| 1. |
- Zouhar, Petr, et al.
(författare)
-
A pyrexic effect of FGF21 independent of energy expenditure and UCP1
- 2021
-
Ingår i: Molecular Metabolism. - : Elsevier BV. - 2212-8778. ; 53
-
Tidskriftsartikel (refereegranskat)abstract
- Objective: Administration of FGF21 to mice reduces body weight and increases body temperature. The increase in body temperature is generally interpreted as hyperthermia, i.e. a condition secondary to the increase in energy expenditure (heat production). Here, we examine an alternative hypothesis: that FGF21 has a direct pyrexic effect, i.e. FGF21 increases body temperature independently of any effect on energy expenditure.Methods: We studied the effects of FGF21 treatment on body temperature and energy expenditure in high-fat-diet-fed and chow-fed mice exposed acutely to various ambient temperatures, in high-fat diet-fed mice housed at 30 °C (i.e. at thermoneutrality), and in mice lacking uncoupling protein 1 (UCP1).Results: In every model studied, FGF21 increased body temperature, but energy expenditure was increased only in some models. The effect of FGF21 on body temperature was more (not less, as expected in hyperthermia) pronounced at lower ambient temperatures. Effects on body temperature and energy expenditure were temporally distinct (daytime versus nighttime). FGF21 enhanced UCP1 protein content in brown adipose tissue (BAT); there was no measurable UCP1 protein in inguinal brite/beige adipose tissue. FGF21 increased energy expenditure through adrenergic stimulation of BAT. In mice lacking UCP1, FGF21 did not increase energy expenditure but increased body temperature by reducing heat loss, e.g. a reduced tail surface temperature.Conclusion: The effect of FGF21 on body temperature is independent of UCP1 and can be achieved in the absence of any change in energy expenditure. Since elevated body temperature is a primary effect of FGF21 and can be achieved without increasing energy expenditure, only limited body weight-lowering effects of FGF21 may be expected.
|
|
| 2. |
- Bagger, Alexander, et al.
(författare)
-
Ab Initio Cyclic Voltammetry on Cu(111), Cu(100) and Cu(110) in Acidic, Neutral and Alkaline Solutions
- 2019
-
Ingår i: ChemPhysChem. - : Wiley. - 1439-4235 .- 1439-7641. ; 20
-
Tidskriftsartikel (refereegranskat)abstract
- Electrochemical reactions depend on the electrochemical interface between the electrode surfaces and the electrolytes. To control and advance electrochemical reactions there is a need to develop realistic simulation models of the electrochemical interface to understand the interface from an atomistic point-of-view. Here we present a method for obtaining thermodynamic realistic interface structures, a procedure we use to derive specific coverages and to obtain ab initio simulated cyclic voltammograms. As a case study, the method and procedure is applied in a matrix study of three Cu facets in three different electrolytes. The results have been validated by direct comparison to experimental cyclic voltammograms. The alkaline (NaOH) cyclic voltammograms are described by H* and OH*, while in neutral medium (KHCO3) the CO3* species are dominating and in acidic (KCl) the Cl* species prevail. An almost one-to-one mapping is observed from simulation to experiments giving an atomistic understanding of the interface structure of the Cu facets. Atomistic understanding of the interface at relevant eletrolyte conditions will further allow realistic modelling of electrochemical reactions of importance for future eletrocatalytic studies.
|
|
| 3. |
- Björnehohn, E., et al.
(författare)
-
Water at Interfaces
- 2016
-
Ingår i: Chemical Reviews. - : American Chemical Society (ACS). - 0009-2665 .- 1520-6890. ; 116:13, s. 7698-7726
-
Forskningsöversikt (refereegranskat)abstract
- The interfaces of neat water and aqueous solutions play a prominent role in many technological processes and in the environment. Examples of aqueous interfaces are ultrathin water films that cover most hydrophilic surfaces under ambient relative humidities, the liquid/solid interface which drives many electrochemical reactions, and the liquid/vapor interface, which governs the uptake and release of trace gases by the oceans and cloud droplets. In this article we review some of the recent experimental and theoretical advances in our knowledge of the properties of aqueous interfaces and discuss open questions and gaps in our understanding.
|
|
| 4. |
|
|
| 5. |
|
|
| 6. |
- Halldin Stenlid, Joakim, et al.
