| 1. |
|
|
| 2. |
|
|
| 3. |
- Olausson, Michael, 1956, et al.
(författare)
-
Adjuvant treatment with ursodeoxycholic acid prevents acute rejection in rats receiving heart allografts.
- 1992
-
Ingår i: Transplant international : official journal of the European Society for Organ Transplantation. - 0934-0874. ; 5 Suppl 1
-
Tidskriftsartikel (refereegranskat)abstract
- Adjuvant treatment with ursodeoxycholic acid (UDCA) for liver-transplant recipients has been reported to reduce the frequency of acute rejection episodes. To explore this effect further, UDCA was given to rats in an experimental heart transplantation model, with or without concomitant immunosuppressive treatment with antihymocyte globulin (ATG). UDCA was administered orally 7 days before and 14 days after transplantation. Rats treated with UDCA alone or in combination with ATG were compared with untreated controls and ATG-treated recipients. Adjuvant treatment with UDCA was found to induce prolonged graft survival and increase the amount of transplant tolerance in rats. Serum levels of bilirubin and aminotransferases were not altered irrespective of the UDCA dose given. The results indicate that UDCA has an immunomodulatory capacity that might not be restricted to the liver, but also might apply to other transplanted organs as well.
|
|
| 4. |
- Waterton, John C., et al.
(författare)
-
Repeatability and reproducibility of longitudinal relaxation rate in 12 small-animal MRI systems
- 2019
-
Ingår i: Magnetic Resonance Imaging. - : Elsevier BV. - 1873-5894 .- 0730-725X. ; 59, s. 121-129
-
Tidskriftsartikel (refereegranskat)abstract
- Background: Many translational MR biomarkers derive from measurements of the water proton longitudinal relaxation rate R 1 , but evidence for between-site reproducibility of R 1 in small-animal MRI is lacking. Objective: To assess R 1 repeatability and multi-site reproducibility in phantoms for preclinical MRI. Methods: R 1 was measured by saturation recovery in 2% agarose phantoms with five nickel chloride concentrations in 12 magnets at 5 field strengths in 11 centres on two different occasions within 1–13 days. R 1 was analysed in three different regions of interest, giving 360 measurements in total. Root-mean-square repeatability and reproducibility coefficients of variation (CoV) were calculated. Propagation of reproducibility errors into 21 translational MR measurements and biomarkers was estimated. Relaxivities were calculated. Dynamic signal stability was also measured. Results: CoV for day-to-day repeatability (N = 180 regions of interest) was 2.34% and for between-centre reproducibility (N = 9 centres) was 1.43%. Mostly, these do not propagate to biologically significant between-centre error, although a few R 1 -based MR biomarkers were found to be quite sensitive even to such small errors in R 1 , notably in myocardial fibrosis, in white matter, and in oxygen-enhanced MRI. The relaxivity of aqueous Ni 2+ in 2% agarose varied between 0.66 s −1 mM −1 at 3 T and 0.94 s −1 mM −1 at 11.7T. Interpretation: While several factors affect the reproducibility of R 1 -based MR biomarkers measured preclinically, between-centre propagation of errors arising from intrinsic equipment irreproducibility should in most cases be small. However, in a few specific cases exceptional efforts might be required to ensure R 1 -reproducibility.
|
|
| 5. |
- Andersson, Helene, 1983, et al.
(författare)
-
The influence of the molecular weight of the water-soluble polymer on phase-separated films for controlled release
- 2016
-
Ingår i: International Journal of Pharmaceutics. - : Elsevier BV. - 0378-5173 .- 1873-3476. ; 511:1, s. 223-235
-
Tidskriftsartikel (refereegranskat)abstract
- Hydroxypropyl cellulose (HPC) and ethyl cellulose (EC) can be used for extended release coatings, where the water-soluble HPC may act as a pore former. The aim was to investigate the effect of the molecular weight of HPC on the microstructure and mass transport in phase-separated freestanding EC/HPC films with 30% w/w HPC. Four different HPC grades were used, with weight averaged molecular weights (Mw) of 30.0 (SSL), 55.0 (SL), 83.5 (L) and 365 (M) kg/mol. Results showed that the phase-separated structure changed from HPC-discontinuous to bicontinuous with increasing Mw of HPC. The film with the lowest Mw HPC (SSL) had unconnected oval-shaped HPC-rich domains, leaked almost no HPC and had the lowest water permeability. The remaining higher Mw films had connected complex-shaped pores, which resulted in higher permeabilities. The highest Mw film (M) had the smallest pores and very slow HPC leakage, which led to a slow increase in permeability. Films with grade L and SL released most of their HPC, yet the permeability of the L film was three times higher due to greater pore connectivity. It was concluded that the phase-separated microstructure, the level of pore percolation and the leakage rate of HPC will be affected by the choice of HPC Mw grade used in the film and this will in turn have strong impact on the film permeability.
