| 1. |
- Dong, Y. B., et al.
(författare)
-
High Light Extraction Efficiency AlGaInP LEDs With Proton Implanted Current Blocking Layer
- 2016
-
Ingår i: IEEE Electron Device Letters. - : Institute of Electrical and Electronics Engineers (IEEE). - 0741-3106 .- 1558-0563. ; 37:10, s. 1303-1306
-
Tidskriftsartikel (refereegranskat)abstract
- Improving light extraction efficiency is the key issue for light-emitting diodes (LEDs). Nowadays, a vertical structure design dominates LEDs. However, the light from the active region just below the p-electrode is severely blocked by the metal contact. In this letter, we use proton implantation with a depth all the way to the active region to turn the part beneath the p-pad insulating, which constitutes the most-effective-ever current blocking method. Earlier particle implantation studies never reached the device active region. Our experimental results show that the H+-implanted LEDs improve the light output power by 75% compared with non-implanted counterparts and the light intensity increases by 64.48%. By virtue of indium tin oxide current spreading film, the increase in working voltage is negligible. Analyzing the reverse leakage current, the side effect associated with the implantation is limited to an acceptable range. Numerical simulation is performed to support the experiment. Our results represent a new and simple method for solving the light blocking problem in vertical LEDs, without introducing the seemingly existing severe implantation damage to the device structure.
|
|
| 2. |
- Kong, Z., et al.
(författare)
-
Growth and Strain Modulation of GeSn Alloys for Photonic and Electronic Applications
- 2022
-
Ingår i: Nanomaterials. - : MDPI AG. - 2079-4991. ; 12:6
-
Tidskriftsartikel (refereegranskat)abstract
- GeSn materials have attracted considerable attention for their tunable band structures and high carrier mobilities, which serve well for future photonic and electronic applications. This research presents a novel method to incorporate Sn content as high as 18% into GeSn layers grown at 285–320◦C by using SnCl4 and GeH4 precursors. A series of characterizations were performed to study the material quality, strain, surface roughness, and optical properties of GeSn layers. The Sn content could be calculated using lattice mismatch parameters provided by X-ray analysis. The strain in GeSn layers was modulated from fully strained to partially strained by etching Ge buffer into Ge/GeSn heterostructures . In this study, two categories of samples were prepared when the Ge buffer was either laterally etched onto Si wafers, or vertically etched Ge/GeSnOI wafers which bonded to the oxide. In the latter case, the Ge buffer was initially etched step-by-step for the strain relaxation study. Meanwhile, the Ge/GeSn heterostructure in the first group of samples was patterned into the form of micro-disks. The Ge buffer was selectively etched by using a CF4/O2 gas mixture using a plasma etch tool. Fully or partially relaxed GeSn micro-disks showed photoluminescence (PL) at room temperature. PL results showed that red-shift was clearly observed from the GeSn microdisk structure, indicating that the compressive strain in the as-grown GeSn material was partially released. Our results pave the path for the growth of high quality GeSn layers with high Sn content, in addition to methods for modulating the strain for lasing and detection of short-wavelength infrared at room temperature.
|
|
| 3. |
- Pan, G. Z., et al.
(författare)
-
Large-Scale Proton-Implant-Defined VCSEL Arrays with Narrow Beamwidth
- 2018
-
Ingår i: IEEE Electron Device Letters. - 0741-3106 .- 1558-0563. ; 39:3, s. 390-393
-
Tidskriftsartikel (refereegranskat)abstract
- In-phase coherently coupled proton-implant-defined vertical cavity surface emitting laser (VCSEL) arrays face difficulties in current spreading, resulting in small array scale, low output power, and broad beamwidth. Although patterned metal grids can improve the current spreading, the undesirable out-of-phase mode tends to be dominant in the array. In this letter, by means of engineering the implantation and array parameters, in-phase mode is obtained in large-scale proton-implant-defined arrays with metal grids. Experimental results show that these arrays are operating in in-phase mode with a nominal interelement spacing of 8 μm and an implantation depth of 2.22 μm. By using these parameters, a 5 × 5 in-phase array with a narrow beamwidth (far-field full width at half maximum) of 1.61° is realized. Besides, a 10 × 10 in-phase array with a beamwidth of 1.89° and an output power of 10.25 mW for the in-phase mode is achieved. The calculation of far fields is performed to confirm the in-phase operation measured results. Such a simple and low-cost technology provides a promising method for preparing large-scale in-phase coherently coupled VCSEL arrays.
|
|
| 4. |
- Xu, K., et al.
(författare)
-
GaN nanorod light emitting diodes with suspended graphene transparent electrodes grown by rapid chemical vapor deposition
- 2013
-
Ingår i: Applied Physics Letters. - : AIP Publishing. - 0003-6951 .- 1077-3118. ; 103:22, s. 5-
-
Tidskriftsartikel (refereegranskat)abstract
- Ordered and dense GaN light emitting nanorods are studied with polycrystalline graphene grown by rapid chemical vapor deposition as suspended transparent electrodes. As the substitute of indium tin oxide, the graphene avoids complex processing to fill up the gaps between nanorods and subsequent surface flattening and offers high conductivity to improve the carrier injection. The as-fabricated devices have 32% improvement in light output power compared to conventional planar GaN-graphene diodes. The suspended graphene remains electrically stable up to 300 degrees C in air. The graphene can be obtained at low cost and high efficiency, indicating its high potential in future applications.
|
|
| 5. |
- Xu, K., et al.