(författare)
-
Electrochemical Interface during Corrosion of Copper in Anoxic Sulfide-Containing Groundwater-A Computational Study
- 2020
-
Ingår i: The Journal of Physical Chemistry C. - : American Chemical Society (ACS). - 1932-7447 .- 1932-7455. ; 124:1, s. 469-481
-
Tidskriftsartikel (refereegranskat)abstract
- Corrosion of copper is an expensive degradation process of materials in engineered infrastructures and in various technical applications. It is also an important factor in the geological disposal of spent nuclear fuel, where sulfide-induced corrosion is expected to be the predominant chemical degradation process of copper canisters used for encapsulation and isolation of the radioactive material from the biosphere. One aspect of the corrosion process that is still under intense research is the corrosion morphology and how it might be affected by the composition of the groundwater. Using density functional theory, we investigate the electrochemical interface of corroding copper in aqueous solutions containing sulfides, with and without the presence of Cl-, HCO3-, and SO42- anions. Through state-of-the-art electrochemical models, we account for the effects of pH, concentrations, and potential on the interfacial structure and composition. Results are presented for the Cu(110) surface facet and compared to the (110) and (001) facets of chalcocite (Cu2S), i.e., the main product of sulfide-induced corrosion. It is found that at low potentials, H dominates on all surfaces, and at high potentials, sulfides. In the intermediate ranges, the surfaces differ with sulfides prevailing on Cu, while adsorbed H2O, Cl, or H dominate on Cu2S. The results are summarized as surface Pourbaix diagrams and are generally applicable in corrosion science and electrochemistry. The implications of the study are discussed in light of the expected conditions of planned spent nuclear fuel repositories in Sweden, Finland, and Canada.
|
|
| 7. |
- Halldin Stenlid, Joakim, et al.
(författare)
-
Uncovering the electrochemical interface of low-index copper surfaces in deep groundwater environments
- 2020
-
Ingår i: Electrochimica Acta. - : Elsevier BV. - 0013-4686 .- 1873-3859. ; 362
-
Tidskriftsartikel (refereegranskat)abstract
- Using a combination of a sophisticated modeling protocol and well-established electrochemical techniques, we unravel the chemical composition of the low-index surfaces of copper in groundwater environments at different ion concentrations, pHs, and redox potentials. By carefully linking density functional theory (DFT) and cyclic voltammetry (CV), we are able to extract fundamental information on interfaces of broad significance. Herein, we focus on the case of groundwater found in deep geological environments of importance to the planned constructions of disposal repositories for spent nuclear fuel around the world. Within the error margins of DFT, we can assign adsorption structures and compositions to the current peaks of the CVs. It is found that among the groundwater ions of main interest (i.e. sulfide, bisulfide, sulfate, chloride and bicarbonate), sulfides (HS-, S2-) bind strongest to the surface, and are likely to dominate at the interfaces under the deep geological conditions relevant for repositories of spent nuclear fuel.
|
|
| 8. |
- Hansen, Martin Hangaard, et al.