|
|
| 6. |
|
|
| 7. |
- Björkegren, Sanna, 1984, et al.
(författare)
-
Surface activity and flocculation behavior of polyethylene glycol-functionalized silica nanoparticles
- 2015
-
Ingår i: Journal of Colloid and Interface Science. - : Elsevier BV. - 1095-7103 .- 0021-9797. ; 452, s. 215-223
-
Tidskriftsartikel (refereegranskat)abstract
- Colloidal silica nanoparticles have been functionalized with methyl polyethylene glycol silane (mPEG silane) and the PEGylated particles have been characterized with focus on exploring their surface chemical properties. The degree of surface functionalization was quantified using NMR diffusometry, and the measurements showed that the silane binds covalently to the silica surface. Samples with surface coverages ranging from 0.068 to 0.315 gmol silane/m(2) have been analyzed. The functionalized particles proved to be surface active and showed a significant reduction in surface charge and zeta potential with increasing degree of PEG functionalization. All samples showed colloidal stability at neutral pH and above within the range studied. At lower pH, the samples with low surface coverage displayed a reversible flocculation behavior, while samples with a high surface coverage and samples without functionalization remained stable. This suggests that steric stabilization is effective at low pH when the surface coverage is high enough; electrostatic stabilization is effective for samples without functionalization; and that inter-particle PEG-silica interactions cause flocculation of particles with too low degrees of PEG functionalization.
|
|
| 8. |
- Erlinge, David, et al.
(författare)
-
Identification of vulnerable plaques and patients by intracoronary near-infrared spectroscopy and ultrasound (PROSPECT II) : a prospective natural history study
- 2021
-
Ingår i: The Lancet. - : Elsevier. - 0140-6736 .- 1474-547X. ; 397:10278, s. 985-995
-
Tidskriftsartikel (refereegranskat)abstract
- Background: Near-infrared spectroscopy (NIRS) and intravascular ultrasound are promising imaging modalities to identify non-obstructive plaques likely to cause coronary-related events. We aimed to assess whether combined NIRS and intravascular ultrasound can identify high-risk plaques and patients that are at risk for future major adverse cardiac events (MACEs).Methods: PROSPECT II is an investigator-sponsored, multicentre, prospective natural history study done at 14 university hospitals and two community hospitals in Denmark, Norway, and Sweden. We recruited patients of any age with recent (within past 4 weeks) myocardial infarction. After treatment of all flow-limiting coronary lesions, three-vessel imaging was done with a combined NIRS and intravascular ultrasound catheter. Untreated lesions (also known as non-culprit lesions) were identified by intravascular ultrasound and their lipid content was assessed by NIRS. The primary outcome was the covariate-adjusted rate of MACEs (the composite of cardiac death, myocardial infarction, unstable angina, or progressive angina) arising from untreated non-culprit lesions during follow-up. The relations between plaques with high lipid content, large plaque burden, and small lumen areas and patient-level and lesion-level events were determined. This trial is registered with ClinicalTrials.gov, NCT02171065.Findings: Between June 10, 2014, and Dec 20, 2017, 3629 non-culprit lesions were characterised in 898 patients (153 [17%] women, 745 [83%] men; median age 63 [IQR 55-70] years). Median follow-up was 3.7 (IQR 3.0-4.4) years. Adverse events within 4 years occurred in 112 (13.2%, 95% CI 11.0-15.6) of 898 patients, with 66 (8.0%, 95% CI 6.2-10.0) arising from 78 untreated non-culprit lesions (mean baseline angiographic diameter stenosis 46.9% [SD 15.9]). Highly lipidic lesions (851 [24%] of 3500 lesions, present in 520 [59%] of 884 patients) were an independent predictor of patient-level non-culprit lesion-related MACEs (adjusted odds ratio 2.27, 95% CI 1.25-4.13) and nonculprit lesion-specific MACEs (7.83, 4.12-14.89). Large plaque burden (787 [22%] of 3629 lesions, present in 530 [59%] of 898 patients) was also an independent predictor of non-culprit lesion-related MACEs. Lesions with both large plaque burden by intravascular ultrasound and large lipid-rich cores by NIRS had a 4-year non-culprit lesion-related MACE rate of 7.0% (95% CI 4.0-10.0). Patients in whom one or more such lesions were identified had a 4-year non-culprit lesion-related MACE rate of 13.2% (95% CI 9.4-17.6).Interpretation: Combined NIRS and intravascular ultrasound detects angiographically non-obstructive lesions with a high lipid content and large plaque burden that are at increased risk for future adverse cardiac outcomes.
