| 1. |
- Jia, Yu, et al.
(författare)
-
Variation of green liquor dregs from different pulp and paper mills for use in mine waste remediation
- 2019
-
Ingår i: Environmental Science and Pollution Research. - : Springer. - 0944-1344 .- 1614-7499. ; 26:30, s. 31284-31300
-
Tidskriftsartikel (refereegranskat)abstract
- The geotechnical, chemical, and mineralogical properties of green liquor dregs (GLDs) generated as byproducts from five paper mills were investigated to assess their buffering and heavy metal immobilization capacities and their roles as water and oxygen barriers. One type of GLD was further studied to test the effects of the retrieval process and the storage, drying, and hydration of GLD. The high water retention capacity of the GLDs is valuable for limiting O2diffusion. Laboratory results showed that the GLDs had hydraulic conductivities of 3.7 × 10−9–4.6 × 10−8 m/s and varied regularly in plasticity. The chemical and mineralogical compositions of the GLDs varied greatly, reflecting the raw material used to produce paper and the process used to retrieve GLDs. Although they had high total heavy metal contents, none of the leached elements from the GLDs (L/S 10 cm3/kg) exceeded the European Union’s limits for landfills of non-hazardous waste. The GLDs exhibited high buffering capacities. In a supplementary test, the buffering capacities varied (0.0041–0.0114 M H+/g GLD) over 72 d after acid was added to the GLD. Changing the filtration process did not greatly affect the GLDs’ properties but mainly affected the hydraulic conductivity, total heavy metal contents and sulfur content. Analyzing the storage of GLDs is necessary in the mining industry because remediation measures require large amounts of material over short periods. The buffering capacity of the dried GLD decreased slightly. The effect of dewatering caused by the mixing of 2% Na-lignosulfate with GLD (w/w) was low.
|
|
| 2. |
- Qureshi, Asif, 1986-, et al.
(författare)
-
Co-disposal of lignite fly ash and coal mine waste rock for neutralisation of AMD
- 2021
-
Ingår i: Environmental Science and Pollution Research. - : Springer. - 0944-1344 .- 1614-7499. ; 28:35, s. 48728-48741
-
Tidskriftsartikel (refereegranskat)abstract
- Waste rocks (WRs) from a lignite-producing coalfield and fly ash (FA) produced from the same lignite have been investigated in this study with a primary objective to determine the potential for co-disposal of WRs and FA to reduce the environmental contamination. Mixing WRs with FA and covering WRs with FA have been investigated. Particle size effect caused ≤2 mm particles to produce low pH (~2) and metal-laden leachates, indicating higher sulphide minerals’ reactivity compared to larger particles (≤10 mm, pH ~ 4). Co-disposal of FA as mixture showed an instantaneous effect, resulting in higher pH (~3–6) and better leachate quality. However, acidity produced by secondary mineralisation caused stabilisation of pH at around 4.5–5. In contrast, the pH of the leachates from the cover method gradually increased from strongly acidic (pH ~ 2) to mildly acidic (pH ~ 4–5) and circumneutral (pH ~ 7) along with a decrease in EC and elemental leaching. Gradually increasing pH can be attributed to the cover effect, which reduces the oxygen diffusion, thus sulphide oxidation. FA cover achieved the pH necessary for secondary mineralisation during the leaching experiment. The co-disposal of FA as cover and/or mixture possesses the potential for neutralisation and/or slowing down AMD and improving leachate quality.
|
|
| 3. |
- Qureshi, Asif, 1986-
(författare)
-
Co-disposal of waste rock and lignite fly ash to mitigate the environmental impact of coal mining
- 2016
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- Waste rocks (WRs) from coal mining and fly ash (FA) from coal combustion were studied to determine the potential of the WRs to generate AMD, FAs to neutralise it and estimate their impacts on environment. The ultimate goal was to develop a methodology based on co-disposal to mitigate the environmental problems associated to both wastes. Two methods for co-disposal were tested: i) Mixing WRs and FAs and ii) covering WRs with FAs.WRs were sampled from the Lakhra coal mines in Pakistan (PK), which has an estimated coal reserves of 1.3 Btonne, varying from lignite to sub-bituminous quality. The FA was sampled from a power plant utilising coal from Lakhra coal mines and is situated in close vicinity (15km) of the mine site. For comparative purposes a bituminous FA from Finland (FI) and biomass FA from Sweden (SE) were also characterised.The WRs and FA samples were characterised by mineralogical and geochemical methods. Besides organic material (coal traces), quartz, pyrite, kaolinite, hematite, gypsum and traces of calcite, lime, malladerite, spangolite, franklinite and birnessite were identified in WRs by XRD. The major elements Si, Al, Ca and Fe were in the range (wt. %) of 8 – 12, 6 – 9, 0.3 – 3 and 1 – 10, respectively, with high S concentrations (1.94 – 11.33 wt. %) in WRs. The AMD potential of WRs ranged from -70 to -492 kg CaCO3 tonne-1.All FAs contained quartz, with iron oxide, anhydrite and magnesioferrite in PK, mullite and lime in FI and calcite and anorthite in SE. The Ca content in SE was 6 and 8 times higher compared to PK and FI, respectively. FAs were enriched in As, Cd, Co, Cr, Cu, Hg, Ni, Pb and Zn compared to continental crust. The acid neutralising potential of PK was equivalent to 20 kg CaCO3 tonne-1 compared to 275 kg CaCO3 tonne-1 (SE) and 25 kg CaCO3 tonne-1 (FI).During the period of 192 days in weathering cell experiments (WCE), the pH of leachates from most acidic WRs was maintained from 1 to 2.5, whereas, the less acidic WRs produced leachates of mildly acidic (2.7) to neutral (7.3) pH. The leachates from very acidic WRs ranged in the concentrations of Fe, SO24− and Al from mg L-1 to g L-1.The samples were subjected to column leaching experiments (CLE) in which mixture (FA:WR; 1:3) and cover (FA:WR; 