| 1. |
- Abelev, Betty, et al.
(författare)
-
Long-range angular correlations on the near and away side in p-Pb collisions at root S-NN=5.02 TeV
- 2013
-
Ingår i: Physics Letters. Section B: Nuclear, Elementary Particle and High-Energy Physics. - : Elsevier BV. - 0370-2693. ; 719:1-3, s. 29-41
-
Tidskriftsartikel (refereegranskat)abstract
- Angular correlations between charged trigger and associated particles are measured by the ALICE detector in p-Pb collisions at a nucleon-nucleon centre-of-mass energy of 5.02 TeV for transverse momentum ranges within 0.5 < P-T,P-assoc < P-T,P-trig < 4 GeV/c. The correlations are measured over two units of pseudorapidity and full azimuthal angle in different intervals of event multiplicity, and expressed as associated yield per trigger particle. Two long-range ridge-like structures, one on the near side and one on the away side, are observed when the per-trigger yield obtained in low-multiplicity events is subtracted from the one in high-multiplicity events. The excess on the near-side is qualitatively similar to that recently reported by the CMS Collaboration, while the excess on the away-side is reported for the first time. The two-ridge structure projected onto azimuthal angle is quantified with the second and third Fourier coefficients as well as by near-side and away-side yields and widths. The yields on the near side and on the away side are equal within the uncertainties for all studied event multiplicity and p(T) bins, and the widths show no significant evolution with event multiplicity or p(T). These findings suggest that the near-side ridge is accompanied by an essentially identical away-side ridge. (c) 2013 CERN. Published by Elsevier B.V. All rights reserved.
|
|
| 2. |
- Abelev, Betty, et al.
(författare)
-
Measurement of prompt J/psi and beauty hadron production cross sections at mid-rapidity in pp collisions at root s=7 TeV
- 2012
-
Ingår i: Journal of High Energy Physics. - 1029-8479. ; :11
-
Tidskriftsartikel (refereegranskat)abstract
- The ALICE experiment at the LHC has studied J/psi production at mid-rapidity in pp collisions at root s = 7 TeV through its electron pair decay on a data sample corresponding to an integrated luminosity L-int = 5.6 nb(-1). The fraction of J/psi from the decay of long-lived beauty hadrons was determined for J/psi candidates with transverse momentum p(t) > 1,3 GeV/c and rapidity vertical bar y vertical bar < 0.9. The cross section for prompt J/psi mesons, i.e. directly produced J/psi and prompt decays of heavier charmonium states such as the psi(2S) and chi(c) resonances, is sigma(prompt J/psi) (p(t) > 1.3 GeV/c, vertical bar y vertical bar < 0.9) = 8.3 +/- 0.8(stat.) +/- 1.1 (syst.)(-1.4)(+1.5) (syst. pol.) mu b. The cross section for the production of b-hadrons decaying to J/psi with p(t) > 1.3 GeV/c and vertical bar y vertical bar < 0.9 is a sigma(J/psi <- hB) (p(t) > 1.3 GeV/c, vertical bar y vertical bar < 0.9) = 1.46 +/- 0.38 (stat.)(-0.32)(+0.26) (syst.) mu b. The results are compared to QCD model predictions. The shape of the p(t) and y distributions of b-quarks predicted by perturbative QCD model calculations are used to extrapolate the measured cross section to derive the b (b) over bar pair total cross section and d sigma/dy at mid-rapidity.
|
|
| 3. |
- Hiller, Johannes, et al.
(författare)
-
The L3Pilot Data Management Toolchain for a Level 3 Vehicle Automation Pilot
- 2020
-
Ingår i: Electronics (Switzerland). - : MDPI AG. - 2079-9292. ; 9:5
-
Tidskriftsartikel (refereegranskat)abstract
- As industrial research in automated driving is rapidly advancing, it is of paramount importance to analyze field data from extensive road tests. This paper investigates the design and development of a toolchain to process and manage experimental data to answer a set of research questions about the evaluation of automated driving functions at various levels, from technical system functioning to overall impact assessment. We have faced this challenge in L3Pilot, the first comprehensive test of automated driving functions (ADFs) on public roads in Europe. L3Pilot is testing ADFs in vehicles made by 13 companies. The tested functions are mainly of Society of Automotive Engineers (SAE) automation level 3, some of them of level 4. In this context, the presented toolchain supports various confidentiality levels, and allows cross-vehicle owner seamless data management, with the efficient storage of data and their iterative processing with a variety of analysis and evaluation tools. Most of the toolchain modules have been developed to a prototype version in a desktop/cloud environment, exploiting state-of-the-art technology. This has allowed us to efficiently set up what could become a comprehensive edge-to-cloud reference architecture for managing data in automated vehicle tests. The project has been released as open source, the data format into which all vehicular signals, recorded in proprietary formats, were converted, in order to support efficient processing through multiple tools, scalability and data quality checking. We expect that this format should enhance research on automated driving testing, as it provides a shared framework for dealing with data from collection to analysis. We are confident that this format, and the information provided in this article, can represent a reference for the design of future architectures to implement in vehicles.
