| 1. |
- Chen, Lan, et al.
(författare)
-
Innovative aryl-based hydrophobic deep eutectic solvent for efficient removal of dyes and nanoplastics
- 2023
-
Ingår i: Separation and Purification Technology. - : Elsevier BV. - 1383-5866 .- 1873-3794. ; 308
-
Tidskriftsartikel (refereegranskat)abstract
- Efficient absorption is a highly important strategy to remove environmental pollutants (i.e., dyes and nano plastics), which relays on the development of innovative and sustainable absorbents. Herein, we designed an innovative aryl-based deep eutectic solvent (DES) using diphenylamine (DPA) and benzophenone (BZP) as the component at a molar ratio of 1:1, and this novel DES was denoted as DPA:BZP-1:1. The developed DPA:BZP-1:1 could efficiently adsorb RhB and PS nanoparticles from their aqueous solution/suspension, and the absorption efficiency could reach up to 97.3% and 80%, respectively. Notably, DPA:BZP-1:1 showed a higher absorption efficiency than commercial activated carbon. Experimental and computational results revealed that hydrogen bonding and 7C-7C stacking synergistically contributed to the excellent absorption ability of DPA:BZP-1:1 on dye Rhodamine B (RhB) and polystyrene (PS) nanoplastics. To the best our knowledge, this is the first study on efficient absorption of dye and nanoplastics by aryl-based DESs.
|
|
| 2. |
- Hu, Chang-Kang, et al.
(författare)
-
Native Conditional iSWAP Operation with Superconducting Artificial Atoms
- 2023
-
Ingår i: Physical Review Applied. - 2331-7019. ; 20:3
-
Tidskriftsartikel (refereegranskat)abstract
- Controlling the flow of quantum information is a fundamental task for quantum computers, which is unfeasible to realize on classical devices. Coherent devices, which can process quantum states are thus required to route the quantum states that encode information. In this paper we demonstrate experimentally the smallest quantum transistor with a superconducting quantum processor, which is composed of a collector qubit, an emitter qubit, and a coupler (transistor gate). The interaction strength between the collector and emitter qubits is controlled by the frequency and state of the coupler, effectively implementing a quantum switch. Through the coupler-state-dependent Heisenberg (inherent) interaction between the qubits, a single-step (native) conditional iSWAP operation can be applied. To this end, we find that it is useful to take into consideration the higher-energy level for achieving a native and high-fidelity transistor operation. By reconstructing the quantum process tomography, we obtain an operation fidelity of 92.36% when the transistor gate is open (iSWAP implementation) and 95.23% in the case of closed gate (identity gate implementation). The architecture has strong potential in quantum information processing applications with superconducting qubits.
|
|
| 3. |
- Hu, Chang-Kang, et al.
(författare)
-
Optimal charging of a superconducting quantum battery
- 2022
-
Ingår i: Quantum Science and Technology. - : IOP Publishing. - 2058-9565. ; 7:4
-
Tidskriftsartikel (refereegranskat)abstract
- Quantum batteries are miniature energy storage devices and play a very important role in quantum thermodynamics. In recent years, quantum batteries have been extensively studied, but limited in theoretical level. Here we report the experimental realization of a quantum battery based on superconducting qutrit. Our model explores dark and bright states to achieve stable and powerful charging processes, respectively. Our scheme makes use of the quantum adiabatic brachistochrone, which allows us to speed up the battery ergotropy injection. Due to the inherent interaction of the system with its surrounding, the battery exhibits a self-discharge, which is shown to be described by a supercapacitor-like self-discharging mechanism. Our results paves the way for proposals of new superconducting circuits able to store extractable work for further usage.
|
|
| 4. |
- Wang, Wei, et al.
(författare)
-
High corrosion resistance duplex fcc + hcp cobalt based entropic alloys: An experimental and theoretical investigation
- 2022
-
Ingår i: Materials and Design. - : Elsevier BV. - 1873-4197 .- 0264-1275. ; 223
-
Tidskriftsartikel (refereegranskat)abstract
- A series of duplex fcc + hcp Co-based entropic alloys are being discovered as a new category of entropic alloys with outstanding mechanical properties, especially to overcome a typical mechanical trade-off between strength and ductility. In this work, CALPHAD-based (CALculation of PHAse Diagram) thermodynamic calculations were performed to facilitate alloy design and to understand corrosion behaviors. The kinetics of the electrochemical corrosion for designed alloys in typical aggressive anion Cl- was investigated by electrochemical tests, including open circuit potential (OCP), polarization and cyclic polarization curves, and electrochemical impedance spectroscopy (EIS). The valence state and the surface morphologies of the passive films were investigated by X-ray photoelectron spectroscopy (XPS) and atomic force microscope (AFM). High corrosion resistance materials with high strength and ductility performances were discovered in the present work. Except for Ni-oxides, various spinel compounds and many other oxides including Co2O3, Cr2O3, Fe2O3, MnO, MoO3, CoCr2O4, FeCr2O4, CoFe2O4, and CoMoO4 were observed in the passive films. The adsorbed and penetrated corrosive anion Cl- will be prone to breakdown the passive films with less Cr2O3, CoCr2O4 and MoO3 to form pitting corrosion (also include other localized corrosion, such as intergranular corrosion and crevice corrosion). The microstructure of the hcp martensite with the fcc matrix has played an important role in the propagation of the localized anodic dissolution in the form of cleavage and quasi-cleavage. The theoretical calculations are in good agreement with the experimental observations. This paper paves a way for the future development of high-performance Co-based entropic alloys served in some harsh environments.
|
|
| 5. |
- Wang, Wei, et al.
(författare)
-
High corrosion resistance duplex fcc plus hcp cobalt based entropic alloys : An experimental and theoretical investigation
- 2022
-
Ingår i: Materials & design. - : Elsevier BV. - 0264-1275 .- 1873-4197. ; 223, s. 111166-
-
Tidskriftsartikel (refereegranskat)abstract
- A series of duplex fcc + hcp Co-based entropic alloys are being discovered as a new category of entropic alloys with outstanding mechanical properties, especially to overcome a typical mechanical trade-off between strength and ductility. In this work, CALPHAD-based (CALculation of PHAse Diagram) thermo-dynamic calculations were performed to facilitate alloy design and to understand corrosion behaviors. The kinetics of the electrochemical corrosion for designed alloys in typical aggressive anion Cl-was inves-tigated by electrochemical tests, including open circuit potential (OCP), polarization and cyclic polariza-tion curves, and electrochemical impedance spectroscopy (EIS). The valence state and the surface morphologies of the passive films were investigated by X-ray photoelectron spectroscopy (XPS) and atomic force microscope (AFM). High corrosion resistance materials with high strength and ductility per-formances were discovered in the present work. Except for Ni-oxides, various spinel compounds and many other oxides including Co2O3, Cr2O3, Fe2O3, MnO, MoO3, CoCr2O4, FeCr2O4, CoFe2O4, and CoMoO4 were observed in the passive films. The adsorbed and penetrated corrosive anion Cl-will be prone to breakdown the passive films with less Cr2O3, CoCr2O4 and MoO3 to form pitting corrosion (also include other localized corrosion, such as intergranular corrosion and crevice corrosion). The microstructure of the hcp martensite with the fcc matrix has played an important role in the propagation of the localized anodic dissolution in the form of cleavage and quasi-cleavage. The theoretical calculations are in good agreement with the experimental observations. This paper paves a way for the future devel-opment of high-performance Co-based entropic alloys served in some harsh environments.
|
|
