SwePub
Sök i SwePub databas

  Utökad sökning

Träfflista för sökning "WFRF:(Valeri V) "

Sökning: WFRF:(Valeri V)

  • Resultat 1-10 av 15
Sortera/gruppera träfflistan
   
NumreringReferensOmslagsbildHitta
1.
  • Casolino, M., et al. (författare)
  • Cosmic ray measurements with Pamela experiment
  • 2009
  • Konferensbidrag (refereegranskat)abstract
    • PAMELA is a satellite borne experiment designed to study with great accuracy cosmic rays of galactic, solar, and trapped nature hi a wide energy range (protons: 80 MeV-700 GeV, electrons 50 MeV-400 GeV). Main objective is the study of the antimatter component: antiprotons (80 MeV-190 GeV), positrons (50 MeV-270 GeV) and search for antinuclei with a precision of the order of 10(-8)). The experiment, housed on board the Russian Resurs-DK1 satellite, was launched on June, 15(th) 2006 in a 350 X 600 km orbit with an inclination of 70 degrees. In this work we describe the scientific objectives awl the performance of PAMELA in its first two years of operation. Data oil protons of trapped, secondary and galactic nature - as well as measurements of the December 13(th) 2006 Solar Particle Event - are also provided.
  •  
2.
  • Gladush, G. G., et al. (författare)
  • Studying the mechanisms of steel sheet perforation by the radiation of a continuous-wave fiber laser
  • 2016
  • Ingår i: Bulletin of the Russian Academy of Sciences: Physics. - 1062-8738 .- 1934-9432. ; 80:4, s. 393-396
  • Tidskriftsartikel (refereegranskat)abstract
    • Aspects of steel sheet perforation are studied experimentally. Calculations show that the mechanisms of thin sheet perforation change as the focal spot size is increased at a constant laser power. If the spot is small, the melt is removed and the film is disrupted by steel boiling in the spot center. With larger spots, the melt is removed by the force of gravity. The hole diameter grows along with the focal spot size and sheet thickness and is reduced upon an increase in laser power.
  •  
3.
  •  
4.
  • Yang, Junfeng, 1979, et al. (författare)
  • 3D CFD modeling of a biodiesel-fueled diesel engine based on a detailed chemical mechanism
  • 2012
  • Ingår i: SAE Technical Papers. - 400 Commonwealth Drive, Warrendale, PA, United States : SAE International. - 0148-7191 .- 2688-3627.
  • Tidskriftsartikel (refereegranskat)abstract
    • A detailed reaction mechanism for the combustion of biodiesel fuels has recently been developed by Westbrook and co-workers [1]. This detailed mechanism involves 5037 species and 19990 reactions, which prohibits its direct use in computational fluid dynamic (CFD) applications. In the present work, various mechanism reduction methods included in the Reaction Workbench software [2] were used to derive a semi-detailed biodiesel combustion mechanism, while maintaining the accuracy of the master mechanism for a desired set of engine conditions. The reduced combustion mechanism for a five-component biodiesel fuel was employed in the FORTÉ CFD simulation package [3] to take advantage of advanced chemistry solver methodologies and advanced spray models. Simulations were performed for a Volvo D12C heavy diesel engine fueled by RME fuel using a 72° sector mesh. Predictions were validated against measured in-cylinder parameters and exhaust emission concentrations. The semi-detailed mechanism was shown to be an efficient and accurate representation of actual biodiesel combustion and emissions formation.
  •  
5.
  •  
6.
  •  
7.
  • Maslova, Marina V., et al. (författare)
  • Extended study on the synthesis of amorphous titanium phosphates with tailored sorption properties
  • 2012
  • Ingår i: Journal of Non-Crystalline Solids. - : Elsevier BV. - 0022-3093 .- 1873-4812. ; 358:22, s. 2943-2950
  • Tidskriftsartikel (refereegranskat)abstract
    • The influence of concentrations of both TiO2 and H2SO4 in the syntheses of amorphous titanium phosphates (TiP) is reported. IR, XRD, TGA, BET and NMR techniques were used to characterise the isolated TiP products. The concentration of sulphuric acid in the initial synthesis plays a major role in the structural diversity and sorption properties of the final ionites. In the primary solutions, Ti(IV) is in monomeric, polymeric and colloidal forms. Upon addition of H3PO4 the presence of monomeric titanium ensures formation of the Ti(HPO4)2 phase. The polymeric Ti(IV) is responsible for formation of the titanium hydroxo-phosphate phase, Ti(OH)2(HPO4), whilst the colloidal form of Ti(IV) appears to have a role in coagulation of a minor Ti(OH)4 phase in an amorphous TiP. It is found that TiP ion-exchange capacities gradually increase with an increase of both TiO2 and H2SO4 concentrations and reach a maximum value of 3.8 mg-eq g− 1 when TiO2 is 70–100 g L− 1 and H2SO4 is 480–560 g L− 1. Analyses of compositional, structural and sorption data allowed 3D correlation diagrams to be built that can facilitate fabrication of TiP with tailored sorption properties.
  •  
8.
  •  
9.
  • Maurichi, A, et al. (författare)
  • Reply to E. Hindié
  • 2020
  • Ingår i: Journal of clinical oncology : official journal of the American Society of Clinical Oncology. - 1527-7755. ; 38:27, s. 3238-
  • Tidskriftsartikel (övrigt vetenskapligt/konstnärligt)
  •  
10.
  •  
Skapa referenser, mejla, bekava och länka
  • Resultat 1-10 av 15

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy