| 1. |
- Antonov, Yury, et al.
(författare)
-
A 20-60ghz digitally controlled composite oscillator for 5G
- 2018
-
Ingår i: 2018 New Generation of CAS, NGCAS 2018. - 9781538676813 ; , s. 166-169
-
Konferensbidrag (refereegranskat)abstract
- This paper describes a frequency generator supporting over-an-octave tuning range for 5G receiver front-end. Generator is built by composition of smaller-range oscillators multiplexed to the common output that drives a downconversion mixer. Simulated in 28nm CMOS with full physical device models the composite oscillator exhibits a frequency tuning range from 21.5 to 60.7GHz (95.3%) dissipating less then 25.8mW from a 0.9V supply. As a result, it achieves -184dBc/Hz FOMTR.
|
|
| 2. |
- Ghoraishi, Mir, et al.
(författare)
-
Towards versatile access networks (Chapter 3)
- 2023
-
Ingår i: Towards Sustainable and Trustworthy 6G: Challenges, Enablers, and Architectural Design. - 9781638282396 ; , s. 40-120
-
Bokkapitel (övrigt vetenskapligt/konstnärligt)abstract
- Compared to its previous generations, the 5th generation (5G) cellular network features an additional type of densification, i.e., a large number of active antennas per access point (AP) can be deployed. This technique is known as massive multipleinput multiple-output (mMIMO) [1]. Meanwhile, multiple-input multiple-output (MIMO) evolution, e.g., in channel state information (CSI) enhancement, and also on the study of a larger number of orthogonal demodulation reference signal (DMRS) ports for MU-MIMO, was one of the Release 18 of 3rd generation partnership project (3GPP Rel-18) work item. This release (3GPP Rel-18) package approval, in the fourth quarter of 2021, marked the start of the 5G Advanced evolution in 3GPP. The other items in 3GPP Rel-18 are to study and add functionality in the areas of network energy savings, coverage, mobility support, multicast broadcast services, and positioning
|
|
| 3. |
- Gustavsson, Ulf, 1975, et al.
(författare)
-
Implementation challenges and opportunities in beyond-5G and 6G communication
- 2021
-
Ingår i: IEEE Journal of Microwaves. - 2692-8388. ; 1:1, s. 86-100
-
Tidskriftsartikel (refereegranskat)abstract
- As 5G New Radio (NR) is being rolled out, research effort is being focused on the evolution of what is to come in the post-5G era. In order to meet the diverse requirements of future wireless communication in terms of increased capacity and reduced latency, technologies such as distributed massive Multiple-Input Multiple-Output (MIMO), sub-millimeter wave and Tera-hertz spectrum become technology components of interest. Furthermore, to meet the demands on connectivity anywhere at anytime, non-terrestrial satellite networks will be needed, which brings about challenges both in terms of implementation as well as deployment. Finally, scaling up massive Internet-of-Things (IoT), energy harvesting and Simultaneous Wireless Information and Power Transfer (SWIPT) is foreseen to become important enablers when deploying a large amount of small, low-power radios. In this paper, we will discuss some of the important opportunities these technologies bring, and the challenges faced by the microwave and wireless communication communities.
|
|
| 4. |
- Sarajlic, Muris, et al.
(författare)
-
Waveforms for sub-THz 6G: Design Guidelines
- 2023
-
Ingår i: 2023 Joint European Conference on Networks and Communications and 6G Summit, EuCNC/6G Summit 2023. ; , s. 168-173
-
Konferensbidrag (refereegranskat)abstract
- The projected sub-THz (100 - 300 GHz) part of the upcoming 6G standard will require a careful design of the waveform and choice of slot structure. Not only that the design of the physical layer for 6G will be driven by ambitious system performance requirements, but also hardware limitations, specific to sub-THz frequencies, pose a fundamental design constraint for the waveform. In this contribution, general guidelines for the waveform design are given, together with a non-exhaustive list of exemplary waveforms that can be used to meet the design requirements.
|
|
| 5. |
- Uusitalo, Mikko A., et al.
