| 1. |
|
|
| 2. |
- Arvidsson, Inger, et al.
(författare)
-
Discrepancies in pain presentation caused by adverse psychosocial conditions as compared to pain due to high physical workload?
- 2012
-
Ingår i: Work: A Journal of Prevention, Assessment & Rehabilitation. - 1875-9270. ; 41, s. 2472-2475
-
Tidskriftsartikel (refereegranskat)abstract
- Disorders in the musculoskeletal system have been associated with a high physical workload as well as psychosocial and individual factors. It is however not obvious which of these factors that is most important to prevent. Musculoskeletal disorders in neck and upper extremity was assessed by interview and clinical examination in 79 teachers and 93 assisting nurses, all females. Psychosocial work environment was assessed by questionnaire. The physical workload was recorded by technical measurements of postures, movements and muscular load, in 9 teachers and 12 nurses. The physical workload was lower among the teachers, but they had a more demanding psychosocial work environment. Among the nurses, but not in the teachers, the neck-shoulder disorders were associated with a high body mass index (BMI). The teachers reported neck-shoulder complaints to a higher extent than the nurses, but had much lower prevalence of diagnoses in the clinical examination (12% vs. 25%; POR 0.3 CI 0.1 - 1.2; adjusted for age and BMI). The results suggest that adverse psychosocial conditions among the teachers give rise to a different kind of pain in the neck-shoulder region than from physical overload, troublesome but not as severe as the one afflicting the nurses.
|
|
| 3. |
- Arvidsson, Inger, et al.
(författare)
-
Rationalization in meat cutting - Consequences on physical workload.
- 2012
-
Ingår i: Applied Ergonomics. - : Elsevier BV. - 1872-9126 .- 0003-6870. ; 43:6, s. 1026-1032
-
Tidskriftsartikel (refereegranskat)abstract
- Meat cutting is associated with several ergonomic risk factors and a high risk of musculoskeletal disorders. The development of new production systems points to an increased degree of mechanization; instead of subdividing split carcasses of pigs with a knife, the halves are trisected by an electrical saw into 'sixth-parts', resulting in shorter work cycles for the workers. Recently, machine-directed line-production systems have been implemented. This study evaluates differences in the physical workload between the production systems. The postures and movements (inclinometry and goniometry) and muscular load (electromyography) of workers in the split-carcass- (five subjects), sixth-part- (ten) and line-production systems (five) were recorded. Most measures showed a statistically significant trend of declining physical exposure with increasing degrees of mechanization. For example, movement velocities of the upper arm were higher in the split-carcass system (50th percentile: mean 209°/s) than in the sixth-part (103°/s) and line production (81°/s). However, the latter two were not statistically significantly different. A novel method for quantifying posture variation, based on inclinometry, showed that the split-carcass system implied the highest variation of the upper arm postures "within-minute" (i.e., a high range of motion each minute), but the lowest "between-minute" (i.e., a low variation during the course of the workday). In conclusion, the physical workload in the line-production system was significantly lower than in the split-carcass one, and tended also to be lower than in the sixth-part system. However, there may be disadvantages in line production, such as machine-directed work pace and shorter work cycles.
|
|
| 4. |
|
|
| 5. |
- Balogh, Istvan, et al.
(författare)
-
Increasing the Degree of Automation in a Production System: Consequences for the physical workload
- 2006
-
Ingår i: International Journal of Industrial Ergonomics. - : Elsevier BV. - 1872-8219 .- 0169-8141. ; 36:4, s. 353 - 365
-
Tidskriftsartikel (refereegranskat)abstract
- In spite of the continuous development of production systems work-related musculoskeletal disorders is still a large problem. One reason might be the difficulties in quantifying the ergonomic effects of interventions. In this paper ergonomic consequences of technical and organisational changes were quantified in a plant for producing slats for parquet flooring. Muscle activity, work postures and movements were assessed for neck/shoulders and upper limb by direct technical measurements at three generations of production lines. The physical workload for 31 operators at the manual, semi-automated and automated line was derived based on all existing work tasks. The work was characterised by moderate muscular loads, the 50th percentiles being 1.2-3.8%MVE for the neck/shoulder muscles, high repetitiveness and constant movements of the hands and a high prevalence of neck/shoulder disorders. There were statistically significant differences considering exposure levels between the work tasks within each line as well as between the lines. The semi-automated line implied reduced muscular load for all muscles registered but more constrained work postures. The automated line, on the other hand, required higher skills, offered less constrained postures, lower loads and repetitiveness for the hands as well as frequent changes between different physical load levels. Relevance to industry: When designing or redesigning production systems, technical solutions are often used to obtain 'beneficial' ergonomic conditions, implying a strive for low physical workloads. However, there is a risk that this might lead to more constrained physical activities. Possibilities for job enlargement must be thoroughly utilised. © 2006 Elsevier B.V. All rights reserved.
|
|
| 6. |
|
|
| 7. |
- Balogh, Istvan, et al.
(författare)
-
Precision of measurements of physical workload during standardized manual handling part III: Goniometry of the wrists.
