| 1. |
|
|
| 2. |
- Anniyev, Toyli, et al.
(författare)
-
Complementarity between high-energy photoelectron and L-edge spectroscopy for probing the electronic structure of 5d transition metal catalysts
- 2010
-
Ingår i: Physical Chemistry, Chemical Physics - PCCP. - : Royal Society of Chemistry (RSC). - 1463-9076 .- 1463-9084. ; 12:21, s. 5694-5700
-
Tidskriftsartikel (refereegranskat)abstract
- We demonstrate the successful use of hard X-ray photoelectron spectroscopy (HAXPES) for selectively probing the platinum partial d-density of states (DOS) in a Pt-Cu nanoparticle catalyst which shows activity superior to pure Pt towards the oxygen-reduction reaction (ORR). The information about occupied Pt d-band states was complemented by Pt L-2-edge X-ray absorption near-edge spectroscopy (XANES), which probes unoccupied valence states. We found a significant electronic perturbation of the Pt projected d-DOS which was narrowed and shifted to higher binding energy compared to pure platinum. The effect of this electronic structure perturbation on the chemical properties of the nanoparticle surface is discussed in terms of the d-band model. We have thereby demonstrated that the combination of L-edge spectroscopy and HAXPES allows for an experimental derivation of the valence electronic structure in an element-specific way for 5d metal catalysts.
|
|
| 3. |
- Eriksson, Anders, et al.
(författare)
-
Arc deposition of Ti–Si–C–N thin films from binary and ternary cathodes — Comparing sources of C
- 2012
-
Ingår i: Surface & Coatings Technology. - : Elsevier. - 0257-8972 .- 1879-3347. ; 213, s. 145-154
-
Tidskriftsartikel (refereegranskat)abstract
- Ti–Si–C–N thin films with composition of 1–11 at.% Si and 1–20 at.% C have been deposited onto cemented carbide substrates by arcing Ti–Si cathodes in a CH4 + N2 gas mixture and, alternatively, through arcing Ti–Si–C cathodes in N2. Films of comparable compositions from the two types of cathodes have similar structure and properties. Hence, C can be supplied as either plasma ions generated from the cathode or atoms from the gas phase with small influence on the structural evolution. Over the compositional range obtained, the films were dense and cubic-phase nanocrystalline, as characterized by X-ray diffraction, ion beam analysis, and scanning and transmission electron microscopy. The films have high hardness (30–40 GPa by nanoindentation) due to hardening from low-angle grain boundaries on the nanometer scale and lattice defects such as growth-induced vacancies and alloying element interstitials.
|
|
| 4. |
- Goyenola, Cecilia, et al.
(författare)
-
Theoretical prediction and synthesis of CSxFy thin films
- 2016
-
Ingår i: The Journal of Physical Chemistry C. - : American Chemical Society (ACS). - 1932-7447 .- 1932-7455. ; 120:17, s. 9527-9534
-
Tidskriftsartikel (refereegranskat)abstract
- A new carbon-based compound: CSxFy was addressed by density functional theory calculations and synthesized by reactive magnetron sputtering. Geometry optimizations and energy calculations were performed on graphene-like model systems containing sulfur and fluorine atoms. It is shown that [S+F] concentrations in the range of 0−10 at.%, structural ordered characteristics similar to graphene pieces containing ring defects are energetically feasible. The modeling predicts that CSxFy thin films with graphite and fullerene-like characteristics may be obtained for the mentioned concentration range. Accordingly, thin films were synthesized from a graphite solid target and sulfur hexafluoride as reactive gas. In agreement with the theoretical prediction, transmission electron microscopy characterization and selected area electron diffraction confirmed the presence of small ordered clusters with graphitic features in a sample containing 0.4 at.% of S and 3.4 at.% of F.
|
|
| 5. |
- Halim, Joseph, et al.
