| 1. |
- Aakko-Saksa, Païvi T., et al.
(författare)
-
Renewable Methanol with Ignition Improver Additive for Diesel Engines
- 2020
-
Ingår i: Energy and Fuels. - : American Chemical Society (ACS). - 0887-0624 .- 1520-5029.
-
Tidskriftsartikel (refereegranskat)abstract
- Reduced emissions and environmental burden from shipping are an important aim of tightening emission regulations and ambitious climate change strategy. Renewable methanol produced from biomass or from other renewable sources represents one option to face these challenges. We studied the potential of renewable methanol to offer such benefits in diesel operation in a Scania ethanol engine, which is designed for additized ethanol fuel (ED95) containing ignition improver and lubricity additives. Methanol (MD95) with several types of ignition improver and lubricity additives was studied for use in diesel engines. MD95 fuels were clean-burning, emitting even less gaseous emissions than ED95, particularly when glycerol ethoxylate was used as an ignition improver. Particle mass and number emissions originating from additives in the experimental fuels could be reduced with an oxidation catalyst. Reduced additive dosing in the MD95 fuels was studied with the aid of fuel injection into the intake manifold. Overall, the results showed that the monofuel MD95 concept is a promising solution for smaller vessels equipped with 800-1200 kW engines. ©
|
|
| 2. |
- Karjalainen, Panu, et al.
(författare)
-
Time-resolved characterization of primary particle emissions and secondary particle formation from a modern gasoline passenger car
- 2016
-
Ingår i: Atmospheric Chemistry and Physics. - : Copernicus GmbH. - 1680-7316 .- 1680-7324. ; 16:13, s. 8559-8570
-
Tidskriftsartikel (refereegranskat)abstract
- Changes in vehicle emission reduction technologies significantly affect traffic-related emissions in urban areas. In many densely populated areas the amount of traffic is increasing, keeping the emission level high or even increasing. To understand the health effects of traffic-related emissions, both primary (direct) particulate emission and secondary particle formation (from gaseous precursors in the exhaust emissions) need to be characterized. In this study, we used a comprehensive set of measurements to characterize both primary and secondary particulate emissions of a Euro 5 level gasoline passenger car. Our aerosol particle study covers the whole process chain in emission formation, from the tailpipe to the atmosphere, and also takes into account differences in driving patterns. We observed that, in mass terms, the amount of secondary particles was 13 times higher than the amount of primary particles. The formation, composition, number and mass of secondary particles was significantly affected by driving patterns and engine conditions. The highest gaseous and particulate emissions were observed at the beginning of the test cycle when the performance of the engine and the catalyst was below optimal. The key parameter for secondary particle formation was the amount of gaseous hydrocarbons in primary emissions; however, also the primary particle population had an influence.
|
|
| 3. |
- Timonen, Hilkka, et al.
(författare)
-
Influence of fuel ethanol content on primary emissions and secondary aerosol formation potential for a modern flex-fuel gasoline vehicle
- 2017
-
Ingår i: Atmospheric Chemistry and Physics. - : Copernicus GmbH. - 1680-7316 .- 1680-7324. ; 17:8, s. 5311-5329
-
Tidskriftsartikel (refereegranskat)abstract
- The effect of fuel ethanol content (10, 85 and 100 %) on primary emissions and on subsequent secondary aerosol formation was investigated for a Euro 5 flex-fuel gasoline vehicle. Emissions were characterized during a New European Driving Cycle (NEDC) using a comprehensive setup of high time-resolution instruments. A detailed chemical composition of the exhaust particulate matter (PM) was studied using a soot particle aerosol mass spectrometer (SPAMS), and secondary aerosol formation was studied using a potential aerosol mass (PAM) chamber. For the primary gaseous compounds, an increase in total hydrocarbon emissions and a decrease in aromatic BTEX (benzene, toluene, ethylbenzene and xylenes) compounds was observed when the amount of ethanol in the fuel increased. In regard to particles, the largest primary particulate matter concentrations and potential for secondary particle formation was measured for the E10 fuel (10% ethanol). As the ethanol content of the fuel increased, a significant decrease in the average primary particulate matter concentrations over the NEDC was found. The PM emissions were 0.45, 0.25 and 0.15 mgm-3 for E10, E85 and E100, respectively. Similarly, a clear decrease in secondary aerosol formation potential was observed with a larger contribution of ethanol in the fuel. The secondary-toprimary PM ratios were 13.4 and 1.5 for E10 and E85, respectively. For E100, a slight decrease in PM mass was observed after the PAM chamber, indicating that the PM produced by secondary aerosol formation was less than the PM lost through wall losses or the degradation of the primary organic aerosol (POA) in the chamber. For all fuel blends, the formed secondary aerosol consisted mostly of organic compounds. For E10, the contribution of organic compounds containing oxygen increased from 35 %, measured for primary organics, to 62% after the PAM chamber. For E85, the contribution of organic compounds containing oxygen increased from 42% (primary) to 57% (after the PAM chamber), whereas for E100 the amount of oxidized organics remained the same (approximately 62 %) with the PAM chamber when compared to the primary emissions.
|
|
