t) > 1.3 GeV/c, vertical bar y vertical bar < 0.9) = 1.46 +/- 0.38 (stat.)(-0.32)(+0.26) (syst.) mu b. The results are compared to QCD model predictions. The shape of the p(t) and y distributions of b-quarks predicted by perturbative QCD model calculations are used to extrapolate the measured cross section to derive the b (b) over bar pair total cross section and d sigma/dy at mid-rapidity.
|
|
| 4. |
- Abelev, Betty, et al.
(author)
-
Underlying Event measurements in pp collisions at root s=0.9 and 7 TeV with the ALICE experiment at the LHC
- 2012
-
In: Journal of High Energy Physics. - 1029-8479. ; :7
-
Journal article (peer-reviewed)abstract
- We present measurements of Underlying Event observables in pp collisions at root s = 0 : 9 and 7 TeV. The analysis is performed as a function of the highest charged-particle transverse momentum p(T),L-T in the event. Different regions are defined with respect to the azimuthal direction of the leading (highest transverse momentum) track: Toward, Transverse and Away. The Toward and Away regions collect the fragmentation products of the hardest partonic interaction. The Transverse region is expected to be most sensitive to the Underlying Event activity. The study is performed with charged particles above three different p(T) thresholds: 0.15, 0.5 and 1.0 GeV/c. In the Transverse region we observe an increase in the multiplicity of a factor 2-3 between the lower and higher collision energies, depending on the track p(T) threshold considered. Data are compared to PYTHIA 6.4, PYTHIA 8.1 and PHOJET. On average, all models considered underestimate the multiplicity and summed p(T) in the Transverse region by about 10-30%.
|
|
| 5. |
|
|
| 6. |
- Zamora, Juan Carlos, et al.
(author)
-
Considerations and consequences of allowing DNA sequence data as types of fungal taxa
- 2018
-
In: IMA Fungus. - : INT MYCOLOGICAL ASSOC. - 2210-6340 .- 2210-6359. ; 9:1, s. 167-185
-
Journal article (peer-reviewed)abstract
- Nomenclatural type definitions are one of the most important concepts in biological nomenclature. Being physical objects that can be re-studied by other researchers, types permanently link taxonomy (an artificial agreement to classify biological diversity) with nomenclature (an artificial agreement to name biological diversity). Two proposals to amend the International Code of Nomenclature for algae, fungi, and plants (ICN), allowing DNA sequences alone (of any region and extent) to serve as types of taxon names for voucherless fungi (mainly putative taxa from environmental DNA sequences), have been submitted to be voted on at the 11th International Mycological Congress (Puerto Rico, July 2018). We consider various genetic processes affecting the distribution of alleles among taxa and find that alleles may not consistently and uniquely represent the species within which they are contained. Should the proposals be accepted, the meaning of nomenclatural types would change in a fundamental way from physical objects as sources of data to the data themselves. Such changes are conducive to irreproducible science, the potential typification on artefactual data, and massive creation of names with low information content, ultimately causing nomenclatural instability and unnecessary work for future researchers that would stall future explorations of fungal diversity. We conclude that the acceptance of DNA sequences alone as types of names of taxa, under the terms used in the current proposals, is unnecessary and would not solve the problem of naming putative taxa known only from DNA sequences in a scientifically defensible way. As an alternative, we highlight the use of formulas for naming putative taxa (candidate taxa) that do not require any modification of the ICN.
|
|
| 7. |
- Bernal, Ximena E., et al.
(author)
-
Empowering Latina scientists
- 2019
-
In: Science. - : American Association for the Advancement of Science (AAAS). - 0036-8075 .- 1095-9203. ; 363:6429, s. 825-826
-
Journal article (other academic/artistic)
|
|
| 8. |
- Aitomäki, Yvonne, et al.