(författare)
-
Transparent Conductive Two-Dimensional Titanium Carbide Epitaxial Thin Films
- 2014
-
Ingår i: Chemistry of Materials. - : American Chemical Society. - 0897-4756 .- 1520-5002. ; 26:7, s. 2374-2381
-
Tidskriftsartikel (refereegranskat)abstract
- Since the discovery of graphene, the quest for two-dimensional (2D) materials has intensified greatly. Recently, a new family of 2D transition metal carbides and carbonitrides (MXenes) was discovered that is both conducting and hydrophilic, an uncommon combination. To date MXenes have been produced as powders, flakes, and colloidal solutions. Herein, we report on the fabrication of similar to 1 x 1 cm(2) Ti3C2 films by selective etching of Al, from sputter-deposited epitaxial Ti3AlC2 films, in aqueous HF or NH4HF2. Films that were about 19 nm thick, etched with NH4HF2, transmit similar to 90% of the light in the visible-to-infrared range and exhibit metallic conductivity down to similar to 100 K. Below 100 K, the films resistivity increases with decreasing temperature and they exhibit negative magnetoresistance-both observations consistent with a weak localization phenomenon characteristic of many 2D defective solids. This advance opens the door for the use of MXenes in electronic, photonic, and sensing applications.
|
|
| 6. |
- Halim, Joseph, et al.
(författare)
-
X-ray Photoelectron Spectroscopy Characterization of Two-Dimensional Titanium Metal Carbides (MXenes)
- 2014
-
Annan publikation (övrigt vetenskapligt/konstnärligt)abstract
- Herein, we report X-ray Photoelectron Spectroscopy (XPS) analysis for cold pressed exfoliated 2D nanocrystals of transition metal carbides, MXenes. MXenes are a recently discovered family of 2D materials produced by selective chemical etching of the A element from MAX phases which are ternary metal carbides and nitrides. The latter has the formula of Mn+1AXn, where M is an early transition metal, A is an A-group element, and X is C and/or N. This study is a comparison between two MXenes, Ti3C2Tx and Ti2CTx, where Tx stands for surface termination groups such as –O, –OH, and –F. Ti3C2Tx and Ti2CTx were prepared by immersion of Ti3AlC2 and Ti2AlC powders in 50% conc. HF. A thorough XPS analysis was performed through peak fitting of high resolution XPS spectra and valence band, VB, spectra analysis. The effect of Ar sputtering as well as the number of layers n was the primarily interest of this study. According to the peak fitting analysis, both phases contain the following species, Ti–C, C–C, Ti–F, Ti–O and Ti–OH resulting in the following chemical formulas: Ti3C2(OH)x(O)y(F)z and Ti2C(OH)x(O)y(F)z. Comparing the VB spectra with the DOS calculations show the valance band spectra is actually a mixture of MXene with various terminations of OH, O and F. Before Ar+ sputtering both phases show a large percentage of fluorinated-TiO2 which is due to MXene surface oxidation as well as CHx, C-O and COO groups arising from either surface contaminations or due to drying the etched powders in ethanol after washing the powder of the HF acid. According to the VB spectra, it is shown that the fluorinated TiO2 is actually a mixture of anatase and rutile. The number of layers, n, also plays a role; the lower n, the more the MXene is prone to oxidation.
|
|
| 7. |
- Högberg, Hans, et al.
(författare)
-
Reactive sputtering of CSx thin solid films using CS2 as precursor
- 2020
-
Ingår i: Vacuum. - : PERGAMON-ELSEVIER SCIENCE LTD. - 0042-207X .- 1879-2715. ; 182
-
Tidskriftsartikel (refereegranskat)abstract
- We deposit CSx thin solid films by reactive direct current magnetron sputtering of a C target in an argon plasma, using carbon disulfide (CS2) as a precursor to film growth. We investigate the influence of the partial pressure of the CS2 vapor introduced into the plasma on the composition, the chemical bonding structure, the structural, and the mechanical properties as determined by x-ray photoelectron spectroscopy (XPS), Raman spectroscopy, scanning electron microscopy (SEM), and nanoindentation for films deposited at 150 and 300 degrees C. The Raman and the XPS results indicate that S atoms are incorporated in mostly sp(2) bonded C network. These results agree with previous ab-initio theoretical findings obtained by modeling of the CSx compound by the Synthetic Growth Concept. The microstructure of the films as well as the results of their Raman characterization and the nano mechanical testing results all point out that with the increasing S content some spa bonding is admixed in the predominantly sp(2) bonded CSx network, leading to typical amorphous structure with short and interlocked graphene-like planes for S contents between 2% and 8%. We conclude that CSx thin solid films deposited by using CS2 as a precursor would be CSx films deposited at low temperature of similar to 150 degrees C and with an S content in the region of 6 at.% may be interesting candidates for applications as hard/elastic protective coatings.
|
|
| 8. |
- Lai, Chung-Chuan, et al.
