| 1. |
- Albán Reyes, Diana Carolina, et al.
(författare)
-
The influence of different parameters on the mercerisation of cellulose for viscose production
- 2016
-
Ingår i: Cellulose. - : Springer Netherlands. - 0969-0239 .- 1572-882X. ; 23:2, s. 1061-1072
-
Tidskriftsartikel (refereegranskat)abstract
- A quantitative analysis of degree of transformation from a softwood sulphite dissolving pulp to alkalised material and the yield of this transformation as a function of the simultaneous variation of the NaOH concentration, denoted [NaOH], reaction time and temperature was performed. Samples were analysed with Raman spectroscopy in combination with multivariate data analysis and these results were confirmed by X-ray diffraction. Gravimetry was used to measure the yield. The resulting data were related to the processing conditions in a Partial Least Square regression model, which made it possible to explore the relevance of the three studied variables on the responses. The detailed predictions for the interactive effects of the measured parameters made it possible to determine optimal conditions for both yield and degree of transformation in viscose manufacturing. The yield was positively correlated to the temperature from room temperature up to 45 A degrees C, after which the relation was negative. Temperature was found to be important for the degree of transformation and yield. The time to reach a certain degree of transformation (i.e. mercerisation) depended on both temperature and [NaOH]. At low temperatures and high [NaOH], mercerisation was instantaneous. It was concluded that the size of fibre particles (mesh range 0.25-1 mm) had no influence on degree of transformation in viscose processing conditions, apparently due to the quick reaction with the excess of NaOH.
|
|
| 2. |
|
|
| 3. |
|
|
| 4. |
- Boman, Christoffer, et al.
(författare)
-
Development of innovative small(micro)-scale biomass-based CHP technologies
- 2017
-
Rapport (övrigt vetenskapligt/konstnärligt)abstract
- To enhance the overall efficiency of the use of biomass in the energy sector in Europe, the large electricity production potential from small-scale biomass heating systems should be utilised. So far, no technologically sound (in terms of efficiency and reliability) and economically affordable micro- and small-scale biomass CHP technologies are, however, available. Therefore, the present ERA-NET project (MiniBioCHP) aimed at the further development and test of new CHP technologies based on small-scale biomass combustion in the electric capacity range between some W and 100 kW. Within the project, an international consortium consisting of 12 partners from 4 countries, including university institutions, institutes and industry (both engineering and manufacturing), collaborated closely to perform high level R&D on three promising micro/small-scale biomass based CHP technologies which are covering a broad range of applications in the residential heating sector. The Austrian engineering company BIOS, coordinated the international project. The project was based on earlier basic research and development work related to these promising new technologies and aimed at the achievement of a technological level which allows a first (commercial) demonstration after the end of the project. The three CHP concepts included in the MiniBioCHP project were;1. Pellet stoves with a thermoelectric generator (TEG)2. Small-scale biomass boilers (10-30 kWth) with a micro-ORC process3. High temperature heat exchanger (HT-HE) for an externally fired gas turbine (EFGT)The Swedish part of the project was focused on the development of the concept of biomass based EFGT with dedicated R&D activities related to the development of the HT-HE system. The Swedish project consisted of the research partners Umeå University (project leader), Luleå University of Technology, Chalmers University of Technology and RISE Research Institutes of Sweden, together with the industrial partners Enertech AB/Osby Parca and Ecergy. The expertise of the Swedish partners regarding ash related problems, grate boiler combustion and modelling, deposit formation and high temperature corrosion, were combined with the know-how of a Polish partner regarding HT-HE design, construction, testing and optimisation.The HT-HE is the most crucial component in EFGT processes significantly influencing the investment costs, availabilities as well as the efficiencies that can be achieved. With a thermal capacity from several hundred kW up to 2-3 MWth) the CHP technology based on a biomass boiler and an EFGT is suitable for district heating systems, or process heat consumers. The electricity produced by the gas turbine (up to some 100 kWel) can be used to cover the own electricity consumption of a company and/or fed into the grid. Even though the concept of biomass based EFGT has been an interesting alternative for small-scale CHP production for some decades, and R&D activities have been undertaken, tackling both economic and technical aspects, only a few pilot-plants have been in operation and no initiative has so far reached the level of commercial implementation. Thus, the concept of EFGT fed with biomass is still considered to be in a rather early development stage and the main technical challenges are related to alkali deposit induced corrosion and thermal stress of the HT-HE material, turbine design/operation and system integration.Within the present project, a HT-HE prototype aimed for an EFGT system was therefore designed, constructed and successfully tested at flue gas temperatures up to 900°C. Thus, appropriate guidelines for a compact design of the HT-HE and recommendations have been worked out to minimize thermal stresses as well as ash related problems regarding ash deposit formation and high temperature corrosion in a biomass boiler system. Furthermore, different concepts for the overall biomass based EFGT system have been worked out and evaluated. The outcome of the project will hopefully be used in the further development work and form the basis for a first testing and demonstration plant within the coming years.