|
|
| 9. |
- Fijneman, Andreas J., et al.
(författare)
-
Local quantification of mesoporous silica microspheres using multiscale electron tomography and lattice Boltzmann simulations
- 2020
-
Ingår i: Microporous and Mesoporous Materials. - : Elsevier BV. - 1387-1811. ; 302
-
Tidskriftsartikel (refereegranskat)abstract
- The multiscale pore structure of mesoporous silica microspheres plays an important role for tuning mass transfer kinetics in technological applications such as liquid chromatography. While local analysis of a pore network in such materials has been previously achieved, multiscale quantification of microspheres down to the nanometer scale pore level is still lacking. Here we demonstrate for the first time, by combining low convergence angle scanning transmission electron microscopy tomography (LC-STEM tomography) with image analysis and lattice Boltzmann simulations, that the multiscale pore network of commercial mesoporous silica microspheres can be quantified. This includes comparing the local tortuosity and intraparticle diffusion coefficients between different regions within the same microsphere. The results, spanning more than two orders of magnitude between nanostructures and entire object, are in good agreement with bulk characterization techniques such as nitrogen gas physisorption and add valuable local information for tuning mass transfer behavior (in liquid chromatography or catalysis) on the single microsphere level.
|
|
| 10. |
- Frost, Rickard, 1979, et al.
(författare)
-
Core−Shell Nanoplasmonic Sensing for Characterization of Biocorona Formation and Nanoparticle Surface Interactions
- 2016
-
Ingår i: ACS Sensors. - : American Chemical Society (ACS). - 2379-3694. ; 1:6, s. 798-806
-
Tidskriftsartikel (refereegranskat)abstract
- Surface properties of nanoparticles imposed by particle size, shape, and surface chemistry are key features that largely determine their environmental fate and effects on biological systems. Consequently, development of analytical tools to characterize surface properties of nanomaterials and their relation to toxicological properties must occur in parallel with applications. As a contribution to this quest, we present a nanoplasmonic sensing strategy that enables systematic in situ characterization of molecule−nanoparticle interactions under well-controlled conditions, in terms of both nanoparticle size and surface chemistry, with particular focus on the importance of surface faceting in crystalline nanoparticles. We assess the performance of our sensing strategy by presenting two case studies. (i) The first is protein corona formation on faceted Au core−SiO2 shell nanoparticles of different sizes, and thus different surface facet-to-edge ratios. Based on 2D and 3D models of the investigated structures, we find that for small particles the curved regions between adjacent facets dominate the response of the corona formation process, whereas the facets dominate the response in the large particle regime. (ii) The second is in situ functionalization of Au core−SiO2 shell nanoparticle surfaces, and analysis of the subsequent protein repellent behavior. Due to the versatility of the presented sensing strategy in studies of nanoparticle surface properties, including in situ surface modifications, and their interactions with (bio)molecules during corona formation, we foresee it to become a valuable tool in the areas of nanomedicine and nanotoxicology.
|
|
