| 1. |
- Kanai, M, et al.
(författare)
-
- 2023
-
swepub:Mat__t
|
|
| 2. |
|
|
| 3. |
- Belonoshko, Anatoly B., et al.
(författare)
-
Melting of a polycrystalline material
- 2013
-
Ingår i: The European Physical Journal Special Topics. - : Springer Science and Business Media LLC. - 1951-6355 .- 1951-6401. ; 216:1, s. 199-204
-
Tidskriftsartikel (refereegranskat)abstract
- Calculating the melting temperature of a solid with a known model of interaction between atoms is nowadays a comparatively simple task. However, when one simulates a single crystal by molecular dynamics method, it does not normally melt at the melting temperature. Instead, one has to significantly overheat it. Yet, a real material melts at the melting point. Here we investigate the impact of the defects and the grain boundaries on melting. We demonstrate that defects and grain boundaries have similar impact and make it possible to simulate melting in close vicinity of thermodynamic melting temperature. We also show that the Z method might be non-applicable in discriminating a stable submelting phase.
|
|
| 4. |
- Belonoshko, Anatoly B., et al.
(författare)
-
Melting of Fe and Fe0.9375Si0.0625 at Earth's core pressures studied using ab initio molecular dynamics
- 2009
-
Ingår i: Physical Review B. Condensed Matter and Materials Physics. - 1098-0121 .- 1550-235X. ; 79:22
-
Tidskriftsartikel (refereegranskat)abstract
- The issue of melting of pure iron and iron alloyed with lighter elements at high pressure is critical to the physics of the Earth. The iron melting curve in the relevant pressure range between 3 and 4 Mbar is reasonably well established from the theoretical point of view. However, so far no one attempted a direct atomistic simulation of iron alloyed with light elements. We investigate here the impact of alloying the body-centered cubic (bcc) Fe with Si. We simulate melting of the bcc Fe and Fe0.9375Si0.0625 alloy by ab initio molecular dynamics. The addition of light elements to the hexagonal-close-packed (hcp) iron is known to depress its melting temperature (T-m). We obtain, in marked contrast, that alloying of bcc Fe with Si does not lead to T-m depression; on the contrary, the T-m slightly increases. This suggests that if Si is a typical impurity in the Earth's inner core, then the stable phase in the core is bcc rather than hcp.
|
|
| 5. |
- Errandonea, Daniel, et al.
(författare)
-
Experimental and theoretical confirmation of an orthorhombic phase transition in niobium at high pressure and temperature
- 2020
-
Ingår i: COMMUNICATIONS MATERIALS. - : Springer Nature. - 2662-4443. ; 1:1
-
Tidskriftsartikel (refereegranskat)abstract
- Compared to other body-centered cubic (bcc) transition metals, Nb has been the subject of fewer compression studies and there are still aspects of its phase diagram which are unclear. Here, we report a combined theoretical and experimental study of Nb under high pressure and temperature. We present the results of static laser-heated diamond anvil cell experiments up to 120 GPa using synchrotron-based fast x-ray diffraction combined with ab initio quantum molecular dynamics simulations. The melting curve of Nb is determined and evidence for a solid-solid phase transformation in Nb with increasing temperature is found. The high-temperature phase of Nb is orthorhombic Pnma. The bcc-Pnma transition is clearly seen in the experimental data on the Nb principal Hugoniot. The bcc-Pnma coexistence observed in our experiments is explained. Agreement between the measured and calculated melting curves is very good except at 40-60 GPa where three experimental points lie below the theoretical melting curve by 250 K (or 7%); a possible explanation is given. The study of materials under extreme conditions can reveal interesting physics in diverse areas such as condensed matter and geophysics. Here, the authors investigate experimentally and theoretically the high pressure-high temperature phase diagram of niobium revealing a previously unobserved phase transition from body-centered cubic to orthorhombic phase.
|
|
