| 1. |
- Degerman, David, 1989-, et al.
(författare)
-
Effect of CO2-Rich Syngas on the Chemical State of Fe(110) during Fischer-Tropsch Synthesis
- 2024
-
Ingår i: The Journal of Physical Chemistry C. - 1932-7447 .- 1932-7455. ; 128:13, s. 5542-5552
-
Tidskriftsartikel (refereegranskat)abstract
- We have used in situ X-ray photoelectron spectroscopy to obtain information about the chemical state of a Fe single-crystal catalyst upon addition of CO2 in the syngas feed during Fischer–Tropsch synthesis (FTS) between 85 and 550 mbar. We found that at certain temperatures, the ternary mixture of CO, CO2, and H2 yields a chemical state which is resemblant of neither the CO hydrogenation nor the CO2 hydrogenation reaction mixtures in isolation. The addition of CO2 to a CO + H2 reaction mixture mostly affects the chemical state at low-temperature FTS conditions (i.e., below 254 °C). In this temperature span, the ternary reaction mixture resulted in a carburized surface, whereas the CO + H2 reaction led to surface oxidation. We propose a hypothesis, where a carbonate intermediate produced by CO2 interaction with Fe oxide aids the reduction of the Fe oxide, paving the way for the carburization of the Fe by dissociated CO. Very small differences in the spectra of the CO + H2 and the CO + CO2 + H2 reaction mixtures were observed above 254 °C, suggesting that the CO2 is a spectator in these conditions. Changing the total pressure of both the CO hydrogenation and ternary reaction mixture causes quantitative changes in the spectra at both low- and high-temperature FTS conditions, the degree of oxidation/carburization was affected in the low-temperature-FTS regime, and the degree of hydrocarbon build-up was affected in the high-temperature-FTS.
|
|
| 2. |
- Gleißner, Robert, et al.
(författare)
-
Role of Oxidation–Reduction Dynamics in the Application of Cu/ZnO-Based Catalysts
- 2023
-
Ingår i: ACS Applied Nano Materials. - 2574-0970. ; 6:9, s. 8004-8016
-
Tidskriftsartikel (refereegranskat)abstract
- We investigated Cu nanoparticles (NPs) on vicinal and basal ZnO supports to obtain an atomistic picture of the catalyst’s structure under in situ oxidizing and reducing conditions. The Cu/ZnO model catalysts were investigated at elevated gas pressures by high energy grazing incidence X-ray diffraction and ambient pressure X-ray photoelectron spectroscopy (AP-XPS). We find that the Cu nanoparticles are fully oxidized to Cu2O under atmospheric conditions at room temperature. As the nanoparticles swell during oxidation, they maintain their epitaxy on basal ZnO (000 ± 1) surfaces, whereas on the vicinal ZnO (101̅4) surface, the nanoparticles undergo a coherent tilt. We find that the oxidation process is fully reversible under H2 flow at 500 K, resulting in predominantly well-aligned nanoparticles on the basal surfaces, whereas the orientation of Cu NPs on vicinal ZnO was only partially restored. The analysis of the substrate crystal truncation rods evidences the stability of basal ZnO surfaces under all gas conditions. No Cu–Zn bulk alloy formation is observed. Under CO2 flow, no diffraction signal from the nanoparticles is detected, pointing to their completely disordered state. The AP-XPS results are in line with the formation of CuO. Scanning electron microscopy images show that massive mass transport has set in, leading to the formation of larger agglomerates.
|
|
| 3. |
- Boscolo Bibi, Sara, 1993-, et al.
(författare)
-
Multi-spectroscopic study of electrochemically-formed oxide-derived gold electrodes
- 2024
-
Ingår i: Physical Chemistry, Chemical Physics - PCCP. - : Royal Society of Chemistry. - 1463-9076 .- 1463-9084. ; 26:3, s. 2332-2340
-
Tidskriftsartikel (refereegranskat)abstract
- Oxide-derived metals are produced by reducing an oxide precursor. These materials, including gold, have shown improved catalytic performance over many native metals. The origin of this improvement for gold is not yet understood. In this study, operando non-resonant sum frequency generation (SFG) and ex situ high-pressure X-ray photoelectron spectroscopy (HP-XPS) have been employed to investigate electrochemically-formed oxide-derived gold (OD-Au) from polycrystalline gold surfaces. A range of different oxidizing conditions were used to form OD-Au in acidic aqueous medium (H3PO4, pH = 1). Our electrochemical data after OD-Au is generated suggest that the surface is metallic gold, however SFG signal variations indicate the presence of subsurface gold oxide remnants between the metallic gold surface layer and bulk gold. The HP-XPS results suggest that this subsurface gold oxide could be in the form of Au2O3 or Au(OH)3. Furthermore, the SFG measurements show that with reducing electrochemical treatments the original gold metallic state can be restored, meaning the subsurface gold oxide is released. This work demonstrates that remnants of gold oxide persist beneath the topmost gold layer when the OD-Au is created, potentially facilitating the understanding of the improved catalytic properties of OD-Au.
|
|