(författare)
-
Graphene GaN-Based Schottky Ultraviolet Detectors
- 2015
-
Ingår i: IEEE Transactions on Electron Devices. - : Institute of Electrical and Electronics Engineers (IEEE). - 1557-9646 .- 0018-9383. ; 62:9, s. 2802-2808
-
Tidskriftsartikel (refereegranskat)abstract
- Graphene GaN-based Schottky ultraviolet detectors are fabricated. The monolayer graphene is grown by chemical vapor deposition. The graphene is much more transparent than metals, as confirmed by the fact that our devices retain their high responsivity up to 360-nm wavelength (corresponding to the band edge absorption of GaN). Importantly, by virtue of the tunable work function of graphene, the graphene GaN Schottky barrier height can be greatly enlarged. The built-in field is enhanced, and the detector performance is improved. The current ratio with and without luminescence is up to 1.6 x 10(4). The characteristic time constants of the devices are in the order of a few milliseconds. The device open-circuit voltage and short-circuit current are also increased. At last, special type Schottky devices consisting of GaN nanorods or surface-etched GaN are prepared for complementary study. It is found although the dry etching induced surface defects lead to an increase in the dark current, and these carrier traps also greatly contribute to the photoconductivity under luminescence, resulting in extraordinarily large responsivity (up to 360 A/W at -6 V).
|
|
| 6. |
|
|
| 7. |
- Aartsen, M. G., et al.
(författare)
-
Characterization of the atmospheric muon flux in IceCube
- 2016
-
Ingår i: Astroparticle physics. - : Elsevier BV. - 0927-6505 .- 1873-2852. ; 78, s. 1-27
-
Tidskriftsartikel (refereegranskat)abstract
- Muons produced in atmospheric cosmic ray showers account for the by far dominant part of the event yield in large-volume underground particle detectors. The IceCube detector, with an instrumented volume of about a cubic kilometer, has the potential to conduct unique investigations on atmospheric muons by exploiting the large collection area and the possibility to track particles over a long distance. Through detailed reconstruction of energy deposition along the tracks, the characteristics of muon bundles can be quantified, and individual particles of exceptionally high energy identified. The data can then be used to constrain the cosmic ray primary flux and the contribution to atmospheric lepton fluxes from prompt decays of short-lived hadrons. In this paper, techniques for the extraction of physical measurements from atmospheric muon events are described and first results are presented. The multiplicity spectrum of TeV muons in cosmic ray air showers for primaries in the energy range from the knee to the ankle is derived and found to be consistent with recent results from surface detectors. The single muon energy spectrum is determined up to PeV energies and shows a clear indication for the emergence of a distinct spectral component from prompt decays of short-lived hadrons. The magnitude of the prompt flux, which should include a substantial contribution from light vector meson di-muon decays, is consistent with current theoretical predictions. The variety of measurements and high event statistics can also be exploited for the evaluation of systematic effects. In the course of this study, internal inconsistencies in the zenith angle distribution of events were found which indicate the presence of an unexplained effect outside the currently applied range of detector systematics. The underlying cause could be related to the hadronic interaction models used to describe muon production in air showers.
|
|
| 8. |
- Baxter, Amanda L., et al.
(författare)
-
Collaborative experience between scientific software projects using Agile Scrum development
- 2022
-
Ingår i: Software, practice & experience. - : John Wiley & Sons. - 0038-0644 .- 1097-024X. ; 52:10, s. 2077-2096
-
Tidskriftsartikel (refereegranskat)abstract
- Developing sustainable software for the scientific community requires expertise in software engineering and domain science. This can be challenging due to the unique needs of scientific software, the insufficient resources for software engineering practices in the scientific community, and the complexity of developing for evolving scientific contexts. While open-source software can partially address these concerns, it can introduce complicating dependencies and delay development. These issues can be reduced if scientists and software developers collaborate. We present a case study wherein scientists from the SuperNova Early Warning System collaborated with software developers from the Scalable Cyberinfrastructure for Multi-Messenger Astrophysics project. The collaboration addressed the difficulties of open-source software development, but presented additional risks to each team. For the scientists, there was a concern of relying on external systems and lacking control in the development process. For the developers, there was a risk in supporting a user-group while maintaining core development. These issues were mitigated by creating a second Agile Scrum framework in parallel with the developers' ongoing Agile Scrum process. This Agile collaboration promoted communication, ensured that the scientists had an active role in development, and allowed the developers to evaluate and implement the scientists' software requirements. The collaboration provided benefits for each group: the scientists actuated their development by using an existing platform, and the developers utilized the scientists' use-case to improve their systems. This case study suggests that scientists and software developers can avoid scientific computing issues by collaborating and that Agile Scrum methods can address emergent concerns.
|
|
| 9. |
- Bentham, James, et al.
(författare)
-
A century of trends in adult human height
- 2016
-
Ingår i: eLIFE. - 2050-084X. ; 5
-
Tidskriftsartikel (refereegranskat)abstract
- Being taller is associated with enhanced longevity, and higher education and earnings. We reanalysed 1472 population-based studies, with measurement of height on more than 18.6 million participants to estimate mean height for people born between 1896 and 1996 in 200 countries. The largest gain in adult height over the past century has occurred in South Korean women and Iranian men, who became 20.2 cm (95% credible interval 17.522.7) and 16.5 cm (13.319.7) taller, respectively. In contrast, there was little change in adult height in some sub-Saharan African countries and in South Asia over the century of analysis. The tallest people over these 100 years are men born in the Netherlands in the last quarter of 20th century, whose average heights surpassed 182.5 cm, and the shortest were women born in Guatemala in 1896 (140.3 cm; 135.8144.8). The height differential between the tallest and shortest populations was 19-20 cm a century ago, and has remained the same for women and increased for men a century later despite substantial changes in the ranking of countries.
|
|
| 10. |
|
|
