| 1. |
- Lin, Chang, et al.
(författare)
-
Novel similarities in the free-surface profiles and velocities of solitary waves traveling over a very steep beach
- 2020
-
Ingår i: Physics of fluids. - : AMER INST PHYSICS. - 1070-6631 .- 1089-7666. ; 32:8
-
Tidskriftsartikel (refereegranskat)abstract
- This study investigates experimentally similarity and Froude number similitude (FNS) in the dimensionless flow features of three solitary waves traveling on a 1:3 sloping beach. These three waves, designated as cases A, B, and C, respectively, have different heights H-0 (=5.8 cm, 2.9 cm, and 1.815 cm) and still water depths h(0) (=16.0 cm, 8.0 cm, and 5.0 cm), but identical ratios H-0/h(0) (=0.363). A high-speed particle image velocimetry system is employed to obtain the free surface profiles (FSPs) and velocity fields/profiles. These features include the free surface elevation (FSE)/FSP time series; velocity fields and profiles, positions, and propagation speeds of flow demarcation curves; times and maximum onshore distances of the maximum run-up heights (MRHs); and times and onshore distances of hydraulic jumps for cases A and B. When the swash tip of a solitary wave reaches the MRH, the contact point becomes almost immobile for a short time interval, with the contact angle changing from obtuse, via right, to acute angle. For cases A and B, the similarities in the dimensionless MRHs and times, at which the run-down motions of the wave tips start, are affirmed. These facts highlight that the swash tips and contact points are subject to complex interactions among gravity force, viscous friction, and surface tension of fluid. Case C, having the smallest length scale, is only focused on the arrival or starting time of the MRH or run-down motion and the MRH and used as a counterexample to demonstrate the absence of similarity or FNS due to the relatively prominent effects of viscous friction and surface tension.
|
|
| 2. |
- Liu, Bilong, 1970-
(författare)
-
Acoustical Characteristics of Aircraft Panels
- 2006
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- A deterministic approach based on a modal expansion and modal receptance method has been developed to evaluate the airborne sound insulation of aircraft panels with stringer and ring frame attachments. Furthermore, this method was extended to predict the noise radiation of stiffening panel subjected to TBL excitation. This approach integrates with the fast and accurate methods in evaluating the modal excitation terms and modal radiation efficiency. Based on these advantages, the effects of the curvature, overpressure, stringers, ring frames, hydrodynamic coincidence, composite structures and structural dissipation on the acoustical properties of a typical aircraft panel are able to be investigated efficiently.Theoretic predictions were compared with laboratory measurements conducted on both model structures and aircraft panels. It was found that a small curvature may result in significant deterioration of the sound transmission loss at frequencies of interest. Unlike a flat uniform panel, the theoretical prediction for curved panels from the infinite model can not provide good agreement with the measurement close to and well below the ring frequency. However, in this frequency range, the finite model has been proved to be applicableFor the large curved airplane panels studied here, it was found that the ring frames have little influence on sound transmission loss in the frequency range of interest. However the stringers may have considerable influence on sound transmission loss. The stringer improves this for a curved panel around the ring frequency, but it may result in a potential deterioration of the sound transmission loss above the ring frequency. In this study it is evident that the sound transmission loss of the composite skin attached with composite stringers is lower than that of the metallic panel attached with metallic stringers.At frequencies higher than the corresponding ring frequency of the curved panel, both experiment and theoretical prediction reveal that the overpressure at the concave side tends to reduce the sound transmission loss at the rate of about 0.5dB /10000 Pa. While at lower frequencies, say well below the ring frequency, the overpressure may increase or reduce sound transmission loss of a finite panel, depending on the shift of the resonant frequencies resulting from the overpressure.For TBL excitation, numerical investigation reveals that the panel with the ring frames behaves more like a sub-panel between two frames. Below 500Hz, the ring frames slightly enhance the sound radiation while dramatically increasing it around 1.3kHz. The TBL forcing field excites the same vibration lever for the panel with and without ring frame attachments, but the modes excited for the panel with ring frames radiate more sound. Unlike the ring frames, the stringers increase sound radiation below 1kHz. Above 1kHz, the sub-panels between two bays respond independently and the stringer effects is therefore not obvious.
|
|