1:5) cases were mimicked (with 10mm particle size) and effects of particle size (2, 5 and 10mm) on element leaching were studied.Despite having the lowest acid-neutralisation potential compared to FI and SE, co-disposal of PKFA as mixture readily provides acid buffering minerals, resulting in better start-up pH conditions and leachate quality. However, acidity produced by secondary mineralisation contributes towards the acidification of the system, causing stabilisation of pH at around 4.5−5. Secondary mineralisation (especially Fe- and Al-mineral precipitation) also removes toxic elements such as As, Pb, Cu, Zn, Cd, Co, Ni and Mn, and these secondary minerals can also buffer acidity when the pH tends to be acidic.In contrast, the pH of the leachates from the PKFA cover scenario gradually increased from strongly acidic to mildly acidic and circumneutral along with decrease in EC and elemental leaching in different WRs. Gradually increasing pH can be attributed to the cover effect, which reduces oxygen ingress, thus sulphide oxidation, causing pH to elevate. Due to the fact that pH~4–5 is sufficient for secondary Fe- and Al-mineral precipitation which also removes toxic elements (such as Cd, Co, Cu, Zn and Ni) by adsorption and/or co-precipitation, the FA cover performs well enough to achieve that pH until the conclusion of the CLE. However, due to the slower reactivity of the buffering system (additional to the initial flush-out), leaching in the beginning could not be restricted.The co-disposal of FA as cover and/or mixture possesses potential for neutralisation of AMD and improving leachate quality significantly. Particle size of the WRs affected the leaching of the sulphide related elements (such as Fe, S, Zn, Co, Cr, Cu, Mn and Ni) in CLE and WCE. Experiments with ≤1mm particle size constantly produced acidic and metal laden leachates. Co-disposal of FA and WRs as cover and mixture need to be investigated on pilot-scales before full-scale application.
|
|
| 4. |
- Qureshi, Asif, 1986-, et al.
(författare)
-
Effects of the co-disposal of lignite fly ash and coal mine waste rocks on AMD and leachate quality
-
Annan publikation (övrigt vetenskapligt/konstnärligt)abstract
- Lignite fly ash (FA) and waste rocks (WRs) were mixed in three different ratios (1:1, 1:3 and 1:5) and studied to compare the effects of adding FA on AMD generation from coal mining WRs, leachability of elements and the potential occurrence of secondary minerals. FA mixed with WRs showed significant differences in pH levels compared to previous research. The 1:1 mixture performed best of all the three mixtures in terms of pH and leachability of elements, mainly due to the higher proportion of FA in the mixture. The pH in the 1:1 mixtures varied between 3.3 – 5.1 compared to other mixtures (2.3 – 3.5). Iron and SO42- leached considerably less from the 1:1 mixture compared to the others, indicating that the oxidation of sulphides was weaker in this mixture. Aluminium leached to a high degree from all mixtures, with concentrations varying from mg L-1–g L-1. The reason behind this increase is probably the addition of FA which, due to acidic conditions and the composition of the FA, increases the availability of Al. For the same reason, high concentrations of Mn and Zn were also measured. Geochemical modelling indicates that the 1:1 mixture performs better in terms of precipitation of Al3+ minerals, whereas Fe3+ minerals precipitated more in mixtures containing less FA. These results suggest that, with time, the pores could possibly be filled with these secondary minerals and sulphate salts (followed by a decrease in sulphide oxidation), improving the pore water pH and decreasing the leachability of elements. Since grain size plays a crucial role in the reactivity of sulphides, there is a risk that the results from the leaching tests may have been influenced by crushing and milling of the WR samples.
|
|
| 5. |
- Qureshi, Asif, 1986-, et al.
(författare)
-
Effects of the co-disposal of lignite fly ash and coal mine waste rocks on AMD and leachate quality
- 2019
-
Ingår i: Environmental Science and Pollution Research. - : Springer. - 0944-1344 .- 1614-7499. ; 26:4, s. 4104-4115
-
Tidskriftsartikel (refereegranskat)abstract
- Lignite fly ash (FA) and waste rocks (WRs) were mixed in three different ratios (1:1, 1:3 and 1:5) and studied to compare the effects of adding FA on acid mine drainage generation from coal mining WRs, leachability of elements and the potential occurrence of the secondary minerals. FA mixed with WRs showed significant differences in pH levels compared to previous research. The 1:1 mixture performed best of all the three mixtures in terms of pH and leachability of elements, mainly due to the higher proportion of FA in the mixture. The pH in the 1:1 mixtures varied between 3.3 and 5.1 compared to other mixtures (2.3–3.5). Iron and SO42− leached considerably less from the 1:1 mixture compared to the others, indicating that the oxidation of sulphides was weaker in this mixture. Aluminium leached to a high degree from all mixtures, with concentrations varying from mg L−1 to g L−1. The reason behind this increase is probably the addition of FA which, due to acidic conditions and the composition of the FA, increases the availability of Al. For the same reason, high concentrations of Mn and Zn were also measured. Geochemical modelling indicates that the 1:1 mixture performs better in terms of precipitation of Al3+ minerals, whereas Fe3+ minerals precipitated more in mixtures containing less FA. These results suggest that, with time, the pores could possibly be filled with these secondary minerals and sulphate salts (followed by a decrease in sulphide oxidation), improving the pore water pH and decreasing the leachability of elements. Since grain size plays a crucial role in the reactivity of sulphides, there is a risk that the results from the leaching tests may have been influenced by crushing and milling of the WR samples.
|
|