|
|
| 4. |
- Hämmerle, Christoph H F, et al.
(författare)
-
Biology of soft tissue wound healing and regeneration : consensus report of group 1 of the 10th European workshop on periodontology
- 2014
-
Ingår i: Journal of Clinical Periodontology. - : John Wiley & Sons. - 0303-6979 .- 1600-051X. ; 41:s15, s. S1-S5
-
Tidskriftsartikel (övrigt vetenskapligt/konstnärligt)abstract
- BACKGROUND:The scope of this consensus was to review the biological processes of soft tissue wound healing in the oral cavity and to histologically evaluate soft tissue healing in clinical and pre-clinical models. AIMS:To review the current knowledge regarding the biological processes of soft tissue wound healing at teeth, implants and on the edentulous ridge. Furthermore, to review soft tissue wound healing at these sites, when using barrier membranes, growth and differentiation factors and soft tissue substitutes. COLLECTION OF DATA:Searches of the literature with respect to recessions at teeth and soft tissue deficiencies at implants, augmentation of the area of keratinized tissue and soft tissue volume were conducted. The available evidence was collected, categorized and summarized. FUNDAMENTAL PRINCIPLES OF ORAL SOFT TISSUE WOUND HEALING:Oral mucosal and skin wound healing follow a similar pattern of the four phases of haemostasis, inflammation, proliferation and maturation/matrix remodelling. The soft connective tissue determines the characteristics of the overlaying oral epithelium. Within 7-14 days, epithelial healing of surgical wounds at teeth is completed. Soft tissue healing following surgery at implants requires 6-8 weeks for maturation. The resulting tissue resembles scar tissue. Well-designed pre-clinical studies providing histological data have been reported describing soft tissue wound healing, when using barrier membranes, growth and differentiation factors and soft tissue substitutes. Few controlled clinical studies with low numbers of patients are available for some of the treatments reviewed at teeth. Whereas, histological new attachment has been demonstrated in pre-clinical studies resulting from some of the treatments reviewed, human histological data commonly report a lack of new attachment but rather long junctional epithelial attachment and connective tissue adhesion. Regarding soft tissue healing at implants human data are very scarce. CONCLUSIONS:Oral soft tissue healing at teeth, implants and the edentulous ridge follows the same phases as skin wound healing. Histological studies in humans have not reported new attachment formation at teeth for the indications studied. Human histological data of soft tissue wound healing at implants are limited. CLINICAL RECOMMENDATIONS:The use of barriers membranes, growth and differentiation factors and soft tissue substitutes for the treatment of localized gingival/mucosal recessions, insufficient amount of keratinized tissue and insufficient soft tissue volume is at a developing stage.
|
|
| 5. |
- Höbig, Nicole, et al.
(författare)
-
Lake Banyoles (northeastern Spain) : A Last Glacial to Holocene multi-proxy study with regard to environmental variability and human occupation
- 2012
-
Ingår i: Quaternary International. - Oxford : Elsevier. - 1040-6182 .- 1873-4553. ; 274, s. 205-218
-
Tidskriftsartikel (refereegranskat)abstract
- Analyses of a 67-m long sediment core from Lake Banyoles (northeastern Spain) have revealed evidence for the palaeoclimate history of the northern Iberian Peninsula. Investigations have included high-resolution and non-destructive sediment-physical, geochemical, and optical methods to generate proxies indicative of sedimentologic variability and climate change. Primary stratigraphic control is based on C-14 and U-series dates of organic and inorganic material, as well as tephra from the Late Pleistocene Olot volcanic episode. While preliminary ages obtained for the core base date back to approximately 60 ka, the Last Glacial Maximum (23-19 ka) interval ends at 15 m. The top 8 m of deposits accumulated in the Holocene. Several slump events were observed in the core section, as were microtectonic structures, which constrain the movement. Evidence for palaeoclimate variations in element ratios is interpreted to represent effects of Heinrich Events H0-H5. Associated changes in environmental conditions (e.g., humidity) may have affected human occupation during the Palaeolithic-Neolithic period. Implications on human occupation in northeastern Iberia due to climate changes are discussed from archeological findings and cave sediments in neighboring areas and are analyzed with respect to the palaeolimnologic of lake Banyoles. (C) 2012 Elsevier Ltd and INQUA. All rights reserved.
