| 1. |
-
Overview of the JET results
- 2015
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 0029-5515 .- 1741-4326. ; 55:10
-
Tidskriftsartikel (refereegranskat)
|
|
| 2. |
- Abel, I, et al.
(författare)
-
Overview of the JET results with the ITER-like wall
- 2013
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
-
Tidskriftsartikel (refereegranskat)abstract
- Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
|
|
| 3. |
- Romanelli, F, et al.
(författare)
-
Overview of the JET results
- 2011
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
-
Tidskriftsartikel (refereegranskat)abstract
- Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
|
|
| 4. |
- Torrisi, Lorenzo, et al.
(författare)
-
High intensity laser-generating plasmas in forward direction in thin films and Thomson parabola spectrometer monitorage
- 2010
-
Rapport (övrigt vetenskapligt/konstnärligt)abstract
- Asterix laser at PALS Laboratory of Prague, operating at 1315 nm fundamental wavelength, 300 ps pulse duration, 1016 W/cm2 intensity and single pulse mode, was employed to irradiate thin hydrogenated targets placed in high vacuum. Non-equilibrium plasmas were obtained in forward direction, i.e. along the normal to the target surface on the rear of the irradiated thin films. Plasmas were monitored with different ion detectors, placed around the direction normal to the target. The main detector was a Thomson parabola spectrometer aligned along the normal in forward direction. This spectrometer permits to provide many plasma parameters concerning the involved ions (energy, charge state, mass,...) obtained in a single laser shot. The spectrometer images, obtained by using a MCP coupled to a fast CCD camera, can be processed by a comparison with the simulation data obtained by a proper software. High ion energies and charge states have been obtained as a function of the laser parameters, target thickness and composition and irradiation conditions.
|
|
| 5. |
- Torrisi, Lorenzo, et al.
(författare)
-
Proton driven acceleration by intense laser pulses irradiating thin hydrogenated targets
- 2013
-
Ingår i: Applied Surface Science. - : Elsevier. - 0169-4332 .- 1873-5584. ; 272, s. 2-5
-
Tidskriftsartikel (refereegranskat)abstract
- The Asterix iodine laser of the PALS laboratory in Prague, operating at 1315 nm fundamental frequency, 300 ps pulse duration, 600 J maximum pulse energy and 1016 W/cm2 intensity, is employed to irradiatethin hydrogenated targets placed in high vacuum. Different metallic and polymeric targets allow togenerate multi-energetic and multi-specie ion beams showing peculiar properties. The plasma obtainedby the laser irradiation is monitored, in terms of properties of the emitted charge particles, by using time-of-flight techniques and Thomson parabola spectrometer (TPS). A particular attention is given tothe proton beam production in terms of the maximum energy, emission yield and angular distributionas a function of the laser energy, focal position (FP), target thickness and composition.
|
|
| 6. |
- Fennell, David A., et al.
(författare)
-
Tourism, animals & the vacant niche : a scoping review and pedagogical agenda
- 2024
-
Ingår i: Current Issues in Tourism. - : Routledge. - 1368-3500 .- 1747-7603. ; , s. 1-29
-
Tidskriftsartikel (refereegranskat)abstract
- The topic of animal ethics has advanced in tourism studies since its inception in 2000, based on a diverse range of studies on species involvement, types of uses and contexts, level of engagement, states of animals, and theoretical perspectives. While there is still considerable scope to amplify research on animal-based tourism, a gap exists in tourism pedagogy amidst the field’s emphasis on a new expanding consciousness platform. We review the depth of existing scholarship on animal ethics in tourism and develop an agenda for advancing animal ethics pedagogy for the future. Our intent is to issue a call to action for curriculum committees, programme administrators, and educators to recognise and act on this critical moral domain in tourism education.
|
|
| 7. |
- Cecconello, Marco, et al.
(författare)
-
Strategy and guidelines for the calibration of the ITER Radial Neutron Camera
- 2019
-
Ingår i: Fusion engineering and design. - : ELSEVIER SCIENCE SA. - 0920-3796 .- 1873-7196. ; 146, s. 2049-2052
-
Tidskriftsartikel (refereegranskat)abstract
- A calibration procedure is proposed for ITER Radial Neutron Camera that relies on embedded sources, reference ITER pulses and cross-calibration with ITER fission chambers and activation system coupled to Monte Carlo simulations of radiation transport. The proposed procedure would allow to measure the neutron emissivity profile and of the fusion power with 10 % accuracy and precision, a time resolution of 10 ms and a spatial resolution of a/10 for ITER entire life-time.
|
|
