| 1. |
- Shanmugam, Vigneshwaran, et al.
(författare)
-
The mechanical testing and performance analysis of polymer-fibre composites prepared through the additive manufacturing
- 2021
-
Ingår i: Polymer testing. - : Elsevier. - 0142-9418 .- 1873-2348. ; 93
-
Forskningsöversikt (refereegranskat)abstract
- The development of fibre composites in recent years has been remarkably strong, owing to their high performance and durability. Various advancements in fibre composites are emerging because of their increased use in a myriad of applications. One of the popular processing methods is additive manufacturing (AM), however, polymer-fibre composites manufactured through AM have a significantly lower strength compared to the conventional manufacturing processes, for instance, injection moulding. This article is a comprehensive review of the mechanical testing and performance analysis of polymer-fibre composites fabricated through AM, in particular fused deposition modelling (FDM). The review highlights the effect of the various processing parameters, involved in the FDM of polymer-fibre composites, on the observed mechanical properties. In addition, the thermal properties of FDM based fibre composites are also briefly reviewed. Overall, the review article has been structured to provide an impetus for researchers in the concerned engineering domain to gain an insight into the mechanical properties of fibre-reinforced polymeric composites manufactured through AM.
|
|
| 2. |
- Shanmugam, Vigneshwaran, et al.
(författare)
-
Experimental Investigation of Thrust Force, Delamination and Surface Roughness in Drilling Hybrid Structural Composites
- 2021
-
Ingår i: Materials. - : MDPI. - 1996-1944. ; 14:16
-
Tidskriftsartikel (refereegranskat)abstract
- Filled hybrid composites are widely used in various structural applications where machining is critical. Hence, it is essential to understand the performance of the fibre composites’ machining behaviour. As such, a new hybrid structural composite was fabricated with redmud as filler and sisal fibre as reinforcement in polyester matrix. The composite was then tested for its drilling performance. A comprehensive drilling experiment was conducted using Taguchi L27 orthogonal array. The effect of the drill tool point angle, the cutting speed, the feed rate on thrust force, delamination, and burr formation were analysed for producing quality holes. The significance of each parameter was analysed, and the experimental outcomes revealed some important findings in the context of the drilling behaviour of sisal fibre/polyester composites with redmud as a filler. Spindle speed contributed 39% in affecting the thrust force, while the feed rate had the maximum influence of ca. 38% in affecting delamination.
|
|
