| 1. |
- Han, Yanting, et al.
(författare)
-
Green preparation of antibacterial shape memory foam based on bamboo cellulose nanofibril and waterborne polyurethane for adaptive relief of plantar pressure
- 2024
-
Ingår i: International Journal of Biological Macromolecules. - : Elsevier BV. - 0141-8130 .- 1879-0003. ; 256
-
Tidskriftsartikel (refereegranskat)abstract
- This study developed an aqueous solution blending and freeze-drying method to prepare an antibacterial shape memory foam (WPPU/CNF) based on waterborne PHMG-polyurethane and cellulose nanofibers derived from bamboo in response to the increasing demand for environmentally friendly, energy conserving, and multifunctional foams. The obtained WPPU/CNF composite foam has a highly porous network structure with well-dispersed CNFs forming hydrogen bonds with the WPPU matrix, which results in a stable and rigid cell skeleton with enhanced mechanical properties (80 KPa) and anti-abrasion ability. The presence of guanidine in the polyurethane chain endowed the WPPU/CNF composite foam with an instinctive and sustained antibacterial ability against Escherichia coli and Staphylococcus aureus. The WPPU/CNF composite foam exhibited a water-sensitive shape memory function in a cyclic shape memory program because of the chemomechanical adaptability of the hydrogen-bonded network of CNFs in the elastomer matrix. The shape-fixation ratio for local compression reached 95 %, and the shape-recovery rate reached 100 %. This allows the WPPU/CNF pad prototype to reversibly adjust the undulation height to adapt to plantar ulcers, which can reduce the local plantar pressure by 60 %. This study provides an environmentally friendly strategy for cellulose-based composite fabrication and enriches the design and application of intelligent foam devices.
|
|
| 2. |
- Koskela, Salla, et al.
(författare)
-
Lytic polysaccharide monooxygenase (LPMO) mediated production of ultra-fine cellulose nanofibres from delignified softwood fibres
- 2019
-
Ingår i: Green Chemistry. - : Royal Society of Chemistry. - 1463-9262 .- 1463-9270. ; 21:21, s. 5924-5933
-
Tidskriftsartikel (refereegranskat)abstract
- The production of cellulose nanofibres (CNFs) typically requires harsh chemistry and strong mechanical fibrillation, both of which have negative environmental impacts. A possible solution is offered by lytic polysaccharide monooxygenases (LPMOs), oxidative enzymes that boost cellulose fibrillation. Although the role of LPMOs in oxidative modification of cellulosic substrates is rather well established, their use in the production of cellulose nanomaterials is not fully explored, and the effect of the carbohydrate-binding module (CBM) on nanofibrillation has not yet been reported. Herein, we studied the activity of two LPMOs, one of which was appended to a CBM, on delignified softwood fibres for green and energy-efficient production of CNFs. The CNFs were used to prepare cellulose nanopapers, and the structure and properties of both nanofibres and nanopapers were determined. Both enzymes were able to facilitate nanocellulose fibrillation and increase colloidal stability of the produced CNFs. However, the CBM-lacking LPMO was more efficient in introducing carboxyl groups (0.53 mmol/g) on the cellulose fibre surfaces and releasing CNFs with thinner width (4.3 ± 1.5 nm) from delignified spruce fibres than the modular LPMO (carboxylate content of 0.38 mmol/g and nanofibre width of 6.7± 2.5 nm through LPMO pretreatment followed by mild homogenisation. The prepared nanopapers showed improved mechanical properties (tensile strength of 262 MPa, and modulus of 16.2 GPa) compared to conventional CNFs preparation methods, demonstrating the potential of LPMOs as green alternatives for cellulose nanomaterials preparation.
|
|
| 3. |
- Xu, Dingfeng, et al.
(författare)
-
Surface Charges Control the Structure and Properties of Layered Nanocomposite of Cellulose Nanofibrils and Clay Platelets
- 2021
-
Ingår i: ACS Applied Materials and Interfaces. - : AMER CHEMICAL SOC. - 1944-8244 .- 1944-8252. ; 13:3, s. 4463-4472
-
Tidskriftsartikel (refereegranskat)abstract
- The interfacial bonding and structure at the nanoscale in the polymer-clay nanocomposites are essential for obtaining desirable material and structure properties. Layered nanocomposite films of cellulose nanofibrils (CNFs)/montmorillonite (MTM) were prepared from the water suspensions of either CNFs bearing quaternary ammonium cations (Q-CNF) or CNFs bearing carboxylate groups (TO-CNF) with MTM nanoplatelets carrying net surface negative charges by using vacuum filtration followed by compressive drying. The effect of the ionic interaction between cationic or anionic charged CNFs and MTM nanoplatelets on the structure, mechanical properties, and flame retardant performance of the TO-CNF/MTM and Q-CNF/MTM nanocomposite films were studied and compared. The MTM nanoplatelets were well dispersed in the network of TO-CNFs in the form of nanoscale tactoids with the MTM content in the range of 5-70 wt %, while an intercalated structure was observed in the Q-CNF/MTM nanocomposites. The resulting TO-CNF/MTM nanocomposite films had a better flame retardant performance as compared to the QCNF/MTM films with the same MTM content. In addition, the effective modulus of MTM for the TO-CNF/MTM nanocomposites was as high as 129.9 GPa, 3.5 times higher than that for Q-CNF/MTM (37.1 GPa). On the other hand, the Q-CNF/MTM nanocomposites showed a synergistic enhancement in the modulus and tensile strength together with strain-to-failure and demonstrated a much better toughness as compared to the TO-CNF/MTM nanocomposites.
|
|
