| 1. |
- Dujon, B, et al.
(författare)
-
The nucleotide sequence of Saccharomyces cerevisiae chromosome XV
- 1997
-
Ingår i: Nature. - : Springer Science and Business Media LLC. - 0028-0836 .- 1476-4687. ; 387:6632, s. 98-102
-
Tidskriftsartikel (refereegranskat)abstract
- Chromosome XV was one of the last two chromosomes of Saccharomyces cerevisiae to be discovered(1). It is the third-largest yeast chromosome after chromosomes XII and IV, and is very similar in size to chromosome VII. It alone represents 9% of the yeast genome (8% if ribosomal DNA is included). When systematic sequencing of chromosome XV was started, 93 genes or markers were identified, and most of them were mapped(2). However, very little else was known about chromosome XV which, in contrast to shorter chromosomes, had not been the object of comprehensive genetic or molecular analysis. It was therefore decided to start sequencing chromosome XV only in the third phase of the European Yeast Genome Sequencing Programme, after experience was gained on chromosomes III, XI and II (refs 3-5). The sequence of chromosome XV has been determined from a set of partly overlapping cosmid clones derived from a unique yeast strain, and physically mapped at 3.3-kilobase resolution before sequencing. As well as numerous new open reading frames (ORFs) and genes encoding tRNA or small RNA molecules, the sequence of 1,091,283 base pairs confirms the high proportion of orphan genes and reveals a number of ancestral and successive duplications with other yeast chromosomes.
|
|
| 2. |
- Böckler, H B, et al.
(författare)
-
Metrology infrastructure for high-pressure gas and liquified hydrogen flows. A brief outline of the MetHyInfra project, measurement challenges, and first results
- 2024
-
Ingår i: Measurement. - : Elsevier B.V.. - 0263-2241 .- 1873-412X. ; 232
-
Tidskriftsartikel (refereegranskat)abstract
- This paper gives an overview of the ongoing Joint Research Project (JRP) 20IND11 “Metrology infrastructure for high pressure gas and liquefied hydrogen flows” (MetHyInfra), which will ensure traceability in the hydrogen distribution chain. For this purpose, very precise nozzles with well-defined geometries have been produced. In this project, Critical Flow Venturi Nozzles (CFVNs) will be traceably calibrated for the first time with hydrogen and pressures up to 100 MPa using a Coriolis Flow Meter (CFM) as a secondary standard. A CFM has been successfully calibrated with hydrogen against a gravimetric primary standard. Equations of State (EoS) are important for the high-pressure calibration of the nozzles, but also for Computational Fluid Dynamics (CFD) simulations. With regard to CFD, a numerical model has been developed to simulate high pressure hydrogen flow in the CFVN. In a parameter study, non-ideal nozzle shapes are investigated using a shape variation parameter. New Speed of Sound (SoS) measurements were conducted at temperatures from 273 to 323 K and pressures from 1 to 100 MPa. These new data were then used to develop a new EoS for normal hydrogen, optimized for gas phase calculations. In addition to gaseous hydrogen, the project has a strong focus on liquefied hydrogen. Here a three-pronged approach allows traceable measurements. Each of the approaches presented is based on a unique flow calibration principle and relies on independent traceability schemes. The results of the project will ensure traceable measurements and thus a higher level of confidence among end users. © 2024 The Authors
|
|