|
|
| 5. |
- Borén, Eleonora, et al.
(författare)
-
Kaolin as fuel additive in grate combustion of biomass to mitigate ash related problems and particle emissions
- 2022
-
Ingår i: Proceedings of the 28th International Conference on the Impact of Fuel Quality on Power Production and the Environment. - : Department of Applied Physics and Electronics, Umeå University.
-
Konferensbidrag (refereegranskat)abstract
- Bioenergy is a fundamental part in sustainable development but use of novel fuel feedstocks potentiallymore sustainable may also bring associated ash-related challenges in practical operation that could bemitigated by co-conversion or additives. Kaolin, a clay mineral, is an additive known to be beneficialfor reduction of slagging tendencies and particulate matter formation in combustion of traditionalwoody-type biomass but its impact on thermal conversion of other biomasses still warrantsinvestigation. The aim of the present work is therefore to investigate how thermal conversion of atypical K-Ca-rich woody-type biomass, poplar, and a K-Si-rich annual crop, grass, is affected by kaolinaddition in fixed bed combustion. Additivation levels were calculated according to amount of alkaliintroduced with the two feedstocks, and incorporated by co-pelletization, in the case of poplar, anadditional blending d method was tested, by powder coating of pellets The results show that kaolinaddition improved the bottom ash characteristics, especially for grass, but the main differencesbetween feedstocks were found in particulate matter and flue gas composition. The particulate matterconcentrations were reduced with kaolin addition due to removal of gaseous K compounds which inturn caused higher SOx and HCl concentrations due to the lower amount of gaseous alkali for reaction.Further, initially high CO levels observed for both fuel feedstocks were reduced with the addition ofkaolin where co-pelletization with poplar proved more effective than powder coating the fuel particlesurfaces. This suggests that high concentrations of gaseous K-compounds may impact conversion ofthe carbonaceous matrix negatively.
|
|
| 6. |
- Boström, Dan, et al.
(författare)
-
Ash transformation chemistry during combustion of biomass
- 2012
-
Ingår i: Energy & Fuels. - Washington DC : American Chemical Society (ACS). - 0887-0624 .- 1520-5029. ; 26:1, s. 85-93
-
Tidskriftsartikel (refereegranskat)abstract
- There is relatively extensive knowledge available concerning ash transformation reactions during combustion of woody biomass. In recent decades, the use of these energy carriers has increased, from a low-technology residential small-scale level to an industrial scale. Along this evolution, ash chemical-related phenomena for woody biomass have been observed and studied. Therefore, presently the understanding for these are, if not complete, fairly good. However, because the demand for CO2-neutral energy resources has increased recently and will continue to increase in the foreseeable future, other biomasses, such as, for instance, agricultural crops, have become highly interesting. The ash-forming matter in agricultural biomass is rather different in comparison to woody biomass, with a higher content of phosphorus as a distinctive feature. The knowledge about the ash transformation behavior in these systems is far from complete. Here, an attempt to give a schematic but general description of the ash transformation reactions of biomass fuels is presented in terms of a conceptual model, with the intention to provide guidance in the understanding of ash matter behavior in the use of any biomass fuel, primarily from the knowledge of the concentrations of ash-forming elements. The model was organized in primary and secondary reactions. Restrictions on the theoretical model in terms of reactivity limitations and physical conditions of the conversion process were discussed and exemplified, and some principal differences between biomass ashes dominated by Si and P, separately, were outlined and discussed.
|
|
| 7. |
|
|
| 8. |
- Boström, Dan, et al.