(författare)
-
6G Vision, Value, Use Cases and Technologies from European 6G Flagship Project Hexa-X
- 2021
-
Ingår i: IEEE Access. - 2169-3536 .- 2169-3536. ; 9, s. 160004-160020
-
Tidskriftsartikel (refereegranskat)abstract
- While 5G is being deployed and the economy and society begin to reap the associated benefits, the research and development community starts to focus on the next, 6th Generation (6G) of wireless communications. Although there are papers available in the literature on visions, requirements and technical enablers for 6G from various academic perspectives, there is a lack of joint industry and academic work towards 6G. In this paper a consolidated view on vision, values, use cases and key enabling technologies from leading industry stakeholders and academia is presented. The authors represent the mobile communications ecosystem with competences spanning hardware, link layer and networking aspects, as well as standardization and regulation. The second contribution of the paper is revisiting and analyzing the key concurrent initiatives on 6G. A third contribution of the paper is the identification and justification of six key 6G research challenges: (i) “connecting”, in the sense of empowering, exploiting and governing, intelligence; (ii) realizing a network of networks, i.e., leveraging on existing networks and investments, while reinventing roles and protocols where needed; (iii) delivering extreme experiences, when/where needed; (iv) (environmental, economic, social) sustainability to address the major challenges of current societies; (v) trustworthiness as an ingrained fundamental design principle; (vi) supporting cost-effective global service coverage. A fourth contribution is a comprehensive specification of a concrete first-set of industry and academia jointly defined use cases for 6G, e.g., massive twinning, cooperative robots, immersive telepresence, and others. Finally, the anticipated evolutions in the radio, network and management/orchestration domains are discussed.
|
|
| 6. |
- Uusitalo, Mikko A., et al.
(författare)
-
Hexa-X: The european 6G flagship project
- 2021
-
Ingår i: 2021 Joint European Conference on Networks and Communications and 6G Summit, EuCNC/6G Summit 2021. ; , s. 580-585
-
Konferensbidrag (refereegranskat)abstract
- Hexa-X will pave the way to the next generation of wireless networks (Hexa) by explorative research (X). The Hexa-X vision is to connect human, physical, and digital worlds with a fabric of sixth generation (6G) key enablers. The vision is driven by the ambition to contribute to objectives of growth, global sustainability, trustworthiness, and digital inclusion. Key 6G value indicators and use cases are defined against the background of technology push, society and industry pull as well as objectives of technology sovereignty. Key areas of research have been formulated accordingly to include connecting intelligence, network of networks, sustainability, global service coverage, extreme experience, and trustworthiness. Critical technology enablers for 6G are developed in the project including, sub-THz transceiver technologies, accurate stand-alone positioning and radio-based imaging, improved radio performance, artificial intelligence (AI) / machine learning (ML) inspired radio access network (RAN) technologies, future network architectures and special purpose solutions including future ultra-reliable low-latency communication (URLLC) schemes. Besides technology enablers, early trials will be carried out to help assess viability and performance aspects of the key technology enablers. The 6G Hexa-X project is integral part of European and global research effort to help define the best possible next generation of networks.
|
|
| 7. |
- Wymeersch, Henk, 1976, et al.
(författare)
-
6G Radio Requirements to Support Integrated Communication, Localization, and Sensing
- 2022
-
Ingår i: 2022 Joint European Conference on Networks and Communications and 6G Summit, EuCNC/6G Summit 2022. ; , s. 463-469
-
Konferensbidrag (refereegranskat)abstract
- 6G will be characterized by extreme use cases, not only for communication, but also for localization, and sensing. The use cases can be directly mapped to requirements in terms of standard key performance indicators (KPIs), such as data rate, latency, or localization accuracy. The goal of this paper is to go one step further and map these standard KPIs to requirements on signals, on hardware architectures, and on deployments. Based on this, system solutions can be identified that can support several use cases simultaneously. Since there are several ways to meet the KPIs, there is no unique solution and preferable configurations will be discussed.
|
|