(author)
-
Vacuum infusion of cellulose nanofibre network composites : Influence of porosity on permeability and impregnation
- 2016
-
In: Materials & design. - : Elsevier BV. - 0264-1275 .- 1873-4197. ; 95, s. 204-211
-
Journal article (peer-reviewed)abstract
- Addressing issues around the processing of cellulose nanofibres (CNF) composites is important in establishing their use as sustainable, renewable polymer reinforcements. Here, CNF networks of different porosity were made with the aim of increasing their permeability and suitability for processing by vacuum infusion (VI). The CNF networks were infused with epoxy using two different strategies. The permeability, morphology and mechanical properties of the dry networks and the resulting nanocomposites were investigated. Calculated fill-times for CNF networks with 50% porosity were the shortest, but are only less than the gel-time of the epoxy if capillary effects are included. In experiments the CNF networks were clearly wetted. However low transparency indicated that impregnation was incomplete. The modulus and strength of the dry CNF networks increased rapidly with decreasing porosity, but their nanocomposites did not follow this trend, showing instead similar mechanical properties to each other. The results demonstrated that increasing the porosity of the CNF networks to ≈ 50% gives better impregnation resulting in a lower ultimate strength, a higher yield strength and no loss in modulus. Better use of the flow channels in the inherently layered CNF networks could potentially reduce void content in these nanocomposites and thus increase their mechanical properties.
|
|
| 9. |
- Aitomäki, Yvonne, et al.
(author)
-
Vacuum Infusion of Nanocellulose Networks of Different Porosity
- 2015
-
In: 20th International Conference on Composite Materials. - : ICCM.
-
Conference paper (peer-reviewed)abstract
- Cellulose nanofibres (CNF) have shown good potential as sustainable, biobased reinforcing materials in polymer composites. Addressing issues around the processing of these composites is an important part of establishing their use in different applications. Here, CNF networks of different porosity are made from nanofibrillated hardwood kraft pulp with the aim of increasing the impregnation of the CNF networks and to allow vacuum infusion to be used. Two different vacuum infusion strategies: in-plane and out of plane were used to infuse the CNF networks with a low viscosity epoxy. The permeability, morphology and mechanical properties of the dry networks and the resulting nanocomposites were investigated and compared to a micro-fibre based network. Using the out-of-plane permeability measurements and Darcy’s law, the fill-time was calculated and showed that the CNF network with 40% porosity had the lowest fill-time when an out-of-plane impregnation strategy is used. However this exceeded the gel-time of the epoxy system. In experiments, the resin reached the other side of the network but low transparency indicated that wetting was poor. The dry CNF preforms showed a very strong dependence on the porosity with both modulus and strength increasing rapidly at low porosity. Interestingly, the composite based on the 60% porosity network showed good wetting particularly with the in-plane infusion strategy, exhibiting a much more brittle fracture and a high yield strength. This shows that in CNF composites produced by VI, lowering the fibre volume content of the CNF composites gives better impregnation resulting in a lower ultimate strength but higher yield strength and no loss in modulus.
|
|
| 10. |
- Akiyama, Kazunori, et al.
(author)
-
The persistent shadow of the supermassive black hole of M 87: I. Observations, calibration, imaging, and analysis*
- 2024
-
In: Astronomy and Astrophysics. - 0004-6361 .- 1432-0746. ; 681
-
Journal article (peer-reviewed)abstract
- In April 2019, the Event Horizon Telescope (EHT) Collaboration reported the first-ever event-horizon-scale images of a black hole, resolving the central compact radio source in the giant elliptical galaxy M 87. These images reveal a ring with a southerly brightness distribution and a diameter of ∼42 μas, consistent with the predicted size and shape of a shadow produced by the gravitationally lensed emission around a supermassive black hole. These results were obtained as part of the April 2017 EHT observation campaign, using a global very long baseline interferometric radio array operating at a wavelength of 1.3 mm. Here, we present results based on the second EHT observing campaign, taking place in April 2018 with an improved array, wider frequency coverage, and increased bandwidth. In particular, the additional baselines provided by the Greenland telescope improved the coverage of the array. Multiyear EHT observations provide independent snapshots of the horizon-scale emission, allowing us to confirm the persistence, size, and shape of the black hole shadow, and constrain the intrinsic structural variability of the accretion flow. We have confirmed the presence of an asymmetric ring structure, brighter in the southwest, with a median diameter of 43.3-3.1+1.5 μas. The diameter of the 2018 ring is remarkably consistent with the diameter obtained from the previous 2017 observations. On the other hand, the position angle of the brightness asymmetry in 2018 is shifted by about 30 relative to 2017. The perennial persistence of the ring and its diameter robustly support the interpretation that the ring is formed by lensed emission surrounding a Kerr black hole with a mass ∼6.5× 109M. The significant change in the ring brightness asymmetry implies a spin axis that is more consistent with the position angle of the large-scale jet.
|
|