- 2009
-
Ingår i: Journal of Electromyography & Kinesiology. - : Elsevier BV. - 1873-5711 .- 1050-6411. ; 19:5, s. 1005-1012
-
Tidskriftsartikel (refereegranskat)abstract
- Goniometry of the wrist is a feasible method for studying wrist movements in most hand-intensive work. The precision and accuracy of the method per se is good. For the knowledge on validity of field measurements, the size of imprecision is of importance. This study evaluated this condition during standardized circumstances. Six women performed three different hand-intensive work tasks: 'materials picking', 'light assembly', and 'heavy assembly', repeated during three different days. Variance components between-days (within subjects) and between-subjects were derived for positions (flexion/extension and deviation) and movements, including angular velocities, % of time with very low velocity (<1 degrees /s), as well as repetitiveness. For positions, the average standard deviations in the three tasks were, both between-days and between-subjects, 3-4 degrees . For movements, the coefficients of variation of angular velocities were about 10% between-days, and could to a great part be explained by differences in work rate. Between-subjects variability was higher, 20-40%. The variability was larger at low velocities than at high ones. The precision of the measured positions was good, expressed as small between-days and between-subjects variability. For movements, the between-days variability was also small, while there was a larger between-subjects variability. The imprecision of goniometry is consequently lower and comparable with inclinometry but lower than for EMG.
|
|
| 8. |
- Balogh, Istvan, et al.
(författare)
-
Questionnaire-based mechanical exposure indices for large population studies--reliability, internal consistency and predictive validity
- 2001
-
Ingår i: Scandinavian Journal of Work, Environment and Health. - 0355-3140. ; 27:1, s. 41-41
-
Tidskriftsartikel (refereegranskat)abstract
- OBJECTIVES: This study attempts to construct valid indices for mechanical exposure of the shoulder-neck region with relation to the development of shoulder-neck pain in a 1-year perspective study of a general population. METHODS: A comprehensive questionnaire was presented to 14 556 subjects aged 45 or 65 years and repeated after 12 months. Twenty-four questions concerning positions, movements, and manual materials handling were registered on a 3-point impact scale. Musculoskeletal problems were reported on a slightly modified version of the Standardized Nordic Questionnaire for the Analysis of Musculoskeletal Symptoms. Test-retest stability after 2 weeks was calculated for 232 consecutive participants. Based on mechanistic theories, 4 exposure indices were formed. Another 5 constructs were obtained by factor analysis. RESULTS: All the indices showed good test-retest stability, and 5 of them had very good internal consistency. Due to overlaps between the indices, 2 indices stood out as having unique properties. One of them concerned mainly postures and the other dealt primarily with measured lifting. However, the latter was not related to the shoulder-neck pain outcome when adjusted for the posture index. The posture index showed an exposure-effect relationship with the outcome. The job titles implied a large degree of exposure misclassification. CONCLUSIONS: The posture index is recommended as a mechanical exposure index for analyses of interaction with other possible determinants of shoulder-neck pain (ie, psychosocial factors). The use of such an index instead of job titles in large population studies will reduce the risk of misclassification.
|
|
| 9. |
- Balogh, Istvan, et al.
(författare)
-
Self-assessed and directly measured occupational physical activities - influence of musculoskeletal complaints, age and gender
- 2004
-
Ingår i: Applied Ergonomics. - : Elsevier BV. - 1872-9126 .- 0003-6870. ; 35:1, s. 49-56
-
Tidskriftsartikel (refereegranskat)abstract
- This study compares questionnaire assessed physical activity with direct technical measurements among cleaners and office workers, stratified regarding age, gender and self-reported neck/shoulder complaints. During two full working days number of steps was recorded by a pedometer, sitting/standing positions by a posimeter and heart rate by a Sport-Tester. In addition the subjects kept a work task diary for 10 days. There were high intra-individual variations in exposure between the days. Subjects with complaints rated their exposure higher than those without, although they in fact showed lower direct measured exposure. This may imply underestimation of exposure-effect relationships. Rate of perceived exertion showed low correlation with heart rate ratio within the two occupational groups, but high, 0.64 when the two groups were combined. Age and complaints explained 31% of the variance for the cleaners.
|
|
| 10. |
- Balogh, Istvan, et al.
(författare)
-
The importance of work organization on workload and musculoskeletal health - Grocery store work as a model.
- 2016
-
Ingår i: Applied Ergonomics. - : Elsevier BV. - 1872-9126 .- 0003-6870. ; 53:Part A, s. 143-151
-
Tidskriftsartikel (refereegranskat)abstract
- We have evaluated the consequences of work organization on musculoskeletal health. Using a postal questionnaire, answered by 1600 female grocery store workers, their main work tasks were identified and four work groups were defined (cashier, picking, and delicatessen work, and a mixed group, who performed a mix of these tasks). The crude odds ratios (ORs) for neck/shoulder complaints were 1.5 (95% CI 1.0-2.2), 1.1 (0.7-1.5) and 1.6 (1.1-2.3), respectively, compared to mixed work. Adjusting for individual and psychosocial factors had no effect on these ORs. For elbows/hands, no significant differences were found. Technical measurements of the workload showed large differences between the work groups. Picking work was the most strenuous, while cashier work showed low loads. Quantitative measures of variation revealed for mixed work high between minutes variation and the highest between/within minutes variation. Combining work tasks with different physical exposure levels increases the variation and may reduce the risk of musculoskeletal complaints.
|
|