(författare)
-
Ash transformation chemistry during energy conversion of biomass
- 2010
-
Ingår i: Proceedings of the International Conference on Impact of Fuel Quality on Power production and the Environment. - : Impacts of Fuel Quality.
-
Konferensbidrag (övrigt vetenskapligt/konstnärligt)abstract
- There is relatively extensive knowledge available concerning ash transformation reactions during energy conversion of woody biomass. Traditionally, these assortments have constituted the main resources for heating in Sweden. In recent decades the utilization of these energy carriers has increased, from a low technology residential small scale level to industrial scale (e.g. CHP plants). Along this evolution ash-chemical related phenomena for woody biomass has been observed and studied. So, presently the understanding for these are, if not complete, fairly good. Briefly, from a chemical point of view the ash from woody biomass could be characterized as a silicate dominated systems with varying content of basic oxides and with relatively high degree of volatilization of alkali sulfates and chlorides. Thus, the main ash transformation mechanisms in these systems have been outlined. Here, an attempt to give a general description of the ash transformation reactions of biomass fuels is presented, with the intention to provide guidance in the understanding of ash matter behavior in the utilization of any biomass fuel, primarily from knowledge of the concentrations of ash forming elements but also by considering the physical condition in the specific combustion appliance and the physical characteristic of the biomass fuel. Furthermore, since the demand for CO2-neutral energy resources has increased the last years and will continue to do so in the foreseeable future, other biomasses as for instance agricultural crops has become highly interesting. Globally, the availability of these shows large variation. In Sweden, for instance, which is a relatively spare populated country with large forests, these bio-masses will play a secondary role, although not insignificant. In other parts of the world, more densely populated and with a large agricultural sector, such bio-masses may constitute the main energy bio-mass resource in the future. However, the content of ash forming matter in agricultural bio-mass is rather different in comparison to woody biomass. Firstly, the content is much higher; from being about 0.3 - 0.5% (wt) in stem wood, it can amount to between 2 and 10 %(wt) in agricultural biomass. In addition, the composition of the ash forming matter is different. Shortly, the main difference is due to a much higher content of phosphorus (occasionally also silicon) which has major consequences on the ash-transformation reactions. In many crops, the concentration of phosphorus and silicon is equivalent, which (depending on the concentration levels of basic oxides) may result in a phosphate dominated ash. The properties of this ash are in several aspects different from the silicate dominated woody biomass ash and will consequently behave differently in various types of energy conversion systems. The knowledge about phosphate dominated ash systems has so far been scarce. We have been working with these systems, both with basic and applied research, for about a decade know. Some general experiences and conclusions as well as some specific examples of our research will be presented
|
|
| 9. |
- Bozaghian Bäckman, Marjan, et al.
(författare)
-
Bed material performance of quartz, natural K-feldspar, and olivine in bubbling fluidized bed combustion of barley straw
- 2024
-
Ingår i: Fuel. - : Elsevier. - 0016-2361 .- 1873-7153. ; 364
-
Tidskriftsartikel (refereegranskat)abstract
- The present study investigates how three different silicate-based bed materials behave in bubbling fluidized bed combustion of a model agricultural residue with respect to ash composition, namely barley straw. Quartz, natural K-feldspar, and olivine were all used in combustion at 700 °C, and the resulting layer formation and bed agglomeration characteristics were determined. Based on this, a general reaction model for bed ash from agricultural residues was proposed, taking into account the reactivity of the different silicates investigated towards the main ash-forming elements K, Ca, and Si. The proposed reaction model links bed material interaction with K-rich bed ash to the degree of polymerization of the silicate bed material, where addition reactions occur in systems with high polymerization, predominately in quartz, and substitution reactions dominate for depolymerized silicates such as K-feldspar and olivine.
|
|
| 10. |
|
|