|
|
| 6. |
- Kattge, Jens, et al.
(författare)
-
TRY plant trait database - enhanced coverage and open access
- 2020
-
Ingår i: Global Change Biology. - : Wiley-Blackwell. - 1354-1013 .- 1365-2486. ; 26:1, s. 119-188
-
Tidskriftsartikel (refereegranskat)abstract
- Plant traits-the morphological, anatomical, physiological, biochemical and phenological characteristics of plants-determine how plants respond to environmental factors, affect other trophic levels, and influence ecosystem properties and their benefits and detriments to people. Plant trait data thus represent the basis for a vast area of research spanning from evolutionary biology, community and functional ecology, to biodiversity conservation, ecosystem and landscape management, restoration, biogeography and earth system modelling. Since its foundation in 2007, the TRY database of plant traits has grown continuously. It now provides unprecedented data coverage under an open access data policy and is the main plant trait database used by the research community worldwide. Increasingly, the TRY database also supports new frontiers of trait-based plant research, including the identification of data gaps and the subsequent mobilization or measurement of new data. To support this development, in this article we evaluate the extent of the trait data compiled in TRY and analyse emerging patterns of data coverage and representativeness. Best species coverage is achieved for categorical traits-almost complete coverage for 'plant growth form'. However, most traits relevant for ecology and vegetation modelling are characterized by continuous intraspecific variation and trait-environmental relationships. These traits have to be measured on individual plants in their respective environment. Despite unprecedented data coverage, we observe a humbling lack of completeness and representativeness of these continuous traits in many aspects. We, therefore, conclude that reducing data gaps and biases in the TRY database remains a key challenge and requires a coordinated approach to data mobilization and trait measurements. This can only be achieved in collaboration with other initiatives.
|
|
| 7. |
|
|
| 8. |
- Meyer-Jacob, Carsten, 1984-, et al.
(författare)
-
Independent measurement of biogenic silica in sediments by FTIR spectroscopy and PLS regression
- 2014
-
Ingår i: Journal of Paleolimnology. - : Springer Netherlands. - 0921-2728 .- 1573-0417. ; 52:3, s. 245-255
-
Tidskriftsartikel (refereegranskat)abstract
- We present an independent calibration model for the determination of biogenic silica (BSi) in sediments, developed from analysis of synthetic sediment mixtures and application of Fourier transform infrared spectroscopy (FTIRS) and partial least squares regression (PLSR) modeling. In contrast to current FTIRS applications for quantifying BSi, this new calibration is independent from conventional wet-chemical techniques and their associated measurement uncertainties. This approach also removes the need for developing internal calibrations between the two methods for individual sediments records. For the independent calibration, we produced six series of different synthetic sediment mixtures using two purified diatom extracts, with one extract mixed with quartz sand, calcite, 60/40 quartz/calcite and two different natural sediments, and a second extract mixed with one of the natural sediments. A total of 306 samples-51 samples per series-yielded BSi contents ranging from 0 to 100 %. The resulting PLSR calibration model between the FTIR spectral information and the defined BSi concentration of the synthetic sediment mixtures exhibits a strong cross-validated correlation ( = 0.97) and a low root-mean square error of cross-validation (RMSECV = 4.7 %). Application of the independent calibration to natural lacustrine and marine sediments yields robust BSi reconstructions. At present, the synthetic mixtures do not include the variation in organic matter that occurs in natural samples, which may explain the somewhat lower prediction accuracy of the calibration model for organic-rich samples.
|
|
| 9. |
|
|
| 10. |
|
|