(författare)
-
Modelling pH and potential in dynamic structures of the water/Pt(111) interface on the atomic scale
- 2017
-
Ingår i: Physical Chemistry, Chemical Physics - PCCP. - : Royal Society of Chemistry (RSC). - 1463-9076 .- 1463-9084. ; 19:34, s. 23505-23514
-
Tidskriftsartikel (refereegranskat)abstract
- We present atomic-scale structures of the Pt(111)/water interface, by calculating distributions of atomic distances as functions of pH. The structure of the Pt(111)/water interface is a particularly interesting model system in electro-catalysis for proton exchange reactions, especially the oxygen reduction reaction in polymer electrolyte membrane fuel cells. Further insight into such reactions requires accurate simulations of the electrolyte structure in the interface. The study displays many interesting details in the behaviour of the electrolyte structure, e.g. that the electrolyte structure average responds to the presence of protons by a H-down water orientation and that hexagonal adsorbed water layers are present only when they are anchored at the surface by HO*. New adsorbate configurations were also found at 5/12 ML coverage of HO*, suggesting an explanation for reported cyclic voltammetry experiments. The present study is a step towards a more complete understanding of the structure of the electrochemical interface on the atomic scale.
|
|
| 9. |
- Karlsson, Rasmus, 1987-
(författare)
-
Theoretical and Experimental Studies of Electrode and Electrolyte Processes in Industrial Electrosynthesis
- 2015
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- Heterogeneous electrocatalysis is the usage of solid materials to decrease the amount of energy needed to produce chemicals using electricity. It is of core importance for modern life, as it enables production of chemicals, such as chlorine gas and sodium chlorate, needed for e.g. materials and pharmaceuticals production. Furthermore, as the need to make a transition to usage of renewable energy sources is growing, the importance for electrocatalysis used for electrolytic production of clean fuels, such as hydrogen, is rising. In this thesis, work aimed at understanding and improving electrocatalysts used for these purposes is presented.A main part of the work has been focused on the selectivity between chlorine gas, or sodium chlorate formation, and parasitic oxygen evolution. An activation of anode surface Ti cations by nearby Ru cations is suggested as a reason for the high chlorine selectivity of the “dimensionally stable anode” (DSA), the standard anode used in industrial chlorine and sodium chlorate production. Furthermore, theoretical methods have been used to screen for dopants that can be used to improve the activity and selectivity of DSA, and several promising candidates have been found. Moreover, the connection between the rate of chlorate formation and the rate of parasitic oxygen evolution, as well as the possible catalytic effects of electrolyte contaminants on parasitic oxygen evolution in the chlorate process, have been studied experimentally.Additionally, the properties of a Co-doped DSA have been studied, and it is found that the doping makes the electrode more active for hydrogen evolution. Finally, the hydrogen evolution reaction on both RuO2 and the noble-metal-free electrocatalyst material MoS2 has been studied using a combination of experimental and theoretically calculated X-ray photoelectron chemical shifts. In this way, insight into structural changes accompanying hydrogen evolution on these materials is obtained.
|
|
| 10. |
- Koroidov, Sergey, et al.
(författare)
-
Chemisorbed oxygen or surface oxides steer the selectivity in Pd electrocatalytic propene oxidation observed by operando Pd L-edge X-ray absorption spectroscopy
- 2021
-
Ingår i: Catalysis Science & Technology. - : Royal Society of Chemistry (RSC). - 2044-4753 .- 2044-4761. ; 11:10, s. 3347-3352
-
Tidskriftsartikel (refereegranskat)abstract
- Controlled electrochemical oxidation of hydrocarbons to desired products is an attractive approach in catalysis. Here we study the electrochemical propene oxidation under operando conditions using Pd L-edge X-ray absorption spectroscopy (XAS) as a sensitive probe to elucidate surface processes occurring during catalysis. Together with ab initio multiple-scattering calculations, our XAS results enable assignment of characteristic changes of the Pd L-edge intensity and energy position in terms of a mechanistic understanding of the selective oxidation of propene. The results, supported by electrochemical density functional theory DFT simulations, show that in the potential range of 0.8–1.0 V vs. the reversible hydrogen electrode (RHE), selective oxidation of propene to acrolein and acrylic acid occurs on the metallic Pd surface. These reactions are proposed to proceed via the Langmuir–Hinshelwood mechanism. In contrast, for the potential range of 1.1–1.3 V vs. RHE, selective oxidation of propene to propylene glycol takes place on a Pd oxide surface.
|
|