(författare)
-
Structural and chemical determination of the new nanolaminated carbide Mo2Ga2C from first principles and materials analysis
- 2015
-
Ingår i: Acta Materialia. - : PERGAMON-ELSEVIER SCIENCE LTD. - 1359-6454 .- 1873-2453. ; 99, s. 157-164
-
Tidskriftsartikel (refereegranskat)abstract
- Following our recent discovery of a new nanolaminated carbide, Mo2Ga2C, we herein present a detailed structural and chemical analysis of this phase based on ab initio calculations, X-ray photoelectron spectroscopy, high resolution scanning transmission electron microscopy, and neutron powder diffraction. Calculations suggest an energetically and dynamically stable structure for C in the octahedral sites between the Mo layers, with Ga bilayers - stacked in a simple hexagonal arrangement - between the Mo2C layers. The predicted elastic properties are below those of the related nanolaminate Mo2GaC. The predicted structure, including lattice parameters and atomic positions, is experimentally confirmed. (C) 2015 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
|
|
| 9. |
- Lai, Chung-Chuan, et al.
(författare)
-
Synthesis and properties of CSxFy thin films deposited by reactive magnetron sputtering in an Ar/SF6 discharge
- 2017
-
Ingår i: Journal of Physics. - : IOP PUBLISHING LTD. - 0953-8984 .- 1361-648X. ; 29:19
-
Tidskriftsartikel (refereegranskat)abstract
- A theoretical and experimental study on the growth and properties of a ternary carbon-based material, CSxFy, synthesized from SF6 and C as primary precursors is reported. The synthetic growth concept was applied to model the possible species resulting from the fragmentation of SF6 molecules and the recombination of S-F fragments with atomic C. The possible species were further evaluated for their contribution to the film growth. Corresponding solid CSxFy thin films were deposited by reactive direct current magnetron sputtering from a C target in a mixed Ar/SF6 discharge with different SF6 partial pressures (P-SF6). Properties of the films were determined by x-ray photoelectron spectroscopy, x-ray reflectivity, and nanoindentation. A reduced mass density in the CSxFy films is predicted due to incorporation of precursor species with a more pronounced steric effect, which also agrees with the low density values observed for the films. Increased P-SF6 leads to decreasing deposition rate and increasing density, as explained by enhanced fluorination and etching on the deposited surface by a larger concentration of F/F-2 species during the growth, as supported by an increment of the F relative content in the films. Mechanical properties indicating superelasticity were obtained from the film with lowest F content, implying a fullerene-like structure in CSxFy compounds.
|
|
| 10. |
- Miller, Daniel J., et al.
(författare)
-
Low O-2 dissociation barrier on Pt(111) due to adsorbate-adsorbate interactions
- 2010
-
Ingår i: Journal of Chemical Physics. - : American Institute of Physics. - 0021-9606 .- 1089-7690. ; 133:22, s. 224701-
-
Tidskriftsartikel (refereegranskat)abstract
- O2 dissociation on Pt(111) has been followed at low and saturation coverage using temperature-programmed x-ray photoelectron spectroscopy and simulated with mean-field kinetic modeling, yielding dissociation (Ea) and desorption (Ed) barriers of 0.32 and 0.36 eV, respectively. DFT calculations show that Ea is strongly influenced by the O–O interatomic potential in the atomic final state: of the supercells considered, that which maximizes attractive third-nearest-neighbor interactions in the atomic final state yields both the lowest computed dissociation barrier (0.24 eV) and the best agreement with experiment. It is proposed that the effect of adsorbate-adsorbate interactions must be considered when modeling catalytic processes involving dissociative steps.
|
|
